Effect of directionality of unidirectional grinding marks on friction and transfer layer formation of Mg on steel using inclined scratch test

Surface topography has been known to play an important role in the friction and transfer layer formation during sliding. In the present investigation, EN8 steel flats were ground to attain different surface roughness with unidirectional grinding marks. Pure Mg pins were scratched on these surfaces using an Inclined Scratch Tester to study the influence of directionality of surface grinding marks on coefficient of friction and transfer layer formation. Grinding angle (i.e., the angle between direction of scratch and grinding marks) was varied between 0 degrees and 90 degrees during the tests. Experiments were conducted under both dry and lubricated conditions. Scanning electron micrographs of the contact surfaces of pins and flats were used to reveal the surface features that included the morphology of the transfer layer. It was observed that the average coefficient of friction and transfer layer formation depend primarily on the directionality of the grinding marks but were independent of surface roughness on the harder mating surface. In addition, a stick-slip phenomenon was observed, the amplitude of which depended both on the directionality of grinding marks and the surface roughness of the harder mating surface. The grinding angle effect on the coefficient of friction, which consists of adhesion and plowing components, was attributed to the variation of plowing component of friction. (c) 2006 Elsevier B.V. All rights reserved.

Folding a Polymer via Two-Point Interaction with an External Folding Agent: Use of H-Bonding and Charge-Transfer Interactions

A polymer containing electron-rich aromatic donors (1,5-dialkoxynaphthalene (DAN)) was coerced into a folded state by an external folding agent that contained an electron-deficient aromatic acceptor (pyromellitic diimide (PM)) unit. The donor-containing polymer was designed to carry a tertiary amine moiety in the linking segment, which served as an H-bonding site for reinforcing the interaction with the acceptor containing folding agent that also bore a carboxylic acid group. The H-bonding interaction of the carboxylic acid and the tertiary amine brings the PDI unit between two adjacent DAN units along the polymer backbone to induce charge-transfer (C-T) interactions, and this in turn causes the polymer chain to form a pleated structure. Evidence for the formation of such a pleated structure was obtained from NMR titration studies and also by monitoring the C-T band in their UV-visible spectra. By varying the length of the segment that links the PDI acceptor to the carboxylic acid group, we showed that the most effective folding agent was the one that had a single carbon spacer, as evident from the highest value of the association constant. Control experiments with propionic acid clearly demonstrated the importance of the additional C-T interactions for venerating the folded structures. Further, solution viscosity measurements in the presence of varying amounts of the folding agent revealed a gradual stiffening of the chain in the case of the PDI carrying carboxylic acid, whereas no such affect was seen in the case of simple propionic acid. These observations were supported by D FT calculations of the interactions of a dimeric model of the polymer with the various folding agents; here too the stability of the complex was seen to be highest in the case of the single carbon spacer.

Cultural differences and capability transfer in cross-border acquisitions: the mediating roles of capability complementarity, absorptive capacity, and social integration

This paper presents an integrative model of the impact of cultural differences on capability transfer in cross-border acquisitions. We propose that cultural differences affect the post-acquisition capability transfer through their impact on social integration, potential absorptive capacity, and capability complementarity. Two dynamic variables – the use of social integration mechanisms, and the degree of operational integration of the acquired unit – are proposed to moderate the effects of cultural differences on social integration and potential absorptive capacity. The implications for acquisition research and practice are discussed.

Knowledge Transfer within Western Multinationals' Subsidiary Units in China and Finland - The Impact of Headquarter Control Mechanisms, Subsidiary Location and Social Capital (summary section only)

