Risk factors for hepatitis C virus transmission in the municipality of Catanduva, State of São Paulo: a case-control study

Introduction Hepatitis C virus (HCV) is primarily transmitted via contact with the blood of infected patients, although the form of contact has not been identified for a significant percentage of carriers. The present study evaluated possible risk factors for HCV transmission in a medium-sized town located in the northwest region of the State of São Paulo. Methods This was a case-control study, with the case group consisting of 190 chronic HCV carriers older than 18 years residing in the municipality of Catanduva. The control group also consisted of 190 individuals with HCV-negative serology. The groups were paired (1:1) for gender, age range (± five years), and place of residence. The same structured questionnaire was applied to all subjects, who gave written informed consent to participate in the study. The data were statistically analyzed using crude and adjusted logistic regression, and the results were expressed as odds ratios with a 95% confidence interval. Results The demographic profiles of the groups indicated a predominance of males (68.9%) and mean ages of 47.1 years (case group) and 47.3 years (control group). After adjusting for conditional regression, the following factors were found to represent risks for HCV: history of sexually transmitted disease (STD) and blood transfusion; accidents with syringes and/or needles; tattoos; and the use of non-injectable drugs and injectable medications. Conclusions The transmission of HCV via the blood route has been well characterized. Other forms of contact with human blood and/or secretions are likely to transmit the virus, although with a lower frequency of occurrence.

Changes in the prevalence, incidence and residual risk for HIV and hepatitis C virus in Southern Brazilian blood donors since the implementation of NAT screening

Introduction Previous studies have shown high residual risk of transfusing a blood donation contaminated by human immunodeficiency virus (HIV) or hepatitis C virus (HCV) in Brazil and motivated the development of a Brazilian platform for simultaneous detection of both viruses by nucleic acid amplification test (NAT) denominated HIV/HCV Bio-Manguinhos/Fundação Oswaldo Cruz (FIOCRUZ). The objective of this study was to verify seroprevalence, incidence and residual risk for both viruses before and after the implementation of NAT. Methods Over 700,000 blood samples from all blood banks in the southern Brazilian State of Santa Catarina were analyzed during the period between January 2007 and July 2013. Results Compared with the period preceding the NAT screening, HIV prevalence increased from 1.38 to 1.58 per 1,000 donors, HIV incidence rate increased from 1.22 to 1.35 per 1,000 donor-years, and HIV residual risk dropped almost 2.5 times during the NAT period. For HCV, seroprevalence increased from 1.22 to 1.35 per 1,000 donors, incidence dropped from 0.12 to 0.06 per 1,000 donor-years, and residual risk decreased more than 3 times after the NAT implementation. Conclusions NAT reduced the duration of the immunologic window for HIV and HCV, thus corresponding to approximately 2.5- and 3-fold respective residual risk reductions.

Spatiotemporal analysis of reported cases of acute Chagas disease in the State of Pernambuco, Brazil, from 2002 to 2013

INTRODUCTION: Control strategies to eliminate the transmission of Chagas disease by insect vectors have significantly decreased the number of reported acute cases in Brazil. However, data regarding the incidence and distribution of acute Chagas disease cases in the State of Pernambuco are unavailable in the literature. METHODS: A geographical information system was used to delineate the spatiotemporal distribution profile of the cases from 2002 to 2013 in 185 municipalities of Pernambuco based on the municipality where notification occurred. The results were presented in digital maps generated by the TerraView software (INPE). RESULTS: A total of 302 cases of acute disease were recorded in 37.8% of the municipalities, for a total of 0.13 cases per 1,000,000 inhabitants per year. Out of the 302 cases, 99.3% were reported between 2002 and 2006. The most affected municipalities were Carnaubeira da Penha, Mirandiba and Terra Nova. The risk maps showed a significant decrease in the number of notifications and a concentration of cases in the Midwest region. CONCLUSIONS: This study highlights a significant decrease in new cases of acute Chagas disease in Pernambuco starting in 2006 when Brazil received an international certification for the interruption of vectorial transmission by Triatoma infestans. However, control strategies should still be encouraged because other triatomine species can also transmit the parasite; moreover, other transmission modes must not be neglected.

Assessment of schistosomiasis in the semi-arid Northeast region of Brazil: the São Francisco River large-scale water transposition project

Abstract: INTRODUCTION Risk of schistosomiasis expansion to semi-arid northeastern Brazil under the influence of the Integration Project of the São Francisco River (IPSFR) was assessed. METHODS: Stool examinations of schoolchildren, epidemiological investigation, and survey of the local host snail Biomphalaria straminea were performed in five IPSFR municipalities. RESULTS Six of 4,770 examined schoolchildren were egg-positive for Schistosoma mansoni. Biomphalaria straminea was widespread, but not naturally infected with S. mansoni. Snails experimentally exposed to two laboratory S. mansoni strains yielded infection indices of 1-4.5%. CONCLUSIONS: There is evidence of active schistosomiasis transmission in the area; thus, intensive surveillance actions are required.

