Effect of plasticizer viscosity on the sensitivity of an [RU(bpy)(3)(2+)(Ph4B-)(2)]-based optical oxygen sensor

The quenching of the electronically-excited, lumophoric state of [Ru(bpy)(3)(2+)(Ph4B-)(2)] by oxygen is studied in a wide variety of neat plasticizers. The Stern-Volmer constant, K-SV, is found to be inversely dependent upon the viscosity of the quenching medium, although the natural lifetime of the electronically excited state of [RU(bPY)(3)(2+)(Ph4B-)(2)] is largely independent of medium. The least viscous of the plasticizers tested, triethyl phosphate, did not, however, produce highly sensitive optical oxygen sensors when used to plasticize [RU(bPY)(3)(2+)(Ph4B-)(2)]-containing cellulose acetate butyrate (CAB) and poly(methyl methacrylate) (PMMA) films, Instead, the compatibility of the polymer-plasticizer combination, as measured by the difference in the values of the solubility parameter of the two, appears to be a major factor in determining the overall oxygen sensitivity of the thin plastic films. For highly compatible polymer-plasticizer combinations, the plasticizer with the lowest viscosity produces films of the highest oxygen sensitivity. This situation arises because in the film the quenching process is partly diffusion-controlled and, as a result, the quenching rate constant is inversely proportional to the effective viscosity of the reaction medium.

How Porosity and Permeability Vary Spatially With Grain Size, Sorting, Cement Volume, and Mineral Dissolution In Fluvial Triassic Sandstones: The Value of Geostatistics and Local Regression

Although it is well known that sandstone porosity and permeability are controlled by a range of parameters such as grain size and sorting, amount, type, and location of diagenetic cements, extent and type of compaction, and the generation of intergranular and intragranular secondary porosity, it is less constrained how these controlling parameters link up in rock volumes (within and between beds) and how they spatially interact to determine porosity and permeability. To address these unknowns, this study examined Triassic fluvial sandstone outcrops from the UK using field logging, probe permeametry of 200 points, and sampling at 100 points on a gridded rock surface. These field observations were supplemented by laser particle-size analysis, thin-section point-count analysis of primary and diagenetic mineralogy, quantitiative XRD mineral analysis, and SEM/EDAX analysis of all 100 samples. These data were analyzed using global regression, variography, kriging, conditional simulation, and geographically weighted regression to examine the spatial relationships between porosity and permeability and their potential controls. The results of bivariate analysis (global regression) of the entire outcrop dataset indicate only a weak correlation between both permeability porosity and their diagenetic and depositional controls and provide very limited information on the role of primary textural structures such as grain size and sorting. Subdividing the dataset further by bedding unit revealed details of more local controls on porosity and permeability. An alternative geostatistical approach combined with a local modelling technique (geographically weighted regression; GWR) subsequently was used to examine the spatial variability of porosity and permeability and their controls. The use of GWR does not require prior knowledge of divisions between bedding units, but the results from GWR broadly concur with results of regression analysis by bedding unit and provide much greater clarity of how porosity and permeability and their controls vary laterally and vertically. The close relationship between depositional lithofacies in each bed, diagenesis, and permeability, porosity demonstrates that each influences the other, and in turn how understanding of reservoir properties is enhanced by integration of paleoenvironmental reconstruction, stratigraphy, mineralogy, and geostatistics.

Theoretical and spatial limits to the value of rural environmental benefits: Evidence from the forestry sector

The valuation of environmental benefits has been well researched in the forestry sector. This is not generally the case in the agriculture sector although schemes to compensate farmers for provision of officially defined environmental benefits are already in place throughout the European Union. This paper draws on empirical findings from forestry and deductions from economic theory to challenge the notion of the universality of such benefits. Empirical findings from forestry suggest recreational use value is location specific rather than widely spread. Household utility theory predicts zero willingness to pay to maintain the status quo level of a previously unpaid for environmental benefit (when provision is not perceived as under risk) but a positive willingness to pay for an increase. Thus, non use values cannot be attributed to the major part of existing commercial forestry area but to spatially restricted schemes such as additional afforestation or preservation of ancient natural woodlands.

