Seismic characterization and dynamic site response of a municipal solid waste landfill in Bangalore, India

Seismic design of landfills requires an understanding of the dynamic properties of municipal solid waste (MSW) and the dynamic site response of landfill waste during seismic events. The dynamic response of the Mavallipura landfill situated in Bangalore, India, is investigated using field measurements, laboratory studies and recorded ground motions from the intraplate region. The dynamic shear modulus values for the MSW were established on the basis of field measurements of shear wave velocities. Cyclic triaxial testing was performed on reconstituted MSW samples and the shear modulus reduction and damping characteristics of MSW were studied. Ten ground motions were selected based on regional seismicity and site response parameters have been obtained considering one-dimensional non-linear analysis in the DEEPSOIL program. The surface spectral response varied from 0.6 to 2g and persisted only for a period of 1s for most of the ground motions. The maximum peak ground acceleration (PGA) obtained was 0.5g and the minimum and maximum amplifications are 1.35 and 4.05. Amplification of the base acceleration was observed at the top surface of the landfill underlined by a composite soil layer and bedrock for all ground motions. Dynamic seismic properties with amplification and site response parameters for MSW landfill in Bangalore, India, are presented in this paper. This study shows that MSW has less shear stiffness and more amplification due to loose filling and damping, which need to be accounted for seismic design of MSW landfills in India.

Capacity approaching codes for non-coherent orthogonal modulation

This paper describes a curve-fitting approach for the design of capacity approaching coded modulation for orthogonal signal sets with non-coherent detection. In particular, bit-interleaved coded modulation with iterative decoding is considered. Decoder metrics are developed that do not require knowledge of the signal-to-noise ratio, yet still offer very good performance. © 2007 IEEE.

Non-Slipping Jkr Model For Transversely Isotropic Materials

A generalized plane strain JKR model is established for non-slipping adhesive contact between an elastic transversely isotropic cylinder and a dissimilar elastic transversely isotropic half plane, in which a pulling force acts on the cylinder with the pulling direction at an angle inclined to the contact interface. Full-coupled solutions are obtained through the Griffith energy balance between elastic and surface energies. The analysis shows that, for a special case, i.e., the direction of pulling normal to the contact interface, the full-coupled solution can be approximated by a non-oscillatory one, in which the critical pull-off force, pull-off contact half-width and adhesion strength can be expressed explicitly. For the other cases, i.e., the direction of pulling inclined to the contact interface, tangential tractions have significant effects on the pull-off process, it should be described by an exact full-coupled solution. The elastic anisotropy leads to an orientation-dependent pull-off force and adhesion strength. This study could not only supply an exact solution to the generalized JKR model of transversely isotropic materials, but also suggest a reversible adhesion sensor designed by transversely isotropic materials, such as PZT or fiber-reinforced materials with parallel fibers. (c) 2007 Elsevier Ltd. All rights reserved.

Growth in an oil abundant economy: The case of Venezuela

This paper has been presented at DEGIT-X held in México 2005.-- Revised: 2008-08.

New Oncogenic Drivers in Hepatocellular Carcinoma: Role of the RNA Binding Protein Hu antigen R

156 p. : graf.

Assessing the sustainability of brackish water aquaculture systems in the Philippines. Working Paper 4: Aquaculture and poverty - a case study of five coastal communities in the Philippines

After reviewing the rather thin literature on the subject, we investigate the relationship between aquaculture and poverty based on a case study of five coastal communities in the Philippines. The analysis relies on a data set collated through a questionnaire survey of 148 households randomly selected in these five communities. The methodological approach combines the qualitative analysis of how this relationship is perceived by the surveyed households and a quantitative analysis of the levels and determinants of poverty and inequality in these communities. There is overwhelming evidence that aquaculture benefits the poor in important ways and that it is perceived very positively by the poor and non-poor alike. In particular, the poor derive a relatively larger share of their income from aquaculture than the rich, and a lowering of the poverty line only reinforces this result. Further, a Gini decomposition exercise shows unambiguously that aquaculture represents an inequality-reducing source of income. We believe that the pro-poor character of brackish water aquaculture in the study areas is explained by the fact that the sector provides employment to a large number of unskilled workers in communities characterized by large surpluses of labour. Our results also suggest that the analysis of the relationship between aquaculture and poverty should not focus exclusively on the socio-economic status of the farm operator/owner, as has often been the case in the past. [PDF contains 51 pages]

Entwicklung einer einfachen und schnellen Analysenmethode für Kohlenmonoxid in Fisch und Durchführung orientierender Untersuchungen

Treatment with gases containing CO, misleadingly called “tasteless smoke” or “clear smoke”, prior to freezing of fish like tuna, tilapia and swordfish (to name only a few of these species that are characterised by an intensive coloration of flesh) stabilise the fresh red colour of muscle also after thawing and suggest consumers non-existing freshness. In the European Union, carbon monoxide is excluded from being a permitted additive and therefore this handling is not allowed. Notwithstanding of the clear legal position, producers and traders are trying to establish CO treated fish on the market. In the case of taking legal measures the food control laboratories have to provide evidence that fish has been treated by CO and therefore a respective method is necessary. The method of determination of carbon monoxide in fish flesh presently applied requires considerable material and mechanistic effort to detect CO by GC after catalytic transformation into methane. The aim of our work was a direct detection of CO using suitable sensor technology. Mechanistic requirements and results of preliminary investigations to detect carbon monoxide in fish flesh will be described.

A smoothing technique for discrete delta functions with application to immersed boundary method in moving boundary simulations.

The effects of complex boundary conditions on flows are represented by a volume force in the immersed boundary methods. The problem with this representation is that the volume force exhibits non-physical oscillations in moving boundary simulations. A smoothing technique for discrete delta functions has been developed in this paper to suppress the non-physical oscillations in the volume forces. We have found that the non-physical oscillations are mainly due to the fact that the derivatives of the regular discrete delta functions do not satisfy certain moment conditions. It has been shown that the smoothed discrete delta functions constructed in this paper have one-order higher derivative than the regular ones. Moreover, not only the smoothed discrete delta functions satisfy the first two discrete moment conditions, but also their derivatives satisfy one-order higher moment condition than the regular ones. The smoothed discrete delta functions are tested by three test cases: a one-dimensional heat equation with a moving singular force, a two-dimensional flow past an oscillating cylinder, and the vortex-induced vibration of a cylinder. The numerical examples in these cases demonstrate that the smoothed discrete delta functions can effectively suppress the non-physical oscillations in the volume forces and improve the accuracy of the immersed boundary method with direct forcing in moving boundary simulations.