Compressive strength and setting time of MTA and portland cement associated with different radiopacifying agents

The aim of this study was to evaluate the compressive strength and setting time of MTA and Portland cement (PC) associated with bismuth oxide (BO), zirconium oxide (ZO), calcium tungstate (CT), and strontium carbonate (SC). Methods. For the compressive strength test, specimens were evaluated in an EMIC DL 2000 apparatus at 0.5 mm/min speed. For evaluation of setting time, each material was analyzed using Gilmore-type needles. The statistical analysis was performed with ANOVA and the Tukey tests, at 5% significance. Results. After 24 hours, the highest values were found for PC and PC + ZO. At 21 days, PC + BO showed the lowest compressive strength among all the groups. The initial setting time was greater for PC. The final setting time was greater for PC and PC + CT, and MTA had the lowest among the evaluated materials (< 0.05). Conclusion. The results showed that all radiopacifying agents tested may potentially be used in association with PC to replace BO.

Effectiveness of the diode laser in the treatment of ligature-induced periodontitis in rats: a histopathological, histometric, and immunohistochemical study

The aim of this study was to evaluate the effects of the use of a high-power gallium-aluminum-arsenide diode laser (GaAlAs; 808 nm, 1 W, 20 s, 20 Hz, 10 J) alone or as adjunctive therapy to scaling and root planing in the treatment of induced periodontitis in rats. Periodontitis was induced by placing a ligature around the mandibular first molar of 60 rats. After 7 days, the ligature was removed and the animals were divided into four groups as follows: C (control), no periodontal treatment; SRP, scaling and root planing (SRP); DL, diode laser (DL) irradiation treatment; and SRP/DL, both SRP and DL irradiation treatment. Five animals from each group were euthanized at 7, 15, and 30 days posttreatment. The effectiveness of the treatments was evaluated in the furcation area using histopathological analysis, histometric analysis of alveolar bone loss (ABL), and immunohistochemical detection of tartrate-resistant acid phosphatase (TRAP), runt-related transcription factor 2 (RUNX2), and osteocalcin (OCN). DL, alone or in combination with adjunctive therapy to SRP in the treatment of experimental periodontitis, resulted in a decreased local inflammatory response. At 7-days posttreatment, the DL and SRP/DL groups had fewer TRAP-positive cells and more RUNX2-positive cells. There was greater OCN immunolabeling in the DL group than in the C and SRP groups at 15 days. There was less ABL in the DL and SRP/DL groups at 15 and 30 days. In conclusion, DL was effective in the treatment of ligature-induced periodontitis in rats, both when used alone and when used as adjunctive therapy to SRP.

A longer time of exposure to antiretroviral therapy improves selenium levels

Background &aims: Selenium is an essential mineral for immunological function, performing crucial functions at the cellular level. This micronutrient has been determined to be frequently deficient in HIV infected patients, with correlations between reduced immunological function and greater susceptibility to opportunistic infections. Our aim was to evaluate the influence of time of exposure to antiretroviral therapy (ART) on the biochemical profile of selenium in HIV-infected patients.Methods: We performed a cross-sectional study on 50 HIV-positive men with different quantitations of viral load and CD4+ T cells, who were either receiving or not receiving ART. Dual energy X-ray absorptiometry (DXA) to determine body composition, biochemical analysis of selenium and albumin, anthropometric measurements were performed. The subjects were divided into groups according to the use of ART or not: The Control Group (CG) was 10 treatment-nave volunteers, Group G < 2 was 20 volunteers on ART for less than 2 years, and Group G > 2 was 20 volunteers on ART for >2 years.Results: The body mass index showed that all subjects were of normal weight. The group with a longer time of exposure to ART (G > 2) had undetectable viremia and a higher CD4+ T cell count: 593.1 +/- 234.6 mm(3). Selenium values (mu g/L) were 55.9 +/- 11.9 for CG, 52.1 +/- 10.5 for G < 2, and 66.9 +/- 20.8 for G > 2, with a significant difference between groups G < 2 and G > 2 (p < 0.05), and only G > 2 showed normal selenium values.Conclusions: Most of the men studied showed selenium deficiency, except for the subjects with a longer exposure to antiretroviral treatment. Thus, an adequate selenium concentration is related to better control of virology and of immunologic function. (C) 2014 Elsevier Ltd and European Society for Clinical Nutrition and Metabolism. All rights reserved.