Economics consulting project for the Iberian Marketing Oil department of Galp Energia: Strategy and Marketing guidelines for Galp Energia’sconvenience business in the Iberian market

Field lab: Consulting lab

Consulting project for the Iberian marketing Oil department of Galp Energia: Strategy and marketing guidelines for Galp Energia's convenience business in the Iberian market

Field lab: Consulting lab

Context costs and comparative advantages in the telecommunications sector in Portugal and China

This Work Project aims to discuss the Context Costs and Comparative Advantages of the Telecommunications sector both in Portugal and China. The work was built mostly on primary research by interviews with relevant people (business persons, University Professors and Agencies directors), and by economic data publicly available. A list of context costs and comparative advantages was drawn for each country and possible resolutions suggestions were made in the end. The context costs depend heavily on the economic situation of the countries and it should be taken into account when assessing the degree of magnitude of each cost of context. The competitive advantages of each country were drawn in comparison with one another. Some key results stand out: firstly, Portugal’s costs of context depend mainly on governmental decisions, uncertainties and instability and China’s cost of context depend primarily on cultural norms, mainly the Guanxi; second, the telecommunications sector shares most of its context costs and advantages with other sectors; third, China as an economic power could use the telecommunications sector as a way to further develop and boost its economy.

Operation modes of battery chargers for electric vehicles in the future smart grids

This paper presents an on-board bidirectional battery charger for Electric Vehicles (EVs), which operates in three different modes: Grid-to- Vehicle (G2V), Vehicle-to-Grid (V2G), and Vehicle-to-Home (V2H). Through these three operation modes, using bidirectional communications based on Information and Communication Technologies (ICT), it will be possible to exchange data between the EV driver and the future smart grids. This collaboration with the smart grids will strengthen the collective awareness systems, contributing to solve and organize issues related with energy resources and power grids. This paper presents the preliminary studies that results from a PhD work related with bidirectional battery chargers for EVs. Thus, in this paper is described the topology of the on-board bidirectional battery charger and the control algorithms for the three operation modes. To validate the topology it was developed a laboratory prototype, and were obtained experimental results for the three operation modes.

Project management: evaluation of the problems in the portuguese construction industry

During recent decades it has been possible to identify several problems in construction industry project management, related with to systematic failures in terms of fulfilling its schedule, cost and quality targets, which highlight a need for an evaluation of the factors that may cause these failures. Therefore, it is important to understand how project managers plan the projects, so that the performance and the results can be improved. However, it is important to understand if other areas beyond cost and time management that are mentioned on several studies as the most critical areas, receive the necessary attention from construction project managers. Despite the cost and time are the most sensitive areas/fields, there are several other factors that may lead to project failure. This study aims at understand the reasons that may cause the deviation in terms of cost, time and quality, from the project management point of view, looking at the knowledge areas mentioned by PMI (Project Management Institute).

Using glass-fibre reinforced polymer composites in the production of sustainable water storage vessels

The present work focuses on the use of the life cycle assessment (LCA) and life cycle costing (LCC)methodologies to evaluate environmental and economic impacts of polymers and polymer composites materials and products. Initially a literature review is performed in order to assess the scope and limitations of existing LCA and LCC studies on these topics. Then, a case study, based on the production of a water storage glass-fibre reinforced polymer (GFRP) composite storage tank, is presented. The storage tank was evaluated via a LCA/LCC integrated model, a novel way of analysing the life cycle (LC) environmental and economic performances of structural products. The overarching conclusion of the review is that the environmental and economic performances of polymers composites in non-mobile applications are seldom assessed and never in a combined integrated way.

