Effect of laser surface treatment on microstructure and properties of MRI 230D Mg alloy

A creep resistant Mg alloy MRI 230D was subjected to laser surface treatment using Nd:YAG laser equipped with a fiber optics beam delivery system in argon atmosphere. The laser surface treatment produced a fine dendritic microstructure and this treatment was beneficial for the corrosion and wear resistance of the alloy. Long-term linear polarisation resistance and Electrochemical Impedance Spectroscopy measurements confirmed that the polarisation resistance values of laser treated material were twice as high as that for the untreated material. This improved behaviour was due to the finer and more homogenous microstructure of the laser treated surface. The laser treatment also increased surface hardness two times and reduced the wear rate by 25% due to grain refinement and solid solution strengthening.

Low-frequency resistance fluctuations in metal films under current stressing at low temperature (T<0.3Tmelting)

In this paper, we report a systematic study of low frequency 1∕fα resistance fluctuation in thin metal films (Ag on Si) at different stages of damage process when the film is subjected to high current stressing. The resistance fluctuation (noise) measurement was carried out in situ using a small ac bias that has been mixed with the dc stressing current. The experiment has been carried out as a function of temperature in the range of 150–350 K. The experiment establishes that the current stressed film, as it undergoes damage due to various migration forces, develops an additional low-frequency noise spectral power that does not have the usual 1∕f spectral shape. The magnitude of extra term has an activated temperature dependence (activation energy of ≈0.1 eV) and has a 1∕f1.5 spectral dependence. The activation energy is the same as seen from the temperature dependence of the lifetime of the film. The extra 1∕f1.5 spectral power changes the spectral shape of the noise power as the damage process progress. The extra term likely arising from diffusion starts in the early stage of the migration process during current stressing and is noticeable much before any change can be detected in simultaneous resistance measurements. The experiment carried out over a large temperature range establish a strong correlation between the evolution of the migration process in a current stressed film and the low-frequency noise component that is not a 1∕f noise.

Impact resistance and evaluation of retained strength on geotextiles

Over the last few decades, geotextiles have progressively been incorporated into geotechnical applications, especially in the field of coastal engineering. Geotextile materials often act as separator and a filter layer between rocks laid above and subgrade beneath. This versatile material has gradually substituted traditional granular materials because of its ease of installation, consistent quality and labour costefficiency. However, geotextiles often suffer damage during installation due to high dynamic bulk loading of rock placement. This can degrade geotextiles' mechanical strength. The properties considered in this paper include the impact resistance and retained strength of geotextiles. In general, the greater the impact energy applied to geotextiles, the greater the potential for damage. Results highlight the inadequacy of using index derived values as an indicator to determine geotextile performance on site because test results shows that geotextiles (staple fibre (SF) and continuous filament (CF)) with better mechanical properties did not outperform lower mechanical strength materials. The toughest CF product with a CBR index value of 9696N shows inferior impact resistance compared to SF product with the least CBR strength (2719N) given the same impact energy of 9.02 kJ. Test results also indicated that the reduction of strength for CF materials were much greater (between 20 and 50%) compared to SF materials (between 0 and 5%) when subjected to the same impact energy of 4.52 kJ.

Inflammatory meditated mechanisms of cisplatin resistance in non-small cell lung cancer

The majority of non-small cell lung cancer (NSCLC) patients present with advanced stage disease, where chemotherapy is usually the most common treatment option. While somewhat effective, patients treated with cisplatin-based chemotherapy will eventually develop resistance. Multiple pathways have been implicated in chemo-resistance, however the critical underlying mechanisms have yet to be elucidated. The aim of this project is to determine the role of inflammatory mediators in cisplatin resistance.

The emerging role of microRNAs in resistance to lung cancer treatments

One of the major challenges in the treatment of lung cancer is the development of drug resistance. This represents a major obstacle in the treatment of patients, limiting the efficacy of both conventional chemotherapy and biological therapies. Deciphering the mechanisms of resistance is critical to further understanding the multifactorial pathways involved, and in developing more specific targeted treatments. To date, numerous studies have reported the potential role of microRNAs (miRNAs) in resistance to various cancer treatments. MicroRNAs are a family of small non-coding RNAs that regulate gene expression by sequence-specific targeting of mRNAs causing translational repression or mRNA degradation. More than 1200 validated human miRNAs have been identified to date. While as little as one miRNA can regulate hundreds of targets, a single target can also be affected by multiple miRNAs. Evidence suggests that dysregulation of specific miRNAs may be involved in the acquisition of resistance to a number of cancer treatments, thereby modulating the sensitivity of cancer cells to such therapies. Therefore, targeting miRNAs may be an attractive strategy for developing novel and more effective individualized therapies, improving drug efficiency, and for predicting patient response to different treatments. In this review, we provide an overview on the role of miRNAs in resistance to current lung cancer therapies and novel biological agents.

