Assessment of CFD models for shock boundary-layer interaction

A workshop on the computational fluid dynamics (CFD) prediction of shock boundary-layer interactions (SBLIs) was held at the 48th AIAA Aerospace Sciences Meeting. As part of the workshop numerous CFD analysts submitted solutions to four experimentally measured SBLIs. This paper describes the assessment of the CFD predictions. The assessment includes an uncertainty analysis of the experimental data, the definition of an error metric and the application of that metric to the CFD solutions. The CFD solutions provided very similar levels of error and in general it was difficult to discern clear trends in the data. For the Reynolds Averaged Navier-Stokes methods the choice of turbulence model appeared to be the largest factor in solution accuracy. Large-eddy simulation methods produced error levels similar to RANS methods but provided superior predictions of normal stresses.

Chitosan from Squilla

Squilla (Oratosquilla nepa) is abundant along the west coast of India, inhabiting burrows in sand and mud. The species is little used as it possesses little meat. There is great similarity between chemical composition of Squilla and prawn waste, and it is suggested that Squilla could therefore be used for making chitosan, a potential industrial chemical with various uses. Preparation of chitosan, and the general nature of the prepared product, is described.

Frictional flow of damp granular material in a conical centrifuge

An analysis is given of velocity and pressure-dependent sliding flow of a thin layer of damp granular material in a spinning cone. Integral momentum equations for steady state, axisymmetric flow are derived using a boundary layer approximation. These reduce to two coupled first-order differential equations for the radial and circumferential sliding velocities. The influence of viscosity and friction coefficients and inlet boundary conditions is explored by presentation of a range of numerical results. In the absence of any interfacial shear traction the flow would, with increasing radial and circumferential slip, follow a trajectory from inlet according to conservation of angular momentum and kinetic energy. Increasing viscosity or friction reduces circumferential slip and, in general, increases the residence time of a particle in the cone. The residence time is practically insensitive to the inlet velocity. However, if the cone angle is very close to the friction angle then the residence time is extremely sensitive to the relative magnitude of these angles. © 2011 Authors.

Aerodynamic effects in ink-jet printing on a moving web

The airflow between the fast-moving substrate and stationary print heads in a web print press may cause print quality issues in high-speed, roll-to-roll printing applications. We have studied the interactions between ink drops and the airflow in the gap between the printhead and substrate, by using an experimental flow channel and high-speed imaging. The results show: 1) the gap airflow is well approximated by a standard Couette flow profile; 2) the effect of gap airflow on the flight paths of main drops and satellites is negligible; and 3) the interaction between the gap airflow and the wakes from the printed ink drops should be investigated as the primary source of aerodynamically- related print quality issues. ©2012 Society for Imaging Science and Technology.

Bayesian Structured Prediction Using Gaussian Processes

We introduce a conceptually novel structured prediction model, GPstruct, which is kernelized, non-parametric and Bayesian, by design. We motivate the model with respect to existing approaches, among others, conditional random fields (CRFs), maximum margin Markov networks (M3N), and structured support vector machines (SVMstruct), which embody only a subset of its properties. We present an inference procedure based on Markov Chain Monte Carlo. The framework can be instantiated for a wide range of structured objects such as linear chains, trees, grids, and other general graphs. As a proof of concept, the model is benchmarked on several natural language processing tasks and a video gesture segmentation task involving a linear chain structure. We show prediction accuracies for GPstruct which are comparable to or exceeding those of CRFs and SVMstruct.

A Critical Review of the Criticisms of System Dynamics

This paper presents a review of the criticisms of system dynamics and assesses the validity of these against recent findings in the field. The authors survey the literature critical of system dynamics and review their criticisms using the current understandings in the system dynamics field. This work suggests that there are some pertinent criticisms that have been aimed at system dynamics. These include the apparent disagreements regarding the role of historical data in model confidence building, system dynamics' reductionist perspective and how system dynamics addresses plurality and hierarchy. Overcoming these criticisms require the ever present need for education, communication and theoretical work. It is hoped this paper will strengthen the mandate of system dynamics in the eyes of its critics, assist and improve the field and its general acceptance as a tool of analysis.

Choice of calibration equations in calibrating microwave test fixtures

The error theory of linear equation system has been applied to the calibration procedure of microwave network analyser in this article. A new explanation for the choice of the linear calibration equations is proposed and a general principle for choosing calibration equations is presented. The method can also be used to predict the occurrence of the problem of frequency limitation at some periodic frequencies. This principle is employed to the thru-short-delay (TSD) method and the solution using the chosen equations gives the most accurate results. A good agreement between the theory and the experiment has been obtained.