Mechanical vs. electrical hysteresis of carbon nanotube/styrene-butadiene-styrene composites and their influence in the electromechanical response

The interesting properties of thermoplastics elastomers can be combined with carbon nanotubes (CNT) for the development of large strain piezoresistive composites for sensor applications. Piezoresistive properties of the composites depend on CNT content, with the gauge factor increasing for concentrations around the percolation threshold, mechanical and electrical hysteresis. The SBS copolymer composition (butadiene/styrene ratio) influences the mechanical and electrical hysteresis of composites and, therefore, the piezoresistive response. This work reports on the electrical and mechanical response of CNT/SBS composites with 4%wt nanofiller content, due to the larger electromechanical response. C401 and C540 SBS copolymers with 80% and 60% butadiene content, respectively have been selected. The copolymer with larger amount of soft phase (C401) shows a rubber-like mechanical behavior, with mechanical hysteresis increasing linearly with strain until 100% strain. The copolymer with the larger amount of hard phase (C540) just shows rubber-like behavior for low strains. The piezoresistive sensibility is similar for both composites for low strains, with a GF≈ 5 for 5% strain. The electrical hysteresis shows opposite behavior than the mechanical hysteresis, increasing with strain for both composites, but with higher increase for softer copolymer, C401. The GF increases with increasing strain, but this increase is larger for composites with lower amounts of soft phase due to the distinct initial modulus and deformation of the soft and hard phases of the copolymer. The soft phase shows larger strain under a given stress than the harder phase and the conductive pathway rearrangements in the composites are different for both phases, the harder copolymer (C540) showing higher piezoresistive sensibility, GF≈ 18, for 20% strain.

Effect of ionic liquid anion type in the performance of solid polymer electrolytes based on Poly(Vinylidene fluoride-trifluoroethylene)

The effect of different anions within the ionic liquid in the characteristics of solid polymer electrolytes (SPEs) based on P(VDF-TrFE) has been investigated. 1-ethyl-3-methylimidazolium acetate, [C2mim][OAc], 1-ethyl-3-methylimidazolium triflate, [C2mim][(CF3SO3)3], 1-ethyl-3-methylimidazolium lactate, [C2mim][Lactate], 1-ethyl-3-methylimidazolium thiocyanate, [C2mim][SNC] and 1-ethyl-3-methylimidazolium hydrogen sulphate [C2mim][HSO4] have been used in SPE prepared by thermally induced phase separation (TIPS). The polymer phase, thermal and electrochemical properties of the SPE have been determined. The thermal and electrical properties of the SPEs strongly depend on the selected IL, as determined by their different interactions with the polymer matrix. The room temperature ionic conductivity increases in the following way for the different anions: [SNC] > [CF3SO3)3] > [HSO4] > [Lactate] > [OAc], which is mainly dependent on the viscosity of the ionic liquid.

Effect of the acoustic impedance in ultrasonic emitter transducers using digital modulations

In an underwater environment it is difficult to implement solutions for wireless communications. The existing technologies using electromagnetic waves or lasers are not very efficient due to the large attenuation in the aquatic environment. Ultrasound reveals a lower attenuation, and thus has been used in underwater long-distance communications. The much slower speed of acoustic propagation in water (about 1500 m/s) compared with that of electromagnetic and optical waves, is another limiting factor for efficient communication and networking. For high data-rates and real-time applications it is necessary to use frequencies in the MHz range, allowing communication distances of hundreds of meters with a delay of milliseconds. To achieve this goal, it is necessary to develop ultrasound transducers able to work at high frequencies and wideband, with suitable responses to digital modulations. This work shows how the acoustic impedance influences the performance of an ultrasonic emitter transducer when digital modulations are used and operating at frequencies between 100 kHz and 1 MHz. The study includes a Finite Element Method (FEM) and a MATLAB/Simulink simulation with an experimental validation to evaluate two types of piezoelectric materials: one based on ceramics (high acoustic impedance) with a resonance design and the other based in polymer (low acoustic impedance) designed to optimize the performance when digital modulations are used. The transducers performance for Binary Amplitude Shift Keying (BASK), On-Off Keying (OOK), Binary Phase Shift Keying (BPSK) and Binary Frequency Shift Keying (BFSK) modulations with a 1 MHz carrier at 125 kbps baud rate are compared.

The importance of risk assessment in the context of investment project management: a case study

Risk management is an important component of project management. Nevertheless, such process begins with risk assessment and evaluation. In this research project, a detailed analysis of the methodologies used to treat risks in investment projects adopted by the Banco da Amazonia S.A. was made. Investment projects submitted to the FNO (Constitutional Fund for Financing the North) during 2011 and 2012 were considered for that purpose. It was found that the evaluators of this credit institution use multiple indicators for risk assessment which assume a central role in terms of decision-making and contribute for the approval or the rejection of the submitted projects; namely, the proven ability to pay, the financial records of project promotors, several financial restrictions, level of equity, level of financial indebtedness, evidence of the existence of a consumer market, the proven experience of the partners/owners in the business, environmental aspects, etc. Furthermore, the bank has technological systems to support the risk assessment process, an internal communication system and a unique system for the management of operational risk.

Brazil's global aspirations and their implications for the relationship with Argentina in the framework of MERCOSUR

Dissertação de mestrado em Relações Internacionais