Period and Time of Harvest Affects the Apitoxin Production in Apis mellifera Lineu (Hymenoptera: Apidae) Bees and Expression of Defensin Stress Related Gene

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Growth and development time of subtropical Cladocera Diaphanosoma birgei Korinek, 1981 fed with different microalgal diets

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Structural characterization of novel chemotactic and mastoparan peptides from the venom of the social wasp Agelaia pallipes pallipes by high-performance liquid chromatography/electrospray ionization tandem mass spectrometry

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Bupropion treatment increases epididymal contractility and impairs sperm quality with no effects on the epididymal sperm transit time of male rats

Bupropion is a dopamine (DA) and norepinephrine (NE) reuptake inhibitor used as smoking cessation and antidepressant drug with a lower incidence of male sexual dysfunction. We showed previously that sibutramine, a norepinephrine/serotonine reuptake inhibitor, reduced male rat fertility. As there are no studies evaluating the impact of bupropion treatment on spermatic parameters and male fertility, we evaluated the effects of bupropion treatment (15 and 30 mg kg(-1), 30 days) on sexual behavior, spermatic parameters and fertility of male Wistar rats and on the epididymal duct in vitro contractility. Bupropion 15 mg kg(-1) increased the serum luteinizing hormone level and the epididymal duct contractility, but the sperm quality was not affected. At 30 mg kg(-1) bupropion impaired sperm quality increasing the incidence of non-progressive sperm. The male sexual behavior and fertility were not modified at both bupropion doses. These results, in rats, suggest the importance of studies evaluating the effects of bupropion on the human male sperm quality.

Rapid determination of 12 antibiotics and caffeine in sewage and bioreactor effluent by online column-switching liquid chromatography/tandem mass spectrometry

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Confocal laser scanning microscopy investigation of bond interfaces involved in fiber glass post cementation

Objective: This confocal microscopy study evaluated the cement/dentin and cement/post interfaces along theroot canalwallswhenfiberglasspostswerebonded to dentin using different types of cements. Material & Methods: Thirty endodontically treated premolars were divided into 3 groups according to the adhesive materials used in the bonding procedure: Prime & Bond 2.1/Self Cure + Enforce, RelyX Unicem and RelyX Luting. Rhodamine B dye was incorporated in the luting materials for the cementation of the fiber glass posts (Exacto, Angelus) to dentin. Three transversal slices (apical, middle and coronal) were examined under confocal laser scanning microscopy. Statistical analysis was performed using the Kappa, Kruskal-Wallis and Dunnet tests, in a significance level of 5%. Results: The Prime & Bond 2.1/Self Cure + Enforce presented a uniform formation of tags in the dentin but gaps in the cement/dentin interface. The RelyX Unicem and RelyX Luting presented an adhesive interface with a fewer amount of gaps, but showed shorter tag formation than the Enforce system. All cements presented the same pattern of bubbles inside the cements. The RelyX Luting presented a greater amount of cracks inside the cement in comparison with the other cements in the coronal third, while no difference was observed between RelyX Unicem and Enforce. The RelyX Luting showed the lowest quantity of cement penetration into the post. Conclusion: In general, the quality of bonding interfaces of fiber posts luted to root canals was affected by both location and type of cement.

Influence of the starting time of preslaughter feed withdrawal on welfare of pigs and pork quality

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

The association between follicular size at time of spontaneous rupture and pregnancy rates in clomiphene citrate treated PCOS patients in coit cycles

Objective: To investigate the follicular size at spontaneous rupture on pregnancy rate in patientswith polycystic ovary syndrome (PCOS) undergoing clomiphene citrate (CC) ovulation.Design: Cross-sectional study.Patients and methods: One hundred and four women with ovulatory cycles after use of CCfollowed by ultrasound to determine the follicle size at the time of rupture, which wassubsequently correlated with the occurrence of pregnancy or not in coit cycles.Results: In the group of follicular rupture at a mean diameter25 mm (n¼54), pregnancy ratewas 35.1% and when follicular rupture occurred at a mean diameter425 mm (n¼50), it was34% (p40.05). When different diameters at follicular rupture were randomly correlated with thepregnancy rate, there was no significant difference.Conclusion: Our data suggest that the occurrence of pregnancy after ovulation induction withCC in women with PCOS is not associated with follicle size at the time of rupture.

