Orthogonal space-time block coding over time-selective fading channels: a PIC detector for the Gi systems

All the orthogonal space-time block coding (O-STBC) schemes are based on the following assumption: the channel remains static over the entire length of the codeword. However, time selective fading channels do exist, and in many cases the conventional O-STBC detectors can suffer from a large error floor in the high signal-to-noise ratio (SNR) cases. This paper addresses such an issue by introducing a parallel interference cancellation (PIC) based detector for the Gi coded systems (i=3 and 4).

Space-time block coding for four transmit antennas over time-selective fading channels: orthogonal or non-orthogonal design?

The paper deals with an issue in space time block coding (STBC) design. It considers whether, over a time-selective channel, orthogonal STBC (O-STBC) or non-orthogonal STBC (NO-STBC) performs better. It is shown that, under time-selectiveness, once vehicle speed has risen above a certain value, NO-STBC always outperforms O-STBC across the whole SNR range. Also, considering that all existing NO-STBC schemes have been investigated under quasi-static channels only, a new simple receiver is derived for the NO-STBC system under time-selective channels.

One-shot near-far resistant CDMA detection in multipath fading channels-an O^3 BPSK based system

This paper applies O3BPSK (orthogonal on-off PSK) signaling scheme to multipath fading CDMA channels, for the purpose of near-far resistant detection in the reverse link. Based on the maximum multipath spreading delay, a minimum duration of “off” is suggested, with which the temporally adjacent bits (TABs) from different users at the receiver are decoupled. As a result, a Rake-type one-shot linear decorrelating detector (LDD) is obtained. Since no knowledge of echo amplitudes is needed, a blind detection can be realised.

Incorporation of lead into calcium carbonate granules secreted by earthworms living in lead contaminated soils

The influence of soil organisms on metal mobility and bioavailability in soils is not currently fully understood. We conducted experiments to determine whether calcium carbonate granules secreted by the earthworm Lumbricus terrestris could incorporate and immobilise lead in lead- and calcium- amended artificial soils. Soil lead concentrations were up to 2000 mg kg-1 and lead:calcium ratios by mass were 0.5-8. Average granule production rates of 0.39 + 0.04 mgcalcite earthworm-1 day-1 did not vary with soil lead concentration. The lead:calcium ratio in granules increased significantly with that of the soil (r2 = 0.81, p = 0.015) with lead concentrations in granules reaching 1577 mg kg-1. X-ray diffraction detected calcite and aragonite in the granules with indications that lead was incorporated into the calcite at the surface of the granules. In addition to the presence of calcite and aragonite X-ray absorption spectroscopy indicated that lead was present in the granules mainly as complexes sorbed to the surface but with traces of lead-bearing calcite and cerussite. The impact that lead-incorporation into earthworm calcite granules has on lead mobility at lead-contaminated sites will depend on the fraction of total soil lead that would be otherwise mobile.

Dissolution rates of earthworm-secreted calcium carbonate

The dissolution of CaCO3 granules secreted by earthworms in soil leaching columns was governed by soil pH and exchange sites available for Ca. Results indicate that granules could last for significant periods of time in soils and that, therefore, granules could be an important source of soil calcite.

Soil pH governs production rate of calcium carbonate secreted by the earthworm Lumbricus terrestris

Lumbricus terrestris earthworms exposed to 11 soils of contrasting properties produced, on average, 0.8 ± 0.1 mgCaCO3 earthworm−1 day−1 in the form of granules up to 2 mm in diameter. Production rate increased with soil pH (r2 = 0.68, p < 0.01). Earthworms could be a significant source of calcite in soils.

Production and dissolution rates of earthworm-secreted calcium carbonate

Earthworms secrete granules of calcium carbonate. These are potentially important in soil biogeochemical cycles and are routinely recorded in archaeological studies of Quaternary soils. Production rates of calcium carbonate granules by the earthworm Lumbricus terrestris L. were determined over 27 days in a range of soils with differing chemical properties (pH, organic matter content, water holding capacity, bulk composition, cation exchange capacity and exchangeable cations). Production rate varied between soils, lay in the range 0–0.043 mmolCaCO3 (0–4.3 mg) earthworm−1 d−1 with an average rate of 8 × 10−3 mmolCaCO3 (0.8 mg) earthworm−1 d−1 and was significantly correlated (r = 0.68, P ≤ 0.01) with soil pH. In a second experiment lasting 315 days earthworms repeatedly (over periods of 39–57 days) produced comparable masses of granules. Converting individual earthworm granule production rates into fluxes expressed on per hectare of land per year basis depends heavily on estimates of earthworm numbers. Using values of 10–20 L. terrestris m−2 suggests a rate of 18– 3139 molCaCO3 ha−1 yr−1. Data obtained from flow-through dissolution experiments suggest that at near neutral pH, granule geometric surface areanormalised dissolution rates are similar to those for other biogenic and inorganic calcium carbonate. Fits of the data to the dissolution relationship r = k(1 − ˝)n where r = dissolution rate, k = a rate constant, ˝ = relative saturation and n = the reaction order gave values of k = 1.72 × 10−10 mol cm−2 s−1 and n = 1.8 for the geometric surface area-normalised rates and k = 3.51 × 10−13 mol cm−2 s−1 and n = 1.8 for the BET surface area-normalised rates. In 196 day leaching column experiments trends in granule dissolution rate referenced to soil chemistry corresponded to predictions made by the SLIM model for dissolution of limestone in soil. If soil solution approaches saturation with respect to calcium carbonate granule dissolution will slow or even stop and granules be preserved indefinitely. Granules have the potential to be a small but significant component of the biogeochemical cycling of C and Ca in soil.

Effect of cutting time, temperature and calcium on curd moisture, whey fat loses and curd yield by response surface methodology

Response surface methodology was used to study the effect of temperature, cutting time, and calcium chloride addition level on curd moisture content, whey fat losses, and curd yield. Coagulation and syneresis were continuously monitored using 2 optical sensors detecting light backscatter. The effect of the factors on the sensors’ response was also examined. Retention of fat during cheese making was found to be a function of cutting time and temperature, whereas curd yield was found to be a function of those 2 factors and the level of calcium chloride addition. The main effect of temperature on curd moisture was to increase the rate at which whey was expelled. Temperature and calcium chloride addition level were also found to affect the light backscatter profile during coagulation whereas the light backscatter profile during syneresis was a function of temperature and cutting time. The results of this study suggest that there is an optimum firmness at which the gel should be cut to achieve maximum retention of fat and an optimum curd moisture content to maximize product yield and quality. It was determined that to maximize curd yield and quality, it is necessary to maximize firmness while avoiding rapid coarsening of the gel network and microsyneresis. These results could contribute to the optimization of the cheese-making process.