部分重力条件下气液两相流型研究

本文分析了"和平号"空间站气液两相流实验中获得的部分重力(0.1 g和0.014 g)条件下的流型特征及其相互转换条件,并将其和常重力与微重力两相流研究中较常用的流型转换模型的预测结果进行了比较.

Slug to annular flow transition of microgravity two-phase flow

A new model is developed for predicting the transition from the slug to annular flow of adiabatic two-phase gas/liquid flow in microgravity (mu g) environment. This model is based on the analyses of the effects of the surface tension and the gas inertia in a sense of more physical approach. The drift-flux model is applied to determine the gas void fraction near the transition region. The new model is compared with previous models and experimental data, and the results show the improvement in explanation of the experimental results.

液相介质对水平气液间歇流动压降的影响

研究了水平管内不同液相介质(水、油和不同浓度的CMC溶液)对气液两相间歇流动压降的影响.实验管道为内径50mm的透明有机玻璃管,从入口到分离器长约30 m,实验段由2个长3 m的水平管组成.共记录了320组不同表观流速下的压降信号:油相0.17～1.85 m/s,水相0.17～2.48 m/s,CMC溶液0.17～1.42 m/s,气相0.06～3.40 m/s.结果表明,液相为牛顿流体(油或水)的气液流动,随着表观气相流速的增大,压降呈增加趋势;非牛顿幂率流体(不同浓度的CMC溶液)的管道流动,当流动指数低于一定值时,压降随气相流量的增加呈降低趋势,并且低于单液相流动的压降.Lockhart-Martinelli模型过高地预测了气-非牛顿幂率流体两相的压降.

The effect of an insoluble surfactant on the skin friction of a bubble

In this paper, we develop a novel moving mesh method suitable for solving axisymmetric free-boundary problems, including the Marangoni effect induced by surfactant or temperature variation. This method employs a body-fitted grid system where the gas-liquid interface is one line of the grid system. We model the surfactant equation of state with a non-linear Langmuir law, and, for simplicity, we limit ourselves to the situation of an insoluble surfactant. We solve complicated dynamic boundary conditions accurately on the gas-liquid interface in the framework of finite-volume methods. Our method is used to study the effect of a surfactant on the skin friction of a bubble in a uniaxial flow. For the limiting case where the surface diffusivity is zero, the effect of a tangential stress generated by the surface tension gradient, allows us to explain a new phenomenon in high concentration regimes: larger surface tension, but also larger deformation. Furthermore, this condition leads to the formation of boundary layers and flow separation at high Reynolds numbers. The influence of these complex flow patterns is examined. © 2005 Elsevier SAS. All rights reserved.

Quantitative RNA-seq analysis of the campylobacter jejuni transcriptome

Campylobacter jejuni is the most common bacterial cause of foodborne disease in the developed world. Its general physiology and biochemistry, as well as the mechanisms enabling it to colonize and cause disease in various hosts, are not well understood, and new approaches are required to understand its basic biology. High-throughput sequencing technologies provide unprecedented opportunities for functional genomic research. Recent studies have shown that direct Illumina sequencing of cDNA (RNA-seq) is a useful technique for the quantitative and qualitative examination of transcriptomes. In this study we report RNA-seq analyses of the transcriptomes of C. jejuni (NCTC11168) and its rpoN mutant. This has allowed the identification of hitherto unknown transcriptional units, and further defines the regulon that is dependent on rpoN for expression. The analysis of the NCTC11168 transcriptome was supplemented by additional proteomic analysis using liquid chromatography-MS. The transcriptomic and proteomic datasets represent an important resource for the Campylobacter research community. © 2011 SGM.

Oil-Water Two-Phase Flow Inside T-Junction

The oil/water two-phase flow inside T-junctions was numerically simulated with a 3-D two-fluid model, and the turbulence was described using the mixture k - epsilon model. Some experiments of oil/water flow inside a single T-junction were conducted in the laboratory. The results show that the separating performance of T-junction largely depends oil the inlet volumetric fraction and flow patterns. A reasonable agreement is reached between the numerical simulation and the experiments for both the oil fraction distribution and the separation efficiency.

