On the optimum mesh size for the capture of Barbus tor (Hamilton)

Results of mesh selectivity experiments on B. tor are presented in this paper. Selectivity curve on the basis of maximum girth of fish in relation to perimeter of mesh was worked out. The optimum girth/mesh perimeter ratio was found to be 1.31. A linear regression of G+0.445L=12.8 was fitted for conversion of length to girth.

Synchronization in climate dynamics and other extended systems

Synchronization is now well established as representing coherent behaviour between two or more otherwise autonomous nonlinear systems subject to some degree of coupling. Such behaviour has mainly been studied to date, however, in relatively low-dimensional discrete systems or networks. But the possibility of similar kinds of behaviour in continuous or extended spatiotemporal systems has many potential practical implications, especially in various areas of geophysics. We review here a range of cyclically varying phenomena within the Earth's climate system for which there may be some evidence or indication of the possibility of synchronized behaviour, albeit perhaps imperfect or highly intermittent. The exploitation of this approach is still at a relatively early stage within climate science and dynamics, in which the climate system is regarded as a hierarchy of many coupled sub-systems with complex nonlinear feedbacks and forcings. The possibility of synchronization between climate oscillations (global or local) and a predictable external forcing raises important questions of how models of such phenomena can be validated and verified, since the resulting response may be relatively insensitive to the details of the model being synchronized. The use of laboratory analogues may therefore have an important role to play in the study of natural systems that can only be observed and for which controlled experiments are impossible. We go on to demonstrate that synchronization can be observed in the laboratory, even in weakly coupled fluid dynamical systems that may serve as direct analogues of the behaviour of major components of the Earth's climate system. The potential implications and observability of these effects in the long-term climate variability of the Earth is further discussed. © 2010 Springer-Verlag Berlin Heidelberg.

Optimum dietary carbohydrate to lipid ratio in stinging catfish, Heteropneustes fossilis (Bloch, 1792)

A feeding trial of 8 weeks was conducted in a static indoor rearing system to investigate the optimum carbohydrate to lipid ratio (CHO:L ratio) in stinging catfish, Heteropneustes fossilis. Five iso-nitrogenous (35% crude protein) and iso-energetic (17.06 kJ gˉ¹ gross energy (GE)) fish meal based diets with varying carbohydrate to lipid (CHO:L g/g) ratios of 0.60, 0.98, 1.53, 2.29 and 3.44 for diets 1-5, were tested, respectively. The diets containing a fixed protein to energy ratio (P:E ratio) of 20.50-mg protein kJˉ¹ GE were fed to triplicate groups of 40 fish (per 70-L tank). Fish were fed 5% of their body weight per day adjusted fortnightly. Diet 1, containing 10% carbohydrate and 17% lipids with a CHO:L ratio of 0.60 produced the poorest (p<0.05) growth rates, feed and protein efficiency. Increasing carbohydrate content in the diets to 26% concomitant with a reduction in lipid content to 11% with a CHO:L ration of 2.29 of diet 5 significantly improved (p<0.05) growth rates, feed and protein efficiency. But did not differ with diet 4, containing CHO:L ratio 2.29. A further increase in dietary carbohydrate up to 31% and a decrease in lipids levels to 9% with a CHO:L ratio ranging from 2.29 to 3.44 (diet 4-5) did not significantly improve the fish performance. Apparent net protein utilisation (ANPU) of fish fed diet 5 was higher (p<0.05) than for diets 1 and 2 but did not differ from diets 3 and 4. Higher lipid deposition (p<0.05) in whole body was observed with decreasing dietary CHO:L ratios as increasing lipid levels. Whole body protein of fish fed varying CHO:L diets did not show any discernible changes among the dietary treatments. This study revealed that H. fossilis can perform equally well on diets containing carbohydrate ranging from 26 to 31%, with 9 to 11% lipid or at CHO:L g/g ratio of 2.29-3.44.

Effect of urban climate on building integrated photovoltaics performance

It is generally recognized that BIPV (building integrated photovoltaics) has the potential to become a major source of renewable energy in the urban environment. The actual output of a PV module in the field is a function of orientation, total irradiance, spectral irradiance, wind speed, air temperature, soiling and various system-related losses. In urban areas, the attenuation of solar radiation due to air pollution is obvious, and the solar spectral content subsequently changes. The urban air temperature is higher than that in the surrounding countryside, and the wind speed in urban areas is usually less than that in rural areas. Three different models of PV power are used to investigate the effect of urban climate on PV performance. The results show that the dimming of solar radiation in the urban environment is the main reason for the decrease of PV module output using the climatic data of urban and rural sites in Mexico City for year 2003. The urban PV conversion efficiency is higher than that of the rural PV system because the PV module temperature in the urban areas is slightly lower than that in the rural areas in the case. The DC power output of PV seems to be underestimated if the spectral response of PV in the urban environment is not taken into account based on the urban hourly meteorological data of Sao Paulo for year 2004. © 2006 Elsevier Ltd. All rights reserved.

