A Monte Carlo Revisiting of N-Methylformamide and Acetone

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Low levels of realized seed and pollen gene flow and strong spatial genetic structure in a small, isolated and fragmented population of the tropical tree Copaifera langsdorffii Desf

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effects of twenty-four hour transport or twenty-four hour feed and water deprivation on physiologic and performance responses of feeder cattle

The objective of this study was to compare the effects of 24-h road transport or 24-h feed and water deprivation on acute-phase and performance responses of feeder cattle. Angus x Hereford steers (n = 30) and heifers (n = 15) were ranked by gender and BW (217 +/- 3 kg initial BW; 185 +/- 2 d initial age) and randomly assigned to 15 pens on d -12 of the experiment (3 animals/pen; 2 steers and 1 heifer). Cattle were fed alfalfa-grass hay ad libitum and 2.3 kg/animal daily (DM basis) of a corn-based concentrate throughout the experiment (d -12 to 28). on d 0, pens were randomly assigned to 1 of 3 treatments: 1) transport for 24 h in a livestock trailer for 1,200 km (TRANS), 2) no transport but feed and water deprivation for 24 h (REST), or 3) no transport and full access to feed and water (CON). Treatments were concurrently applied from d 0 to d 1. Total DMI was evaluated daily from d -12 to d 28. Full BW was recorded before treatment application (d -1 and 0) and at the end of experiment (d 28 and 29). Blood samples were collected on d 0, 1, 4, 7, 10, 14, 21, and 28. Mean ADG was greater (P < 0.01) in CON vs. TRANS and REST cattle but similar (P = 0.46) between TRANS and REST cattle (1.27, 0.91, and 0.97 kg/d, respectively; SEM = 0.05). No treatment effects were detected for DMI (P >= 0.25), but CON had greater G: F vs. TRANS (P < 0.01) and REST cattle (P = 0.08) whereas G: F was similar (P = 0.21) between TRANS and REST cattle. Plasma cortisol concentrations were greater (P <= 0.05) in REST vs. CON and TRANS cattle on d 1, 7, 14, and 28 and also greater (P = 0.02) in TRANS vs. CON cattle on d 1. Serum NEFA concentrations were greater (P < 0.01) in REST and TRANS vs. CON cattle on d 1 and greater (P < 0.01) in REST vs. TRANS cattle on d 1. Plasma ceruloplasmin concentrations were greater (P = 0.04) in TRANS vs. CON cattle on d 1, greater (P = 0.05) in REST vs. CON on d 4, and greater (P <= 0.05) in REST vs. TRANS and CON on d 14. Plasma haptoglobin concentrations were greater (P < 0.01) in TRANS vs. CON and REST cattle on d 1 and greater (P <= 0.05) for REST vs. TRANS and CON cattle on d 7. In conclusion, 24-h transport and 24-h nutrient deprivation elicited acute-phase protein reactions and similarly reduced feedlot receiving performance of feeder cattle. These results suggest that feed and water deprivation are major contributors to the acute-phase response and reduced feedlot receiving performance detected in feeder cattle transported for long distances.

Clinical evaluation and induced corneal vascularization study by native and anionic collagen membranes in rabbits corneas

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effect of Flasking and Polymerization Techniques on Tooth Movement in Complete Denture Processing

Purpose: The purpose of this study was to compare the artificial tooth positional changes following the flasking and polymerization of complete dentures by a combination of two flasking methods and two polymerization techniques using computer graphic measurements.Materials and Methods: Four groups of waxed complete dentures (n = 10) were invested and polymerized using the following techniques: (1) adding a second investment layer of gypsum and conventional water bath polymerization (Control), (2) adding a second investment layer of gypsum and polymerization with microwave energy (Gyp-micro), (3) adding a second investment layer of silicone (Zetalabor) and conventional polymerization (Silwater), and (4) adding a second investment layer of silicone and polymerization with microwave energy (Silmicro). For each specimen, six segments of interdental distances (A to F) were measured to determine the artificial tooth positions in the waxed and polymerized stages using software program AutoCad R14. The mean values of the changes were statistically compared by univariate ANOVA with Tukey post-hoc test at 5% significance.Results: There were no significant differences among the four groups, except for segment D of the Silmicro group (-0.004 +/- 0.032 cm) in relation to the Gypwater group (0.044 +/- 0.031 cm) (p < 0.05), which presented, repectively, expansion and shrinkage after polymerization.Conclusions: Within the limitations of this study, it was concluded that although the differences were not statistically significant, the use of a silicone investment layer when flasking complete dentures resulted in the least positional changes of the artificial teeth regardless of the polymerization technique.

