Comparative study of the performance of the M-cycle counter-flow and cross-flow heat exchangers for indirect evaporative cooling - paving the path towards sustainable cooling of buildings

This paper provides a comparative study of the performance of cross-flow and counter-flow M-cycle heat exchangers for dew point cooling. It is recognised that evaporative cooling systems offer a low energy alternative to conventional air conditioning units. Recently emerged dew point cooling, as the renovated evaporative cooling configuration, is claimed to have much higher cooling output over the conventional evaporative modes owing to use of the M-cycle heat exchangers. Cross-flow and counter-flow heat exchangers, as the available structures for M-cycle dew point cooling processing, were theoretically and experimentally investigated to identify the difference in cooling effectiveness of both under the parallel structural/operational conditions, optimise the geometrical sizes of the exchangers and suggest their favourite operational conditions. Through development of a dedicated computer model and case-by-case experimental testing and validation, a parametric study of the cooling performance of the counter-flow and cross-flow heat exchangers was carried out. The results showed the counter-flow exchanger offered greater (around 20% higher) cooling capacity, as well as greater (15%–23% higher) dew-point and wet-bulb effectiveness when equal in physical size and under the same operating conditions. The cross-flow system, however, had a greater (10% higher) Energy Efficiency (COP). As the increased cooling effectiveness will lead to reduced air volume flow rate, smaller system size and lower cost, whilst the size and cost are the inherent barriers for use of dew point cooling as the alternation of the conventional cooling systems, the counter-flow system is considered to offer practical advantages over the cross-flow system that would aid the uptake of this low energy cooling alternative. In line with increased global demand for energy in cooling of building, largely by economic booming of emerging developing nations and recognised global warming, the research results will be of significant importance in terms of promoting deployment of the low energy dew point cooling system, helping reduction of energy use in cooling of buildings and cut of the associated carbon emission.

Simulation of the future performance of low-energy evaporative cooling systems using UKCP09 climate projections

Recent activity in the development of future weather data for building performance simulation follows recognition of the limitations of traditional methods, which have been based on a stationary (observed) climate. In the UK, such developments have followed on from the availability of regional climate models as delivered in UKCIP02 and recently the probabilistic projections released under UKCP09. One major area of concern is the future performance and adaptability of buildings which employ exclusively passive or low-energy cooling systems. One such method which can be employed in an integral or retrofit situation is direct or indirect evaporative cooling. The effectiveness of evaporative cooling is most strongly influenced by the wet-bulb depression of the ambient air, hence is generally regarded as most suited to hot, dry climates. However, this technology has been shown to be effective in the UK, primarily in mixed-mode buildings or as a retrofit to industrial/commercial applications. Climate projections for the UK generally indicate an increase in the summer wet-bulb depression, suggesting an enhanced potential for the application of evaporative cooling. The paper illustrates this potential by an analysis of the probabilistic scenarios released under UKCP09, together with a detailed building/plant simulation of case study building located in the South-East of England. The results indicate a high probability that evaporative cooling will still be a viable low-energy technique in the 2050s.

Boundaries and Bridges: the influence of James Cooksey Culwick on the development of the teaching and learning of music in nineteenth century Ireland

James Cooksey Culwick (1845-1907) was born in England. Trained as chorister and organist in Lichfield Cathedral, he moved to Ireland at twenty- one and remained until his death in 1907. Although his reputation as scholar, musician and teacher was acknowledged widely during his lifetime - he received an honorary doctorate from University of Dublin (1893) - little is known about the contribution he made to music education. This paper addresses this gap in the literature and argues that it was Culwick's singular achievement to pay attention to music pedagogy at secondary level, by recognizing that music could be seen as a serious career option for girls, and by providing resources for teachers which emphasised the development of an 'art-feeling' in pupils of all abilities. In addition, he considered Irish music as an art which had significance as music first, and Irish music second, and advocated a 'laudable tolerance' for opposing views on matters of cultural identity to Ireland at the end of the nineteenth century.

The performance of football club managers: skill or luck?

This paper evaluates the extent to which the performance of English Premier League football club managers can be attributed to skill or luck when measured separately from the characteristics of the team. We first use a specification that models managerial skill as a fixed effect and we examine the relationship between the number of points earned in league matches and the club’s wage bill, transfer spending, and the extent to which they were hit by absent players through injuries, suspensions or unavailability. We next implement a bootstrapping approach to generate a simulated distribution of average points that could have taken place after the impact of the manager has been removed. The findings suggest that there are a considerable number of highly skilled managers but also several who perform below expectations. The paper proceeds to illustrate how the approach adopted could be used to determine the optimal time for a club to part company with its manager. We are able to identify in advance several managers who the analysis suggests could have been fired earlier and others whose sackings were hard to justify based on their performances.