It is suggested that the ability and practices of how the multinational corporation (MNC) manages knowledge transfer among its geographically dispersed subsidiary units are crucial for the building and development of firm competitive advantage. However, cross-border transfer of valuable organizational knowledge is likely to be problematic and laborious, especially within diversified and differentiated MNCs. Using data collected from 164 western multinational companies’ subsidiary units located in China and Finland, this study aims to investigate cross-border knowledge transfer within the MNC. It explores a number of factors that influence the transfer of knowledge among units in the differentiated MNC. The study consists of five individual papers. Paper 1 investigates a range of organizational mechanisms that may positively influence a subsidiary’s propensity to undertake knowledge transfers to other parts of the corporation. Paper 2 explores the impact of subsidiary location on the motivational dispositions of knowledge receiving units to value and accept knowledge from subsidiaries located in economically less advanced countries. Paper 3 examines the influence of social capital variables on knowledge transfer in dyadic relationships between foreign-owned subsidiaries and their sister and patent units. Paper 4 provides some initial insights into potentially different effects of trust and shared vision in intra-organizational vs. inter-organizational relationships. Using a case study setting, Paper 5 explores means and mechanisms used in transferring human resource management practices to Western MNCs’ business units in China from a cultural perspective. The results of the study show that MNC management through choices regarding organizational controls can encourage and enhance corporate-internal knowledge transfer. It also finds evidence that more knowledge is transferred from subsidiaries located in an industrialized country (e.g., Finland) than subsidiaries located in a developing country (e.g., China). While the study has highlighted the importance of social capital in promoting knowledge transfer, it has also uncovered some new findings that the effect of trust and shared vision may be contingent upon different contexts. Finally, in Paper 5, a number of mechanisms used in transferring selected HRM practices and competences to the Chinese business units have been identified. The findings suggest that cultural differences should be taken into consideration in the choice and use of different transfer mechanisms.

Ab initio studies on proton transfer involving Schiff base and related nitrogen compounds

Proton transfer across cationic hydrogen bonds involving Schiff base, ammonia and related compounds has been studied at the 4-31G level. Proton transfer characteristics are correlated to the proton affinities of the species involved. Hydrogen bond strengths of these hydrogen bonds are correlated to the differences in the proton affinity of the donor and the acceptor. Influence of a neighbouring hydrogen bond on the proton transfer from Schiff base to ammonia and Schiff base to water is also discussed.

Simultaneous heat and mass transfer in unsteady free convection from two-dimensional and axisymmetric bodies

The unsteady laminar free convection boundary layer flows around two-dimensional and axisymmetric bodies placed in an ambient fluid of infinite extent have been studied when the flow is driven by thermal buoyancy forces and buoyancy forces from species diffusion. The unsteadiness in the flow field is caused by both temperature and concentration at the wall which vary arbitrarily with time. The coupled nonlinear partial differential equations with three independent variables governing the flow have been solved numerically using an implicit finite-difference scheme in combination with the quasilinearization technique. Computations have been performed for a circular cylinder and a sphere. The skin friction, heat transfer and mass transfer are strongly dependent on the variation of the wall temperature and concentration with time. Also the skin friction and heat transfer increase or decrease as the buoyancy forces from species diffusion assist and oppose, respectively, the thermal buoyancy force, whereas the mass transfer rate is higher for small values of the ratio of the buoyancy parameters than for large values. The local heat and mass transfer rates are maximum at the stagnation point and they decrease progressively with increase of the angular position from the stagnation point.

Network Knowledge versus Cluster Knowledge- The Gordian Knot of Knowledge Transfer Concepts

Both management scholars and economic geographers have studied knowledge and argued that the ability to transfer knowledge is critical to competitive success. Networks and other forms for cooperation are often the context when analyzing knowledge transfer within management research, while economic geographers focus on the role of the cluster for knowledge transfer and creation. With the common interest in knowledge transfer, few attempts to interdisciplinary research have been made. The aim of this paper is to outline the knowledge transfer concepts in the two strands of literature of management and economic geography (EG). The paper takes an analytical approach to review the existing contributions and seek to identify the benefits of further interaction between the disciplines. Furthermore, it offers an interpretation of the concepts of cluster and network, and suggests a clearer distinction between their respective definitions. The paper posits that studies of internal networks transcending national borders and clusters are not necessarily mutually exclusive when it comes to transfer of knowledge and the learning process of the firm. Our conclusion is that researchers in general seem to increasingly acknowledge the importance of studying both the effect of and the need for geographical proximity and external networks for the knowledge transfer process, but that there exists equivocalness in defining clusters and networks.