Optimum Magnetic Circuit Configurations for Permanent Magnet Aerospace Generators

In the design of high-speed low-power electrical generators for unmanned aircraft and spacecraft, maximization of specific output (power/weight) is of prime importance. Several magnetic circuit configurations (radial-field, axial-field, flux-squeezing, homopolar) have been proposed, and in this paper the relative merits of these configurations are subjected to a quantitative investigation over the speed range 10 000–100000 rev/min and power range 250 W-10 kW. The advantages of incorporating new high energy-density magnetic materials are described. Part I deals with establishing an equivalent circuit for permanent-magnet generators. For each configuration the equivalent circuit parameters are related to the physical dimensions of the generator components and an optimization procedure produces a minimum volume design at discrete output powers and operating speeds. The technique is illustrated by a quantitative comparison of the specific outputs of conventional radial-field generators with samarium cobalt and alnico magnets. In Part II the specific outputs of conventional, flux-squeezing, and claw-rotor magnetic circuit configurations are compared. The flux-squeezing configuration is shown to produce the highest specific output for small sizes whereas the conventional configuration is best at large sizes. For all sizes the claw-rotor configuration is significantly inferior. In Part III the power densities available from axial-field and flux-switching magnetic circuit configurations are maximized, over the power range 0.25-10 kW and speed range 10 000–100000 rpm, and compared to the results of Parts I & II. For the axial-field configuration the power density is always less than that of the conventional and flux-squeezing radial-field configurations. For the flux-switching generator, which is able to withstand relatively high mechanical forces in the rotor, the power density is again inferior to the radial-field types, but the difference is less apparent for small (low power, high speed) generator sizes. From the combined results it can be concluded that the flux-squeezing and conventional radial-field magnetic circuit configurations yield designs with minimum volume over the power and speed ranges considered. © 1985, IEEE. All rights reserved.

The role for low carbon electrification technologies in poverty reduction and climate change strategies: A focus on renewable energy mini-grids with case studies in Nepal, Peru and Kenya

As a potential poverty reduction and climate change strategy, this paper considers the advantages and disadvantages of using renewable energy technologies for rural electrification in developing countries. Although each case must be considered independently, given a reliable fuel source, renewable energy mini-grids powered by biomass gasifiers or micro-hydro plants appear to be the favoured option due to their lower levelised costs, provision of AC power, potential to provide a 24. h service and ability to host larger capacity systems that can power a wide range of electricity uses. Sustainability indicators are applied to three case studies in order to explore the extent to which sustainable welfare benefits can be created by renewable energy mini-grids. Policy work should focus on raising awareness about renewable energy mini-grids, improving institutional, technical and regulatory frameworks and developing innovative financing mechanisms to encourage private sector investments. Establishing joint technology and community engagement training centres should also be encouraged. © 2011 Elsevier Ltd.

Designing for resilience: Using a Delphi study to identify resilience issues for hospital designs in a changing climate

Hospitals are facing a triple challenge - meeting mandatory climate change targets and refurbishing aging infrastructure while simultaneously providing quality of care. With the potential of more frequent disruptive weather events, a UK government-funded project was launched in 2009 to investigate practical strategies for the National Health Service to increase its resilience to climate change. This paper presents the process of defining resilience by using the Delphi method and demonstrates its applicability within healthcare design. A Delphi survey is nearing completion which has determined the significant resilience issues and temperature ranges for ideal and critical conditions. Our preliminary findings identified six priorities that lead towards increasing resilience. Using the Delphi method can be a useful tool in clarifying the focus for healthcare design considerations. Copyright © 2002-2012 The Design Society. All rights reserved.

Management of thermal performance risks in buildings subject to climate change

This article reports on the use of building performance simulation to quantify the risks that climate change poses to the thermal performance of buildings, and to their critical functions. Through a number of case studies the article demonstrates that any prediction of the probable thermal building performance on the long timeframes inherent in climate change comes with very large uncertainties. The same cases are used to illustrate that assessing the consequences of predicted change is problematic, since the functions that the building provides in themselves often are a moving target. The article concludes that quantification of the risks posed by climate change is possible, but only with many restrictions. Further research that is needed to move to more effective discussion about risk acceptance and risk abatement for specific buildings is identified. © 2012 Elsevier Ltd.