Alterações físico-químicas dos óleos de girassol, milho e soja em frituras

The aim of this study is to determine the influence of frying time on the alterations of sunflower, corn and soybean oils during deep fat frying of potato chips. The analytical methods used to evaluate the oil alterations are: free fatty acids, peroxide value, refractive index and total polar compounds. An increase of free fatty acids, refractive index and total polar compounds with frying time were observed. The different behaviors observed for the three vegetables oils can be explained by the differences in the initial composition and quality of them.

The effect of microfibrillated cellulose addition on drying shrinkage and dimensional stability of wood-free paper

Microfibrillated cellulose (MFC) is known to enhance strength properties of paper. Improved strength usually means increased bonding which is strongly connected to dimensional instability of paper. Dimensional instability is due to changes in moisture content of paper; when paper is moistened it expands and when dried, it shrinks. Hygroexpansion is linked to end-use problems and excessive drying shrinkage consumes strength potential. Effective use of materials requires controlling of these phenomena. There isn’t yet data concerning dimensional stability of papers containing MFC which restricts wider use of MFC. Main objective of the work was to evaluate dimensional stability of wood-free paper containing different amounts of MFC. Sheets were dried with different methods to see how drying strains effected on drying shrinkage and hygroexpansion. Also tensile strength was measured to find out the effect of MFC. Results were compared to sheets containing kraft fines and in some test points cationic starch was used alongside with MFC. MFC increased the dimensional instability of freely dried sheets. As the amounts of MFC increased the effects on dimensional stability became more severe. However the fineness of MFC didn’t play any important role. Both hygroexpansion and drying shrinkage were decreased with cationic starch addition. Prevention of drying shrinkage over powered the effects of additives on hygroexpansion. Tensile strength improved up till 7 % addition amount which could be set as the upper limit of MFC addition when paper preparation and tensile strength are concerned.

Physicochemical composition of pure and adulterated royal jelly

The physicochemical composition of pure royal jelly as well as of some adulterated samples was analyzed by determining moisture, ash, lipids, nitrogen/proteins, carbohydrates, starch and 10- HDA (10-hydroxy-2-decenoic acid). The solubility in alkaline medium was used to detect the main frauds for adulterating royal jelly which comprise addition of yogurt, water, egg white, sweet condensed milk mixed with propolis, unripe banana and corn starch slurry.

Método titrimétrico para determinar fosfito em amostras agroindustriais

A new titrimetric method for the determination of phosphite in fertilizer samples, based on reaction of H3PO3 with standard iodine solution in neutral media, is proposed. Diluted samples containing ca. 0.4% m/v P2O5 are heated and titrated with 0.05 mol L-1 iodine standard until the solution becomes faint yellow. Back titration is also feasible: a slight excess of titrant is added followed by starch indicator and titration is completed taking as the end point the change in color from blue to colorless. The influence of chemical composition and pH of buffers, temperature and foreign species on waiting time and end-point detection were investigated. For the Na2HPO4/NaH2PO4 buffer (pH 6.8) at 70 °C, the titration time was 10 min, corresponding to about 127 mg iodine, 200 mg KI and 174 mg Na2HPO4 and 176 mg NaH2PO4 consumed per determination. Accuracy was checked for phosphite determination in seven fertilizer samples. Results obtained by the proposed procedure were in agreement with those obtained by spectrophotometry at 95% confidence level. The R.S.D. (n=10) for direct and back titration was 0.4% and 1.3% respectively.

LS-SVM: uma nova ferramenta quimiométrica para regressão multivariada. Comparação de modelos de regressão LS-SVM e PLS na quantificação de adulterantes em leite em pó empregando NIR

Least-squares support vector machines (LS-SVM) were used as an alternative multivariate calibration method for the simultaneous quantification of some common adulterants found in powdered milk samples, using near-infrared spectroscopy. Excellent models were built using LS-SVM for determining R², RMSECV and RMSEP values. LS-SVMs show superior performance for quantifying starch, whey and sucrose in powdered milk samples in relation to PLSR. This study shows that it is possible to determine precisely the amount of one and two common adulterants simultaneously in powdered milk samples using LS-SVM and NIR spectra.

Estudo sobre a adsorção do fluido de perfuração salgado contendo polímeros sobre SiO2

Polysaccharide-based drilling fluids have been often applied in horizontal wells of petroleum reservoirs in Campos, Rio de Janeiro. The present study aimed to understand the mechanism of adsorption and desorption of the drill-in fluid, xanthan, modified starch and lubricant on SiO2 by means of ellipsometry. The effect of pH and brine on the mean thickness (D) of adsorbed layer was systematically investigated. The adsorption was mainly favored under alkaline conditions. A model has been proposed to explain this effect. The adsorption isotherms determined separately for xanthan and starch on SiO2 surfaces could be fitted with the Langmuir model, which yielded similar adsorption constant values.

Estudo das propriedades e biodegradabilidade de blendas de poliéster/amido submetidas ao ataque microbiano

This work deals with the biodegradation of blends of poly(beta-hydroxybutyrate)/starch and poly(beta-hydroxybutyrate-co-hydroxyvalerate)/starch. The blends were obtained by evaporation of the solvent in the mixture of the polymers in chloroform. Tests were carried out in presence of micro-organisms which acted as biodegradation agents. The blends were consumed as carbon substrate and the production of CO2 was evaluated in the process. In addition, the polyesters' mechanical properties were reduced by the incorporation of starch in its structure. (¹H) NMR and infrared spectroscopy detected some characteristic polyester degradation groups in the polyesters' chemical structure, thus confirming the alteration suffered by it.

