Distributed Fault Diagnosis Using Bayesian Reasoning in MAGNETO

Many of the emerging telecom services make use of Outer Edge Networks, in particular Home Area Networks. The configuration and maintenance of such services may not be under full control of the telecom operator which still needs to guarantee the service quality experienced by the consumer. Diagnosing service faults in these scenarios becomes especially difficult since there may be not full visibility between different domains. This paper describes the fault diagnosis solution developed in the MAGNETO project, based on the application of Bayesian Inference to deal with the uncertainty. It also takes advantage of a distributed framework to deploy diagnosis components in the different domains and network elements involved, spanning both the telecom operator and the Outer Edge networks. In addition, MAGNETO features self-learning capabilities to automatically improve diagnosis knowledge over time and a partition mechanism that allows breaking down the overall diagnosis knowledge into smaller subsets. The MAGNETO solution has been prototyped and adapted to a particular outer edge scenario, and has been further validated on a real testbed. Evaluation of the results shows the potential of our approach to deal with fault management of outer edge networks.

Study of the evolution of the seismic cycle of stress and strain associated to the El Salvador Fault Zone

• Central America: – Regional studies in Central America (Seismic Hazard). – El Salvador Fault Zone (ESFZ). – Aguacaliente‐Navarro Fault Zone (ANFZ), Central Valley of Costa Rica. – Haiti (seismic hazard) • Spain: – Regional‐Nacional studies of seismic hazards (applications to building codes, eurocode, emergency plans, etc.) – Betic range zone, south of Spain. – Ibero‐Maghrebi region (collision zone)

Fault Tolerance Analysis and Self-Healing Strategy of Autonomous, Evolvable Hardware Systems

This paper presents an analysis of the fault tolerance achieved by an autonomous, fully embedded evolvable hardware system, which uses a combination of partial dynamic reconfiguration and an evolutionary algorithm (EA). It demonstrates that the system may self-recover from both transient and cumulative permanent faults. This self-adaptive system, based on a 2D array of 16 (4×4) Processing Elements (PEs), is tested with an image filtering application. Results show that it may properly recover from faults in up to 3 PEs, that is, more than 18% cumulative permanent faults. Two fault models are used for testing purposes, at PE and CLB levels. Two self-healing strategies are also introduced, depending on whether fault diagnosis is available or not. They are based on scrubbing, fitness evaluation, dynamic partial reconfiguration and in-system evolutionary adaptation. Since most of these adaptability features are already available on the system for its normal operation, resource cost for self-healing is very low (only some code additions in the internal microprocessor core)

A mathematical framework for new fault detection schemes in nonlinear stochastic continuous-time dynamical systems

n this work, a mathematical unifying framework for designing new fault detection schemes in nonlinear stochastic continuous-time dynamical systems is developed. These schemes are based on a stochastic process, called the residual, which reflects the system behavior and whose changes are to be detected. A quickest detection scheme for the residual is proposed, which is based on the computed likelihood ratios for time-varying statistical changes in the Ornstein–Uhlenbeck process. Several expressions are provided, depending on a priori knowledge of the fault, which can be employed in a proposed CUSUM-type approximated scheme. This general setting gathers different existing fault detection schemes within a unifying framework, and allows for the definition of new ones. A comparative simulation example illustrates the behavior of the proposed schemes.

Simulation of academic performance rates, estimation of indicators of subjects and of a complete degree

