Design and experimental testing of air slab caps which convert commercial electron diodes into dual purpose, correction-free diodes for small field dosimetry

Purpose Two diodes which do not require correction factors for small field relative output measurements are designed and validated using experimental methodology. This was achieved by adding an air layer above the active volume of the diode detectors, which canceled out the increase in response of the diodes in small fields relative to standard field sizes. Methods Due to the increased density of silicon and other components within a diode, additional electrons are created. In very small fields, a very small air gap acts as an effective filter of electrons with a high angle of incidence. The aim was to design a diode that balanced these perturbations to give a response similar to a water-only geometry. Three thicknesses of air were placed at the proximal end of a PTW 60017 electron diode (PTWe) using an adjustable “air cap”. A set of output ratios (ORfclin Det ) for square field sizes of side length down to 5 mm was measured using each air thickness and compared to ORfclin Det measured using an IBA stereotactic field diode (SFD). k fclin, f msr Qclin,Qmsr was transferred from the SFD to the PTWe diode and plotted as a function of air gap thickness for each field size. This enabled the optimal air gap thickness to be obtained by observing which thickness of air was required such that k fclin, f msr Qclin,Qmsr was equal to 1.00 at all field sizes. A similar procedure was used to find the optimal air thickness required to make a modified Sun Nuclear EDGE detector (EDGEe) which s “correction-free” in small field relative dosimetry. In addition, the feasibility of experimentally transferring k fclin, f msr Qclin,Qmsr values from the SFD to unknown diodes was tested by comparing the experimentally transferred k fclin, f msr Qclin,Qmsr values for unmodified PTWe and EDGEe diodes to Monte Carlo simulated values. Results 1.0 mm of air was required to make the PTWe diode correction-free. This modified diode (PTWeair) produced output factors equivalent to those in water at all field sizes (5–50 mm). The optimal air thickness required for the EDGEe diode was found to be 0.6 mm. The modified diode (EDGEeair) produced output factors equivalent to those in water, except at field sizes of 8 and 10 mm where it measured approximately 2% greater than the relative dose to water. The experimentally calculated k fclin, f msr Qclin,Qmsr for both the PTWe and the EDGEe diodes (without air) matched Monte Carlo simulated results, thus proving that it is feasible to transfer k fclin, f msr Qclin,Qmsr from one commercially available detector to another using experimental methods and the recommended experimental setup. Conclusions It is possible to create a diode which does not require corrections for small field output factor measurements. This has been performed and verified experimentally. The ability of a detector to be “correction-free” depends strongly on its design and composition. A nonwater-equivalent detector can only be “correction-free” if competing perturbations of the beam cancel out at all field sizes. This should not be confused with true water equivalency of a detector.

DIY media architecture: Open and participatory approaches to community engagement

Media architecture’s combination of the digital and the physical can trigger, enhance, and amplify urban experiences. In this paper, we examine how to bring about and foster more open and participatory approaches to engage communities through media architecture by identifying novel ways to put some of the creative process into the hands of laypeople. We review technical, spatial, and social aspects of DIY phenomena with a view to better understand maker cultures, communities, and practices. We synthesise our findings and ask if and how media architects as a community of practice can encourage the ‘open-sourcing’ of information and tools allowing laypeople to not only participate but become active instigators of change in their own right. We argue that enabling true DIY practices in media architecture may increase citizen control. Seeking design strategies that foster DIY approaches, we propose five areas for further work and investigation. The paper begs many questions indicating ample room for further research into DIY Media Architecture.

The psychology of containment : mis/representing emotional and behavioural difficulties in Australian schools

The number of students in special schools has increased at a rapid rate in some Australian states, due in part to increased enrolment under the categories of emotional disturbance (ED) and behaviour disorder (BD). Nonetheless, diagnostic distinctions between ED and BD are unclear. Moreover, despite international findings that students with particular backgrounds are over-represented in special schools, little is known about the backgrounds of students entering such settings in Australia. This study examined the government school enrolment data from New South Wales, the most populous of the Australian states. Linear and quadratic trends were used to describe the numbers and ages of students enrolled in special schools in the ED and BD categories. Changes between 1997 and 2007 were observed. Results showed an over-representation of boys that increased across the decade and a different pattern across age for boys and girls. Consistent with international findings, these results indicate that trends in special school placements are unrelated to disability prevalence in the population. Rather, it is suggested that schools act to preserve time and resources for others by removing their more challenging students: most typically, boys.

