Performance and emissions testing of a small two stroke engine using mid-level ethanol blends

With the introduction of the mid-level ethanol blend gasoline fuel for commercial sale, the compatibility of different off-road engines is needed. This report details the test study of using one mid-level ethanol fuel in a two stroke hand held gasoline engine used to power line trimmers. The study sponsored by E3 is to test the effectiveness of an aftermarket spark plug from E3 Spark Plug when using a mid-level ethanol blend gasoline. A 15% ethanol by volume (E15) is the test mid-level ethanol used and the 10% ethanol by volume (E10) was used as the baseline fuel. The testing comprises running the engine at different load points and throttle positions to evaluate the cylinder head temperature, exhaust temperature and engine speed. Raw gas emissions were also measured to determine the impact of the performance spark plug. The low calorific value of the E15 fuel decreased the speed of the engine along with reduction in the fuel consumption and exhaust gas temperature. The HC emissions for E15 fuel and E3 spark plug increased when compared to the base line in most of the cases and NO formation was dependent on the cylinder head temperature. The E3 spark plug had a tendency to increase the temperature of the cylinder head irrespective of fuel type while reducing engine speed.

Effect of segmented anodes on the performance and plume of a hall thruster

Development of alternative propellants for Hall thruster operation is an active area of research. Xenon is the current propellant of choice for Hall thrusters, but can be costly in large thrusters and for extended test periods. Condensible propellants may offer an alternative to xenon, as they will not require costly active pumping to remove from a test facility, and may be less expensive to purchase. A method has been developed which uses segmented electrodes in the discharge channel of a Hall thruster to divert discharge current to and from the main anode and thus control the anode temperature. By placing a propellant reservoir in the anode, the evaporation rate, and hence, mass flow of propellant can be controlled. Segmented electrodes for thermal control of a Hall thruster represent a unique strategy of thruster design, and thus the performance of the thruster must be measured to determine the effect the electrodes have on the thruster. Furthermore, the source of any changes in thruster performance due to the adjustment of discharge current between the shims and the main anode must be characterized. A Hall thruster was designed and constructed with segmented electrodes. It was then tested at anode voltages between 300 and 400 V and mass flows between 4 and 6 mg/s, as well as 100%, 75%, 50%, 25%, and <5% of the discharge current on the shim electrodes. The level of current on the shims was adjusted by changing the shim voltage. At each operating point, the thruster performance, plume divergence, ion energy, and multiply charged ion fraction were measured performance exhibited a small change with the level of discharge current on the shim electrodes. Thrust and specific impulse increased by as much as 6% and 7.7%, respectively, as discharge current was shifted from the main anode to the shims at constant anode voltage. Thruster efficiency did not change. Plume divergence was reduced by approximately 4 degrees of half-angle at high levels of current on the shims and at all combinations of mass flow and anode voltage. The fraction of singly charged xenon in the thruster plume varied between approximately 80% and 95% as the anode voltage and mass flow were changed, but did not show a significant change with shim current. Doubly and triply charged xenon made up the remainder of the ions detected. Ion energy exhibited a mixed behavior. The highest voltage present in the thruster largely dictated the most probable energy; either shim or anode voltage, depending on which was higher. The overall change in most probable ion energy was 20-30 eV, the majority of which took place while the shim voltage was higher than the anode voltage. The thrust, specific impulse, plume divergence, and ion energy all indicate that the thruster is capable of a higher performance output at high levels of discharge current on the shims. The lack of a change in efficiency and fraction of multiply charged ions indicate that the thruster can be operated at any level of current on the shims without detrimental effect, and thus a condensible propellant thruster can control the anode temperature without a decrease in efficiency or a change in the multiply charged ion fraction.

Evaluation of the performance and cost-effectiveness of pavement sections containing open-graded base courses