Lung cancer stem cells: The root of resistance

In the absence of specific treatable mutations, platinum-based chemotherapy remains the gold standard of treatment for lung cancer patients. However, 5-year survival rates remain poor due to the development of resistance and eventual relapse. Resistance to conventional cytotoxic therapies presents a significant clinical challenge in the treatment of this disease. The cancer stem cell (CSC) hypothesis suggests that tumors are arranged in a hierarchical structure, with the presence of a small subset of stem-like cells that are responsible for tumor initiation and growth. This CSC population has a number of key properties such as the ability to asymmetrically divide, differentiate and self-renew, in addition to having increased intrinsic resistance to therapy. While cytotoxic chemotherapy kills the bulk of tumor cells, CSCs are spared and have the ability to recapitulate the heterogenic tumor mass. The identification of lung CSCs and their role in tumor biology and treatment resistance may lead to innovative targeted therapies that may ultimately improve clinical outcomes in lung cancer patients. This review will focus on lung CSC markers, their role in resistance and their relevance as targets for future therapies.

Single and multi-step phase transformation in CuZr nanowire under compressive/tensile loading

A novel stress induced martenistic phase transformation is reported in an initial B2-CuZr nanowire of cross-sectional dimensions in the range of 19.44 x 19.44-38.88 x 38.88 angstrom(2) and temperature in the range of 10-400 K under both tensile and compressive loading. Extensive Molecular Dynamic simulations are performed using an inter-atomic potential of type Finnis and Sinclair. The nanowire shows a phase transformation from an initial B2 phase to BCT (body-centered-tetragonal) phase with failure strain of similar to 40% in tension, whereas in compression, comparatively a small B2 -> BCT phase transformation is observed with failure strain of similar to 25%. Size and temperature dependent deformation mechanisms which control ultimately the B2 -> BCT phase transformation are found to be completely different for tensile and compressive loadings. Under tensile loading, small cross-sectional nanowire shows a single step phase transformation, i.e. B2 -> BCT via twinning along {100} plane, whereas nanowires with larger cross-sectional area show a two step phase transformation, i.e. B2 -> R phase -> BCT along with intermediate hardening. In the first step, nanowire shows phase transformation from B2 -> R phase via twinning along {100} plane, afterwards the nanowire deforms via twinning along {110} plane which cause further transformation from R phase -> BCT phase. Under compressive loading, the nanowire shows crushing along {100} plane after a single step phase transformation from B2 -> BCT. Proper tailoring of such size and temperature dependent phase transformation can be useful in designing nanowire for high strength applications with corrosion and fatigue resistance. (C) 2009 Elsevier Ltd. All rights reserved.

