von Neumann spin measurements with Rashba fields

We show that dynamics in the spin-orbit coupling field simulate the von Neumann measurement of a particle spin. We demonstrate how the measurement influences the spin and coordinate evolution of a particle by comparing two examples of such a procedure. The first example is a simultaneous measurement of spin components, sigma(x) and sigma(y), corresponding to non-commuting operators, which cannot be accurately obtained together at a given time instant due to the Heisenberg uncertainty ratio. By mapping spin dynamics onto a spatial walk, such a procedure determines measurement-time averages of sigma(x) and sigma(y), which can already be precisely evaluated in a single short-time measurement. The other, qualitatively different, example is the spin of a one-dimensional particle in a magnetic field. Here, the measurement outcome depends on the angle between the spin-orbit coupling and magnetic fields. These results can be applied to studies of spin-orbit coupled cold atoms and electrons in solids.

Electric field distribution in resonant reflection filters under normal incidence

Electric field distributions inside resonant reflection filters constructed using planar periodic waveguides are investigated in this paper. The electric fields may be intensified by resonance effects. Although the resonant reflection peaks can be quite narrow using weakly modulated planar periodic waveguides, the strong electric field enhancement limits their use in high-power laser systems. Strongly modulated waveguides may be used to reduce the electric field enhancement and a cover layer may be used to narrow the bandwidth at the same time. Desired results (i.e. almost no electric field enhancement together with narrow bandwidth) can be realized using this simple structure.

River Ribble sheep dip incident September 1997. Electric-fishing survey report

This report summarises the findings of a series of electric-fishing surveys carried out at four sites on the River Ribble from September 1997 to September 1998. The aims of these surveys were to assess the impact on juvenile salmonids of a pollution incident involving Synthetic Pyrethrin (SP) that occurred near High Birkwith I (SD 802 767) in September 1997.One of these sites was 2.65km upstream of the pollution whilst the remaining three were at varying distances downstream. Data was collected during surveys of the River Ribble in 1992, 97 and 98. The 1997 and 1998 surveys were carried out specifically to monitor for any possible effects of the SP discharge. Data are shown as grades derived from the National Fisheries Classification scheme (NFC). Results are given for the four salmonid life stages; 0+ trout, >0+ trout, 0+ salmon, >0+ salmon and also Total Salmonids.

An investigation into the effects of electric fishing equipment on salmon and sea trout within the area of the Lancashire River Board.

The report looks at experiments into electric fishing equipment and effects on salmon and trout within the Lancashire River Board. Experiments include obtaining information on voltage gradients, ascertaining what damage to fish of the larger size groups resulted from electric fishing, determining whether or not fractures could occur in coarse fish and brown trout,similar to those occurring in salmon and sea trout, and effects low temperatures have on electrofishing techniques.

Measurements of resistance and reactance in fish with the use of bioelectrical impedance analysis: sources of error

New technologies can be riddled with unforeseen sources of error, jeopardizing the validity and application of their advancement. Bioelectrical impedance analysis (BIA) is a new technology in fisheries research that is capable of estimating proximate composition, condition, and energy content in fish quickly, cheaply, and (after calibration) without the need to sacrifice fish. Before BIA can be widely accepted in fisheries science, it is necessary to identify sources of error and determine a means to minimize potential errors with this analysis. We conducted controlled laboratory experiments to identify sources of errors within BIA measurements. We concluded that electrode needle location, procedure deviations, user experience, time after death, and temperature can affect resistance and reactance measurements. Sensitivity analyses showed that errors in predictive estimates of composition can be large (>50%) when these errors are experienced. Adherence to a strict protocol can help avoid these sources of error and provide BIA estimates that are both accurate and precise in a field or laboratory setting.

Comparison of echogram measurements against data expectations and assumptions for distinguishing seafloor substrates

Defining types of seafloor substrate and relating them to the distribution of fish and invertebrates is an important but difficult goal. An examination of the processing steps of a commercial acoustics analyzing software program, as well as the data values produced by the proprietary first echo measurements, revealed potential benef its and drawbacks for distinguishing acoustically distinct seafloor substrates. The positive aspects were convenient processing steps such as gain adjustment, accurate bottom picking, ease of bad data exclusion, and the ability to average across successive pings in order to increase the signal-to-noise ratio. A noteworthy drawback with the processing was the potential for accidental inclusion of a second echo as if it were part of the first echo. Detailed examination of the echogram measurements quantified the amount of collinearity, revealed the lack of standardization (subtraction of mean, division by standard deviation) before principal components analysis (PCA), and showed correlations of individual echogram measurements with depth and seafloor slope. Despite the facility of the software, these previously unknown processing pitfalls and echogram measurement characteristics may have created data artifacts that generated user-derived substrate classifications, rather than actual seafloor substrate types.

Aspects of quality control of wind profiler measurements in complex topography

It is well known in the scientific community that some remote sensing instruments assume that sample volumes present homogeneous conditions within a defined meteorological profile. At complex topographic sites and under extreme meteorological conditions, this assumption may be fallible depending on the site, and it is more likely to fail in the lower layers of the atmosphere. This piece of work tests the homogeneity of the wind field over a boundary layer wind profiler radar located in complex terrain on the coast under different meteorological conditions. The results reveal the qualitative importance of being aware of deviations in this homogeneity assumption and evaluate its effect on the final product. Patterns of behavior in data have been identified in order to simplify the analysis of the complex signal registered. The quality information obtained from the homogeneity study under different meteorological conditions provides useful indicators for the best alternatives the system can offer to build wind profiles. Finally, the results are also to be considered in order to integrate them in a quality algorithm implemented at the product level.

Measurements of total scattering spectra from bocaccio (Sebastes paucispinis)

Marine sportfishing in southern California is a huge industry with annual revenues totaling many billions of dollars. However, the stocks of lingcod and six rockfish species have been declared overfished by the Pacific Fisheries Management Council. As part of a multifaceted fisheries management plan, marine conservation areas, covering many million square nautical miles, have been mandated. To monitor the recovery of the rockfish stocks in these areas, scientists are faced with the following challenges: 1) multiple species of rockfish exist in these areas; 2) the species reside near or on the bottom at depths of 80 to 300 m; and 3) they are low in numerical density. To meet these challenges, multifrequency echosounders, multibeam sonar, and cameras mounted on remotely operated vehicles are frequently used (Reynolds et al., 2001). The accuracy and precision of these echosounder results are largely dependent upon the accuracy of the species classification and target strength estimation (MacLennan and Simmonds, 1992).

hp-Adaptive simulation and inversion of magnetotelluric measurements

xlix, 121 p.

Precision and accuracy of fish length measurements obtained with two visual underwater methods

During the VITAL cruise in the Bay of Biscay in summer 2002, two devices for measuring the length of swimming fish were tested: 1) a mechanical crown that emitted a pair of parallel laser beams and that was mounted on the main camera and 2) an underwater auto-focus video camera. The precision and accuracy of these devices were compared and the various sources of measurement errors were estimated by repeatedly measuring fixed and mobile objects and live fish. It was found that fish mobility is the main source of error for these devices because they require that the objects to be measured are perpendicular to the field of vision. The best performance was obtained with the laser method where a video-replay of laser spots (projected on fish bodies) carrying real-time size information was used. The auto-focus system performed poorly because of a delay in obtaining focus and because of some technical problems.