“I’m Happy with Who I Am” : A Discursive Analysis of the Self-characterisation Practices of Boys in “Behaviour” Schools

In this chapter, I draw on poststructural theories of language to examine the self-characterisation practices of 33 boys attending special schools for students with disruptive behaviour. During a semi-structured interview, each boy was asked to describe his personality and then to choose from a selection of positive/negative word pairs. The objective was to determine whether these young people would characterise themselves in positive or negative ways. Participants were then asked if there was anything they would change about themselves if they could. Responses were analysed and compared against a discourse model developed from media reports and interviews with their principals. Findings suggest that while discourse may well ‘form the objects of which it speaks’ (Foucault, 1972, p. 49) in the eyes of teachers, principals, psychiatrists and paediatricians, it also offers a means through which the constituted subject can re-author itself in a more positive frame.

Implementation and evaluation of open source unified communications for SMBs

Unified Communication (UC) is the integration of two or more real time communication systems into one platform. Integrating core communication systems into one overall enterprise level system delivers more than just cost saving. These real-time interactive communication services and applications over Internet Protocol (IP) have become critical in boosting employee accessibility and efficiency, improving customer support and fostering business agility. However, some small and medium-sized businesses (SMBs) are far from implementing this solution due to the high cost of initial deployment and ongoing support. In this paper, we will discuss and demonstrate an open source UC solution, viz. “Asterisk” for use by SMBs, and report on some performance tests using SIPp. The contribution from this research is the provision of technical advice to SMBs in deploying UC, which is manageable in terms of cost, ease of deployment and support.

It's safe to say there is no safe level of air pollution

Outdoor air pollution is a killer. A recent report from the World Health Organization estimated that 3.7 million deaths per year are due to outdoor air pollution. Most of these deaths are in low and middle income countries, with China being the country that often springs to mind. However, Australia still has a relatively big air pollution problem with an estimated 3,000 deaths per year. Traffic pollution is the major contributor to urban air pollution in Australia. Extreme events, such dust storms, bushfires and the recent coal fire in Morwell, dramatically increase pollution levels (for days or weeks) and are also very hazardous to health. Australian governments in the last 30 years have committed to improving air quality, and policies have been discussed and implemented with the aim of creating cleaner air. One key policy measure is the National Environment Protection Measures for air quality. These set standards for six important outdoor pollutants. Their key goal is to create “ambient air quality that allows for the adequate protection of human health and wellbeing”.

“This is not a burning issue for me”: How citizens justify their use of wood heaters in a city with a severe air pollution problem

Although wood smoke pollution has been linked to health problems, wood burning remains a popular form of domestic heating in many countries across the world. In this paper, we describe the rhetoric of resistance to wood heater regulation amongst citizens in the regional Australian town of Armidale, where wood smoke levels regularly exceed national health advisory limits. We discuss how this is related to particular sources of resistance, such as affective attachment to wood heating and socio-cultural norms. The research draws on six focus groups with participants from households with and without wood heating. With reference to practice theory, we argue that citizen discourses favouring wood burning draw upon a rich suite of justifications and present this activity as a natural and traditional activity promoting comfort and cohesion. Such discourses also emphasise the identity of the town as a rural community and the supposed gemeinschaft qualities of such places. We show that, in this domain of energy policy, it is not enough to present ‘facts’ which have little emotional association or meaning for the populace. Rather, we need understand how social scripts, often localised, inform identity and practice.