Resistance responses blocking systemic movement of Potato virus A in potato

Peruna kestää A-virusta estämällä sen leviämistä Peruna on maissin ohella maailman kolmanneksi tärkein ravintokasvi vehnän ja riisin jälkeen. Perunaa lisätään kasvullisesti mukuloita istuttamalla, jolloin virukset siirtyvät sairaiden siemenmukuloiden välityksellä kasvukaudesta toiseen. Virustauteja voi torjua ainoastaan terveen siemenperunan ja kestävien lajikkeiden avulla. Kestävyys perustuu usein siihen, että kasvi estää viruksen leviämisen tartuntakohdasta välttyäkseen virustaudilta. Tässä työssä tutkittiin kolmea perunan A-viruksen (PVA) liikkumista estävää kestävyysmekanismia perunassa. Lisäksi työn kokeelliseen osaan oleellisesti kuuluvaa virustartutusta varten kehitettiin uusi paranneltu versio geenipyssystä. Tämä itse rakennettu laite optimoitiin PVA:n tartuttamiseen mahdollisimman helposti ja pienin käyttökustannuksin. Tutkimuksen kohteena olleessa perunan risteytysjälkeläistössä oli PVA:ta kestäviä kasveja (ryhmä nnr), jotka estivät viruksen liikkumisen aiheuttamatta oireita tartutuskohdassa, sekä kasveja, joissa PVA aiheutti kuolioläikkinä näkyvän yliherkkyysvasteen (ryhmä HR). Molemmissa kestävyystyypeissä virus pystyi monistumaan ja leviämään solusta soluun paikallisesti, mutta liikkuminen muihin kasvinosiin nilan kautta estyi. Ryhmän nnr kasveissa PVA-tartunta ei aiheuttanut tilastollisesti merkitsevää muutosta useimpien geenien ilmenemiseen tartuntakohdassa. Ainoastaan geeniperhe, joka ilmentää tiettyä proteinaasi-inhibiittoria (PI), reagoi PVA:han 24 tuntia tartutuksesta. Kun tämän PVA:han reagoivan geeniperheen jäsenet hiljennettiin nnr- perunalinjoissa, ne muuttuivat alttiiksi PVA:lle ja virus levisi tartuntakohdasta muihin kasvinosiin. Tulos osoittaa, että PI on viruskestävyystekijä. Lisäksi muut tutkimuksessa saadut tulokset tukevat mahdollisuutta, että PI estää PVA:n P1-proteinaasin toimintaa. HR-linjoissa todettiin erilaisiin puolustusvasteisiin liittyvien PR-geenien aktivoitumista PVA-tartunnan seurauksena, mutta myös ilman sitä kasvien kasvettua mullassa noin neljä viikkoa. Sen sijaan solukkoviljelyssä tai vasta kaksi viikkoa mullassa kasvaneissa kasveissa vastaavaa ei vielä todettu. Tulos viittaa siihen, että HR-perunat reagoivat herkemmin ympäristöön ja/tai kasvin kehitysasteeseen laukaisten puolustusvasteita, jotka saattavat parantaa kestävyyttä taudinaiheuttajia vastaan. Kolmas tutkittu kestävyystyyppi havaittiin Pito-perunalajikkeessa. Se muistutti nnr-kestävyyttä siten, että myös siinä viruksen liikkuminen nilassa muihin kasvinosiin estyi. PVA:n todettiin pysähtyvän vasta lehtiruodin tyvelle muodostuvaan irtoamisvyöhykkeeseen, mitä havainnollistettiin käyttämällä muunnettua PVA-rotua, joka tuotti UV-valossa fluoresoivaa vihreää valoa. Tulos viittaa siihen, että virus ei pääse kulkemaan vyöhykkeeseen kuuluvan suojaavan kerroksen läpi, jollei sillä ole pääsyä nilaan. Tällainen kestävyys on tarpeen, jotta virus ei voi korvata nilakuljetusta solusta soluun leviämisellä. Tulokset tuovat uusia näkökulmia kasvien viruskestävyyteen ja auttavat selittämään viruksen nilakuljetuksen estymistä sekä solusta soluun leviämisen pysähtymistä kestävissä kasveissa.

Molecular Basis for the Role of Staphylococcus aureus Penicillin Binding Protein 4 in Antimicrobial Resistance

Penicillin binding proteins (PBPs) are membrane-associated proteins that catalyze the final step of murein biosynthesis. These proteins function as either transpeptidases or carboxypeptidases and in a few cases demonstrate transglycosylase activity. Both transpeptidase and carboxypeptidase activities of PBPs occur at the D-Ala-D-Ala terminus of a murein precursor containing a disaccharide pentapeptide comprising N-acetyl-glucosamine and N-acetyl-muramic acid-L-Ala-D-Glu-L-Lys-D-Ala-D-Ala. beta-Lactam antibiotics inhibit these enzymes by competing with the pentapeptide precursor for binding to the active site of the enzyme. Here we describe the crystal structure, biochemical characteristics, and expression profile of PBP4, a low-molecular-mass PBP from Staphylococcus aureus strain COL. The crystal structures of PBP4-antibiotic complexes reported here were determined by molecular replacement, using the atomic coordinates deposited by the New York Structural Genomics Consortium. While the pbp4 gene is not essential for the viability of S. aureus, the knockout phenotype of this gene is characterized by a marked reduction in cross-linked muropeptide and increased vancomycin resistance. Unlike other PBPs, we note that expression of PBP4 was not substantially altered under different experimental conditions, nor did it change across representative hospital- or community-associated strains of S. aureus that were examined. In vitro data on purified recombinant S. aureus PBP4 suggest that it is a beta-lactamase and is not trapped as an acyl intermediate with beta-lactam antibiotics. Put together, the expression analysis and biochemical features of PBP4 provide a framework for understanding the function of this protein in S. aureus and its role in antimicrobial resistance.

Voltage delay during constant-current or constant-resistance discharge of Mg-MnO2 dry cells: A comparative study

A theoretical approach has been developed to relate the voltage delay transients of the Mg-MnO2 dry cell observed during discharge by two commonly employed modes, viz., (1) at constant current, and (2) across a constant resistance. The approach has been verified by comparison of experimentally obtained transients with those generated from theory. The method may be used to predict the delay parameters of the Mg-MnO2 dry cell under the two modes of discharge and can, in principle, be extended to lithium batteries.