Chemical reactions at nuclear fuel-clad interfaces

This thesis presents a study of the chemical reactions that may occur at the fuel- clad interfaces of fuel elements used in advanced gas-coooled reactors (A.G.R.) The initial investigation involved a study of the inner surfaces of irradiated stainless steel clad and evidence was obtained to show that fission products, in particular tellerium, were associated with reaction products on these surfaces. An accelerated rate of oxidation was observed on the inner surfaces of a failed A.G.R. fuel pin. It is believed that fission product caesium was responsible for this enhancement. A fundamental study of the reaction between 20%Cr/25%Ni/niobium stabilised stainless steel and tellerium was then undertaken over the range 350 - 850 degrees C. Reaction occurred with increasing rapidity over this range and long term exposure at ≤ 750 degrees resulted in intergranular attack of the stainless steel and chromium depletion. The reaction on unoxidised steel surfaces involved the formation of an initial iron-nickel-tellerium layer which subsequently transformed to a chromium telluride product during continued exposure. The thermodynamic stabilities of the steel tellurides were determined to be chromium telluride > nickel telluride > iron telluride. Oxidation of the stainless steel surface prior to tellerium exposure inhibited the reaction. However reaction did occur in regions where the oxide layer had either cracked or spalled.

Air traffic controller reactions to computer assistance

The research was instigated by the Civil Aviation Authority (CAA) to examine the implications for air traffic controllers' (ATCO) job satisfaction of the possible introduction of systems incorporating computer-assisted decision making. Additional research objectives were to assess the possible costs of reductions in ATCO job satisfaction, and to recommend appropriate task allocation between ATCOs and computer for future systems design (Chapter 1). Following a review of the literature (Chapter 2) it is argued that existing approaches to systems and job design do not allow for a sufficiently early consideration of employee needs and satisfactions in the design of complex systems. The present research develops a methodology for assessing affective reactions to an existing system as a basis for making reommendations for future systems design (Chapter 3). The method required analysis of job content using two techniques: (a) task analysis (Chapter 4.1) and (b) the Job Diagnostic Survey (JDS). ATCOs' affective reactions to the several operational positions on which they work were investigated at three levels of detail: (a) Reactions to positions, obtained by ranking techniques (Chapter 4.2); (b) Reactions to job characteristics, obtained by use of JDS (Chapter 4.3); and (c) Reactions to tasks, obtained by use of Repertory Grid technique (Chapter 4.4). The conclusion is drawn that ATCOs' motivation and satisfaction is greatly dependent on the presence of challenge, often through tasks requiring the use of decision making and other cognitive skills. Results suggest that the introduction of systems incorporating computer-assisted decision making might result in financial penalties for the CAA and significant reductions in job satisfaction for ATCOs. General recommendations are made for allocation of tasks in future systems design (Chapter 5).

The pharmacist's contribution towards monitoring and reporting adverse drug reactions

The activities and function of the West Midlands Adverse Drug Reaction Study Group are described. The impact of the Group on the reporting of adverse drug reactions to the CSM by the yellow card system has been evaluated in several ways including a comparison with the Trent Region. The role of the pharmacist in the Group is highlighted. A nationwide survey of the hospital pharmacist's involvement in adverse drug reaction reporting and monitoring is described, the results are reported and discussed. The available sources of information on adverse drug reactions, both primary and secondary, are critically reviewed. A checklist of necessary details for case reports is developed and examples of problems in the literature are given. The contribution of the drug information pharmacist in answering enquiries and encouraging reporting is examined. A role for the ward pharmacist in identifying, reporting, documenting and following up adverse drug reactions is proposed. Studies conducted to support this role are described and the results discussed. The ward pharmacist's role in preventing adverse drug reactions is also outlined. The reporting of adverse drug reactions in Australia is contrasted with the U.K. and particular attention is drawn to the pharmacist's contribution in the former. The problems in evaluating drug safety are discussed and examples are given where serious reactions have only been recognised after many patients have been exposed. To remedy this situation a case is made for enhancing the CSM yellow card scheme by further devolution of reporting, increasing the involvement of pharmacists and improving arrangements at the CSM. It is proposed that pharmacists should undertake the responsibility for reporting reactions to the CSM in some instances.