Synthetic peptides interacting with the 67-kd laminin receptor can reduce retinal ischemia and inhibit hypoxia-induced retinal neovascularization.

The high-affinity 67-kd laminin receptor (67LR) is expressed by proliferating endothelial cells during retinal neovascularization. The role of 67LR has been further examined experimentally by administration of selective 67LR agonists and antagonists in a murine model of proliferative retinopathy. These synthetic 67LR ligands have been previously shown to stimulate or inhibit endothelial cell motility in vitro without any direct effect on proliferation. In the present study, a fluorescently labeled 67LR antagonist (EGF33–42) was injected intraperitoneally into mice and its distribution in the retina was assessed by confocal scanning laser microscopy. Within 2 hours this peptide was localized to the retinal vasculature, including preretinal neovascular complexes, and a significant amount had crossed the blood retinal barrier. For up to 24 hours postinjection, the peptide was still present in the retinal vascular walls and, to a lesser extent, in the neural retina. Non-labeled EGF33–42 significantly inhibited pre-retinal neovascularization in comparison to controls treated with phosphate-buffered saline or scrambled peptide (P <0.0001). The agonist peptide (Lamß1925–933) also significantly inhibited proliferative retinopathy; however, it caused a concomitant reduction in retinal ischemia in this model by promoting significant revascularization of the central retina (P <0.001). Thus, 67LR appears to be an important target receptor for the modulation of retinal neovascularization. Agonism of this receptor may be valuable in reducing the hypoxia-stimulated release of angiogenic growth factors which drives retinal angiogenesis.

Scaling of domain periodicity with thickness measured in BaTiO3 single crystal lamellae and comparison with other ferroics

The focused ion beam microscope has been used to cut parallel-sided {100}-oriented thin lamellae of single crystal barium titanate with controlled thicknesses, ranging from 530 nm to 70 nm. Scanning transmission electron microscopy has been used to examine domain configurations. In all cases, stripe domains were observed with {011}-type domain walls in perovskite unit-cell axes, suggesting 90 degrees domains with polarization in the plane of the lamellae. The domain widths were found to vary as the square root of the lamellar thickness, consistent with Kittel's law, and its later development by Mitsui and Furuichi and by Roytburd. An investigation into the manner in which domain period adapts to thickness gradient was undertaken on both wedge-shaped lamellae and lamellae with discrete terraces. It was found that when the thickness gradient was perpendicular to the domain walls, a continuous change in domain periodicity occurred, but if the thickness gradient was parallel to the domain walls, periodicity changes were accommodated through discrete domain bifurcation. Data were then compared with other work in literature, on both ferroelectric and ferromagnetic systems, from which conclusions on the widespread applicability of Kittel's law in ferroics were made.

Polymer nanotubes by wetting of ordered porous templates

We have developed a simple technique for the fabrication of polymer nanotubes with a monodisperse size distribution and uniform orientation. When either a polymer melt or solution is placed on a substrate with high surface energy, it will spread to form a thin film, known as a precursor film, similar to the behavior of low molar mass liquids. Similar wetting phenomena occur if porous templates are brought into contact with polymer solutions or melts: A thin surface film will cover the pore walls in the initial stages of wetting. This is because the cohesive driving forces for complete filling are much weaker than the adhesive forces. Wall wetting and complete filling of the pores thus take place on different time scales. The latter is prevented by thermal quenching in the case of melts or by solvent evaporation in the case of solutions, thus preserving a nanotube structure. If the template is of monodisperse size distribution, aligned or ordered, so are the nanotubes, and ordered polymer nanotube arrays can be obtained if the template is removed. Any melt-processible polymer, such as polytetrafluoroethylene (PTFE), blends, or multicomponent solutions can be formed into nanotubes with a wall thickness of a few tens of nanometers. Owing to its versatility, this approach should be a promising route toward functionalized polymer nanotubes.

Quantum conductance of multiwall carbon nanotubes

An analysis on the conductance of multiwall carbon nanotubes (MWNT's) is presented. Recent experiment indicated that MWNT's are good quantum conductors. Our theory shows that tunneling current between states on different walls of a defect-free, infinitely long MWNT is vanishingly small in general, which leads to the quantization of the conductance of the MWNT's. With a reasonable simple model, we explicitly show that the conductance of a capped MWNT can be determined by the outermost wall for an infinitely long nanotube. We apply the theory to finite MWNT's and estimate the generic interwall conductance to be negligible compared to the intrawall ballistic conductance.

