CuInS2/In2S3 Cells using a Cost-effective Technique: Significance of Precursor Ratios on Cell Parameters

Thin film solar cells having structure CuInS2/In2S3 were fabricated using chemical spray pyrolysis (CSP) technique over ITO coated glass. Top electrode was silver film (area 0.05 cm2). Cu/In ratio and S/Cu in the precursor solution for CuInS2 were fixed as 1.2 and 5 respectively. In/S ratio in the precursor solution for In2S3 was fixed as 1.2/8. An efficiency of 0.6% (fill factor -37.6%) was obtained. Cu diffusion to the In2S3 layer, which deteriorates junction properties, is inevitable in CuInS2/In2S3 cell. So to decrease this effect and to ensure a Cu-free In2S3 layer at the top of the cell, Cu/In ratio was reduced to 1. Then a remarkable increase in short circuit current density was occurred from 3 mA/cm2 to 14.8 mA/cm2 and an efficiency of 2.13% was achieved. Also when In/S ratio was altered to 1.2/12, the short circuit current density increased to 17.8 mA/cm2 with an improved fill factor of 32% and efficiency remaining as 2%. Thus Cu/In and In/S ratios in the precursor solutions play a crucial role in determining the cell parameters

Low-Cost Micromechanically Tunable Optical Devices: Strained Resonator Engineering, Technological Implementation and Characterization

The rapid growth of the optical communication branches and the enormous demand for more bandwidth require novel networks such as dense wavelength division multiplexing (DWDM). These networks enable higher bitrate transmission using the existing optical fibers. Micromechanically tunable optical microcavity devices like VCSELs, Fabry-Pérot filters and photodetectors are core components of these novel DWDM systems. Several air-gap based tunable devices were successfully implemented in the last years. Even though these concepts are very promising, two main disadvantages are still remaining. On the one hand, the high fabrication and integration cost and on the other hand the undesired adverse buckling of the suspended membranes. This thesis addresses these two problems and consists of two main parts: • PECVD dielectric material investigation and stress control resulting in membranes shape engineering. • Implementation and characterization of novel tunable optical devices with tailored shapes of the suspended membranes. For this purposes, low-cost PECVD technology is investigated and developed in detail. The macro- and microstress of silicon nitride and silicon dioxide are controlled over a wide range. Furthermore, the effect of stress on the optical and mechanical properties of the suspended membranes and on the microcavities is evaluated. Various membrane shapes (concave, convex and planar) with several radii of curvature are fabricated. Using this resonator shape engineering, microcavity devices such as non tunable and tunable Fabry-Pérot filters, VCSELs and PIN photodetectors are succesfully implemented. The fabricated Fabry-Pérot filters cover a spectral range of over 200nm and show resonance linewidths down to 1.5nm. By varying the stress distribution across the vertical direction within a DBR, the shape and the radius of curvature of the top membrane are explicitely tailored. By adjusting the incoming light beam waist to the curvature, the fundamental resonant mode is supported and the higher order ones are suppressed. For instance, a tunable VCSEL with 26 nm tuning range, 400µW maximal output power, 47nm free spectral range and over 57dB side mode suppresion ratio (SMSR) is demonstrated. Other technologies, such as introducing light emitting organic materials in microcavities are also investigated.

The competitiveness of domestic rice production in East Africa: A domestic resource cost approach in Uganda

The rapid increase of rice imports in sub-Saharan Africa under the unstable situation in the world rice market during the 2000s has made it an important policy target for the countries in the region to increase self-sufficiency in rice in order to enhance food security. Whether domestic rice production can be competitive with imported rice is a serious question in East African countries that lie close, just across the Arabian Sea, to major rice exporting countries in South Asia. This study investigates the international competitiveness of domestic rice production in Uganda in terms of the domestic resource cost ratio. The results show that rainfed rice cultivation, which accounts for 95% of domestic rice production, does not have a comparative advantage with respect to rice imported from Pakistan, the largest supplier of imported rice to Uganda. However, the degree of non-competitiveness is not serious, and a high possibility exists for Uganda’s rainfed rice cultivation to become internationally competitive by improving yield levels by applying more modern inputs and enhancing labour productivity. Irrigated rice cultivation, though very limited in area, is competitive even under the present input-output structure when the cost of irrigation infrastructure is treated as a sunk cost. If the cost of installing irrigation infrastructure and its operation and maintenance is taken into account, the types of irrigation development that are economically feasible are not large-scale irrigation projects, but are small- and microscale projects for lowland rice cultivation and rain-water harvesting for upland rice cultivation.