The purpose of this paper is to present a program written in Matlab-Octave for the simulation of the time evolution of student curricula, i.e, how students pass their subjects along time until graduation. The program computes, from the simulations, the academic performance rates for the subjects of the study plan for each semester as well as the overall rates, which are a) the efficiency rate defined as the ratio of the number of students passing the exam to the number of students who registered for it and b) the success rate, defined as the ratio of the number of students passing the exam to the number of students who not only registered for it but also actually took it. Additionally, we compute the rates for the bachelor academic degree which are established for Spain by the National Quality Evaluation and Accreditation Agency (ANECA) and which are the graduation rate (measured as the percentage of students who finish as scheduled in the plan or taking an extra year) and the efficiency rate (measured as the percentage of credits which a student who graduated has really taken). The simulation is done in terms of the probabilities of passing all the subjects in their study plan. The application of the simulator to Polytech students in Madrid, where requirements for passing are specially stiff in first and second year subjects, is particularly relevant to analyze student cohorts and the probabilities of students finishing in the minimum of four years, or taking and extra year or two extra years, and so forth. It is a very useful tool when designing new study plans. The calculation of the probability distribution of the random variable "number of semesters a student has taken to complete the curricula and graduate" is difficult or even unfeasible to obtain analytically, and this is even truer when we incorporate uncertainty in parameter estimation. This is why we apply Monte Carlo simulation which not only provides illustration of the stochastic process but also a method for computation. The stochastic simulator is proving to be a useful tool for identification of the subjects most critical in the distribution of the number of semesters for curriculum vitae (CV) completion and subsequently for a decision making process in terms of CV planning and passing standards in the University. Simulations are performed through a graphical interface where also the results are presented in appropriate figures. The Project has been funded by the Call for Innovation in Education Projects of Universidad Politécnica de Madrid (UPM) through a Project of its school Escuela Técnica Superior de Ingenieros Industriales ETSII during the period September 2010-September 2011.

Ranking web services using centralities and social indicators

Nowadays, developers of web application mashups face a sheer overwhelming variety and pluralism of web services. Therefore, choosing appropriate web services to achieve specific goals requires a certain amount of knowledge as well as expertise. In order to support users in choosing appropriate web services it is not only important to match their search criteria to a dataset of possible choices but also to rank the results according to their relevance, thus minimizing the time it takes for taking such a choice. Therefore, we investigated six ranking approaches in an empirical manner and compared them to each other. Moreover, we have had a look on how one can combine those ranking algorithms linearly in order to maximize the quality of their outputs.

A multi-agent system with distributed bayesian reasoning for network fault diagnosis

In this paper, an innovative approach to perform distributed Bayesian inference using a multi-agent architecture is presented. The final goal is dealing with uncertainty in network diagnosis, but the solution can be of applied in other fields. The validation testbed has been a P2P streaming video service. An assessment of the work is presented, in order to show its advantages when it is compared with traditional manual processes and other previous systems.

Damage assessment on building structures subjected to the recent near-fault earthquake in Lorca (Spain)

The city of Lorca (Spain) was hit on May 11th 2011 by two consecutive earthquakes with 4.6 and 5.2 Mw respectively, causing casualties and important damage in buildings. Lorca is located in the south-east region of Spain and settled on the trace of the Murcia-Totana-Lorca fault. Although the magnitudes of these ground motions were not severe, the damage observed was considerable over a great amount of buildings. More than 300 of them have been demolished and many others are being retrofitted. This paper reports a field study on the damage caused by these earthquakes. The observed damage is related with the structural typology. Further, prototypes of the damaged buildings are idealized with nonlinear numerical models and their seismic behavior and proneness to damage concentration is further investigated through dynamic response analyses.

Time derivatives in air temperature and enthalpy as non-invasive welfare indicators during long distance animal transport in Spain and Portugal.

High temperatures and relative humidity can compromise animal welfare on the farm level, but less is known about those changes during long distance transport of domestic animals to slaughter. Although upper temperature limits have been established to transport pigs in Europe, few indices include relative or absolute humidity maxima or mention appropriate enthalpy ranges.

Fault detection and isolation on a noisy nonlinear circuit

In this paper fault detection and isolation (FDI) schemes are applied in the context of the surveillance of emerging faults in an electrical circuit. The FDI problem is studied on a noisy nonlinear circuit, where both abrupt and incipient faults in the voltage source are considered. A rigorous analysis of fault detectability precedes the application of the fault detection (FD) scheme; then, the fault isolation (FI) phase is accomplished with two alternative FI approaches, proposed as new extensions of that FD approach. Numerical simulations illustrate the applicability of the mentioned schemes.