Ultrafast laser-driven microlens to focus and energy-select mega-electron volt protons

We present a technique for simultaneous focusing and energy selection of high-current, mega-electron volt proton beams With the use of radial, transient electric fields (107 to 1010 volts per meter) triggered on the inner walls of a hollow microcylinder by an intense subpicosecond laser pulse. Because of the transient nature of the focusing fields, the proposed method allows selection of a desired range out of the spectrum of the polyenergetic proton beam. This technique addresses current drawbacks of laser-accelerated proton beams, such as their broad spectrum and divergence at the source.

Current-driven magnetic rearrangements in spin-polarized point contacts

A method for investigating the dynamics of atomic magnetic moments in current-carrying magnetic point contacts under bias is presented. This combines the nonequilibrium Green's function (NEGF) method for evaluating the current and the charge density with a description of the dynamics of the magnetization in terms of quasistatic thermally activated transitions between stationary configurations. This method is then implemented in a tight-binding (TB) model with parameters chosen to simulate the main features of the electronic structures of magnetic transition metals. We investigate the domain wall (DW) migration in magnetic monoatomic chains sandwiched between magnetic leads, and for realistic parameters find that collinear arrangement of the magnetic moments of the chain is always favorable. Several stationary magnetic configurations are identified, corresponding to a different number of Bloch walls in the chain and to a different current. The relative stability of these configurations depends on the geometrical details of the junction and on the bias; however, we predict transitions between different configurations with activation barriers of the order of a few tens of meV. Since different magnetic configurations are associated with different resistances, this suggests an intrinsic random telegraph noise at microwave frequencies in the I-V curves of magnetic atomic point contacts at room temperature. Finally, we investigate whether or not current-induced torques are conservative.

Effects of vasectomy on spermatogenesis and fertility outcomes after assisted conception

Abstract BACKGROUND: Each year 40,000 men have a vasectomy in the UK whilst another 2400 request a reversal to begin a second family. Sperm can now be obtained by testicular biopsy and subsequently used in assisted conception with intracytoplasmic sperm injection (ICSI). The study aims were to compare sperm yields of men post-vasectomy or with obstructive azoospermia (OA) of unknown aetiology with fertile men and to assess any alteration in the clinical pregnancy rates after ICSI. METHODS: Testicular tissue was obtained by Trucut needle from men who had undergone a vasectomy >5yrs previously, had OA from other causes and from fertile men during vasectomy. Seminiferous tubules were milked to measure sperm yields. Numbers of Sertoli cells, spermatids and thickness of the seminiferous tubule walls were assessed using quantitative computerized analysis. RESULTS and CONCLUSIONS: Sperm yields/g testis were significantly decreased in men post-vasectomy and in men with OA, relative to fertile men. Significant reductions were also observed in early (40%) and mature (29%) spermatid numbers and an increase of 31% was seen in the seminiferous tubule wall (basal membrane and collagen thickness) of vasectomised men compared to fertile men. Clinical pregnancy rates in couples who had had a vasectomy were also significantly reduced.

Structure and dynamics of a confined ionic liquid. topics of relevance to dye-sensitized solar cells

The behavior of a model ionic liquid (IL) confined between two flat parallel walls was studied at various interwall distances using computer simulations. The results focus both on structural and dynamical properties. Mass and charge density along the confinement axis reveal a structure of layers parallel to the walls that leads to an oscillatory profile in the electrostatic potential. Orientational correlation functions indicate that cations at the interface orient tilted with respect to the surface and that any other orientational order is lost thereafter. The diffusion coefficients of the ions exhibit a maximum as a function of the confinement distance, a behavior that results from a combination of the structure of the liquid as a whole and a faster molecular motion in the vicinity of the walls. We discuss the relevance of the present results and elaborate on topics that need further attention regarding the effects of ILs in the functioning of IL-based dye-sensitized solar cells.

The Soviet Union and the International Brigades, 1936-1939

The International Brigades are typically viewed as a fighting force whose impetus came from the Comintern, and thus from within the walls of the Kremlin. If the assumption is essentially correct, the broader relation between Stalin’s USSR and the IB has received little attention. This chapter constitutes an empirically-based study of the Soviet role not only in the formation of the IB, but of the Red Army’s collaboration with IB units, and Moscow’s role in the climax and denouement of the brigadistas’ Spanish experience. This study’s principal conclusion is twofold: First, that the creation and sustenance of the IB was part of Stalin’s goal of linking the Loyalist cause with that of the Soviet Union and international communism, a component of a larger geo-strategic gamble which sought to create united opposition to the fascist menace, one which might eventually bring Moscow and the West into a closer alliance. The second conclusion is that the IB, like the broader projection of Soviet power and influence into the Spanish theater, was an overly ambitious operational failure whose abortive retreat is indicative of the basic weakness of the Stalinist regime in the years prior to the Second World War.