Coordinating Inventory Control and Pricing Strategies with Random Demand and Fixed Ordering Cost: The Finite Horizon Case

We analyze a finite horizon, single product, periodic review model in which pricing and production/inventory decisions are made simultaneously. Demands in different periods are random variables that are independent of each other and their distributions depend on the product price. Pricing and ordering decisions are made at the beginning of each period and all shortages are backlogged. Ordering cost includes both a fixed cost and a variable cost proportional to the amount ordered. The objective is to find an inventory policy and a pricing strategy maximizing expected profit over the finite horizon. We show that when the demand model is additive, the profit-to-go functions are k-concave and hence an (s,S,p) policy is optimal. In such a policy, the period inventory is managed based on the classical (s,S) policy and price is determined based on the inventory position at the beginning of each period. For more general demand functions, i.e., multiplicative plus additive functions, we demonstrate that the profit-to-go function is not necessarily k-concave and an (s,S,p) policy is not necessarily optimal. We introduce a new concept, the symmetric k-concave functions and apply it to provide a characterization of the optimal policy.

Coordinating Inventory Control and Pricing Strategies with Random Demand and Fixed Ordering Cost: the Infinite Horizon Case

We analyze an infinite horizon, single product, periodic review model in which pricing and production/inventory decisions are made simultaneously. Demands in different periods are identically distributed random variables that are independent of each other and their distributions depend on the product price. Pricing and ordering decisions are made at the beginning of each period and all shortages are backlogged. Ordering cost includes both a fixed cost and a variable cost proportional to the amount ordered. The objective is to maximize expected discounted, or expected average profit over the infinite planning horizon. We show that a stationary (s,S,p) policy is optimal for both the discounted and average profit models with general demand functions. In such a policy, the period inventory is managed based on the classical (s,S) policy and price is determined based on the inventory position at the beginning of each period.

A process-based cost estimating tool for ship structural designs

by John M. Barentine.

Breakguides: Creació d'una empresa de guiatge low cost

El projecte es planteja el repte de cobrir un forat en l’oferta turística seguint la fórmula low cost: el guiatge turístic. La idea de la empresa que volem estudiar i crear (BREAKGUIDES) és la de poder oferir els serveis de guiatge, ja siguin guies correu o guies locals en destinació, seguint una fórmula low cost que s’adapti al nou perfil de turista i al seu pressupost. L’empresa tindrà un perfil semblant al d’una xarxa social que ofereixi serveis de guiatge a canvi d’un petit sou i la manutenció

A quality-based cost distribution charging scheme for QoS multicast networks

This paper presents a new charging scheme for cost distribution along a point-to-multipoint connection when destination nodes are responsible for the cost. The scheme focus on QoS considerations and a complete range of choices is presented. These choices go from a safe scheme for the network operator to a fair scheme to the customer. The in-between cases are also covered. Specific and general problems, like the incidence of users disconnecting dynamically is also discussed. The aim of this scheme is to encourage the users to disperse the resource demand instead of having a large number of direct connections to the source of the data, which would result in a higher than necessary bandwidth use from the source. This would benefit the overall performance of the network. The implementation of this task must balance between the necessity to offer a competitive service and the risk of not recovering such service cost for the network operator. Throughout this paper reference to multicast charging is made without making any reference to any specific category of service. The proposed scheme is also evaluated with the criteria set proposed in the European ATM charging project CANCAN

Operational Cost Reduction in WDM Networks using Lighttours

Wavelength division multiplexing (WDM) networks have been adopted as a near-future solution for the broadband Internet. In previous work we proposed a new architecture, named enhanced grooming (G+), that extends the capabilities of traditional optical routes (lightpaths). In this paper, we compare the operational expenditures incurred by routing a set of demands using lightpaths with that of lighttours. The comparison is done by solving an integer linear programming (ILP) problem based on a path formulation. Results show that, under the assumption of single-hop routing, almost 15% of the operational cost can be reduced with our architecture. In multi-hop routing the operation cost is reduced in 7.1% and at the same time the ratio of operational cost to number of optical-electro-optical conversions is reduced for our architecture. This means that ISPs could provide the same satisfaction in terms of delay to the end-user with a lower investment in the network architecture

All-Optical Label Stacking: Easing the Trade-offs Between Routing and Architecture Cost in All-Optical Packet Switching

All-optical label swapping (AOLS) forms a key technology towards the implementation of all-optical packet switching nodes (AOPS) for the future optical Internet. The capital expenditures of the deployment of AOLS increases with the size of the label spaces (i.e. the number of used labels), since a special optical device is needed for each recognized label on every node. Label space sizes are affected by the way in which demands are routed. For instance, while shortest-path routing leads to the usage of fewer labels but high link utilization, minimum interference routing leads to the opposite. This paper studies all-optical label stacking (AOLStack), which is an extension of the AOLS architecture. AOLStack aims at reducing label spaces while easing the compromise with link utilization. In this paper, an integer lineal program is proposed with the objective of analyzing the softening of the aforementioned trade-off due to AOLStack. Furthermore, a heuristic aiming at finding good solutions in polynomial-time is proposed as well. Simulation results show that AOLStack either a) reduces the label spaces with a low increase in the link utilization or, similarly, b) uses better the residual bandwidth to decrease the number of labels even more