Moisture induced distresses have been the prevalent distress type affecting the deterioration of both asphalt and concrete pavement sections. While various surface techniques have been employed over the years to minimize the ingress of moisture into the pavement structural sections, subsurface drainage components like open-graded base courses remain the best alternative in minimizing the time the pavement structural sections are exposed to saturated conditions. This research therefore focuses on assessing the performance and cost-effectiveness of pavement sections containing both treated and untreated open-graded aggregate base materials. Three common roadway aggregates comprising of two virgin aggregates and one recycled aggregate were investigated using four open-ended gradations and two binder types. Laboratory tests were conducted to determine the hydraulic, mechanical and durability characteristics of treated and untreated open-graded mixes made from these three aggregate types. Results of the experimental program show that for the same gradation and mix design types, limestone samples have the greatest drainage capacity, stability to traffic loads and resistance to degradation from environmental conditions like freeze-thaw. However, depending on the gradation and mix design used, all three aggregate types namely limestone, natural gravel and recycled concrete can meet the minimum coefficient of hydraulic conductivity required for good drainage in most pavements. Tests results for both asphalt and cement treated open-graded samples indicate that a percent air void content within the range of 15-25 will produce a treated open-graded base course with sufficient drainage capacity and also long term stability under both traffic and environmental loads. Using the new Mechanistic and Empirical Design Guide software, computer simulations of pavement performance were conducted on pavement sections containing these open-graded base aggregate base materials to determine how the MEPDG predicted pavement performance is sensitive to drainage. Using three truck traffic levels and four climatic regions, results of the computer simulations indicate that the predicted performance was not sensitive to the drainage characteristics of the open-graded base course. Based on the result of the MEPDG predicted pavement performance, the cost-effectiveness of the pavement sections with open-graded base was computed on the assumption that the increase service life experienced by these sections was attributed to the positive effects of subsurface drainage. The two cost analyses used gave two contrasting results with the one indicating that the inclusion of open-graded base courses can lead to substantial savings.

How the Entrepreneurial Top Management Team Setup Influences Firm Performance and the Ability to Raise Capital: A Literature Review

This paper reviews research findings on entrepreneurial top management teams within the last 20 years. It concentrates on team-based management factors and their influence on a new venture’s growth and ability to raise capital. This paper integrates recent findings and provides an overview of the current state of research. Moreover, it contributes to the overall topic by proposing five clusters of major team-specific influences, derives determinants of success and failure, and reveals recommendations for further research.

Chromium supplementation and substitution of barley grain with corn: Effects on performance and lactation in periparturient dairy cows

Thirty-two multiparous Holstein cows were used to investigate the effects of chromium-l-methionine (Cr-Met) supplementation and dietary grain source on performance and lactation during the periparturient period. Cows were fed a total mixed ration consisting of either a barley-based diet (BBD) or a corn-based diet (CBD) from 21 d before anticipated calving through 28 d after calving. The Cr-Met was supplemented at dosages of 0 or 0.08 mg of Cr/kg of metabolic body weight. The study was designed as a randomized complete block design with 2 (Cr-Met levels) x 2 (grain sources) factorial arrangement. There was no Cr effect on prepartum dry matter intake (DMI) or postpartum DMI, body weight (BW), net energy balance, and whole tract apparent digestibility of nutrients. Prepartum DMI as a percentage of BW tended to increase with Cr-Met. Supplemental Cr-Met tended to increase milk yield whereas milk protein percentage decreased. Pre- and postpartum DMI, BW, net energy balance, milk yield, and milk composition were not affected by substituting ground barley with ground corn. The addition of Cr-Met increased prepartum DMI and tended to increase postpartum DMI of the BBD but not the CBD. The change in prepartum DMI was smaller when the BBD was supplemented with Cr-Met but remained unchanged when the CBD was supplemented with Cr-Met. Yields of crude protein and total solids in milk and prepartum digestibility of DM and organic matter tended to increase when Cr-Met was added to the BBD but remained unchanged when added to the CBD. Periparturient cows failed to respond to the grain source of the diet, whereas they showed greater response in milk yield to diets supplemented with Cr-Met. In conclusion, the present results demonstrate that the beneficial effect of Cr-Met supplementation during the periparturient period to improve feed intake may depend on the grain source of the diet.

Effect of Optimum® High Oil Corn on Performance and Carcass Characteristics of Finishing Yearling Steers

Steers fed Optimum® high oil corn had statistically similar live performance as steers fed isogenetic control corn or the control corn + fat. Numerically steers fed high oil corn gained 3% faster during the 107-day study with similar feed conversion. During the first half of the experiment, steers fed high oil corn did not perform as well as those fed control corn. During the second half of the experiment, steers fed high oil corn gained 21% faster and were 17% more efficient. There were no effects of feeding high oil corn on carcass characteristics, except there were more Choice carcasses from the steers fed high oil corn as compared with control corn (57% vs. 43% Choice).

Effect of Feeding Procedure and Intake Level on Steer Feedlot Performance and Carcass Composition: A Progress Report

Two feedlot trials were conducted to evaluate the effects of feeding frequency (once daily in the morning, once daily in the afternoon or twice daily) and feeding level (ad libitum, 95% of ad libitum, or 90% of ad libitum) on the feedlot performance and carcass composition of beef steers. Data were collected using 196 yearling beef steers. In both trials cattle fed once daily in the morning tended to have higher gains and better feed efficiencies than cattle fed once daily in the afternoon or cattle fed twice daily. Overall, cattle restricted to 95% and 90% of ad libitum intake levels had better feed efficiencies than cattle with ad libitum access to feed. Cattle fed once daily in the morning tended to have less backfat than cattle fed once daily in the afternoon or cattle fed twice daily.