Experimental Investigation into the Production Behavior of Methane Hydrate in Porous Sediment with Hot Brine Stimulation

The gas production behavior from methane hydrate in porous sediment by injecting the brine with the salinity of 0−24 wt % and the temperature of −1 to 130 °C was investigated in a one-dimensional experimental apparatus. The results show that the gas production process consists of three periods: the free gas production, the hydrate dissociation, and the general gas reservoir production. The hydrate dissociation accompanies the temperature decrease with the injection of the brine (NaCl solution), and the dissociation duration is shortened with the increase of the salinity. With the injection of hot brine, instantaneous hydrate dissociation rate also increases with the increase of the salinity. However, while the NaCl concentration is beyond a certain value, the rate has no longer continued increasing. Thermal efficiency and energy ratio for the hydrate production can be enhanced by injecting hot brine, and the enhanced effectiveness is quite good with the injection of high salinity at lower temperature.

Numerical investigation of particle velocity distributions in aeolian sand transport

Particle velocity distribution in a blowing sand cloud is a reflection of saltation movement of many particles. Numerical analysis is performed for particle velocity distribution with a discrete particle model. The probability distributions of resultant particle velocity in the impact-entrainment process, particle horizontal and vertical velocities at different heights and the vertical velocity of ascending particles are analyzed. The probability distributions of resultant impact and lift-off velocities of saltating particles can be expressed by a log-normal function, and that of impact angle comply with an exponential function. The probability distribution of particle horizontal and vertical velocities at different heights shows a typical single-peak pattern. In the lower part of saltation layer, the particle horizontal velocity distribution is positively skewed. Further analysis shows that the probability density function of the vertical velocity of ascending particles is similar to the right-hand part of a normal distribution function, and a general equation is acquired for the probability density function of non-dimensional vertical velocity of ascending particles which is independent of diameter of saltating particles, wind strength and height. These distributions in the present numerical analysis are consistent with reported experimental results. The present investigation is important for understanding the saltation state in wind-blown sand movement. (C) 2009 Elsevier B.V. All rights reserved.

Statistical distribution of nonlinear random wave height

A statistical model of random wave is developed using Stokes wave theory of water wave dynamics. A new nonlinear probability distribution function of wave height is presented. The results indicate that wave steepness not only could be a parameter of the distribution function of wave height but also could reflect the degree of wave height distribution deviation from the Rayleigh distribution. The new wave height distribution overcomes the problem of Rayleigh distribution that the prediction of big wave is overestimated and the general wave is underestimated. The prediction of small probability wave height value of new distribution is also smaller than that of Rayleigh distribution. Wave height data taken from East China Normal University are used to verify the new distribution. The results indicate that the new distribution fits the measurements much better than the Rayleigh distribution.

CIM与工业自动化总体技术——它的目标、方法和实践

本文概述了近年国际上兴起的CIM与国内的工业自动化总体技术,阐明了其出现背景,以及它的目标、方法、参考模型和有关实践情况,在CIM参考模型和体系结构中,叙述了西欧ESPRIT的CIM/OSA模型、美国普渡大学的企业参考体系结构与CIM模型,并简述了它们在建立综合自动化系统中的主要思路。

成年女儿照料老年父母的心理体验及关系质量作用的研究

Previous researches about family caregiving revealed that caregiving has both negative and positive effects on caregivers’ well-being. Based on Lawton’s two-factor model, this study aims at examining how caring for old parents would affect adult daughters’ psychological well-being. According to Lawton, objective stressors as caregiving would arouse two different kinds of caregivers’ subjective appraisal, i.e., negative appraisal and positive appraisal, which in turn correlate with the negative and positive dimensions of caregivers’ psychological well-being, respectively. There were two main purposes of this study: a) to verify both the negative and positive paths in the two-factor model and their relatively independence; and b) to examine the effects of relationship quality between caregiver and care-recipient on those paths. The results are as follows: 1) Caregiving stressors have significant positive predictive effect on caregivers’ negative appraisal, but have no direct effect on caregivers’ positive appraisal. 2) Caregivers’ negative appraisal has significant positive predictive effect on their negative emotional experience, while caregivers’ positive appraisal has significant positive predictive effect on their positive emotional experience. 3) Certain dimensions of relationship quality, including the Appreciation and General Appraisal, have significant negative predictive effect on caregivers’ negative appraisal, and have significant positive predictive effect on caregivers’ positive appraisal. 4) The Appreciation dimension of relationship quality moderates the path from caregiving demands to caregivers’ burden; and the General Appraisal of relationship quality moderates the path from caregivers’ positive appraisal to life satisfaction. Based on the above results, the researcher concluded that a) both the negative path and positive path exist in caregiving process, and they are relatively independent from each other; and b) relationship quality does moderate certain paths in the model. Meanwhile, the main effect of relationship quality on caregivers’ experience is also significant and more remarkable. This study attempts to explain these results in terms of coping resources. Both relationship quality and many other factors might be explained as resources that caregivers utilize to cope with stress of caregiving. With more resources, caregivers tend to appraise more positively, and less negatively, and vice versa. However, the resources which might affect caregivers’ positive appraisal, as well as the ways they work, may be different from that affect caregivers’ negative appraisal.