Networks and RegionalCompetitiveness: Towards a Transaction Cost Approach of Small-Scale Cooperation

A preoccupation with competition often dominates the study of governance. A focus on competition often unnecessarily precludes the possibility that regional institutions can suspend competition in certain areas and facilitate cooperation among potential rivals, thereby potentially contributing to their mutual success. In many ways companies cooperating through these types of networks have a greater degree of flexibility than firms which are forced to rely solely on hierarchies or markets for solutions to their problems. In order to fully understand how such networks work, this article first parses out differences in definitions of networks in order to understand how the type of network mentioned above actually differs from other uses of this term. Then it develops a theory of governance that goes beyond hierarchies and markets by demonstrating how this type of network can lead to reductions in transaction costs. This claim is illustrated on hand from examples of alternative forms of organization in Germany and Italy.

Business cycle asymmentries: An investment cost approach

In this paper, investment cost asymmetry is introduced in order to test wheter this kind of asymmetry can account for asymmetries in business cycles. By using a smooth transition function, asymmetric investment cost is modeled and introduced in a canonical RBC model. Simulations of the model with Perturbations Method (PM) are very close to simulations through Parameterized Expectations Algorithm (PEA), which allows the use of the former for the sake of time reduction and computational costs. Both symmetric and asymmetric models were simulated and compared. Deterministic and stochastic impulse-response excersices revealed that it is possible to adequately reproduce asymmetric business cycles by modeling asymmetric investment costs. Simulations also showed that higher order moments are insu_cient to detect asymmetries. Instead, methods such as Generalized Impulse Response Analysis (GIRA) and Nonlinear Econometrics prove to be more e_cient diagnostic tools.

The impact of a minimum pension on old age poverty and its budgetary cost. Evidence from Latin America

This paper examines the impact on old age poverty and the fiscal cost of universal minimum oldage pensions in Latin America using recent household survey data for 18 countries. Alleviatingold age poverty requires different approach from other age groups and a minimum pension islikely to be the only alternative available. First we measure old age poverty rates for all countries.Second we discuss the design of minimum pensions schemes, means-tested or not, as wellas the disincentive effects that they are expected to have on the economic and social behavior ofhouseholds including labor supply, saving and family solidarity. Third we use the household surveysto simulate the fiscal cost and the impact on poverty rates of alternative minimum pensionschemes in the 18 countries. We show that a universal minimum pension would substantiallyreduce poverty among the elderly except in Argentina, Brazil, Chile and Uruguay where minimumpension systems already exist and poverty rates are low. Such schemes have much tobe commended in terms of incentives, spillover effects and administrative simplicity but have ahigh fiscal cost. The latter is a function of the age at which benefits are awarded, the prevailinglongevity, the generosity of benefits, the efficacy of means testing, and naturally the fiscal capacityof the country.

Bilateral Transport Cost, Infrastructure, Common Bilateral Ties and Political Stability.

Los costos de transporte son una de las más importantes fuentes de barreras al comercio. Inspirados por este aspecto, utilizamos un modelo empírico ad-hoc con el fin de examinar los posibles determinantes de los costos de transporte. Utilizando una base de datos de costos de transporte bilaterales para el año 1990, replicamos el trabajo de Limao y Venables (2001) y encontramos que el efecto de su ´índice de infraestructura sobre los costos de transporte no es robusto. Siguiendo a Micco (2004) y Micco y Serebrinzky (2005) calculamos dos ´índices alternativos de infraestructura. Utilizando estos ´índices encontramos que aparte de la distancia, la infraestructura, la estabilidad política, las relaciones bilaterales comunes y los acuerdos de cielos abiertos son otros importantes canales mediante los cuales los costos de transporte pueden reducirse.

Low cost eye tracking for human-machine interfacing

One of the main challenges for developers of new human-computer interfaces is to provide a more natural way of interacting with computer systems, avoiding excessive use of hand and finger movements. In this way, also a valuable alternative communication pathway is provided to people suffering from motor disabilities. This paper describes the construction of a low cost eye tracker using a fixed head setup. Therefore a webcam, laptop and an infrared lighting source were used together with a simple frame to fix the head of the user. Furthermore, detailed information on the various image processing techniques used for filtering the centre of the pupil and different methods to calculate the point of gaze are discussed. An overall accuracy of 1.5 degrees was obtained while keeping the hardware cost of the device below 100 euros.