Determinação de metais traço no material particulado em suspensão em Ouro Preto, Minas Gerais

The determination of the airborne particulate matter (PTS) mass and trace metals concentrations were performed in three sites in Ouro Preto, MG, Brazil. It was evaluated 288 samples. The legal limit of annual geometric average (60 µg m-3) to PTS concentrations didn't exceed, but the legal limit for 24 h (240 µg m-3) did in three measurements. Seven metals (Al, Cr, Cu, Fe, Mn, Ni, Pb) analysed by ICP-AES were quantified in 18 samples. Aluminum and iron showed the highest concentrations, indicating the contribution of the soil and of one aluminum plant. The high nickel concentration is probably due to vehicular emissions and industrial combustion processes.

Síntese hidrotermal de sodalita básica a partir de um rejeito de caulim termicamente ativado

Basic sodalite was successfully synthesized by hydrothermal method using kaolin waste as source of Aluminum and Silicon. This waste is mainly composed by kaolinite and is produced in large amount by kaolin processing industries for paper coating from the Amazon region. Initially, the waste has been calcined at 700 ºC for 2 h and then reacted with the following solutions: Na2CO3 and mixture of Na2CO3 + NaOH to 150 ºC with autogenous pressure for 24 h. The raw materials and transformed materials were characterized by XRD, FTIR and SEM. In both studied media, well-crystallized, basic sodalite was the only phase synthesized, while in the literature usually a mixture of zeolites is obtained.

Preparação e propriedades de zeólitas faujasita contendo cátions amônio

Sodium faujasite zeolites with Si/Al ratio of 1.4 and 2.5 were exchanged with methylammonium cations. The influence of framework aluminum and ion exchange degree in their basic properties were evaluated. These properties were assessed in the Knoevenagel catalytic condensation. The sodium ion exchange was restricted to the supercavity and the exchange degree depended on the cation volume and on the Si/Al ratio. The higher catalytic activity is achieved for the zeolite with the lower Si/Al ratio exchanged with the monomethylammonium cation. The best performance of this catalyst is attributed to the higher basicity in combination with elevated micropore volume.

Utilização de diferentes tipos de policloretos de alumínio para purificação de hidrolisado de bagaço de cana através da técnica de coagulação e floculação

In order to investigate the action of the flocculating agents Panfloc and Panclar a full factorial design 2³ and a Central Composite design 2² were carried out. The control variables were the flocculant concentration, pH and temperature. The response variables were phenolic compounds reduction and spectral area reduction. The best conditions of treatment was hydrolyzate at pH 9 for both coagulants, but the use of Panfloc was more effective in the phenolic compounds reduction (73.9%) and spectral area reduction (65.8%).

Calorímetro de gelo: uma abordagem histórica e experimental para o ensino de química na graduação

In addition to the usual advantage of an ice calorimeter of being able to measure slow heat changes, the instrument described here is extremely simple to construct and operate. Specific heat of aluminum, copper, lead and tin metals were determined using the ice calorimeter made with easily accessible materials. The values obtained from specific heat are near to those found in the literature and were 0.204; 0.030; 0.086; 0.046 cal/g °C with an error of theoretical values of 6.84; 1,64; 5.49 and 8.00% for aluminum, copper, lead and tin, respectively.

Co2 na desidrogenação oxidativa do etilbenzeno utilizando catalisadores compostos de óxido de ferro e óxido de alumínio

Materials containing aluminum and iron oxide were synthesized through the preparation of hybrid spheres and tested in the dehydrogenation of ethylbenzene in the presence of CO2. The catalytic results suggest that the high initial ethylbenzene conversion is due to the contribution of basic sites. These results also point to a competitive process between CO2 adsorption and the oxidative dehydrogenation of ethylbenzene for the basic sites (lattice oxygen). In spite of the coke deposition is originating from ethylbenzene and CO2, the amount of carbonaceous deposits was smaller with the presence of CO2, if compared with the dehydrogenation in the absence of CO2.

A gestão do conhecimento aplicada à reciclagem de componentes automotivos através do tratamento das informações contidas em documentos de patentes

This article evaluates the technologies adopted for recycling and reuse of automobile components, through the analysis of patents documents. The automobile batteries recycling is the main topic, followed by the automatic disassembly of vehicles, tires recycling and polyurethane recycling. None document approached recycling of steel and aluminum or ceramics products. The reduced number of technologies for the recycling of the polymeric compounds (including polyurethane) indicates that a bigger number of research and inventions must be elaborated in the next years, aiming at to the reduction of costs of processes and adequacy to the more restricted environmental legislation.

Tintas anti-incrustantes de terceira geração: novos biocidas no ambiente aquático

Antifouling agents have been used on vessels and boats since ancient civilizations. Thus, a brief history on the three generations of antifouling paints was provided in the present review. Additionally, information about physic-chemical properties, environmental levels, toxicology and analytical methods was discussed for the 16 "new" booster biocides used as third-generation antifouling paints. The main problems, limitations and future trends related to this subject were also presented. Finally, actions were suggested in order to appraise the current status of the environmental impact caused by these compounds in South America.