Modeling the growth rate and lag time of different strains of Salmonella enterica and Listeria monocytogenes in ready-to-eat lettuce

The growth parameters (growth rate, mu and lag time, lambda) of three different strains each of Salmonella enterica and Listeria monocytogenes in minimally processed lettuce (MPL) and their changes as a function of temperature were modeled. MPL were packed under modified atmosphere (5% O-2, 15% CO2 and 80% N-2), stored at 7-30 degrees C and samples collected at different time intervals were enumerated for S. enterica and L monocytogenes. Growth curves and equations describing the relationship between mu and lambda as a function of temperature were constructed using the DMFit Excel add-in and through linear regression, respectively. The predicted growth parameters for the pathogens observed in this study were compared to ComBase, Pathogen modeling program (PMP) and data from the literature. High R-2 values (0.97 and 0.93) were observed for average growth curves of different strains of pathogens grown on MPL Secondary models of mu and lambda for both pathogens followed a linear trend with high R2 values (>0.90). Root mean square error (RMSE) showed that the models obtained are accurate and suitable for modeling the growth of S. enterica and L monocytogenes in MP lettuce. The current study provides growth models for these foodborne pathogens that can be used in microbial risk assessment. (C) 2011 Elsevier Ltd. All rights reserved.

Fluoride plus CO2 laser against the progression of caries in root dentin

Purpose: To evaluate the effect of a 1.23% acidulated phosphate fluoride (APF) gel combined with CO2 laser in protecting carious root dentin against further cariogenic challenges. Methods: After a 7-day lead-in period, 12 volunteers wore an intraoral palatal device containing four carious root dentin slabs, treated with APF and APF+CO2 or placebo and placebo+CO2. After a 14-day wash-out period, volunteers were crossed-over to the other treatment arm. During both intraoral phases, specimens were submitted to cariogenic challenges and then evaluated for cross-sectional Knoop microhardness. Results: Two-way ANOVA demonstrated that there was significant effect for both main factors: CO2 laser irradiation (P< 0.0001) and gel treatment (P< 0.0001), and that there was no interaction between them (P= 0.4706). Protection of carious root dentin against further cariogenic challenges may be provided by APF fluoride gel and CO2 laser, but no additive benefit was found by combining such strategies. (Am J Dent 2012;25:114-117).

Effect of Temperature on the Degree of Conversion and Working Time of Dual-Cured Resin Cements Exposed to Different Curing Conditions

Objectives: This study evaluated the degree of conversion (DC) and working time (WT) of two commercial, dual-cured resin cements polymerized at varying temperatures and under different curing-light accessible conditions, using Fourier transformed infrared analysis (FTIR). Materials and Methods: Calibra (Cal; Dentsply Caulk) and Variolink II (Ivoclar Vivadent) were tested at 25 degrees C or preheated to 37 degrees C or 50 degrees C and applied to a similar-temperature surface of a horizontal attenuated-total-reflectance unit (ATR) attached to an infrared spectrometer. The products were polymerized using one of four conditions: direct light exposure only (600 mW/cm(2)) through a glass slide or through a 1.5- or 3.0-mm-thick ceramic disc (A2 shade, IPS e.max, Ivoclar Vivadent) or allowed to self-cure in the absence of light curing. FTIR spectra were recorded for 20 min (1 spectrum/s, 16 scans/spectrum, resolution 4 cm(-1)) immediately after application to the ATR. DC was calculated using standard techniques of observing changes in aliphatic-to-aromatic peak ratios precuring and 20-min postcuring as well as during each 1-second interval. Time-based monomer conversion analysis was used to determine WT at each temperature. DC and WT data (n=6) were analyzed by two-way analysis of variance and Tukey post hoc test (p=0.05). Results: Higher temperatures increased DC regardless of curing mode and product. For Calibra, only the 3-mm-thick ceramic group showed lower DC than the other groups at 25 degrees C (p=0.01830), while no significant difference was observed among groups at 37 degrees C and 50 degrees C. For Variolink, the 3-mm-thick ceramic group showed lower DC than the 1-mm-thick group only at 25 degrees C, while the self-cure group showed lower DC than the others at all temperatures (p=0.00001). WT decreased with increasing temperature: at 37 degrees C near 70% reduction and at 50 degrees C near 90% for both products, with WT reduction reaching clinically inappropriate times in some cases (p=0.00001). Conclusion: Elevated temperature during polymerization of dual-cured cements increased DC. WT was reduced with elevated temperature, but the extent of reduction might not be clinically acceptable.