Complex weathering in drylands: implications of 'stress' history for rock debris breakdown and sediment release

Weathering studies have often sought to explain features in terms of a prevailing set of environmental conditions. However, it is clear that in most present-day hot desert regions, the surface rock debris has been exposed to a range of weathering environments and processes. These different weathering conditions can arise in two ways, either from the effects of long-term climate change acting on debris that remains relatively static within the landscape or through the spatial relocation of debris from high to low altitude. Consequently, each fragment of rock may contain a unique weathering-related legacy of damage and alteration — a legacy that may greatly influence its response to present-day weathering activity. Experiments are described in which blocks of limestone, sandstone, granite and basalt are given ‘stress histories’ by subjecting them to varying numbers of heating and freezing cycles as a form of pre-treatment. These imposed stress histories act as proxies for a weathering history. Some blocks were used in a laboratory salt weathering simulation study while others underwent a 2 year field exposure trial at high, mid and low altitude sites in Death Valley, California. Weight loss and ultrasonic pulse velocity measurements suggest that blocks with stress histories deteriorate more rapidly than unstressed samples of the same rock type exposed to the same environmental conditions. Laboratory data also indicate that the result of imposing a known ‘weathering history’ on samples by pre-stressing them is an increase in the amount of fine sediment released during salt weathering over a given period of time in comparison to unstressed samples.

Calcium currents in interstitial cells from the guinea-pig bladder.

OBJECTIVE: To determine whether there are inward currents in interstitial cells (IC) isolated from the guinea-pig detrusor and if so, to characterise them using the patch-clamp technique and pharmacological agents. MATERIALS AND METHODS: Using the whole-cell patch-clamp technique, inward currents were studied in IC enzymatically isolated from the detrusor of the guinea-pig bladder. Currents were evoked by stepping positively from a holding potential of - 80 mV. RESULTS: Outward K+ currents were blocked by Cs+ internal solution to reveal inward currents, which activated at voltages more positive than - 50 mV, peaked at 0 mV, reversed near + 50 mV and were half-maximally activated at - 27 mV. The inward currents showed voltage-dependent inactivation and were half-maximally inactivated at - 36 mV. Fitting the activation and inactivation data with a Boltzmann function revealed a window current between - 40 mV and + 20 mV. The decay of the current evoked at 0 mV could be fitted with a single exponential with a mean time-constant of 88 ms. Replacing external Ca2+ with Ba2+ significantly increased this to 344 ms. The current amplitude was augmented by Ba2+, and by Bay K 8644. Inward currents were significantly reduced by 1 microm nifedipine, across the voltage range, but the blockade was more effective on the current evoked at 0 mV than that evoked by a step to - 20 mV, perhaps indicating voltage-dependence of the action of nifedipine or another component of inward current. Increasing the concentration of the drug to 10 microm caused no further significant reduction either at 0 mV or at -20 mV. However, in the presence of 1 microm nifedipine the latter current was significantly reduced by 100 microm Ni2+. Both currents were significantly reduced in Ca2+-free solution. CONCLUSIONS: IC from the guinea-pig detrusor possess inward currents with typical characteristics of L-type Ca2+ current. They also have a component of inward Ca2+ current, which was resistant to nifedipine, but sensitive to Ni2+. Further work is needed to characterise the latter conductance. PMID: 16686735 [PubMed - indexed for MEDLINE]

The calcium channel blocker used with cyclosporin has an effect on gingival overgrowth

Background/aims, To investigate whether the choice of calcium channel blocker, used in conjunction with cyclosporin A, affected the prevalence of gingival overgrowth.

Software Release Planning: An Evolutionary and Iterative Approach

Abstract To achieve higher flexibility and to better satisfy actual customer requirements, there is an increasing tendency to develop and deliver software in an incremental fashion. In adopting this process, requirements are delivered in releases and so a decision has to be made on which requirements should be delivered in which release. Three main considerations that need to be taken account of are the technical precedences inherent in the requirements, the typically conflicting priorities as determined by the representative stakeholders, as well as the balance between required and available effort. The technical precedence constraints relate to situations where one requirement cannot be implemented until another is completed or where one requirement is implemented in the same increment as another one. Stakeholder preferences may be based on the perceived value or urgency of delivered requirements to the different stakeholders involved. The technical priorities and individual stakeholder priorities may be in conflict and difficult to reconcile. This paper provides (i) a method for optimally allocating requirements to increments; (ii) a means of assessing and optimizing the degree to which the ordering conflicts with stakeholder priorities within technical precedence constraints; (iii) a means of balancing required and available resources for all increments; and (iv) an overall method called EVOLVE aimed at the continuous planning of incremental software development. The optimization method used is iterative and essentially based on a genetic algorithm. A set of the most promising candidate solutions is generated to support the final decision. The paper evaluates the proposed approach using a sample project.

