Objective metrics for functional evaluation of upper limb during the ADL of drinking: application in SCI

Three-dimensional kinematic analysis provides quantitative assessment of upper limb motion and is used as an outcome measure to evaluate movement disorders. The aim of the present study is to present a set of kinematic metrics for quantifying characteristics of movement performance and the functional status of the subject during the execution of the activity of daily living (ADL) of drinking from a glass. Then, the objective is to apply these metrics in healthy people and a population with cervical spinal cord injury (SCI), and to analyze the metrics ability to discriminate between healthy and pathologic people. 19 people participated in the study: 7 subjects with metameric level C6 tetraplegia, 4 subjects with metameric level C7 tetraplegia and 8 healthy subjects. The movement was recorded with a photogrammetry system. The ADL of drinking was divided into a series of clearly identifiable phases to facilitate analysis. Metrics describing the time of the reaching phase, the range of motion of the joints analyzed, and characteristics of movement performance such as the efficiency, accuracy and smoothness of the distal segment and inter-joint coordination were obtained. The performance of the drinking task was more variable in people with SCI compared to the control group in relation to the metrics measured. Reaching time was longer in SCI groups. The proposed metrics showed capability to discriminate between healthy and pathologic people. Relative deficits in efficiency were larger in SCI people than in controls. These metrics can provide useful information in a clinical setting about the quality of the movement performed by healthy and SCI people during functional activities.

Evaluation of mission planning strategies of a robotic aerial vehicle for the AIRC international competition

The International Aerial Robotics Competition (IARC) is an important event where teams from universities design flying autonomous vehicles to overcome the last challenges in the field. The goal of the Seventh Mission proposed by the IARC is to guide several mobile ground robots to a target area. The scenario is complex and not determinist due to the random behavior of the ground robots movement. The UAV must select efficient strategies to complete the mission. The goal of this work has been evaluating different alternative mission planning strategies of a UAV for this competition. The Mission Planner component is in charge of taking the UAV decisions. Different strategies have been developed and evaluated for the component, achieving a better performance Mission Planner and valuable knowledge about the mission. For this purpose, it was necessary to develop a simulator to evaluate the different strategies. The simulator was built as an improvement of an existing previous version.

A web-based application for the management and evaluation of tutoring requests in PBL-based massive laboratories

One important steps in a successful project-based-learning methodology (PBL) is the process of providing the students with a convenient feedback that allows them to keep on developing their projects or to improve them. However, this task is more difficult in massive courses, especially when the project deadline is close. Besides, the continuous evaluation methodology makes necessary to find ways to objectively and continuously measure students' performance without increasing excessively instructors' work load. In order to alleviate these problems, we have developed a web service that allows students to request personal tutoring assistance during the laboratory sessions by specifying the kind of problem they have and the person who could help them to solve it. This service provides tools for the staff to manage the laboratory, for performing continuous evaluation for all students and for the student collaborators, and to prioritize tutoring according to the progress of the student's project. Additionally, the application provides objective metrics which can be used at the end of the subject during the evaluation process in order to support some students' final scores. Different usability statistics and the results of a subjective evaluation with more than 330 students confirm the success of the proposed application.

Energy efficiency evaluation of zero energy houses

Given the global energy and environmental situation, the European Union has been issuing directives with increasingly demanding requirements in term of the energy efficiency in buildings. The international competition of sustainable houses, Solar Decathlon Europe (SDE), is aligned with these European objectives. SDE houses are low energy solar buildings that must reach the near to zero energy houses’ goal. In the 2012 edition, in order to emphasize its significance, the Energy Efficiency Contest was added. SDE houses’ interior comfort, functioning and energy performance is monitored. The monitoring data can give an idea about the efficiency of the houses. However, a jury comprised by international experts is responsible for carrying out the houses energy efficiency evaluation. Passive strategies and houses services are analyzed. Additionally, the jury's assessment has been compared with the behavior of the houses during the monitoring period. Comparative studies make emphasis on the energy aspects, houses functioning and their interior comfort. Conclusions include thoughts related with the evaluation process, the results of the comparative studies and suggestions for the next competitions.