Effects of Sorting Steer Calves on Feedlot Performance and Carcass Value

Three groups of steer calves totaling 480 head were sorted into smaller and larger frame sizes, and those groups were sorted into groups with more and less backfat. There was no difference in age among the four sorted groups. The larger steers and steers with less fat had faster rates of gain and tended to have superior feed efficiencies. Steers with more initial fat were fed fewer days. The larger framed steers and steers with less fat had heavier carcasses, less carcass backfat, more yield grade 1 carcasses and a lower percentage of Choice carcasses, but they also had greater value per carcass when evaluated using a grid paying premiums for quality and yield grades. The greatest profit to the feedyard was realized from the smaller framed steers and those with less initial backfat. For similar profit it was calculated that the larger steers should have been discounted as feeders $3.50 per hundred compared with the smaller steers and the steers with more fat discounted $5.00 per hundred compared with those having less initial fat. The results of this study suggest that sorting based on initial fat thickness may have more potential for enhancing the value of finished cattle than sorting based on frame score.

Effects of Feeding Cobalt Dextro Lac (CDL) on Feedlot Performance and Carcass Value of Finishing Steers Fed Wet Corn Gluten Feed

A 192-day experiment involving 144 young Angus steers fed growing and finishing diets containing 20% corn gluten feed was conducted to evaluate feeding a soluble source of readily available cobalt. No benefits were observed in rate of gain, feed intake or carcass value by feeding the available source of cobalt.

The Effects of Feeding a Live Microbial Product on Feedlot Performance and Carcass Value of Finishing Steers Fed Wet Corn Gluten Feed

This experiment was conducted to evaluate the efficacy of daily feeding a live microbial preparation containing two live organisms to finishing cattle. One organism was a lactobacillus, and the other was a propionibacterium, thought to work in concert to improve fermentation in the rumen and overall digestion. The study was conducted with Angus steers with an average initial weight of 550 lbs that were fed a finishing ration containing 50% wet corn gluten feed on a dry basis for 184 days. Feeding the microbial product improved daily gain and feed efficiency 1.7% and 2.4%, respectively, but the differences were not statistically significant. The microbial preparation increased carcass weights 1% but had no effects on quality or yield grades. It is concluded that potential benefits of this product are more likely to be greater when cattle are fed high grain rations rather than diets containing high concentrations of corn gluten feed.

Effect of Supplemental Vitamin E and A on Reproductive Performance and Serological Profiles of Ewes Managed in Drylot

Forty Hampshire and 40 Suffolk ewes were allotted to one of four groups (VitA, VitE, VitA&E, Control) in a 2 x 2 factorial treatment arrangement to evaluate the effect of supplemental vitamin E (0 or 300 IU) and vitamin A (0 or 250,000 IU) on reproductive performance. Laparoscopy and ultrasonography were used to measure ovulation rate, embryonic loss, and fetal loss. Serum profiles of a-tocopherol (vitamin E) and retinol (vitamin A) also were monitored. There were no differences (P>.05) among treatment groups in any reproductive trait. Suffolk ewes exhibited a higher (P<.02) ovulation rate than Hampshire ewes, and yearling ewes incurred higher (P<.001) embryonic loss than other age groups, resulting in a lower (P<.001) litter size. Serum levels of a-tocopherol were higher (P<.05) for Hampshire than for Suffolk ewes and were lower (P<.001) in yearling ewes versus ewes two years of age and older. Serum levels of a-tocopherol declined (P<.01) throughout the study in VitA and Control ewes but remained unchanged in VitE and VitA&E ewes. Serum level of retinol remained unchanged in VitA ewes, whereas the level increased (P<.01) initially in VitE, VitA&E, and Control ewes before declining toward initial levels. Correlations were detected between ovulation rate and the change of pre-mating a-tocopherol serum level (r=-.29; P<.02), the change in pre-mating retinol serum level (r=-.50; P<.02) and the interval from vitamin A injection (r=-.60; P<.05). These data indicate significant influences of breed, age, and treatment on a-tocopherol and retinol serum levels in ewes and suggest that the timing of vitamin A administration may influence ovulation rate; however, vitamin supplementation, administered at random stages of the estrous cycle, was unable to alter flock reproductive performance.