Nitric Oxide Produced in Response to Engagement of beta 2 Integrins on Human Neutrophils Activates the Monomeric GTPases Rap1 and Rap2 and Promotes Adhesion

We found that engagement of beta 2 integrins on human neutrophils increased the levels of GTP-bound Rap1 and Rap2. Also, the activation of Rap1 was blocked by PP1, SU6656, LY294002, GF109203X, or BAPTA-AM, which indicates that the downstream signaling events in Rap1 activation involve Src tyrosine kinases, phosphoinositide 3-kinase, protein kinase C, and release of calcium. Surprisingly, the integrin-induced activation of Rap2 was not regulated by any of the signaling pathways mentioned above. However, we identified nitric oxide as the signaling molecule involved in beta 2 integrin-induced activation of Rap1 and Rap2. This was illustrated by the fact that engagement of beta 2 integrins increased the production of nitrite, a stable end-product of nitric oxide. Furthermore, pretreatment of neutrophils with N-monomethyl-L-arginine, or 1400W, which are inhibitors of inducible nitric-oxide synthase, blocked integrin-induced activation of Rap1 and Rap2. Similarly, Rp-8pCPT-cGMPS, an inhibitor of cGMP-dependent serine/threonine kinases, also blunted the integrin-induced activation of Rap GTPases. Also nitric oxide production and its downstream activation of cGMP-dependent serine/threonine kinases were essential for proper neutrophil adhesion by beta 2 integrins. Thus, we made the novel findings that beta 2 integrin engagement on human neutrophils triggers production of nitric oxide and its downstream signaling is essential for activation of Rap GTPases and neutrophil adhesion.

Electron impact excitation of carbon-like calcium

Collision strengths for transitions among the energetically lowest 46 fine-structure levels belonging to the (1s(2)) 2s(2)2p(2), 2s2p(3). 2p(4), 2s(2)2p3s, 2s(2)2p3p and 2s(2)2p3d configurations of Ca XV are computed. over an electron energy range of 50 less than or equal to E less than or equal to 300 Ryd. using the recent Dirac Atomic R-matrix Code (DARC) of Norrington and Grant. All partial waves with J less than or equal to 40.5 have been included, and the contribution of higher partial waves has been added to ensure the convergence of collision strengths for all transitions and at all energies. The results are compared with those available in the literature, and the accuracy of the data is assessed.

Neighboring Group-Controlled Hydrolysis: Towards “Designer” Drug Release Biomaterials

To give the first demonstration of neighboring group-controlled drug delivery rates, a series of novel, polymerizable ester drug conjugates was synthesized and fully characterized. The monomers are suitable for copolymerization in biomaterials where control of drug release rate is critical to prophylaxis or obviation of infection. The incorporation of neighboring group moieties differing in nucleophilicity, geometry, and steric bulk in the conjugates allowed the rate of ester hydrolysis, and hence drug liberation, to be rationally and widely controlled. Solutions (2.5 x 10-5 mol dm-3) of ester conjugates of nalidixic acid incorporating pyridyl, amino, and phenyl neighboring groups hydrolyzed according to first-order kinetics, with rate constants between 3.00 ( 0.12 10-5 s -1 (fastest) and 4.50 ( 0.31 10- 6 s-1 (slowest). The hydrolysis was characterized using UV-visible spectroscopy. When copolymerized with poly(methyl methacrylate), free drug was shown to elute from the resulting materials, with the rate of release being controlled by the nature of the conjugate, as in solution. The controlled molecular architecture demonstrated by this system offers an attractive class of drug conjugate for the delivery of drugs from polymeric biomaterials such as bone cements in terms of both sustained, prolonged drug release and minimization of mechanical compromise as a result of release. We consider these results to be the rationale for the development of 'designer' drug release biomaterials, where the rate of required release can be controlled by predetermined molecular architecture.