A Raman spectroscopic study of copiapites Fe2+Fe3+(SO4)6(OH)2 · 20H2O: environmental implications

Raman spectroscopy has been used to study selected mineral samples of the copiapite group. Copiapite (Fe2+Fe3+(SO4)6(OH)2 · 20H2O) is a secondary mineral formed through the oxidn. of pyrite. Minerals of the copiapite group have the general formula AFe4(SO4)6(OH)2 · 20H2O, where A has a + 2 charge and can be either magnesium, iron, copper, calcium and/or zinc. The formula can also be B2/3Fe4(SO4)6(OH)2 · 20H2O, where B has a + 3 charge and may be either aluminum or iron. For each mineral, two Raman bands are obsd. at around 992 and 1029 cm-1, assigned to the (SO4)2-ν1 sym. stretching mode. The observation of two bands provides evidence for the existence of two non-equiv. sulfate anions in the mineral structure. Three Raman bands at 1112, 1142 and 1161 cm-1 are obsd. in the Raman spectrum of copiapites, indicating a redn. of symmetry of the sulfate anion in the copiapite structure. This redn. in symmetry is supported by multiple bands in the ν2 and ν4(SO4)2- spectral regions.

Characterisation of organoclays and adsorption of p-nitrophenol : environmental application

Organoclays were synthesised through ion exchange of a single surfactant for sodium ions, and characterised by a range of method including X-ray diffraction (XRD), BET, X-ray photoelectron spectroscopy (XPS), thermogravimetric analysis (TGA), Fourier transform infrared spectroscopy (FT-IR), and transmission electron microscopy (TEM). The change in surface properties of montmorillonite and organoclays intercalated with the surfactant, tetradecyltrimethylammonium bromide (TDTMA) were determined using XRD through the change in basal spacing and the expansion occurred by the adsorbed p-nitrophenol. The changes of interlayer spacing were observed in TEM. In addition, the surface measurement such as specific surface area and pore volume was measured and calculated using BET method, this suggested the loaded surfactant is highly important to determine the sorption mechanism onto organoclays. The collected results of XPS provided the chemical composition of montmorillonite and organoclays, and the high-resolution XPS spectra offered the chemical states of prepared organoclays with binding energy. Using TGA and FT-IR, the confirmation of intercalated surfactant was investigated. The collected data from various techniques enable an understanding of the changes in structure and surface properties. This study is of importance to provide mechanisms for the adsorption of organic molecules, especially in contaminated environmental sites and polluted waters.

Design for eco-services. Part A - Environmental Services

Without the virtually free services of nature like clean air and water, humans would not last long. Natural systems can be incorporated in existing urban structures or spaces to add public amenity, mitigate the heat island effect, reduce pollution, add oxygen, and ensure water, electricity and food security in urban areas. Th ere are many eco-solutions that could radically reduce resource consumption and pollution and even provide surplus ecosystem services in the built environment at little or no operational cost, if adequately supported by design. Th is paper is the fi rst of a two part paper that explains what eco-services are, then provides examples of how design can generate natural as well as social capital. Using examples of actual and notional solutions, both papers set out to challenge designers to ‘think again’, and invent ways of creating net positive environmental gains through built environment design.

An assessment of timber dwellings typical of the Queenslander era, and constraints associated with their relocation, component and adaptive reuse when considering 'regeneration'

This paper presents an explanation of why the reuse of building components after demolition or deconstruction is critical to the future of the construction industry. An examination of the historical cause and response to climate change sets the scene as to why governance is becoming increasingly focused on the built environment as a mechanism to controlling waste generation associated with the process of demolition, construction and operation. Through an annotated description to the evolving design and construction methodology of a range of timber dwellings (typically 'Queenslanders' during the eras of 1880-1900, 1900-1920 & 1920-1940) the paper offers an evaluation to the variety of materials, which can be used advantageously by those wishing to 'regenerate' a Queenslander. This analysis of 'regeneration' details the constraints when considering relocation and/ or reuse by adaption including deconstruction of building components against the legislative framework requirements of the Queensland Building Act 1975 and the Queensland Sustainable Planning Act 2009, with a specific examination to those of the Building Codes of Australia. The paper concludes with a discussion of these constraints, their impacts on 'regeneration' and the need for further research to seek greater understanding of the practicalities and drivers of relocation, adaptive and building components suitability for reuse after deconstruction.

Multiple evolutionary rate classes in animal genome evolution

The proportion of functional sequence in the human genome is currently a subject of debate. The most widely accepted figure is that approximately 5% is under purifying selection. In Drosophila, estimates are an order of magnitude higher, though this corresponds to a similar quantity of sequence. These estimates depend on the difference between the distribution of genomewide evolutionary rates and that observed in a subset of sequences presumed to be neutrally evolving. Motivated by the widening gap between these estimates and experimental evidence of genome function, especially in mammals, we developed a sensitive technique for evaluating such distributions and found that they are much more complex than previously apparent. We found strong evidence for at least nine well-resolved evolutionary rate classes in an alignment of four Drosophila species and at least seven classes in an alignment of four mammals, including human. We also identified at least three rate classes in human ancestral repeats. By positing that the largest of these ancestral repeat classes is neutrally evolving, we estimate that the proportion of nonneutrally evolving sequence is 30% of human ancestral repeats and 45% of the aligned portion of the genome. However, we also question whether any of the classes represent neutrally evolving sequences and argue that a plausible alternative is that they reflect variable structure-function constraints operating throughout the genomes of complex organisms.

What the experts think : fast bowling expertise acquisition and talent development

For applied sport scientists charged with developing talented performers an essential requirement is to identify components contributing to the development and maintenance of expertise. Previous qualitative analysis has revealed several psychological (e.g., mental focus, goal-setting and selfevaluation), socio-cultural (e.g. community and family support, cultural influence), physical (e.g., strength, height) and environmental (e.g., access to facilities and climate) constraints on successful Olympian development (Abbott et al., 2005). Open-ended interviews with expert athletes and/or expert coaches have been used to reveal competencies of elite performers to derive factors associated with success (Durand-Bush et al., 2002). However, the influence of these factors is likely to be sport-specific due to different task constraints and the changing nature of the performer-environment relationship through practice, coaching and competing (Vaeyens et al., 2008). So far, only one study on expertise acquisition in cricket has been undertaken. Weissensteiner, et al. (2009) found that development of expertise in cricket batting in Australia may be facilitated by early unstructured play (i.e. ‘backyard cricket’), a wide range of sport experience during development, and early exposure to playing with seniors.

The constraints-based approach to motor learning : Implications for a non-linear pedagogy in sport and physical education

Recently, a constraints- led approach has been promoted as a framework for understanding how children and adults acquire movement skills for sport and exercise (see Davids, Button & Bennett, 2008; Araújo et al., 2004). The aim of a constraints- led approach is to identify the nature of interacting constraints that influence skill acquisition in learners. In this chapter the main theoretical ideas behind a constraints- led approach are outlined to assist practical applications by sports practitioners and physical educators in a non- linear pedagogy (see Chow et al., 2006, 2007). To achieve this goal, this chapter examines implications for some of the typical challenges facing sport pedagogists and physical educators in the design of learning programmes.