Manganese: Minerals, Microbes, and the Evolution of Oxygenic Photosynthesis

Oxygenic photosynthesis fundamentally transformed our planet by releasing molecular oxygen and altering major biogeochemical cycles, and this exceptional metabolism relies on a redox-active cubane cluster of four manganese atoms. Not only is manganese essential for producing oxygen, but manganese is also only oxidized by oxygen and oxygen-derived species. Thus the history of manganese oxidation provides a valuable perspective on our planet’s environmental past, the ancient availability of oxygen, and the evolution of oxygenic photosynthesis. Broadly, the general trends of the geologic record of manganese deposition is a chronicle of ancient manganese oxidation: manganese is introduced into the fluid Earth as Mn(II) and it will remain only a trace component in sedimentary rocks until it is oxidized, forming Mn(III,IV) insoluble precipitates that are concentrated in the rock record. Because these manganese oxides are highly favorable electron acceptors, they often undergo reduction in sediments through anaerobic respiration and abiotic reaction pathways.

The following dissertation presents five chapters investigating manganese cycling both by examining ancient examples of manganese enrichments in the geologic record and exploring the mineralogical products of various pathways of manganese oxide reduction that may occur in sediments. The first chapter explores the mineralogical record of manganese and reports abundant manganese reduction recorded in six representative manganese-enriched sedimentary sequences. This is followed by a second chapter that further analyzes the earliest significant manganese deposit 2.4 billon years ago, and determines that it predated the origin of oxygenic photosynthesis and thus is supporting evidence for manganese-oxidizing photosynthesis as an evolutionary precursor prior to oxygenic photosynthesis. The lack of oxygen during this early manganese deposition was partially established using oxygen-sensitive detrital grains, and so a third chapter delves into what these grains mean for oxygen constraints using a mathematical model. The fourth chapter returns to processes affecting manganese post-deposition, and explores the relationships between manganese mineral products and (bio)geochemical reduction processes to understand how various manganese minerals can reveal ancient environmental conditions and biological metabolisms. Finally, a fifth chapter considers whether manganese can be mobilized and enriched in sedimentary rocks and determines that manganese was concentrated secondarily in a 2.5 billion-year-old example from South Africa. Overall, this thesis demonstrates how microbial processes, namely photosynthesis and metal oxide-reducing metabolisms, are linked to and recorded in the rich complexity of the manganese mineralogical record.

Recolonisation of temporary streams and evolution of a degree of stability of the zoocenose [Translation from: Ecologia Mediterranea No.1 149-164, 1976]

When flow returns to a temporary stream a certain number of plant and animal species establish themselves more or less rapidly on the stream-bed constituting the initial phase of evolution of the re-population. This phase is essentially characterised by the ”awakening” of animal species that passed the dry season in a dormant state and by the development of the first unicellular algae that constitute the periphyton. Then they are succeeded by more or less stable animal groups and the structural complexity increases. The authors of the present study aim to analyse the dynamics of community succession from the return of water to the biotope until its drying up. It is attempted to determine the influence of the duration of flow on this evolution. This work is based on the analysis of population diversity with reference to its two complementary aspects, species richness and equitability. The River Destel which was studied for this project is situated in the Gorge of Ollioules near the town of Toulon.

Observation and interpretation of tectonic strain release mechanisms

In four chapters various aspects of earthquake source are studied.

Chapter I

Surface displacements that followed the Parkfield, 1966, earthquakes were measured for two years with six small-scale geodetic networks straddling the fault trace. The logarithmic rate and the periodic nature of the creep displacement recorded on a strain meter made it possible to predict creep episodes on the San Andreas fault. Some individual earthquakes were related directly to surface displacement, while in general, slow creep and aftershock activity were found to occur independently. The Parkfield earthquake is interpreted as a buried dislocation.

Chapter II

The source parameters of earthquakes between magnitude 1 and 6 were studied using field observations, fault plane solutions, and surface wave and S-wave spectral analysis. The seismic moment, M_O, was found to be related to local magnitude, M_L, by log M_O = 1.7 M_L + 15.1. The source length vs magnitude relation for the San Andreas system found to be: M_L = 1.9 log L - 6.7. The surface wave envelope parameter AR gives the moment according to log M_O = log AR₃₀₀ + 30.1, and the stress drop, τ, was found to be related to the magnitude by τ = 0.54 M - 2.58. The relation between surface wave magnitude M_S and M_L is proposed to be M_S = 1.7 M_L - 4.1. It is proposed to estimate the relative stress level (and possibly the strength) of a source-region by the amplitude ratio of high-frequency to low-frequency waves. An apparent stress map for Southern California is presented.

Chapter III

Seismic triggering and seismic shaking are proposed as two closely related mechanisms of strain release which explain observations of the character of the P wave generated by the Alaskan earthquake of 1964, and distant fault slippage observed after the Borrego Mountain, California earthquake of 1968. The Alaska, 1964, earthquake is shown to be adequately described as a series of individual rupture events. The first of these events had a body wave magnitude of 6.6 and is considered to have initiated or triggered the whole sequence. The propagation velocity of the disturbance is estimated to be 3.5 km/sec. On the basis of circumstantial evidence it is proposed that the Borrego Mountain, 1968, earthquake caused release of tectonic strain along three active faults at distances of 45 to 75 km from the epicenter. It is suggested that this mechanism of strain release is best described as "seismic shaking."

