979 resultados para Power demand curve
Resumo:
A preliminary study of the pharmacokinetic parameters of t-Butylaminoethyl disulfide was performed after administration of two different single doses (35 and 300 mg/kg) of either the cold or labelled drug. Plasma or blood samples were treated with dithiothreitol, perchloric acid, and, after filtration, submitted to further purification with anionic resein. In the final step, the drug was retained on a cationic resin column, eluted with NaCl 1M and detected according to the method of Ellman (1958). Alternatively, radioactive drug was detected by liquid scintillation counting. The results corresponding to the smaller dose of total drug suggested a pharmacokinetic behavior related to a one open compartment model with the following parameters: area under the intravenous curve (AUC i.v.):671 ± 14; AUC oral: 150 ± 40 µg.min. ml [raised to the power of -1]; elimination rate constant: 0.071 min [raised to the power of -1]; biological half life: 9.8 min; distribution volume: 0.74 ml/g. For the higher dose, the results seemed to obey a more complex undertermined model. Combining the results, the occurence of a dose-dependent pharmacokinetic behavior is suggested, the drug being rapidly absorbed and rapidly eliminated; the elimination process being related mainly to metabolization. The drug seems to be more toxic when administered I.V. because by this route it escapes first pass metabolism, while being quickly distributed to tissues. The maximum tolerated blood level seems to be around 16 µg/ml.
Resumo:
The World Health Organization (WHO) criteria for the diagnosis of osteoporosis are mainly applicable for dual X-ray absorptiometry (DXA) measurements at the spine and hip levels. There is a growing demand for cheaper devices, free of ionizing radiation such as promising quantitative ultrasound (QUS). In common with many other countries, QUS measurements are increasingly used in Switzerland without adequate clinical guidelines. The T-score approach developed for DXA cannot be applied to QUS, although well-conducted prospective studies have shown that ultrasound could be a valuable predictor of fracture risk. As a consequence, an expert committee named the Swiss Quality Assurance Project (SQAP, for which the main mission is the establishment of quality assurance procedures for DXA and QUS in Switzerland) was mandated by the Swiss Association Against Osteoporosis (ASCO) in 2000 to propose operational clinical recommendations for the use of QUS in the management of osteoporosis for two QUS devices sold in Switzerland. Device-specific weighted "T-score" based on the risk of osteoporotic hip fractures as well as on the prediction of DXA osteoporosis at the hip, according to the WHO definition of osteoporosis, were calculated for the Achilles (Lunar, General Electric, Madison, Wis.) and Sahara (Hologic, Waltham, Mass.) ultrasound devices. Several studies (totaling a few thousand subjects) were used to calculate age-adjusted odd ratios (OR) and area under the receiver operating curve (AUC) for the prediction of osteoporotic fracture (taking into account a weighting score depending on the design of the study involved in the calculation). The ORs were 2.4 (1.9-3.2) and AUC 0.72 (0.66-0.77), respectively, for the Achilles, and 2.3 (1.7-3.1) and 0.75 (0.68-0.82), respectively, for the Sahara device. To translate risk estimates into thresholds for clinical application, 90% sensitivity was used to define low fracture and low osteoporosis risk, and a specificity of 80% was used to define subjects as being at high risk of fracture or having osteoporosis at the hip. From the combination of the fracture model with the hip DXA osteoporotic model, we found a T-score threshold of -1.2 and -2.5 for the stiffness (Achilles) determining, respectively, the low- and high-risk subjects. Similarly, we found a T-score at -1.0 and -2.2 for the QUI index (Sahara). Then a screening strategy combining QUS, DXA, and clinical factors for the identification of women needing treatment was proposed. The application of this approach will help to minimize the inappropriate use of QUS from which the whole field currently suffers.
