Calcium carbonate, total and organic carbon and accumulation rate characteristics at DSDP Leg 78A Holes

Bulk sediment accumulation rates and carbonate and carbonate-free accumulation rates corrected for tectonic tilting have been calculated for Leg 78A sediments. These rates are uniformly low, ranging from 0.1 to 6.8 g/(cm**2 x 10**3 yr.), reflecting the pelagic-hemipelagic nature of all the sediments drilled in the northern Lesser Antilles forearc. Rates calculated for Sites 541 and 542 [0.6-6.8 g/(cm**2 x 10**3 yr.)], located on the lower slope of the accretionary prism, are significantly greater than the Neogene rates calculated for oceanic reference Site 543 [0.1-2.4 g/(cm**2 x 10**3)]. This difference could be the result of (1) tectonic thickening of accretionary prism sediments due to folding, small-scale faulting, and layer-parallel shortening; (2) deposition in shallower water farther above the CCD (carbonate compensation depth) resulting in preservation of a greater percentage of calcareous microfossils; or (3) a greater percentage of foraminiferal sediment gravity flows. Terrigenous turbidites are not documented in the Leg 78A area because of (1) great distance from South American sources; (2) damming effects of east-west trending tectonic elements; and (3) location on the Tiburon Rise (Site 543). This lack of terrigenous material, characteristic of intraoceanic convergent margins, suggests that published sedimentation models for active continental convergent margins with abundant terrigenous influxes are not applicable to intraoceanic convergent margin settings.

(Table 2) Estimated basement temperatures at DSDP Hole 69-504B

The achievement of deep penetration (562 m) of seafloor basalts at Hole 504B, near the Costa Rica Rift (1°13.63'N, 83°43.81'W), on DSDP Legs 69 and 70 presented a rare opportunity to examine the structure of young (6 m.y.) oceanic crust. In addition to the recovery of samples for laboratory studies, an extensive suite of downhole logs and experiments was carried out at this site, for two main purposes: (1) to allow reliable deductions about the nature of the entire section of penetrated crust, because recovery of samples was far from complete (-25%); (2) to probe the physical state of rock around the drilled hole on a scale of tens of meters to kilometers. Information on the latter large-scale phenomena at Hole 504B were provided mainly by the oblique seismic experiment, utilizing a bore-hole seismometer (Stephen 1983), and by the large-scale-electrical- resistivity experiment described below.

Oxygen and carbon isotopic composition of benthic and planktonic foraminifers at DSDP Site 610

A record of carbon and oxygen isotopes in benthic and planktonic foraminifers has been obtained from the interval corresponding to the last 2.4 m.y. of Site 610, Holes 610 and 610A, with a sample resolution of about 30 kyr. The record from the late Quaternary (<0.9 Ma) shows large amplitudes and high frequencies in oxygen isotopic variation. Prior to 0.9 Ma the isotopic variability record is reduced in amplitude (but not in frequency) compared with the late Quaternary, suggesting lower ice-volume and climatic fluctuations, and higher average eustatic sea level. Left-coiling (L, polar) Neogloboquadrinapachyderma were not found in samples between 1.0 and 2.2 Ma, indicating less influence of polar front migrations in the Northeast Atlantic. Both polar planktonic faunas and larger isotope fluctuations reappear in the lowermost samples (2.3 to 2.4 Ma), pointing toward a period of larger climatic variability in the late Pliocene than in the early Quaternary. The variation in benthic d13C and hence in deep-water d13C seems to have been constant through the analyzed section, reflecting a stable variability in the production of North Atlantic Deep Water (NADW) and possibly in Norwegian-Greenland Sea Overflow. Preliminary analyses of amino-acid epimerization in N. pachyderma (L) indicate a constant rate of epimerization to approximately 0.3 Ma. Beneath this level the average epimerization rate is much reduced.