Richtmyer-Meshkov不稳定性流体混合区发展的实验研究

使用矩形激波管,在马赫数分别为M=1.5和1.7的条件下实验研究了气/液界面上(即Atwood数A接近1时)由Richtmyer-Meshkov不稳定性引起的流体混合现象.得到了气/液界面上Richtmyer-Meshkov不稳定性后期流体混合区域宽度随时间的发展呈现出线性关系的结果,即h∝t.比较了不同马赫数和初始扰动下的发展情况,发现当马赫数增加时,同一时间混合区域宽度随之增加,混合区域宽度增长变快;而相比于波长差别不大的弱多模态初始扰动(无人为干扰界面),当界面初始扰动获得随机外界干扰时,界面混合区域具有较大的宽度以及增长速度.并且增加激波马赫数和初始扰动多模态性,流体混合程度更为剧烈

关于气液两相流流型及其判别的若干问题

气液两相流体系是一个复杂的多变量随机过程体系，流型的定义、流型过渡准则和判别方法等方面的研究是多相流学科目前研究的重点内容。本文就与气液两相流流型及其判别有关的研究状况进行了回顾和评述，力图反映近年来气液两相流流型及其判别问题研究的状态和趋势。

气/液界面上Richtmyer-Meshkov不稳定性的实验研究

报道了在国内首次实现的矩形激波管内气/液界面上(即Atwood number,A1)的Richtmyer-Meshkov(RM)不稳定性现象.实验在一台垂直矩形激波管中进行,得到了较低马赫数(M=1.36和1.58)下,多元扰动R-M不稳定性后期阶段气泡和尖钉高度对时间的增长规律,即气泡高度h_b ~ t~(0.55±0.01)1 ,尖钉高度h_s~ t.当激波马赫数从1.36增加到1.58时,气泡和尖钉高度对时间的指数规律没有发生明显改变,气泡的增长速度没有受到影响,而尖钉增长速度却有大幅度的增加.同时还观察研究了多元扰动R-M不稳定性中典型的气泡竞争现象.

Determination of drugs used in combined cardiovascular therapy

Cardiovascular diseases are nowadays the first cause of mortality worldwide, causing around the 30% of global deaths each year. The risk of suffering from cardiovascular illnesses is strongly related to some factors such as hypertension, high cholesterol levels, diabetes, obesity The combination of these different risk factors is known as metabolic syndrome and it is considered a pandemic due to the high prevalence worldwide. The pathology of the disorders implies a combined cardiovascular therapy with drugs which have different targets and mechanisms of action, to regulate each factor separately. The simultaneous analysis of these drugs turns interesting but it is a complex task since the determination of multiple substances with different physicochemical properties and physiological behavior is always a challenge for the analytical chemist. The complexity of the biological matrices and the difference in the expected concentrations of some analytes require the development of extremely sensitive and selective determination methods. The aim of this work is to fill the gap existing in this field of the drug analysis, developing analytical methods capable of quantifying the different drugs prescribed in combined cardiovascular therapy simultaneously. Liquid chromatography andem mass spectrometry (LCMS/MS) has been the technique of choice throughout the main part of this work, due to the high sensitivity and selectivity requirements.

气-液两相流界面迁移现象的数值模拟研究

借助于Level Set函数,建立了气-液两相的统一控制方程组,并在交错网格中进行离散.用两种格式,即Superbee-TVD格式和5阶WENO格式求解Level Set函数的输运方程,用SIMPLER算法的思想对主流场控制方程的求解方法进行改进.数值实验结果表明,在求解Level Set的控制方程时,5阶WENO方法比Superbee-TVD格式的结果更准确;用改进的数值算法可成功实现对密度比大于1 000/1的气-液两相流界面迁移问题的数值模拟.对几种典型大密度比气-液两相流问题的计算结果与实际问题的物理规律完全一致,验证了该方法的有效性和可靠性.

