Passive urban ventilation by combined buoyancy-driven slope flow and wall flow: Parametric CFD studies on idealized city models

This paper reports the results of a parametric CFD study on idealized city models to investigate the potential of slope flow in ventilating a city located in a mountainous region when the background synoptic wind is absent. Examples of such a city include Tokyo in Japan, Los Angeles and Phoenix in the US, and Hong Kong. Two types of buoyancy-driven flow are considered, i.e., slope flow from the mountain slope (katabatic wind at night and anabatic wind in the daytime), and wall flow due to heated/cooled urban surfaces. The combined buoyancy-driven flow system can serve the purpose of dispersing the accumulated urban air pollutants when the background wind is weak or absent. The microscopic picture of ventilation performance within the urban structures was evaluated in terms of air change rate (ACH) and age of air. The simulation results reveal that the slope flow plays an important role in ventilating the urban area, especially in calm conditions. Katabatic flow at night is conducive to mitigating the nocturnal urban heat island. In the present parametric study, the mountain slope angle and mountain height are assumed to be constant, and the changing variables are heating/cooling intensity and building height. For a typical mountain of 500 m inclined at an angle of 20° to the horizontal level, the interactive structure is very much dependent on the ratio of heating/cooling intensity as well as building height. When the building is lower than 60 m, the slope wind dominates. When the building is as high as 100 m, the contribution from the urban wall flow cannot be ignored. It is found that katabatic wind can be very beneficial to the thermal environment as well as air quality at the pedestrian level. The air change rate for the pedestrian volume can be as high as 300 ACH.

A change detection approach to flood mapping in urban areas using TerraSAR-X

Very high-resolution Synthetic Aperture Radar sensors represent an alternative to aerial photography for delineating floods in built-up environments where flood risk is highest. However, even with currently available SAR image resolutions of 3 m and higher, signal returns from man-made structures hamper the accurate mapping of flooded areas. Enhanced image processing algorithms and a better exploitation of image archives are required to facilitate the use of microwave remote sensing data for monitoring flood dynamics in urban areas. In this study a hybrid methodology combining radiometric thresholding, region growing and change detection is introduced as an approach enabling the automated, objective and reliable flood extent extraction from very high-resolution urban SAR images. The method is based on the calibration of a statistical distribution of “open water” backscatter values inferred from SAR images of floods. SAR images acquired during dry conditions enable the identification of areas i) that are not “visible” to the sensor (i.e. regions affected by ‘layover’ and ‘shadow’) and ii) that systematically behave as specular reflectors (e.g. smooth tarmac, permanent water bodies). Change detection with respect to a pre- or post flood reference image thereby reduces over-detection of inundated areas. A case study of the July 2007 Severn River flood (UK) observed by the very high-resolution SAR sensor on board TerraSAR-X as well as airborne photography highlights advantages and limitations of the proposed method. We conclude that even though the fully automated SAR-based flood mapping technique overcomes some limitations of previous methods, further technological and methodological improvements are necessary for SAR-based flood detection in urban areas to match the flood mapping capability of high quality aerial photography.

Spatio-temporal variation in predation by urban domestic cats (Felis catus) and the acceptability of possible management actions in the UK

Urban domestic cat (Felis catus) populations can attain exceedingly high densities and are not limited by natural prey availability. This has generated concerns that they may negatively affect prey populations, leading to calls for management. We enlisted cat-owners to record prey returned home to estimate patterns of predation by free-roaming pets in different localities within the town of Reading, UK and questionnaire surveys were used to quantify attitudes to different possible management strategies. Prey return rates were highly variable: only 20% of cats returned ≥4 dead prey annually. Consequently, approximately 65% of owners received no prey in a given season, but this declined to 22% after eight seasons. The estimated mean predation rate was 18.3 prey cat−1 year−1 but this varied markedly both spatially and temporally: per capita predation rates declined with increasing cat density. Comparisons with estimates of the density of six common bird prey species indicated that cats killed numbers equivalent to adult density on c. 39% of occasions. Population modeling studies suggest that such predation rates could significantly reduce the size of local bird populations for common urban species. Conversely, most urban residents did not consider cat predation to be a significant problem. Collar-mounted anti-predation devices were the only management action acceptable to the majority of urban residents (65%), but were less acceptable to cat-owners because of perceived risks to their pets; only 24% of cats were fitted with such devices. Overall, cat predation did appear to be of sufficient magnitude to affect some prey populations, although further investigation of some key aspects of cat predation is warranted. Management of the predation behavior of urban cat populations in the UK is likely to be challenging and achieving this would require considerable engagement with cat owners.

Soil injections of carbohydrates improve fine root growth of established urban trees

Four established mature tree species (Aesculus hippocastanum L., Betula pendula Roth., Primus avium L. and Quercus rohur L.) commonly planted in UK urban landscapes were subjected to soil injections of the carbohydrate sucrose at 25, 50 and 70g per litre of water. Fine root dry weight was recorded at month 5 following soil injections. Soil injections of sucrose significantly increased fine root dry weight compared to controls, however; growth responses were influenced by species and the concentration of sucrose applied. Results indicate soil injections of sucrose ≥ 50g litre of water may be able to improve root growth of established mature trees. Such a response is desirable as root damage following construction is a frequent problem encountered by established trees growing in UK towns and cities.