Modificação química e física do amido de quirera de arroz para aproveitamento na indústria de alimentos

The study evaluated the efficiency of chemical (phosphorylation) and physical (extrusion) modifications of the starch of broken rice. Results demonstrated a reduction in the moisture content of extruded and phosphorylated broken rice and an increase in the ash content of phosphorylated broken rice. Both phosphorylation and extrusion increased cold water binding capacity, swelling power, and solubility. Extruded and phosphorylated pastes were stable under refrigeration, but only extruded paste was stable when submitted to freezing. Phosphorylated paste had the lowest viscosity and the highest stability during heating, while the extruded one gelatinized without heating, but had higher losses during heating.

Produção de etanol a partir de torta de mamona (Ricinus communis L.) e avaliação da letalidade da torta hidrolisada para camundongos

The castor bean cake is rich in starch (48 ± 0.53%) and bears a problem linked to the occurrence of a toxic protein (ricin). The chemical hydrolysis (ratio solid:liquid = 1:6; H2SO4= 0.1 mol L-1; 120 °C; 40 min) generated a medium with 27 g L-1 of reducing sugars (hydrolysis efficiency= 32%). The hydrolyzed product was fermented and produced 11 g L-1 of ethanol (volumetric productivity=1.38 g L-1 h-1 and ethanol yield on substrate consumed=0.45 g g-1). In vivo experiments (DL50) revealed a reduction of roughly 240 times in the CBC toxicity (2.11 µg g-1).

Produção, purificação e aumento da performance de ciclodextrina glicosiltransferases para produção de ciclodextrinas

Biospecific affinity chromatography was used to purify three cyclodextrin glycosyl transferases (CGTases) obtained from microorganisms isolated of soil. The cyclodextrins (CDs) production by CGTases was evaluated using starches from different sources. CDs were measured through the Complexation Theory and by HPLC. CGTase from Bacillus firmus strain 7B showed the best production (30 mmol/L of β-CD and 4.3 mmol/L of γ-CD), and its cultivation conditions were optimized. The maximum enzymatic activity was achieved using lung peptone, soluble starch and agitation speed of 160 rpm. Studied CGTases were shown quite interesting for the industrial production of CDs.

Modificação enzimática da farinha de arroz visando a produção de amido resistente

The aim of this work was to study the enzymatic modification on rice flour using lipase pancreatic and amyloglucosidase to obtain resistant starch. For this, Response Surface Methodology (RSM) was used to determine the best operating conditions for each enzyme. For lypase pancreatic, the highest value for resistant starch (45%) was achieved within 2 h reaction at pH 7 using an enzyme/substrate ratio of 4% (w/w) and Dp= 100/200 tyler. For amyloglucosidase, optima conditions corresponded to an enzyme/substrate ratio of 0,006 mL/g and Dp= 100/200 tyler at 45 ºC, yielding 57% of resistant starch in 2 h reaction. These results show the potential of using both enzymes to modified rice flour, increasing the resistant starch in about 5.7 folds in relation to the flour without treatment (resistant starch=10.6%).

Produção de poli(3-hidroxibutirato) por Cupriavidus Necator em meio hidrolisado de amido de arroz com suplementação de óleo de soja em diferentes temperaturas

Poly (3-hydroxybutyrate) (P(3HB)) is a biopolymer, completely biodegradable, which has similar properties to fuel-based polymers. However to make it economically competitive it is necessary the study of cheap sources of substrate. The influence of hydrolyzed rice starch supplemented with soybean oil at different temperatures (30, 35 and 40 °C) was studied in the production of P(3HB) by C. necator. The percentage of P(3HB) produced in the cultures at 30, 35 °C was 30, 39% and 35, 43% without and with supplementation of oil, respectively. The culture at 40 °C showed no production phase due to a possible oxygen limitation. These results demonstrate that hydrolyzed rice starch supplemented with soybean oil increases the yield of P(3HB) and temperature of 35 ºC is the most favorable for biopolymer production.

Poliuretanos elastoméricos obtenidos a partir de aceite de ricino y almidón de yuca original y modificado con anhídrido propiónico: síntesis, propiedades fisicoquímicas y fisicomecánicas

Chemical modification of cassava starch was conducted through an acylation reaction by using pyridine and propionic anhydride to replace the functional groups of starch. Polyurethane elastomers were prepared using suspensions of the mixture obtained from castor oil and yucca starch that was modified by a propionic anhydride reaction. The suspensions were characterized by means of tests based on The Fourier Transform Infrared Spectroscopy and the Hydroxyl Index. The castor oil-AMP suspensions were used for the PU synthesis. The PUs were characterized by their physical-mechanical properties like tension- deformation and Shore A. hardness, thermal gravimetric analysis and swelling test. The density cross-linking of from swelling tests was determined by applying the Flory-Rehner equation.

Filmes de amidos de mandioca modificados para recobrimento e conservação de uvas

In this article, films were produced with six types of cassava's starch mixed with gelatin and plasticized with sorbitol. These films were used in covering of grapes 'Benitaka' (Vitis vinifera L.) as biodegradable packaging. The acetylated starch film showed the best results in solubility, thickness and homogeneity, besides the less water loss the fruit, resulting in better coverage, increasing the shelf life fruits in 12 days. These results demonstrate the great potential of using films in food conservation, adding value to agricultural activity and helping to reduce non-biodegradable plastics in the environment.