Transport Properties Investigation of Aqueous Protic Ionic Liquid Solutions through Conductivity, Viscosity, and NMR Self-Diffusion Measurements

We present a study on the transport properties through conductivity (s), viscosity (?), and self-diffusion coefficient (D) measurements of two pure protic ionic liquids—pyrrolidinium hydrogen sulfate, [Pyrr][HSO4], and pyrrolidinium trifluoroacetate, [Pyrr][CF3COO]—and their mixtures with water over the whole composition range at 298.15 K and atmospheric pressure. Based on these experimental results, transport mobilities of ions have been then investigated in each case through the Stokes–Einstein equation. From this, the proton conduction in these PILs follows a combination of Grotthuss and vehicle-type mechanisms, which depends also on the water composition in solution. In each case, the displacement of the NMR peak attributed to the labile proton on the pyrrolidinium cation with the PILs concentration in aqueous solution indicates that this proton is located between the cation and the anion for a water weight fraction lower than 8%. In other words, for such compositions, it appears that this labile proton is not solvated by water molecules. However, for higher water content, the labile protons are in solution as H3O+. This water weight fraction appears to be the solvation limit of the H+ ions by water molecules in these two PILs solutions. However, [Pyrr][HSO4] and [Pyrr][CF3COO] PILs present opposed comportment in aqueous solution. In the case of [Pyrr][CF3COO], ?, s, D, and the attractive potential, Epot, between ions indicate clearly that the diffusion of each ion is similar. In other words, these ions are tightly bound together as ion pairs, reflecting in fact the importance of the hydrophobicity of the trifluoroacetate anion, whereas, in the case of the [Pyrr][HSO4], the strong H-bond between the HSO4– anion and water promotes a drastic change in the viscosity of the aqueous solution, as well as on the conductivity which is up to 187 mS·cm–1 for water weight fraction close to 60% at 298 K.

Parenting advantage in the MNC: An embeddedness perspective on the value added by headquarters

What determines the value an MNC’s headquarters adds to its own affiliates? In this paper, we shed light on this question by linking the embeddedness view of the multinational corporation to the literature on parenting advantage. We test our hypotheses on an original dataset of 124 manufacturing subsidiaries located in Europe. Our results indicate that the external embeddedness of the MNC is an antecedent to headquarters’ value creation. We find that headquarters’ investments into their own relationships with the subsidiaries’ contexts are positively related to the value added by headquarters. Furthermore, this relationship is stronger when the subsidiary itself is strongly embedded. We discuss implications for the MNC literature, embeddedness research, and the literature on parenting and headquarters’ roles. Copyright © 2013 John Wiley & Sons, Ltd.

Defining a Research Agenda in Value Driven Design: Questions That Need to be Asked

Value driven design is an innovative design process that utilizes the optimization of a system level value function to determine the best possible design. This contrasts with more traditional systems engineering techniques, which rely on satisfying requirements to determine the design solution. While ‘design for value’ is intuitively acceptable, the transformation of value driven design concepts into practical tools and methods for its application is challenging. This, coupled with the growing popularity of value-centric design philosophies, has led to a proposed research agenda in value driven design. This research agenda asks fundamental questions about the design philosophy and attempts to identify areas of significant challenge. The research agenda is meant to stimulate discussion in the field, as well as prompt research that will lead to the development of tools and methodologies that will facilitate the application of value driven design and further the state of the art.

An Analytical Study of Surplus Value using a Value Driven Design Methodology

People are now becoming more environmentally aware and as a consequence of this, industries such as the aviation industry are striving to design more environmentally friendly products. To achieve this, the current design methodologies must be modified to ensure these issues are considered from product conception through to disposal. This paper discusses the environmental problems in relation to the aviation industry and highlights some logic for making the change from the traditional Systems Engineering approach to the recent design paradigm known as Value Driven Design. Preliminary studies have been undertaken to aid in the understanding of this methodology and the existing surplus value objective function. The main results from the work demonstrate that surplus value works well bringing disparate issues such as manufacture and green taxes together to aid decision making. Further, to date studies on surplus value have used simple sensitivity analysis, but deeper consideration shows non-linear interactions between some of the variables and further work will be needed to fully account for complex issues such as environmental impact and taxes.