Design of a Self-Adaptive Down-Hole Layered Steam Injector and Its Application

Layered steam injection, widely used in Liaohe Oilfield at Present, is an effective recovery technique to heavy oil reserves. Which makes the steam front-peak push forward uniformly, the amount of steam injection be assigned rationally, and the effect of injection steam be obtained as expected. To maintain a fixed ratio of layered steam injection and solve the problem of nonadjustable hole diameter with the change of layer pressure in the existing injectors, a new method is proposed in this paper to design layered steam injectors based on the dynamic balance theory. According to gas-liquid two-phase flow theory and beat transfer theory, the energy equation and the heat conduction equation in boreholes are developed. By analyzing the energy equilibrium of water-steam passing through the injector hole, we find an expression to describe the relation between the cross-sectional area of injector hole and the layer pressure. With this expression, we provide a new set of calculation methods and write the corresponding computer program to design and calculate the main parameters of a steam injector. The actual measurement data show that the theoretically calculated results are accurate, the software runs reliably, and they provide the design of self-adjustable layered steam injectors with the theoretical foundation.

Bubble-to-Slug Transition for Low-Re Two-Phase Flows

A critical review on the mechanism and models on the bubble-to-slug transition of two-phase gas-liquid flows are presented in the present paper. It is shown that the most possible mechanism controlled the bubble-to-slug transition is the bubble coalescence. Focusing on the bubble-to-slug transition for the low-Re two-phase flow, a simple Monte Carlo method is used to simulate the influence of the initial bubble size on the bubble-to-slug transition. Some secondary factors, such as the liquid viscosity, the surface tension, and the relative slip between the two phases, are ignored in the present study. It is found that the locus of the dimensionless rate of collision is a universal curve. Based on this curve, it is determined that the bubble initial size can affect the phase distribution and flow pattern when its dimensionless value is in the range from 0.03 to 0.4. A simple relationship between the critical void fraction and the initial bubble size is proposed, which agrees very well with the experimental data.

Design of a Self-Adaptive Down-Hole Layered Steam Injector and Its Application

Layered steam injection, widely used in Liaohe Oilfield at present, is an effective recovery technique to heavy oil reserves. Which makes the steam front-peak push forward uniformly, the amount of steam injection be assigned rationally, and the effect of injection steam be obtained as expected. To maintain a fixed ratio of layered steam injection and solve the problem of nonadjustable hole diameter with the change of layer pressure in the existing injectors, a new method is proposed in this paper to design layered steam injectors based on the dynamic balance theory According to gas-liquid two-phase flow theory and heat transfer theory, the energy equation and the heat conduction equation in boreholes are developed. By analyzing the energy equilibrium of water-steam passing through the injector hole, we find an expression to describe the relation between the cross-sectional area of injector hole and the layer pressure. With this expression, we provide a new set of calculation methods and write the corresponding computer program to design and calculate the main parameters of a steam injector. The actual measurement data show that the theoretically calculated results are accurate, the software runs reliably, and they provide the design of self-adjustable layered steam injectors with the theoretical foundation.

Space experimental studies of microgravity fluid science in China

Microgravity fluid physics is an important part of microgravity sciences, which consists of simple fluids of many new systems, gas-liquid two-phase flow and heat transfer, and complex fluid mechanics. In addition to the importance of itself in sciences and applications, microgravity fluid physics closely relates to microgravity combustion, space biotechnology and space materials science, and promotes the developments of interdisciplinary fields. Many space microgravity experiments have been per- formed on board the recoverable satellites and space ships of China and pushed the rapid development of microgravity sciences in China. In the present paper, space experimental studies and the main re- sults of the microgravity fluid science in China in the last 10 years or so are introduced briefly.