Maxillo-mandibular counter-clockwise rotation and mandibular advancement with TMJ Concepts (R) total joint prostheses Part II - Airway changes and stability

The purpose of this study was to evaluate the anatomical changes and stability of the oropharyngeal airway and head Posture following TMJ reconstruction and mandibular advancement with TMJ Concepts custom-made total joint prostheses and maxillary osteotomies with counter-clockwise rotation of the maxillo-mandibular complex. All patients were operated at Baylor University Medical Center, Dallas TX, USA, by one surgeon (Wolford). The lateral cephalograms of 47 patients were analyzed to determine surgical and post-surgical changes of the oropharyngeal airway, hyoid bone and head posture. Surgery increased the narrowest retroglossal airway space 4.9 mm. Head Posture showed flexure immediately after surgery (-5.6 +/- 6.7 degrees) and extension long-term post surgery (1.8 +/- 6.7 degrees); cervical curvature showed no significant change. Surgery increased the distances between the third cervical vertebrae and the menton 11.7 +/- 9.1 mm and the third cervical vertebrae and hyoid 3.2 +/- 3.9 mm, and remained stable. The distance from the hyoid to the mandibular plane decreased during surgery (-3.8 +/- 5.8 mm) and after surgery (-2.5 +/- 5.2 mm), Maxillo-mandibular advancement with counter-clockwise rotation and TMJ reconstruction with total joint prostheses produced immediate increase in oropharyngeal airway dimension, which was influenced by long-term changes in head posture but remained stable over the follow-up period.

Influence of microwave disinfection on the dimensional stability of intact and relined acrylic resin denture bases

Statement of problem. Microwave irradiation has been suggested as a method to disinfect denture bases. However, the effect of microwave heating on the dimensional stability of the relined denture bases is unknown.Purpose. The purpose of this study was to evaluate the dimensional stability of intact and relined acrylic resin denture bases after microwave disinfection.Material and methods. A standard brass cast simulating an edentulous maxillary arch was machined and used to fabricate 2- and 4-mm-thick denture bases (n=200), which were processed with heat-polymerized acrylic resin (Lucitone 550). The 2-mm thick-specimens (n=160) were relined with 2 mm of autopolymerizing resin (Tokuso Rebase Fast, Ufi Gel Hard, Kooliner, or New Truliner). Distances between 5 removable pins on the standard brass cast were measured with a Nikon optical comparator, and the area (mm(2)) formed by the distance between 5 pins was calculated and served as baseline. During fabrication, the pins were transferred to the intaglio surface of the specimens. Differences between the baseline area and those subsequently determined for the specimens were used to calculate the percent dimensional changes. The intact and relined denture bases were divided into 4 groups (n=10) and evaluated after: polymerization (control group P); 1 cycle of microwave disinfection (MW); daily microwave disinfection for 7 days (control group MW7); water storage for 7 days (WS7). Microwave irradiation was performed for 6 minutes at 650 W. Data were analyzed using 2-way ANOVA followed by Tukey's test (alpha=.05).Results. Intact specimens and those relined with Kooliner and New Truliner showed increased shrinkage after 1 (P=.05, .018, and .001, respectively) and 7 (P <.001, .003, and <.001, respectively) cycles of microwave disinfection. With the exception of specimens relined with Kooliner, intact specimens showed greater shrinkage than the relined specimens after 7 cycles of microwave disinfection.Conclusions. Microwave disinfection produced increased shrinkage of intact specimens and those relined with New Truliner and Kooliner.

Linear dimensional changes of denture base and hard chair-side reline resins after disinfection

Objectives: This study evaluated the effect of disinfection by immersion in sodium perborate (50 degrees C/10 min) or microwave irradiation (650 W/6 min) on the linear dimensional change (LDC) of four reline resins (Kooliner-K, New Truliner-N, Tokuso Rebase Fast-T, Ufi Gel Hard-U) and one heat-polymerizing denture base resin (Lucitone 550-L). Methods: Specimens (50.0 mm diameter, 0.5 mm thickness) were made using a split mold with reference points, and divided into two controls and four test groups (u = 8). The distances between the points were measured on the mold (baseline readings), and compared to those obtained from the specimens after: polymerization or immersion in water (37 degrees C) for 7 days (controls); 2 or 7 cycles of disinfection by immersion or microwave irradiation. Results: the two-way ANOVA and Tukey's test (alpha = 0.05) showed that microwave disinfection significantly increased the mean LDC of materials L (-1.43%), N (-1.27%) and K (-1.06%). Material N also exhibited a significant increase in LDC after two cycles of chemical disinfection (-0.73%). For U (-0.47%) and T (-0.21%) materials, no significant changes in LDC were found. Conclusions: Microwave disinfection increases the shrinkage of materials L, N, and K. The dimensional stability of resins U and T was not affected by the disinfection methods evaluated. (c) 2006 Wiley Periodicals, Inc.

