An industrial scale dehydration process for natural gas involving membranes

An industrial scale dehydration process based on hollow fiber membranes for lowering the dew point of natural gas is described in this paper. A pilot test with the feed flux scale of 12x10(4) Nm(3)/d was carried out. Dew points of -8 degreesC-13 degreesC at a gas transport pressure in the pipeline of 4.6M Pa and methane recovery of more than 98% were attained. The water vapor content of the product gas could be maintained around 0.01 vol% during a continuous run of about 700 hours. The effects of feed flux and operation pressure on methane recovery and water vapor content were also investigated. Additionally, some auxiliary technologies, such as a full-time engine using natural gas as fuel and the utilization of vent gas in the process, are also discussed. A small amount of the vent gas from the system was used as a fuel for an engine to drive vacuum pumps, and the heat expelled from the engine was used to warm up the natural gas feed. The whole system can be operated in a self-sustainable manner from an energy point of view, and has a relatively high efficiency in the utilization of natural gas.

Research and development of catalytic processes for petroleum and natural gas conversions in the Dalian Institute of Chemical Physics

The Dalian Institute of Chemical Physics (DICP) of the Chinese Academy of Sciences has a long history in the R&D of catalysts and catalytic processes for petroleum and natural gas conversions in China. In this paper, results and features of some commercialized petrochemical catalysts and processes as well as newly developed processes for natural gas conversion in the pilot-plant stage are described. (C) 1999 Elsevier Science B.V. All rights reserved.

An integrated air-POM syngas/dimethyl ether process from natural gas

A Cu-Zn-Al methanol catalyst combined with HZSM-5 was used for dimethyl ether (DME) synthesis from a syngas containing nitrogen, which was produced by air-partial oxidation of methane (air-POM). Air-POM occurred at 850 degreesC, 0.8 MPa, CH4/air/H2O/CO2 ratio of 1/2.4/0.8/0.4 over a Ni-based catalyst modified by magnesia and lanthanum oxide with 96% CH4 conversion and constantly gave syngas with a H-2/CO ratio of 2/1 during a period of 450 h. The obtained N-2-containing syngas was used directly for DME synthesis. About 90% CO per-pass conversion, 78% DME selectivity and 70% DME yield could be achieved during 450 h stability testing under the pressure of 5.0 MPa. the temperature of 240 degreesC and the space velocity of 1000 h(-1). (C) 2002 Elsevier Science B. V. All rights reserved.

Cupins-de-montículo em pastagens.

Cupins-de-montículo predominam em áreas menos sujeitas à mecanização, como as pastagens. Dessa forma, quando não controlados, pastagens mais velhas podem apresentar níveis de infestação mais elevados. Em verdade, altas infestações desses cupins são, em muitos casos, indicadores de pastagens degradadas. As espécies mais comuns em pastagens pertencem ao gênero Cornitermes, destacando-se C. cumulans, C. bequaerti e C. silvestrii. Não há confirmação de danos diretos ocasionados por esses insetos em pastagens, assim como, contesta-se sobre a possível redução de área útil, normalmente associada aos cupinzeiros. Podem, sim, dificultar a movimentação de máquinas e implementos, assim como abrigar animais peçonhentos. Embora a importância desses cupins como pragas de pastagem seja discutível, tem sido generalizada a demanda por controle; que, predominantemente, tem sido feito através de inseticidas químicos. Ressalta-se que em pastagens altamente infestadas, muitas vezes velhas e degradadas, ocorre a morte natural de colônias, e o percentual de cupinzeiros já abandonados na área pode ser alto. Como essas áreas são passíveis de serem reformadas, não se recomenda o controle prévio dos cupinzeiros dessas espécies, e sim, que sejam implementadas as práticas previstas e recomendadas na reforma da pastagem. Estas práticas por si só controlam a maioria, se não todas, as colônias presentes na área. Alerta-se, no entanto, que alguns cupins pertencentes ao gênero Syntermes que, por vezes, também constroem montículos em pastagens, têm a característica de forragear na superfície, coletando folhas secas e verdes. Embora se admita que ocorram em menor freqüência, se comparado a outras espécies de cupins-de-montículo em pastagens, os mesmos representam uma ameaça em potencial.