Relationship between objective and subjective indicators in urban soundscape analysis. The case of Cordoba - Argentina

This paper presents the main results of a comparative evaluation of some acoustical parameters with the user´s perception of urban sounds. The study was carried out in three open spaces integrated with different environmental characteristics but similar objective conditions of urban noise. The subjective evaluation was done by means of a survey simultaneously with the objective measurements. The results of the crossed analysis confirmed that in environments with similar noise levels not always exists direct correlation between the objetive indicators and the acoustic comfort of the people. To predict the acustical quality of the soundscape it is necessary to consider aspects such as the background noise and the perception of natural or technological sounds as complements of the general sound level.

Indicators and Estimators in P-Adaptive Boundary Elements

The paper presents the possibility of implementing a p-adaptive process with the B.E.M. Although the exemples show that good results can be obtained with a limited amount of storage and with the simple ideas explained above, more research is needed in order to improve the two main problems of the method, i.e.: the criteria of where to refine and until what degree. Mathematically based reasoning is still lacking and will be useful to simplify the decission making. Nevertheless the method seems promising and, we hope, opens a path for a series of research lines of maximum interest. Although the paper has dealt only with plane potential problem the extension to plane elasticity as well as to 3-D potential problem is straight-forward.

The influence of economic incentives linked to road safety indicators on accidents: The case of toll concessions in Spain

The goal of this paper is to evaluate whether the incentives incorporated in toll highway concession contracts in order to encourage private operators to adopt measures to reduce accidents are actually effective at improving safety. To this end, we implemented negative binomial regression models using information about highway characteristics and accident data from toll highway concessions in Spain from 2007 to 2009. Our results show that even though road safety is highly influenced by variables that are not managed by the contractor, such as the annual average daily traffic (AADT), the percentage of heavy vehicles on the highway, number of lanes, number of intersections and average speed; the implementation of these incentives has a positive influence on the reduction of accidents and injuries. Consequently, this measure seems to be an effective way of improving safety performance in road networks.

Indicators of sustainability of agriculture and livestock in Spain - Indicadores de sostenibilidad de la agricultura y ganadería española

Sustainability is an adjective used to characterize agriculture according to the degree of fulfillment of goals. Those goals are related to agro-ecological, environmental and socio-economic dimensions. Sustainability is a dynamic and temporal character. In absolute terms there is not an ending value because it changes as its dimensions make it. Spain is one of the main agricultural countries of the European Union both in terms of crop land and value of productions. The object of this study is to present a methodology of sustainability account to be incorporated into national statistical and to assess their performance in the course of the years. For that reason the data sources used have been the statistics of the Department of Agriculture and from others database. We presented a set of indicators of sustainability and its evaluation in a time series of at least 30 years. The trend analysis offers the evolution of the numerical values of the indicators in terms of efficiency, physical units used for a unit of product or its value in euros. The analyzed crops have been: wheat, barley, maize, sunflower, sugar beet, wine grape, olive oil, citrus, melon and tomato. Physical indicators were: land, water, energy, erosion, soil organic matter, and carbon balance; socio-economic indicators were: agricultural final production, prices, income, employment and use of fertilizers. In general, all crops increased their productive efficiency, higher in irrigated than on dry land. Spanish agricultural carbon sequestration capacity has multiplied by five in the last seventy years, as a result of the increase in the productivity of crops, in terms of total biomass and the modification of the soil management techniques. Livestock sector presents data of pork, broilers and laying hen. Those showed an improvement in efficiency and economic indicators. Overall we can say that Spanish agriculture and livestock subsector have a tendency towards sustainability, being its main threats extreme meteorological factors and the instability of todays markets.

Modelling the relationship between urban environment and travel behaviour: policy and indicators

Due to the necessity to undertake activities, every year people increase their standards of travelling (distance and time). Urban sprawl development plays an important role in these "enlargements". Thus, governments invest money in an exhaustiva search for solutions to high levels of congestion and car-trips. The complex relationship between urban environment and travel behaviour has been studied in a number of cases. Thus, the objective of this paper is to answer the important question of which land-use attributes influence which dimensions of travel behaviour, and to verify to what extent specific urban planning measures affect the individual decision process, by exhaustiva statistical and systematic tests. This paper found that a crucial issue in the analysis of the relationship between the built environment and travel behaviour is the definition of indicators. As such, we recommend a feasible list of indicators to analyze this relationship.