Using the R-PAS' Aggressive Content Score For the Evaluation of Aggressive Behaviors in Children

The Rorschach Performance Assessment System (R-PAS) was developed in 2011 as analternative to the previous Comprehensive System. The goal was to improve the psychometrics,and particularly the validity, of this assessment method. The norms for children werequestionable in the Comprehensive system (e.g., outdated, low numbers of subjects) and validitystudies for children were sparse. One of the indicators included in the R-PAS system, theaggressive content indicator (AgC), is intended to reflect aggressive behavior, but few studieshave examined the validity of this indicator. This study examined the validity of AgC in asample of 32 children and adolescents receiving services at a residential treatment center.Subjects' AgC scores were analyzed in relation to demographics and diagnosis, as well as ratingsof aggression and conduct problems from the Behavioral Assessment System for Children-2(BASC-2) Parent and Teacher Reports. Correlations between the AgC score and BASC-2aggression and conduct problems scores were not statistically significant. None of thecorrelations between AgC score and a diagnosis of Conduct Disorder, Oppositional DefiantDisorder, Posttraumatic Stress Disorder, or Mood Disorders were significant either. Given thesmall sample size, null results may be a result of power concerns. The lack of significantcorrelations may however, indicate that operational definitions of aggression used in variousforms of measurement reflect different constructs.

An Evaluation of Sport Psychology Service Delivery in Collegiate Athletics

Sport and Performance Psychology is an ever-evolving specialty. While its development continues, it has not been without its challenges. Sport and performance psychologists work in a variety of settings and often come from similar, yet inherently different, training backgrounds. Individuals from both sport sciences and psychology have made compelling arguments as to which approach provides quality services to their respective clients. The question that remains, however, is what are these quality services? Who are the clients and what do they need from professionals in the field?Collegiate student athletes inherently face a number of typical issues related to their age and development. They also face a number of atypical difficulties as a result of their status as student athletes. As such, they provide an adequate sample of potential presenting issues for sport and performance psychologists. This current study utilized a qualitative, exploratory method to evaluate the presenting issues that brought clients to seek services from professionals.This paper seeks to establish a foundation for the development of a theoretical basis of the psychology of human performance, including both performance and general mental health concerns, and how sport and performance psychologists can most effectively intervene in this process. This paper is based on an analysis of seven years of service delivery within a NCAA Division I athletic department.Results indicate that collegiate student athletes seek services related to performance enhancement and general mental health at relative equal frequency. As such, training and service delivery in both areas would be most beneficial and best serve this population.  

Real time optimization in chemical process: evaluation of strategies, improvements and industrial application.

The increasing economic competition drives the industry to implement tools that improve their processes efficiencies. The process automation is one of these tools, and the Real Time Optimization (RTO) is an automation methodology that considers economic aspects to update the process control in accordance with market prices and disturbances. Basically, RTO uses a steady-state phenomenological model to predict the process behavior, and then, optimizes an economic objective function subject to this model. Although largely implemented in industry, there is not a general agreement about the benefits of implementing RTO due to some limitations discussed in the present work: structural plant/model mismatch, identifiability issues and low frequency of set points update. Some alternative RTO approaches have been proposed in literature to handle the problem of structural plant/model mismatch. However, there is not a sensible comparison evaluating the scope and limitations of these RTO approaches under different aspects. For this reason, the classical two-step method is compared to more recently derivative-based methods (Modifier Adaptation, Integrated System Optimization and Parameter estimation, and Sufficient Conditions of Feasibility and Optimality) using a Monte Carlo methodology. The results of this comparison show that the classical RTO method is consistent, providing a model flexible enough to represent the process topology, a parameter estimation method appropriate to handle measurement noise characteristics and a method to improve the sample information quality. At each iteration, the RTO methodology updates some key parameter of the model, where it is possible to observe identifiability issues caused by lack of measurements and measurement noise, resulting in bad prediction ability. Therefore, four different parameter estimation approaches (Rotational Discrimination, Automatic Selection and Parameter estimation, Reparametrization via Differential Geometry and classical nonlinear Least Square) are evaluated with respect to their prediction accuracy, robustness and speed. The results show that the Rotational Discrimination method is the most suitable to be implemented in a RTO framework, since it requires less a priori information, it is simple to be implemented and avoid the overfitting caused by the Least Square method. The third RTO drawback discussed in the present thesis is the low frequency of set points update, this problem increases the period in which the process operates at suboptimum conditions. An alternative to handle this problem is proposed in this thesis, by integrating the classic RTO and Self-Optimizing control (SOC) using a new Model Predictive Control strategy. The new approach demonstrates that it is possible to reduce the problem of low frequency of set points updates, improving the economic performance. Finally, the practical aspects of the RTO implementation are carried out in an industrial case study, a Vapor Recompression Distillation (VRD) process located in Paulínea refinery from Petrobras. The conclusions of this study suggest that the model parameters are successfully estimated by the Rotational Discrimination method; the RTO is able to improve the process profit in about 3%, equivalent to 2 million dollars per year; and the integration of SOC and RTO may be an interesting control alternative for the VRD process.