Fatigue strength: effect of welding type and joint design executed in Ti-6Al-4V structures

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Anatomic study of the mandibular foramen, lingula and antilingula in dry mandibles, and its statistical relationship between the true lingula and the antilingula

The authors verified the anatomical location of the mandibular foramen, lingula and antilingula in dry mandibles, aiming to obtain information that could be used when performing mandibular osteotomies. Forty-four mandibles (88 sides) were evaluated. The distances were measured using a sliding calliper, with the mandibles fixed in a reproducible position. Results showed that the mandibular foramen is on average 5.82 mm below the lingula. Regarding the statistical comparison between the mandibular foramen entrance and the anti lingula position, there is no correlation between the position of those two structures in the studied sample. The mandibular foramen is slightly posterior in relation to the centre of the ramus. The lingula is an important anatomic landmark for ramus surgery, and for determining the distance to the mandibular foramen entrance. The use of the antilingula as a landmark for the position of the vertical ramus osteotomy is not recommended.

5S rDNA chromosomal mapping and COI sequence analysis reveal differentiation among distinct populations of a characid fish Serrapinnus notomelas

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Mitochondrial DNA polymorphism and heteroplasmy in populations of Aedes aegypti in Brazil

The tropical mosquito Aedes aegypti (Diptera: Culicidae) is the most important domestic vector of urban yellow fever and dengue viruses. Ae. aegypti originated from Africa and was probably introduced into Brazil during the colonial period through embarkations, and dengue epidemics soon followed. Genetic analysis of 12 Ae. aegypti populations from five states in Brazil was conducted based on two mitochondrial DNA fragments: cytochrome oxidase I and NADH dehydrogenase subunit 4. Analyses comparing individual haplotypes indicated the existence of two well-defined clades, probably representing two mitochondrial lineages. Analysis of molecular variance showed significant variability in genetic structure among collections within groups. Mantel regression analysis showed a correlation between genetic and geographic distances, mainly because of northern and northeastern populations, in comparison with those in the southeast. The population from Santos, the largest port in Brazil, showed the greatest diversity, with 10 unique haplotypes, an indication of recent introductions that have not yet spread to other Brazilian cities. Different mitochondrial DNA sequences were found in three specimens, indicating the presence of heteroplasmy.

Phenology, sex ratio, and spatial distribution among dioecious species of Trichilia (Meliaceae)

The flowering, sex ratio, and spatial distribution of four dioecious species of Trichilia (Meliaceae) were studied in a semi-deciduous forest in southeastern Brazil. All reproductive trees (T. clausseni, T. pallida and T. catigua) with dbh greater than or equal to5 cm within a 1-ha plot were collected, sexed, mapped and, for individuals of each species, the distances to the nearest neighbour of the same and opposite sex were measured. For the shrub species T elegans (dbh <5 cm), all reproductive individuals were sampled randomly in 10 samples of 10 x 10 m. The reproductive phenology was observed at weekly to monthly intervals from May 1988 to January 1990. The species are strictly dioecious, did not present any sex-mixed trees or sex switching during the study, and sex ratio did not differ significantly from 1:1. The size distributions and the relative size variation were not significantly different. between sexes. There was no significant segregation or clumping between individuals of either sex and no fruit production without pollination. Onset of flowering and flowering peak were synchronous between male and female plants for all species studied. Flower synchrony was related to outcrossing and pollinator attraction rather than climatic factors.

Variation in liana abundance and biomass along an elevational gradient in the tropical Atlantic Forest (Brazil)

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Natural and artificially-induced habitat complexity and freshwater fish species composition

The effects of habitat complexity, induced by construction of artificial reefs, on the fish assemblages in the Barra Bonita reservoir, Brazil, and in the lotic zone immediately below the dam were studied. Four artificial reefs were constructed in each habitat at variable distances from the shore. Multiple correspondence analysis showed that the factors distance from the shore and type of habitat were determinants for the group formation, and artificial reefs had a lesser effect. Fish species composition was about the same at locations with and without reefs.