Teacher education for high-poverty schools : keeping the bar high

For some time now, there has been a focus, both in Australia and internationally, on quality teaching as a fundamental component that affects the educational outcomes of all students. The question of how teacher education programs in Australia prepare effective teachers to work across all school settings-including low-SES schools-has been elevated to national prominence by data from the 20 12 Programme for International Student Assessment (PIS A), which revealed a fall in Australian students' world ranking across Mathematics, Reading and Science. Education is commonly acknowledged as a "foundation capability" that improves a person's life chances, including employment prospects, and it is widely understood to be a "route out of disadvantage" (McLachlan, Gilfillan, and Gordon 20 13). The Australian Bureau of Statistics 201 1- 12 data suggest that around 2.6 million (11.8%) Australians currently live under the poverty line (Phillips et a!. 2012, 8). According to the Organisation for Economic Cooperation and Development (OECD), despite the significant effects teachers have on student performance, disadvantaged schools are not always staffed with the highest quality teachers (see Darling-Hammond, 2006).

Subtropical futures : Victoria Park re-imagined

Brisbane, the capital of Queensland, in South-East Queensland is situated on the Brisbane River, one of the largest rivers (and floodplains) on the east coast of Australia. The river defines the city and gives it its name. The river has been a natural place to accommodate some population growth for the city with high-density development that capitalises on the natural amenity, cycleways and a string of parks and the flatter land. The major floods of 2011 and the scare of 2013, has seen a more malevolent quality of the river and shift of thinking on its role within the city. The floods have made council, for the first time, acquire prime development sites near the river, with proposals for high density development and made them parks, at great cost. The pressure for population growth in Brisbane remains. 140,000 new dwellings are required by 2031. Brownfield sites are less plentiful and there is interest to rethink of some of the other strategic locations in the city away from the river on higher ground and steeper slopes. Some of these places are currently open spaces. Victoria Park Golf Course sits on a high ridge line and a very strategic part of the city just north of the city centre is one of the few remaining golf courses close to the centre of an Australian capital city. While it is a public course and a valuable community asset, it has been compromised by the recently completed northern busway with two bus stations constructed on its edges. It is bounded on the west and north-east by two major community facilities, the Queensland University of Technology (QUT) to the west and RBW Hospital at its northern end. In a city in need of urban consolidation, perhaps it is time to review the future of the golf course. This question has been investigated as a conjecture in the Master of Architecture program at the QUT. The project has been to re-imagine Victoria Park as a new city parkland and a place that makes an urban connection from the QUT to the hospital. This new urban precinct is be a medium to high-density transit oriented development that capitalises on the bus way stations and the proximity of the university and hospital. The precinct will frame/define/interact with the new major urban park for the city. A key question being addressed is how the design can embody and define principles of a subtropical urbanism. Students are identifying the appropriate street and block structure, density and built form to be accommodated on blocks that define and activate a rich sequence of streets and public spaces. The paper will present a critical overview of the project work that provides a lens to how future professionals may respond to these issue that will be the focus of their professional lives.

Integrated approach to optimize open-pit mine block sequencing

Critical stage in open-pit mining is to determine the optimal extraction sequence of blocks, which has significant impacts on mining profitability. In this paper, a more comprehensive block sequencing optimisation model is developed for the open-pit mines. In the model, material characteristics of blocks, grade control, excavator and block sequencing are investigated and integrated to maximise the short-term benefit of mining. Several case studies are modeled and solved by CPLEX MIP and CP engines. Numerical investigations are presented to illustrate and validate the proposed methodology.

A non-fullerene electron acceptor based on fluorene and diketopyrrolopyrrole building blocks for solution-processable organic solar cells with an impressive open-circuit voltage

A novel solution-processable non-fullerene electron acceptor 6,6′-(5,5′-(9,9-dioctyl-9H-fluorene-2,7-diyl)bis(thiophene-5,2-diyl))bis(2,5-bis(2-ethylhexyl)-3-(thiophen-2-yl)pyrrolo[3,4-c]pyrrole-1,4(2H,5H)-dione) (DPP1) based on fluorene and diketopyrrolopyrrole conjugated moieties was designed, synthesized and fully characterized. DPP1 exhibited excellent solubility and high thermal stability which are essential for easy processing. Upon using DPP1 as an acceptor with the classical electron donor poly(3-hexylthiophene), solution processable bulk-heterojunction solar cells afforded a power conversion efficiency of 1.2% with a high open-circuit voltage (1.1 V). As per our knowledge, this value of open circuit voltage is one of the highest values reported so far for a bulk-heterojunction device using DPP1 as a non-fullerene acceptor.