Evaluation of online tools as didactic resource in the university education

Recently, many efforts have been made in the academic world to adapt the new degrees to the new European Higher Education Area (EHEA). New technologies have been the most important factor to carry out this adaptation. In particular, the tools 2.0 have been spreading quickly, not just the Web 2.0, but even in all the educational levels. Nevertheless, it is now necessary to evaluate whether all these efforts and all the changes, carried out in order to obtain improved academic performance among students, have provided good results. Therefore, the aim of this paper is focused on studying the impact of the implementation of information and communication technologies (ICTs) in a subject belonging to a Master from the University of Alicante in the academic year (2010-2011). In special, it is an elective course called "Advanced Visual Ergonomics" from the Master of Clinical Optometry and Vision. The methodology used to teach this course differs from the traditional one in many respects. For example, one of the resources used for the development of this course is a blog developed specifically to coordinate a series of virtual works, whose purpose is that the student goes into specific aspects of the current topic. Next, the student participates in an active role by writing a personal assessment on the blog. However, in the course planning, there is an attendance to lessons, where the teacher presents certain issues in a more traditional way, that is, with a lecture supported with audiovisual materials, such as materials generated in powerpoint. To evaluate the quality of the results achieved with this methodology, in this work the personal assessment of the students, who have completed this course during this academic year, are collected. In particular, we want to know their opinion about the used resources, as well as the followed methodology. The tool used to collect this information was a questionnaire. This questionnaire evaluates different aspects of the course: a general opinion, quality of the received information, satisfaction about the followed methodology and the student´s critical awareness. The design of this questionnaire is very important to get conclusive information about the methodology followed in the course. The questionnaire has to have an adequate number of questions; whether it has many questions, it might be boring for the student who would pay no enough attention. The questions should be well-written, with a clear structure and message, to avoid confusion and an ambiguity. The questions should be objectives, without any suggestion for a desired answer. In addition, the questionnaire should be interesting to encourage the student´ s interest. In conclusion, this questionnaire developed for this subject provided good information to evaluate whether the methodology was a useful tool to teach "Advanced Visual Ergonomics". Furthermore, the student´s opinion collected by this questionnaire might be very helpful to improve this didactic resource.

Evaluation of semi-passive treatment technologies for septic lagoon capacity expansion

In Canada, increases in rural development has led to a growing need to effectively manage the resulting municipal and city sewage without the addition of significant cost- and energy- expending infrastructure. Storring Septic Service Limited is a family-owned, licensed wastewater treatment facility located in eastern Ontario. It makes use of a passive waste stabilization pond system to treat and dispose of waste and wastewater in an environmentally responsible manner. Storring Septic, like many other similar small-scale wastewater treatment facilities across Canada, has the potential to act as a sustainable eco-engineered facility that municipalities and service providers could utilize to manage and dispose of their wastewater. However, it is of concern that the substantial inclusion of third party material could be detrimental to the stability and robustness of the pond system. In order to augment the capacity of the current facility, and ensure it remains a self-sustaining system with the capacity to safely accept septage from other sewage haulers, it was hypothesized that pond effluent treatment could be further enhanced through the incorporation of one of three different technology solutions, which would allow the reduction of wastewater quality parameters below existing regulatory effluent discharge limits put in place by Ontario’s Ministry of the Environment and Climate Change (MOECC). Two of these solutions make use of biofilm technologies in order to enhance the removal of wastewater parameters of interest, and the third utilizes the natural water filtration capabilities of zebra mussels. Pilot-scale testing investigated the effects of each of these technologies on treatment performance under both cold and warm weather operation. This research aimed to understand the important mechanisms behind biological filtration methods in order to choose and optimize the best treatment strategy for full-scale testing and implementation. In doing so, a recommendation matrix was elaborated provided with the potential to be used as a universal operational strategy for wastewater treatment facilities located in environments of similar climate and ecology.

The development and evaluation of a prototype grade severity rating system. Final report.

Federal Highway Administration, Washington, D.C.

Passenger vehicle, light truck and van convex mirror optimization and evaluation studies. Volume 2: evaluation of alternative mirror configurations. Final report.

National Highway Traffic Safety Administration, Washington, D.C.

Test and evaluation of the AMF, Inc. and Fairchild Industries experimental safety vehicles. Volume III. ESV program summary. Final report.

National Highway Traffic Safety Administration, Washington, D.C.

Accident avoidance evaluation of General Motors experimental safety vehicle. Final report.

National Highway Traffic Safety Administration, Washington, D.C.

Light vehicle antilock brake research program. Report 1 - evaluation of an electronic four sensor, three circuit integrated system. Final report.

Mode of access: Internet.

Light vehicle antilock brake research program. Report 2 - evaluation of a fully mechanical, two circuit, two sensor system. Final report.

Mode of access: Internet.