Estimating the Heading of a Husky Mobile Robot with a LiDAR Compass based on Direction Maps

Without an absolute position sensor (e.g., GPS), an accurate heading estimate is necessary for proper localization of an autonomous unmanned vehicle or robot. This paper introduces direction maps (DMs), which represent the directions of only dominant surfaces of the vehicle’s environment and can be created with negligible effort. Given an environment with reoccurring surface directions (e.g., walls, buildings, parked cars), lines extracted from laser scans can be matched with a DM to provide an extremely lightweight heading estimate that is shown, through experimentation, to drastically reduce the growth of heading errors. The algorithm was tested using a Husky A200 mobile robot in a warehouse environment over traverses hundreds of metres in length. When a simple a priori DM was provided, the resulting heading estimation showed virtually no error growth.

Wall thickness dependence of the scaling law for ferroic stripe domains

The periodicity of 180 degrees. stripe domains as a function of crystal thickness scales with the width of the domain walls, both for ferroelectric and for ferromagnetic materials. Here we derive an analytical expression for the generalized ferroic scaling factor and use this to calculate the domain wall thickness and gradient coefficients ( exchange constants) in some ferroelectric and ferromagnetic materials. We then use these to discuss some of the wider implications for the physics of ferroelectric nanodevices and periodically poled photonic crystals.

'An aid to mental health': natural history, alienists and therapeutics in Victorian Scotland

In the nineteenth century natural history was widely regarded as a rational and ‘distracting’ pursuit that countered the ill-effects, physical and mental, of urban life. This familiar argument was not only made by members of naturalists’ societies but was also borrowed and adapted by alienists concerned with the moral treatment of the insane. This paper examines the work of five long-serving superintendents in Victorian Scotland and uncovers the connections made between an interest in natural history and the management of mental disease. In addition to recovering a significant influence on the conduct of several alienists the paper explores arguments made outside the asylum walls in favour of natural history as an aid to mental health. Investigating the promotion of natural history as a therapeutic recreation in Scotland and elsewhere reveals more fully the moral and cultural significance attached to natural history pursuits in the nineteenth century.

Agricultura urbana, condición para el desarrollo sostenible y la mejora del paisaje

Este artículo resulta de investigaciones en torno al “enverdecimiento” de las ciudades y las oportunidades de la agricultura urbana para la alimentación de una población en constante aumento que no trabaja la tierra. También es fruto de actividades de mejora de ambientes urbanos realizadas con la Escuela de Ingenieros Agrónomos de la Universidad Politécnica de Madrid. A través de casos de agricultura urbana, entendiendo por ella el conjunto de prácticas para la producción de alimentos y plantas ornamentales dentro de las ciudades y en sus entornos, se analizan alternativas para la recuperación de espacios construidos e incremento de la calidad de vida de la población. Todo ello se traduce, además, en creación de riqueza y mejora del paisaje urbano, siempre desde criterios de sostenibilidad que favorecen el desarrollo local desde la Cumbre de la Tierra de Río de 1992 y la Conferencia sobre Desarrollo Sostenible Río+20 de 2013.

Comparison between fluid simulations and experiments in inductively coupled argon/chlorine plasmas

Comparisons of 2D fluid simulations with experimental measurements of Ar/Cl-2 plasmas in a low-pressure inductively coupled reactor are reported. Simulations show that the wall recombination coefficient of Cl atom (gamma) is a crucial parameter of the model and that neutral densities are very sensitive to its variations. The best agreement between model and experiment is obtained for gamma = 0.02, which is much lower than the value predicted for stainless steel walls (gamma = 0.6). This is consistent with reactor wall contaminations classically observed in such discharges. The electron density, negative ion fraction and Cl atom density have been investigated under various conditions of chlorine and argon concentrations, gas pressure and applied rf input power. The plasma electronegativity decreases with rf power and increases with chlorine concentration. At high pressure, the power absorption and distribution of charged particles become more localized below the quartz window. Although the experimental trends are well reproduced by the simulations, the calculated charged particle densities are systematically overestimated by a factor of 3-5. The reasons for this discrepancy are discussed in the paper.