Chapter IV

The changes of apparent stress with depth are studied in the South American deep seismic zone. For shallow earthquakes the apparent stress is 20 bars on the average, the same as for earthquakes in the Aleutians and on Oceanic Ridges. At depths between 50 and 150 km the apparent stresses are relatively high, approximately 380 bars, and around 600 km depth they are again near 20 bars. The seismic efficiency is estimated to be 0.1. This suggests that the true stress is obtained by multiplying the apparent stress by ten. The variation of apparent stress with depth is explained in terms of the hypothesis of ocean floor consumption.

Modelagem sedimentar de sistemas deltaicos altamente eficientes: aplicação para o preenchimento sedimentar do terciário superior da bacia de Bengala, porção nordeste da Índia

A bacia de Bengala, localizada a Nordeste da Índia tem uma história evolutiva extraordinária, diretamente controlada bela fragmentação do Gondwana. O início da formação desta bacia é considerada como sendo relacionada ao final do evento da quebra, datado em 126 Ma quando a Índia separou do continente Antártico e da Austrália. Desde então, a placa continental Indiana viajou do pólo sul a uma velocidade muito rápida (16 cm/a) chocando-se com o hemisfério norte e fundindo-se com a Placa Eurasiana. Durante a viagem passou por cima de um hot spot, onde hoje estão localizadas as ilhas Seicheles, resultando em um dos maiores derrames de lava basáltica do mundo, conhecido como Deccan Trap. Na região onde a bacia de Bengala foi formada, não houve aporte significativo de sedimentos siliciclásticos, resultando na deposição de uma espessa plataforma carbonática do Cretáceo tardio ao Eoceno. Após este período, devido a colisão com algumas microplacas e a amalgamação com a Placa Eurasiana, um grande volume sedimentar siliciclástico foi introduzido para a bacia, associado também ao soerguimento da cadeia de montanhas dos Himalaias. Atualmente, a Bacia de Bengala possui mais de 25 km de sedimentos, coletados neste depocentro principal. Nesta dissertação foram aplicados conceitos básicos de sismoestratigrafia na interpretação de algumas linhas regionais. As linhas sísmicas utilizadas foram adquiridas recentemente por programa sísmico especial, o qual permitiu o imageamento sísmico a mais de 35km dentro da litosfera (crosta continental e transicional). O dado permitiu interpretar eventos tectônicos, como a presença dos Seawards Dipping Reflectors (SDR) na crosta transicional, coberto por sedimentos da Bacia de Bengala. Além da interpretação sísmica amarrada a alguns poços de controle, o programa de modelagem sedimentar Beicip Franlab Dionisos, foi utilizado para modelar a história de preenchimento da bacia para um período de 5,2 Ma. O nível relativo do nível do mar e a taxa de aporte sedimentar foram os pontos chaves considerados no modelo. Através da utilização dos dados sísmicos, foi possível reconhecer dez quebras de plataformas principais, as quais foram utilizadas no modelo, amarrados aos seus respectivos tempos geológico, provenientes dos dados dos poços do Plioceno ao Holoceno. O resultado do modelo mostrou que a primeira metade modelada pode ser considerada como um sistema deposicional retrogradacional, com algum picos transgressivos. Este sistema muda drasticamente para um sistema progradacional, o qual atuou até o Holoceno. A seção modelada também mostra que no período considerado o total de volume depositado foi em torno de 2,1 x 106 km3, equivalente a 9,41 x 1014 km3/Ma.

Is there a subgroup of long-term evolution among patients with advanced lung cancer?: Hints from the analysis of survival curves from cancer registry data

Background: Recently, with the access of low toxicity biological and targeted therapies, evidence of the existence of a long-term survival subpopulation of cancer patients is appearing. We have studied an unselected population with advanced lung cancer to look for evidence of multimodality in survival distribution, and estimate the proportion of long-term survivors. Methods: We used survival data of 4944 patients with non-small-cell lung cancer (NSCLC) stages IIIb-IV at diagnostic, registered in the National Cancer Registry of Cuba (NCRC) between January 1998 and December 2006. We fitted one-component survival model and two-component mixture models to identify short-and long-term survivors. Bayesian information criterion was used for model selection. Results: For all of the selected parametric distributions the two components model presented the best fit. The population with short-term survival (almost 4 months median survival) represented 64% of patients. The population of long-term survival included 35% of patients, and showed a median survival around 12 months. None of the patients of short-term survival was still alive at month 24, while 10% of the patients of long-term survival died afterwards. Conclusions: There is a subgroup showing long-term evolution among patients with advanced lung cancer. As survival rates continue to improve with the new generation of therapies, prognostic models considering short-and long-term survival subpopulations should be considered in clinical research.

Understanding function and function-to-form evolution

This is a report on a workshop held at Cambridge University Engineering Design Centre, 17-10 June 1992. This workshop was held to discuss the issue of 'function' and 'function-to-form' evolution in mechanical design. The authors organised this workshop as they felt that their understanding of these topics was incomplete and that discussions between researchers might help to clarify some key issues.

The topic chosen for the workshop proved to be a stimulating one. The term 'function' is part of a designer's daily vocabulary, however there is poor agreement about its definition. In order to develop computer systems to support product evolution, a precise definition is required. Further the value of 'function' and 'function-to-form' evolution as a good choice of workshop topic is evident from the lack of firm conclusions that resulted from the sessions. This lack of consensus made for lively discussion and left participants questioning many of their preconceived ideas.

Attendance at the workshop was by invitation only. A list of the participants (not all those invited could attend due to time and financial constraints) is given in Appendix 1.