Resumo:
In previous work we have applied the environmental multi-region input-output (MRIO) method proposed by Turner et al (2007) to examine the ‘CO2 trade balance’ between Scotland and the Rest of the UK. In McGregor et al (2008) we construct an interregional economy-environment input-output (IO) and social accounting matrix (SAM) framework that allows us to investigate methods of attributing responsibility for pollution generation in the UK at the regional level. This facilitates analysis of the nature and significance of environmental spillovers and the existence of an environmental ‘trade balance’ between regions. While the existence of significant data problems mean that the quantitative results of this study should be regarded as provisional, we argue that the use of such a framework allows us to begin to consider questions such as the extent to which a devolved authority like the Scottish Parliament can and should be responsible for contributing to national targets for reductions in emissions levels (e.g. the UK commitment to the Kyoto Protocol) when it is limited in the way it can control emissions, particularly with respect to changes in demand elsewhere in the UK. However, while such analysis is useful in terms of accounting for pollution flows in the single time period that the accounts relate to, it is limited when the focus is on modelling the impacts of any marginal change in activity. This is because a conventional demand-driven IO model assumes an entirely passive supply-side in the economy (i.e. all supply is infinitely elastic) and is further restricted by the assumption of universal Leontief (fixed proportions) technology implied by the use of the A and multiplier matrices. In this paper we argue that where analysis of marginal changes in activity is required, a more flexible interregional computable general equilibrium approach that models behavioural relationships in a more realistic and theory-consistent manner, is more appropriate and informative. To illustrate our analysis, we compare the results of introducing a positive demand stimulus in the UK economy using both IO and CGE interregional models of Scotland and the rest of the UK. In the case of the latter, we demonstrate how more theory consistent modelling of both demand and supply side behaviour at the regional and national levels affect model results, including the impact on the interregional CO2 ‘trade balance’.
Resumo:
We analyse risk-taking behaviour of banks in the context of spatial competition. Banks mobilise unsecured deposits by offering deposit rates, which they invest either in a prudent or a gambling asset. Limited liability along with high return of a successful gamble induce moral hazard at the bank level. We show that when the market power is low, banks invest in the gambling asset. On the other hand, for sufficiently high levels of market power, all banks choose the prudent asset to invest in. We further show that a merger of two neighboring banks increases the likelihood of prudent behaviour. Finally, introduction of a deposit insurance scheme exacerbates banks’ moral hazard problem.
Resumo:
This paper develops a theoretical model for the demand of alcohol where intensity and frequency of consumption are separate choices made by individuals in order to maximize their utility. While distinguishing between intensity and frequency of consumption may be unimportant for many goods, this is clearly not the case with alcohol where the likelihood of harm depends not only on the total consumed but also on the pattern of use. The results from the theoretical model are applied to data from rural Australia in order to investigate the factors that affect the patterns of alcohol use for this population group. This research can play an important role in informing policies by identifying those factors which influence preferences for patterns of risky alcohol use and those groups and communities who are most at risk of harm.
Resumo:
Neurally adjusted ventilatory assist (NAVA) is a ventilation assist mode that delivers pressure in proportionality to electrical activity of the diaphragm (Eadi). Compared to pressure support ventilation (PS), it improves patient-ventilator synchrony and should allow a better expression of patient's intrinsic respiratory variability. We hypothesize that NAVA provides better matching in ventilator tidal volume (Vt) to patients inspiratory demand. 22 patients with acute respiratory failure, ventilated with PS were included in the study. A comparative study was carried out between PS and NAVA, with NAVA gain ensuring the same peak airway pressure as PS. Robust coefficients of variation (CVR) for Eadi and Vt were compared for each mode. The integral of Eadi (ʃEadi) was used to represent patient's inspiratory demand. To evaluate tidal volume and patient's demand matching, Range90 = 5-95 % range of the Vt/ʃEadi ratio was calculated, to normalize and compare differences in demand within and between patients and modes. In this study, peak Eadi and ʃEadi are correlated with median correlation of coefficients, R > 0.95. Median ʃEadi, Vt, neural inspiratory time (Ti_ ( Neural )), inspiratory time (Ti) and peak inspiratory pressure (PIP) were similar in PS and NAVA. However, it was found that individual patients have higher or smaller ʃEadi, Vt, Ti_ ( Neural ), Ti and PIP. CVR analysis showed greater Vt variability for NAVA (p < 0.005). Range90 was lower for NAVA than PS for 21 of 22 patients. NAVA provided better matching of Vt to ʃEadi for 21 of 22 patients, and provided greater variability Vt. These results were achieved regardless of differences in ventilatory demand (Eadi) between patients and modes.
Resumo:
The research reported here is an output of Karen Turner’s ESRC Climate Change Leadership Fellow project (Grant reference RES-066-27-0029). However, this research builds on previous work funded by the ESRC on modelling the economic and environmental impacts of technological improvement (Grant reference: RES-061-25-0010) and by the EPSRC through the SuperGen Marine Energy Research Consortium on accounting for and modeling environmental indicators (Grant reference: EP/E040136/1).