Comparing the thermal performance of horizontal slinky-loop and vertical slinky-loop heat exchangers

The heat pump market in the UK has grown rapidly over the last few years. Performance analyses of vertical ground-loop heat exchanger configurations have been widely carried out using both numerical modelling and experiments. However, research findings and design recommendations on horizontal slinky-loop and vertical slinky-loop heat exchangers are far fewer compared with those for vertical ground-loop heat exchanger configurations, especially where the long-term operation of the systems is concerned. The paper presents the results obtained from a numerical simulation for the horizontal slinky-loop and vertical slinky-loop heat exchangers of a ground-source heat pump system. A three-dimensional numerical heat transfer model was developed to study the thermal performance of various heat exchanger configurations. The influence of the loop pitch (loop spacing) and the depth of a vertical slinky-loop installation were investigated and the thermal performance and excavation work required for the horizontal and vertical slinky-loop heat exchangers were compared. The influence of the installation depth for vertical slinky-loop configurations was also investigated. The results of this study show that the influence of the installation depth of the vertical slinky-loop heat exchanger on the thermal performance of the system is small. The maximum difference in the thermal performance between the vertical and horizontal slinky-loop heat exchangers with the same loop diameter and loop pitch is less than 5%.

Simulation of thermal performance of horizontal slinky-loop heat exchangers for ground source heat pumps

This paper presents results obtained from a numerical simulation for the horizontal slinky-loop heat exchanger of a ground-source heat pump system. A three-dimensional numerical model was developed and the results of the thermal performance of various heat exchanger configurations are presented. The investigation was carried out on five types of loop pitch (loop spacing), three types of loop diameter, three values of soil thermal properties, and allowing continuous and intermittent operation. Comparison was made for the heat transfer rate, the amount of pipe material needed, as well as excavation work required for the horizontal slinky-loop heat exchanger. The results indicate that system parameters have a significant effect on the thermal performance of the system

Characterising the energy performance of centralised HVAC&R systems in the UK

Heating, ventilation, air conditioning and refrigeration (HVAC&R) systems account for more than 60% of the energy consumption of buildings in the UK. However, the effect of the variety of HVAC&R systems on building energy performance has not yet been taken into account within the existing building energy benchmarks. In addition, the existing building energy benchmarks are not able to assist decision-makers with HVAC&R system selection. This study attempts to overcome these two deficiencies through the performance characterisation of 36 HVAC&R systems based on the simultaneous dynamic simulation of a building and a variety of HVAC&R systems using TRNSYS software. To characterise the performance of HVAC&R systems, four criteria are considered; energy consumption, CO2 emissions, thermal comfort and indoor air quality. The results of the simulations show that, all the studied systems are able to provide an acceptable level of indoor air quality and thermal comfort. However, the energy consumption and amount of CO2 emissions vary. One of the significant outcomes of this study reveals that combined heating, cooling and power systems (CCHP) have the highest energy consumption with the lowest energy related CO2 emissions among the studied HVAC&R systems.

Differentiated effects of formal and informal institutional distance between countries 2 on the environmental performance of multinational enterprises

This research examines the influence of environmental institutional distance between home and host countries on the standardization of environmental performance among multinational enterprises using ordinary least-squares (OLS) regression techniques and a sample of 128 multinationals from high-polluting industries. The paper examines the environmental institutional distance of countries using the concepts of formal and informal institutional distances. The results show that whereas a high formal environmental distance between home and host countries leads multinational enterprises to achieve a different level of environmental performance according to each country's legal requirements, a high informal environmental distance encourages these firms to unify their environmental performance independently of the countries in which their units are based. The study also discusses the implications for academia, managers, and policy makers.

The M curve and the performance of Spanish international new ventures

In this paper we address three challenges. First, we discuss how international new ventures (INVs) are probably not explained by the Uppsala model as there is no time for learning about foreign markets in newly born and small firms. Only in the longer term can INVs develop experiential learning to overcome the liability of foreignness as they expand abroad. Second, we advance theoretically on previous research demonstrating that the multinationality−performance relationship of INVs follows a traditional S-shaped relationship, but they first experience a ‘born global illusion’ which leads to a non-traditional M curve. Third, using a panel data analysis for the period 1994–2008 we find empirically that Spanish INVs follow an inverted U curve in the very short term, where no learning takes place, but that experience gained over time yields an M-curve relationship once learning takes place.