Um método para avaliar a taxa de corrosão

In this paper it is proposed an indirect method to evaluate the corrosion rate of an aluminum and zinc alloy in alkaline solution by using a well-known device for collecting gases over water. The hydrogen gas formation, a corrosion product, is monitored at different time intervals and associated with the alloy mass loss. It has been suggested that the students should work in groups, which may make feasible the social interaction among them and that results discussion may be done collectively under a professor orientation. This proposal may propitiate the learning of terminology and involved concepts as well as contribute to a better understanding of corrosion phenomena that occur in their everyday life.

Influência das características físico-químicas dos solos no ciclo hidrobiogeoquímico do mercúrio na região do Rio Aracá - AM

The region of Aracá River (Middle and Upper Rio Negro-AM) has peculiar characteristics, having soils with atypical profile and high organic matter contents in great deep. The levels of aluminum and iron in the soil samples increased as a function of depth and concentrations of mercury ranged from 0.097 to 0.964 µg g-1. Statistical analysis showed the degree of similarity between soil samples collected. The highest concentrations of mercury in soil samples are directly related to soil higher content of organic matter, directly influencing the fate and bioavailability of mercury species to the environment.

Produção e caracterização de espumas cerâmicas obtidas a partir de lodo de anodização de alumínio

Ceramic foams were produced from a sludge generated in the aluminum anodizing process by using an industrial polyurethane foam (replication method) with open cell sizes of 10 ± 5 ppi (porosity = 97%) which were impregnated with suspensions containing 50-61 wt.% alumina, 1 wt.% citric acid, 6 wt.% bentonite and fired at 1600 ºC for 2 h. The aluminum anodizing sludge shows a high alumina content (87.5 wt.%) and a low particle size (~1.7 mm) after calcination and milling. The obtained filters show porosity of approximately 70%, filtration capability (mass water flow) of 1.7 kg/s and mechanical strength under compression of 2.40 MPa.

Acúmulo de cargas elétricas em propelente sólido compósito com matriz de polibutadieno líquido hidroxilado

Composite solid propellants prepared with HTPB prepolymer - Hydroxyl Terminated Polybutadiene, AP - Ammonium Perchlorate as oxidizer and aluminum particles as an additive metal, have characteristics of high electrical resistivity. The loading process of the polymer matrix did not obtain homogeneity, resulting in clusters, mainly of metal particles. The effect of clustering in the composite was studied and observed experimentally, and this effect was one of the factors explaining the phenomenon of electrical charging of the composite. This electrical potential, when discharged abruptly, can generate an electric spark with sufficient energy for sustained ignition of a solid rocket motor.

Avaliação da remoção de fármacos e de desreguladores endócrinos em águas de abastecimento por clarificação em escala de bancada

In this work, the efficiency of clarification treatment (coagulation, flocculation and sedimentation) with polyaluminum chloride (PAC) and aluminum sulfate (SA) as coagulants was evaluated in the removal of 7 microcontaminants (diclofenac - DCF, sulfamethoxazole - SMX, ethinylestradiol - EE2, bisphenol-A - BPA, estradiol - E2, estrone - E1 and estriol - E3) in water of low and high turbidity. The clarification treatment led to poor removal rates (40% at most) for all microcontaminants except SMX which exhibited intermediate removal efficiency (67 to 70%). Overall, PAC application yielded better performance compared to SA.

Avaliação da labilidade de alumínio em infusões de erva-mate empregando voltametria adsortiva de redissolução catódica

Infusions of yerba mate obtained at different stages of industrialization were evaluated to determine the bioavailable fraction of Al. Adsorptive Cathodic Stripping Voltammetry using DASA (complexing agent) was applied to determine the labile fraction of Al at pH 5.0 and pH 8.0 for the total fraction of dissolved Al. The results indicate that on average 60% of Al is complexed with organic compounds, minimizing their bioavailability; however, the labile fraction exceeds by up to 4 times the maximum weekly intake recommended by the World Health Organization.

ACIDITY OF MODIFIED MORDENITES SYNTHESIZED FROM RICE HUSK SILICA AND CATALYTIC TRANSFORMATION OF METHYLBUTYNOL

Mordenite (MOR) was synthesized using rice husk silica and modified by base (B), acid (A) or acid-base (AB) and converted to H-form. The modification did not destroy the MOR structure but increased surface area and generated mesopores. Lewis acidity of the parent and modified MOR samples investigated by aluminum NMR and NH3-TPD showed a decrease in the following order: HMOR > BMOR > ABMOR > AMOR. For the catalytic transformation of methylbutynol, ABMOR provided the highest conversion and selectivity of products from acid sites.