Resumo:
This paper develops stochastic search variable selection (SSVS) for zero-inflated count models which are commonly used in health economics. This allows for either model averaging or model selection in situations with many potential regressors. The proposed techniques are applied to a data set from Germany considering the demand for health care. A package for the free statistical software environment R is provided.
Resumo:
We present a unique empirical analysis of the properties of the New Keynesian Phillips Curve using an international dataset of aggregate and disaggregate sectoral in ation. Our results from panel time-series estimation clearly indicate that sectoral heterogeneity has important consequences for aggregate in ation behaviour. Heterogeneity helps to explain the overestimation of in ation persistence and underestimation of the role of marginal costs in empirical investigations of the NKPC that use aggregate data. We nd that combining disaggregate information with heterogeneous-consistent estimation techniques helps to reconcile, to a large extent, the NKPC with the data.
Resumo:
The revival of support for a living wage has reopened a long-run debate over the extent to which active regulation of labour markets may be necessary to attain desired outcomes. Market failure is suggested to result in lower wages and remuneration for low skilled workers than might otherwise be expected from models of perfect competition. This paper examines the theoretical underpinning of living wage campaigns and demonstrates that once we move away from idealised models of perfect competition to one where employers retain power over the bargaining process, such as monopsony, it is readily understandable that low wages may be endemic in low skilled employment contracts. The paper then examines evidence, derived from the UK Quarterly Labour Force Survey, for the extent to which a living wage will address low pay within the labour force. We highlight the greater incidence of low pay within the private sector and then focus upon the public sector where the Living Wage demand has had most impact. We examine the extent to which addressing low pay within the public sector increases costs. We further highlight the evidence that a predominance of low pay exists among public sector young and women workers (and in particular lone parent women workers) but not, perhaps surprisingly, among workers from ethnic minority backgrounds. The paper then builds upon the results from the Quarterly Labour Force Survey with analysis of the British Household Panel Survey in order to examine the impact the introduction of a living wage, within the public sector, would have in reducing household inequality. The paper concludes that a living wage is indeed an appropriate regulatory response to market failure for low skilled workers and can act to reduce age and gender pay inequality, and reduce household income inequality among in-work households below average earnings.
Resumo:
John Hardman Moore outlines his joint research with Oliver Hart, looking at the economics of power and control and the foundations of contractual incompleteness
Resumo:
UK regional policy has been advocated as a means of reducing regional disparities and stimulating national growth. However, there is limited understanding of the interregional and national effects of such a policy. This paper uses an interregional computable general equilibrium model to identify the national impact of a policy-induced regional demand shock under alternative labour market closures. Our simulation results suggest that regional policy operating solely on the demand side has significant national impacts. Furthermore, the effects on the non-target region are particularly sensitive to the treatment of the regional labour market.
Resumo:
Within a two-country model of international trade in which heterogeneous firms face firm-specific unions, we study the effects of different forms of trade liberalisation on market structure and competitive selection in the presence of inter-country asymmetries in size and labour market institutions. For given levels of trade openness, an increase in a country’s relative unions’ strength reduces the average productivity of its domestic producers but increases that of its exporters. Whilst an unfavourable union power differential, by increasing wages, weakens a country’s firms’ competitive position, the higher wages reinforce standard market access mechanisms to give rise to aggregate income effects. When the initial levels of trade openness are sufficiently low, this ‘expansionary’ aggregate effect can attract industry in the country with stronger unions and also result in an increase in the extensive margin of exports. For sufficiently large inter-country differences in the bargaining power of unions, trade liberalization can then result in a pro-variety effect, with an increase in the total availability of varieties to consumers in both countries, regardless of there being inter-country differences in size.
Resumo:
Illegal hunting for bushmeat is regarded as an important cause of biodiversity decline in Africa. We use a stated preferences method to obtain information on determinants of demand for bushmeat in villages around the Serengeti National Park, Tanzania. We estimate the effects of changes in the own price of bushmeat and in the prices of two substitute protein sources – fish and chicken. Promoting the availability of protein substitutes at lower prices would be effective at reducing pressures on wildlife. Supply-side measures that raise the price of bushmeat would also be effective.