The challenge of validation: assessing the performance of a test of productive vocabulary

This paper assesses the performance of a vocabulary test designed to measure second language productive vocabulary knowledge.The test, Lex30, uses a word association task to elicit vocabulary, and uses word frequency data to measure the vocabulary produced. Here we report firstly on the reliability of the test as measured by a test-retest study, a parallel test forms experiment and an internal consistency measure. We then investigate the construct validity of the test by looking at changes in test performance over time, analyses of correlations with scores on similar tests, and comparison of spoken and written test performance. Last, we examine the theoretical bases of the two main test components: eliciting vocabulary and measuring vocabulary. Interpretations of our findings are discussed in the context of test validation research literature. We conclude that the findings reported here present a robust argument for the validity of the test as a research tool, and encourage further investigation of its validity in an instructional context

An insight into the public acceptance of nutrigenomic-based personalised nutrition.

It is predicted that non-communicable diseases will account for over 73 % of global mortality in 2020. Given that the majority of these deaths occur in developed countries such as the UK, and that up to 80 % of chronic disease could be prevented through improvements in diet and lifestyle, it is imperative that dietary guidelines and disease prevention strategies are reviewed in order to improve their efficacy. Since the completion of the human genome project our understanding of complex interactions between environmental factors such as diet and genes has progressed considerably, as has the potential to individualise diets using dietary, phenotypic and genotypic data. Thus, there is an ambition for dietary interventions to move away from population-based guidance towards 'personalised nutrition'. The present paper reviews current evidence for the public acceptance of genetic testing and personalised nutrition in disease prevention. Health and clear consumer benefits have been identified as key motivators in the uptake of genetic testing, with individuals reporting personal experience of disease, such as those with specific symptoms, being more willing to undergo genetic testing for the purpose of personalised nutrition. This greater perceived susceptibility to disease may also improve motivation to change behaviour which is a key barrier in the success of any nutrition intervention. Several consumer concerns have been identified in the literature which should be addressed before the introduction of a nutrigenomic-based personalised nutrition service. Future research should focus on the efficacy and implementation of nutrigenomic-based personalised nutrition.

Impact of I/Q imbalance on the performance of two-way CSI-assisted AF relaying

In this paper, we investigate half-duplex two-way dual-hop channel state information (CSI)-assisted amplify-and-forward (AF) relaying in the presence of in-phase and quadrature-phase (I/Q) imbalance. A compensation approach for the I/Q imbalance is proposed, which employs the received signals together with their conjugations to detect the desired signal. We also derive the average symbol error probability of the considered half-duplex two-way dual-hop CSI-assisted AF relaying networks with and without compensation for I/Q imbalance in Rayleigh fading channels. Numerical results are provided and show that the proposed compensation method mitigates the impact of I/Q imbalance to a certain extent.

On the performance of the tick test

In financial research, the sign of a trade (or identity of trade aggressor) is not always available in the transaction dataset and it can be estimated using a simple set of rules called the tick test. In this paper we investigate the accuracy of the tick test from an analytical perspective by providing a closed formula for the performance of the prediction algorithm. By analyzing the derived equation, we provide formal arguments for the use of the tick test by proving that it is bounded to perform better than chance (50/50) and that the set of rules from the tick test provides an unbiased estimator of the trade signs. On the empirical side of the research, we compare the values from the analytical formula against the empirical performance of the tick test for fifteen heavily traded stocks in the Brazilian equity market. The results show that the formula is quite realistic in assessing the accuracy of the prediction algorithm in a real data situation.

Effects of temporal resolution of input precipitation on the performance of hydrological forecasting

Flood prediction systems rely on good quality precipitation input data and forecasts to drive hydrological models. Most precipitation data comes from daily stations with a good spatial coverage. However, some flood events occur on sub-daily time scales and flood prediction systems could benefit from using models calibrated on the same time scale. This study compares precipitation data aggregated from hourly stations (HP) and data disaggregated from daily stations (DP) with 6-hourly forecasts from ECMWF over the time period 1 October 2006–31 December 2009. The HP and DP data sets were then used to calibrate two hydrological models, LISFLOOD-RR and HBV, and the latter was used in a flood case study. The HP scored better than the DP when evaluated against the forecast for lead times up to 4 days. However, this was not translated in the same way to the hydrological modelling, where the models gave similar scores for simulated runoff with the two datasets. The flood forecasting study showed that both datasets gave similar hit rates whereas the HP data set gave much smaller false alarm rates (FAR). This indicates that using sub-daily precipitation in the calibration and initiation of hydrological models can improve flood forecasting.