Studies on friction and transfer layer: role of surface texture

Friction influences the nature of transfer layer formed at the interface between tool and metal during sliding. In the present investigation, experiments were conducted using “Inclined Scratch Tester” to understand the effect of surface texture of hard surfaces on coefficient of friction and transfer layer formation. EN8 steel flats were ground to attain surfaces of different textures with different roughness. Then super purity aluminium pins were scratched against the prepared steel flats. Scanning electron micrographs of the contact surfaces of pins and flats were used to reveal the morphology of transfer layer. It was observed that the coefficient of friction and the formation of transfer layer depend primarily on the texture of hard surfaces, but independent of surface roughness of hard surfaces. It was observed that on surfaces that promote plane strain conditions near the surface, the transfer of material takes place due to the plowing action of the asperities. But, on a surface that promotes plane stress conditions the transfer layer was more due to the adhesion component of friction. It was observed that the adhesion component increases for surfaces that have random texture but was constant for the other surfaces

Simultaneous measurement of aerodynamic and heat transfer data for large angle blunt cones in hypersonic shock tunnel

Aerodynamic forces and fore-body convective surface heat transfer rates over a 60 degrees apex-angle blunt cone have been simultaneously measured at a nominal Mach number of 5.75 in the hypersonic shock tunnel HST2. An aluminum model incorporating a three-component accelerometer-based balance system for measuring the aerodynamic forces and an array of platinum thin-film gauges deposited on thermally insulating backing material flush mounted on the model surface is used for convective surface heat transfer measurement in the investigations. The measured value of the drag coefficient varies by about +/-6% from the theoretically estimated value based on the modified Newtonian theory, while the axi-symmetric Navier-Stokes computations overpredict the drag coefficient by about 9%. The normalized values of measured heat transfer rates at 0 degrees angle of attack are about 11% higher than the theoretically estimated values. The aerodynamic and the heat transfer data presented here are very valuable for the validation of CFD codes used for the numerical computation of How fields around hypersonic vehicles.

Photophysics of conjugated polymers: interplay between Forster energy migration and defect concentration in shaping a photochemical funnel in PPV

Recent single molecule experiments have suggested the existence of a photochemical funnel in the photophysics of conjugated polymers, like poly[2-methoxy-5-(2'-ethylhexyl)oxy-1,4-phenylenevinylene] (MEH-PPV). The funnel is believed to be a consequence of the presence of conformational or chemical defects along the polymer chain and efficient non-radiative energy transfer among different chromophore segments. Here we address the effect of the excitation energy dynamics on the photophysics of PPV. The PPV chain is modeled as a polymer with the length distribution of chromophores given either by a Gaussian or by a Poisson distribution. We observe that the Poisson distribution of the segment lengths explains the photophysics of PPV better than the Gaussian distribution. A recently proposed version of an extended particle-in-a-box' model is used to calculate the exciton energies and the transition dipole moments of the chromophores, and a master equation to describe the excitation energy transfer among different chromophores. The rate of energy transfer is assumed to be given here, as a first approximation, by the well-known Forster expression. The observed excitation population dynamics confirms the photochemical funneling of excitation energy from shorter to longer chromophores of the polymer chain. The time scale of spectral shift and energy transfer for our model polymer, with realistic values of optical parameters, is in the range of 200-300 ps. We find that the excitation energy may not always migrate towards the longest chromophore segments in the polymer chain as the efficiency of energy transfer between chromophores depends on the separation distance between the two and their relative orientation.

Surface Ligand Population Controlled Oriented Attachment: A Case of CdS Nanowires

using two types of organic ligands having similar chemical structure but different physical properties and varying their dynamic population at the surface of zinc blende seed nanocrystals, self-assembled zinc blende semicircular-shaped bent nanowires of CdS are synthesized via a colloidal synthetic approach. It is found that the hydrophobic tail interaction of long-chain ligands puts strain on these thin nanowires (< 2 nm diameter) and bend them to some extent, forming strained nanowires.

Molecular analysis of Friedreich's ataxia locus in the Indian population

Friedreich's ataxia (FRDA) is an autosomal recessive neurodegenerative disorder caused by expansion of GAA repeats in the frataxin gene. We have carried out the first molecular analysis at the Friedreich's ataxia locus in the Indian population. Materials and methods - Three families clinically diagnosed for Friedreich's ataxia were analyzed for GAA expansion at the FRDA locus. The distribution of GAA repeats was also estimated in normal individuals of Indian origin. Results - All patients clinically diagnosed for Friedreich's ataxia were found to be homozygous for GAA repeat expansion. The GAA repeat in the normal population show a bimodal distribution with 94% of alleles ranging from 7-16 repeats. Conclusion - Indian patients with expansion at the FRDA locus showed typical clinical features of Friedreich's ataxia. The low frequency of large normal alleles (6%) could indicate that the prevalence of this disease in the Indian population is likely to be low.