(Table 1) Sediment characteristics at DSDP Hole 75-532A

Orientation and geometry of pores as well as sediment compressibility can be approximated by determining the shrinkage behavior of standardized samples. The sections investigated show that these measurements are influenced by changing sediment composition. This is also well documented by the relationship between void ratio and overburden pressure. Median pore-diameter calculations clearly reflect both sediment composition and compaction.

Mössbauer study at DSDP Hole 95-612

57Fe Mössbauer spectra of 15 oceanic sediment samples collected from Site 612 (Deep Sea Drilling Project Leg 95) were recorded. These spectra showed that most of the iron in the sediments was present as high-spin, paramagnetic Fe2+ and Fe3+. The ferrous iron was mainly distributed in terrigenous clays and biogenic carbonates. The variation of the Mössbauer parameters for Fe2+ with sub-bottom depth suggests that the main Fe2+-bearing component changed with geologic time. The amount of iron in each iron-bearing phase as estimated from the corresponding peak areas in the spectra also changed with depth. These variations in the Mössbauer parameters and peak areas are correlated with lithologic changes in the sediment column.

Organic carbon, calcium carbonate and carbon/nitrogen ratio at DSDP Leg 93 sites

A large number of samples of nonlithified and lithified sediments from Leg 93 sites were analyzed for their contents of organic carbon and calcium carbonate. An average of two samples was selected from every core for carbonate determination; organic carbon was measured in most of these samples. Nearly all of these analyses were performed on board Glomar Challenger for samples from Sites 603 and 604. Site 605 samples, plus some of the deeper samples from Hole 603B, were analyzed at the University of Michigan. The procedures used in both cases were virtually the same, and their results compared well. Organic carbon analyses were done using a Hewlett- Packard 185-B CHN Analyzer. Portions of samples selected for calcium carbonate determinations were treated with dilute HC1 to remove carbonate, washed with deionized water, and dried at 110°C. A Cahn Electrobalance was used to weight 20-mg samples of sediment for CHN analysis. Samples were combusted at 1050°C in the presence of an oxidant, and the volumes of the evolved gases determined as measures of the C, H, and N contents of sediment organic matter. Areas of gas peaks were determined and compared to those of rock standards of known carbon and nitrogen contents. These values were used to standardize instrument response so that C/N atomic ratios could be reported. Organic carbon concentrations were calculated on the basis of sediment dry weight. Hydrogen elemental analysis with the procedure used is untrustworthy because of the variable amounts of clay minerals and their hydrates, hence hydrogen values are not reported for samples analyzed by this method.

(Figure 1) Silicoflagellates at DSDP Hole 69-504

Diverse and abundant late Miocene to Pleistocene silicoflagellates at DSDP Site 504 can be correlated by tropical biostratigraphic zones and relative paleotemperature values to eastern tropical Pacific reference site DSDP 503A farther to the west. Early Pliocene assemblages, which were poorly known until now, are present and can be correlated locally between DSDP Holes 504, 503A, and 495, using species events associated with the new Dictyocha pulchella Subzone and Dictyocha angulata Subzone. Silicoflagellate relative paleotemperature values show major warming at 4.7 to 5.0 Ma (Cores 45-48), 3.4 to 3.8 Ma (Cores 32-33), 1.5 to 1.7 Ma (Cores 12-16), and 0.5 to 0.8 Ma (Cores 3-6). Major coolings occurred at 5.0 to 5.1 Ma (Core 51), 3.9 to 4.4 Ma (Cores 38-44), and 1.0 to 1.3 Ma (Cores 8-10). The appearance of Dictyocha longa is proposed to replace the asperoid/fibuloid ratio reversal as the bottom of the Dictyocha fibula Zone, because the non-evolutionary ratio reverses several times in the upper Miocene of Hole 503A, and at least once in Hole 504. Three new Pliocene silicoflagellates are defined: Dictyocha concinna Bukry, n. sp., D. helix Bukry, n. sp., and D. tamarae Bukry, n. sp.