中学生强迫症状及其心理、环境危险因素和整合模型研究

Obsessive-Compulsive Symptoms, which are one of common factors effected on mental health of secondary school students, have been rarely studied at home and abroad. In accordance with the problems existed in these literature up till now, the thesis had mainly studied the measured tool, contents and structure, developmental features, psychosocial risk factors and integrated model of obsessive-compulsive symptoms from them by means of investigation with quetionnaires. The entire research was divided into three phases. 3185 students(age 14.68±1.75 years) were firstly measured with the 20-item Leyton Obsessional Inventory-Child Version(LOI-CV) at four secondary schools including six grades in Beijing city, which was applied to revise LOI-CV, and to study the structure and contents, developmental features and screen of obsessive-compulsive symptoms. Then, 216 subjects with obsessive-compulsive symptoms, paired with controls in the light of school, grade and gender, were investigated with 10 self-rating scales on obsessive-compulsive symptoms, anxiety, depression, personality, coping and attributional style, negative life events, parent's rearing style, family environment and life adaptation in school, and with an inventory on social demography. The results were used to explore psychosocial risk factors and integrated model of obsessive-compulsive symptoms. The third survey was only carried out, about two months after the second, among 264 subjects with obsessive-compulsive symptoms through MMOCI and Negative Life Event Scale for Adolescents, in order to probe into the integrated model. The research had mainly found: (1) LOI-CV can be used as a screen tool for obsessive-compulsive symptoms in urban adolescents in China; (2) Total screening-out ratio of obsessive-compulsive symptoms was 13.6% (male:15.0%, female:12.2%). The most common manifestations of obsessive-compulsive symptoms were hating dirt and contamination, doing things in exact manner, angry if someone messes desk, bad conscience but no one else, worry about cleanliness, repeated thoughts or words; the least were favorite or special number, spending extra time on homework, special number or words to avoid, talking or moving to avoid bad luck, fussy about hands. The checking and repetition, cleanliness and tidiness, general obsessions were more common forms than numbers-luck; (3) No differences were existed in serious degree of obsessive-compulsive symptoms, but the screening-out ratio in male was higher than it in female; (4) No differences were detected in the serious degree of obsessive-compulsive symptoms except the scores of cleanliness and tidiness among grades, but the screening-out ratio of the grades justly entering secondary school or going to graduate were higher than other ones; (5) The main psychosocial risk factors for obsessive-compulsive symptoms included anxiety, mother's over-protecting and over-interfering, fantasy, flexibility, self-actualization, peers relationship, sense of responsibility, negative life events, mother's occupation, help-seeking, and (6) The integrated model on psychosocial risk factors suggested that the possible developed and sustained mechanism of obsessive-compulsive symptoms was that personality, coping and attributional styles constructed the developmental diathesis foundation of obsessive-compulsive symptoms; negative life events were promoting factors of them. There was a dynamic interaction between personality and environmental factors. Negative emotion played a core role in the developmental process of them. The continued existence of obsessive-compulsive symptoms was related to pre-existed obsessive-compulsive symptoms and negative life events experienced by an individual. Therefore, this research not only let us get a deeper understanding of obsessive-compulsive symptoms and more entirely find out psychosocial risk factors, firstly applied diathesis-stress theory to comprehend the psychological mechanism of obsessive-compulsive symptoms and, moreover, elaborate and expand it, but also has more important practice significance of treatment, prevent and education for obsessive-compulsive symptoms in secondary school students.

Leaving Planet Earth (Follow-on Voucher Project).

SFC FOLLOW-ON VOUCHER The project was undertaken as a SFC Follow-on Voucher (£40K) alongside a student project with BDes (Hons) Design & Digital Arts (D&DA).James Blake (Centre for Media & Culture) brought together students and staff to develop digital content, including films, for a transmedia project and the induction video on the coaches to Ratho. Malcolm Innes, Ian Lambert, Andrew O’Dowd, and Euan Winton (Centre for Design Practice & Research) developed the Old Earth Museum (both physical and virtual), and transmedia designer and research student Beata Zemanek oversaw the transmedia strategy and making of the Gatekeeper film, supported by D&DA students and graduates.

Evaluating SWICE-R (South West Information for Clinical Effectiveness - Rural). Final report for South West Workforce Development Confederations (Knowledge Resources Development Unit)

Yeoman, A., Durbin, J. & Urquhart, C. (2004). Evaluating SWICE-R (South West Information for Clinical Effectiveness - Rural). Final report for South West Workforce Development Confederations, (Knowledge Resources Development Unit). Aberystwyth: Department of Information Studies, University of Wales Aberystwyth. Sponsorship: South West WDCs (NHS)