The influence of biostimulants on growth and vitality of three urban tree species following transplanting

Four commercially available, biostimulants sold under the trade names ‘Generate’, ‘Crop Set’, ‘Fulcrum’ and ‘Redicrop 2000’ were applied either as a root drench or foliar spray to three transplant-sensitive tree species, red oak(Quercus rubra), birch(Betula pendula) and beech (Fagus sylvatica) post transplanting. The short and long-term efficacy of the biostimulants on growth was quantified by recording root and shoot vigour at week 8 and 20. In addition, improvements in tree vitality were assessed by measurement of a chlorophyll a performance index based on leaf chlorophyll fluorescence emissions. Irrespective of species, no significant effect of mode of application (foliar spray versus root drench) was recorded on growth and vitality. The biostimulants Generate and Fulcrum increased growth of all three tree species. No significant effects on growth and chlorophyll fluorescence of birch and beech were recorded following applications of the biostimulants Crop Set and Redicrop 2000, however, significant increase in growth of red oak was recorded. Only the biostimulant Generate increased chlorophyll fluorescence values of all test species. Results show use of biostimulants can improve root and shoot vigour following transplanting. However, selection of an appropriate biostimulant is critical as effects on growth and vitality can vary widely between tree species possibly as a result of the differing active ingredient used in the formulation of the product.

The role of retailing in urban regeneration

Recent ‘best practice’ research and guidance has emphasised the important role that can be played by retail-led urban regeneration projects, particularly in ‘under-served markets’ in the UK. This builds on ideas first formulated in the USA by Michael Porter through his close relationship with the Initiative for the Competitive Inner City (ICIC). This paper critically examines the role of retailing in urban regeneration nationally and locally in the UK, focusing on in-town shopping centres located in inner city areas of the UK. The paper is based on case study research in these centres, and was completed during 2003 for The Office of Science and Technology. The paper examines how employment impact in retail-led regeneration is commonly measured, and calls for more research to determine the real impact of retail in deprived communities using other, relevant measures.

Briefing: re-engineering the city 2020–2050 – urban foresight and transition management

Cities may be responsible for up to 70% of global carbon emissions and 75% of global energy consumption and by 2050 it is estimated that 70% of the world's population could live in cities. The critical challenge for contemporary urbanism, therefore, is to understand how to develop the knowledge, capacity and capability for public agencies, the private sector and multiple users in city regions systemically to re-engineer their built environment and urban infrastructure in response to climate change and resource constraints. Re-Engineering the City 2020–2050: Urban Foresight and Transition Management (Retrofit 2050) is a major new interdisciplinary project funded under the Engineering and Physical Science Research Council's (EPSRC) Sustainable Urban Environments Programme which seeks to address this challenge. This briefing describes the background and conceptual framing of Retrofit 2050 project, its aims and objectives and research approach.

Retrofit city futures: visions for urban sustainability

This report (which is part of the EPSRC Retrofit 2050 project) sets out three contrasting long term (2050) visions for retrofit city-regional futures, developed through an in-depth participatory backcasting and foresight process. These contextual scenarios are intended as a tool which can be adapted and used by a wide variety of stakeholders and organisations to stimulate discussion and inform future policy and long-term planning.

Rural-urban disparities in child nutrition in Bangladesh and Nepal

Background The persistence of rural-urban disparities in child nutrition outcomes in developing countries alongside rapid urbanisation and increasing incidence of child malnutrition in urban areas raises an important health policy question - whether fundamentally different nutrition policies and interventions are required in rural and urban areas. Addressing this question requires an enhanced understanding of the main drivers of rural-urban disparities in child nutrition outcomes especially for the vulnerable segments of the population. This study applies recently developed statistical methods to quantify the contribution of different socio-economic determinants to rural-urban differences in child nutrition outcomes in two South Asian countries – Bangladesh and Nepal. Methods Using DHS data sets for Bangladesh and Nepal, we apply quantile regression-based counterfactual decomposition methods to quantify the contribution of (1) the differences in levels of socio-economic determinants (covariate effects) and (2) the differences in the strength of association between socio-economic determinants and child nutrition outcomes (co-efficient effects) to the observed rural-urban disparities in child HAZ scores. The methodology employed in the study allows the covariate and coefficient effects to vary across entire distribution of child nutrition outcomes. This is particularly useful in providing specific insights into factors influencing rural-urban disparities at the lower tails of child HAZ score distributions. It also helps assess the importance of individual determinants and how they vary across the distribution of HAZ scores. Results There are no fundamental differences in the characteristics that determine child nutrition outcomes in urban and rural areas. Differences in the levels of a limited number of socio-economic characteristics – maternal education, spouse’s education and the wealth index (incorporating household asset ownership and access to drinking water and sanitation) contribute a major share of rural-urban disparities in the lowest quantiles of child nutrition outcomes. Differences in the strength of association between socio-economic characteristics and child nutrition outcomes account for less than a quarter of rural-urban disparities at the lower end of the HAZ score distribution. Conclusions Public health interventions aimed at overcoming rural-urban disparities in child nutrition outcomes need to focus principally on bridging gaps in socio-economic endowments of rural and urban households and improving the quality of rural infrastructure. Improving child nutrition outcomes in developing countries does not call for fundamentally different approaches to public health interventions in rural and urban areas.