Post-dispersal seed predation of non-target weeds in arable crops

Field experiments were conducted to quantify the natural levels of post-dispersal seed predation of arable weed species in spring barley and to identify the main groups of seed predators. Four arable weed species were investigated that were of high biodiversity value, yet of low to moderate competitive ability with the crop. These were Chenopodium album, Sinapis arvensis, Stellaria media and Polygonum aviculare. Exclusion treatments were used to allow selective access to dishes of seeds by different predator groups. Seed predation was highest early in the season, followed by a gradual decline in predation over the summer for all species. All species were taken by invertebrates. The activity of two phytophagous carabid genera showed significant correlations with seed predation levels. However, in general carabid activity was not related to seed predation and this is discussed in terms of the mainly polyphagous nature of many Carabid species that utilized the seed resource early in the season, but then switched to carnivory as prey populations increased. The potential relevance of post-dispersal seed predation to the development of weed management systems that maximize biological control through conservation and optimize herbicide use, is discussed.

Greenhouse whitefly (Homoptera : Aleyrodidae) dispersal under different UV-light environments

The greenhouse whitefly, Dialeurodes vaporariorum (Westwood) (Homoptera: Aleyrodidae), is known to respond to UV light (UV). Field studies were conducted to improve our understanding of the behavioral effects and practical implications of using UV-blocking plastic films for the control of whitefly. Adult whiteflies were released in outdoor-located choice-chamber experiments with compartments clad with a range of films that transmitted incident UV to different extents. In release-recapture experiments, a very small proportion of the whiteflies recovered had dispersed into compartments where the entire UV spectrum was blocked, whereas the major proportion preferred compartments with UV. Compartments clad with films that blocked LTV below 375 nm attracted significantly more whiteflies than films that blocked UV below 385 nm, whereas the absorption of LTV wavelengths above 385 nm did not show any further effect on whitefly numbers. A reduction in the side cladding of the compartments by > 20% significantly reduced the advantage of using LTV-blocking films. Adult whitefly did not discriminate between direct- and diffused-light environments, as long as the UV-absorbing properties of the films were equivalent. Whitefly dispersal was influenced by the time of the day when adult whitefly were released, with a higher proportion of whitelly avoiding compartments clad with LTV-blocking films, at times of the day when light intensities were higher. The future use of UV-blocking films as a potentially highly effective component of integrated pest management systems for the control of whitefly is discussed.

Effects of UV-blocking films on the dispersal behavior of Encarsia formosa (Hymenoptera : Aphelinidae)

The parasitoid Encarsia formosa Gahan (Hymenoptera: Aphelinidae) has been used successfully for the control of Trialeurodes vaporariorum (Westwood) (Homoptera: Aleyrodidae). The development of UV-blocking plastic films has added a new component to future integrated pest management systems by disrupting insect pest infestation when UV light is excluded. Because both T. vaporariorum and E. formosa are reported to have similar spectral efficiency, there was a need to identify the impact of UV-blocking films on the dispersal behavior of both the pest and the natural enemy. In field studies, using choice-chamber experiments, E. formosa showed some preference to disperse into compartments where less UV light was blocked. However, further studies indicated that the effect was primarily attributable to the different light diffusion properties of the films tested. Thus, unlike its whitefly host, when the UV-absorbing properties of the films were similar, but the light diffusion properties differed, E.formosa adults preferred to disperse into compartments clad with films that had high light diffusion properties. When the plastic films differed most in their UV-absorbing capacity and had no light-diffusion capability, the initial dispersal of E. formosa between treatments was similar, although a small preference toward the environment with UV light was observed over time. When parasitoid dispersal was measured 3 h after release, more parasitoids were found on plants, suggesting that the parasitoids would search plants for whitefly hosts, even in a UV-blocked light environment. The potential for the integration of UV-blocking films with E. formosa in an advanced whitefly management system is discussed.

Post-dispersal seed predation of non-target weeds in arable crops

Field experiments were conducted to quantify the natural levels of post-dispersal seed predation of arable weed species in spring barley and to identify the main groups of seed predators. Four arable weed species were investigated that were of high biodiversity value, yet of low to moderate competitive ability with the crop. These were Chenopodium album, Sinapis arvensis, Stellaria media and Polygonum aviculare. Exclusion treatments were used to allow selective access to dishes of seeds by different predator groups. Seed predation was highest early in the season, followed by a gradual decline in predation over the summer for all species. All species were taken by invertebrates. The activity of two phytophagous carabid genera showed significant correlations with seed predation levels. However, in general carabid activity was not related to seed predation and this is discussed in terms of the mainly polyphagous nature of many Carabid species that utilized the seed resource early in the season, but then switched to carnivory as prey populations increased. The potential relevance of post-dispersal seed predation to the development of weed management systems that maximize biological control through conservation and optimize herbicide use, is discussed.

Workflow data exchange semantics, object discovery & integration architecture for cross media production & distribution

There has been a clear lack of common data exchange semantics for inter-organisational workflow management systems where the research has mainly focused on technical issues rather than language constructs. This paper presents the neutral data exchanges semantics required for the workflow integration within the AXAEDIS framework and presents the mechanism for object discovery from the object repository where little or no knowledge about the object is available. The paper also presents workflow independent integration architecture with the AXAEDIS Framework.

A peer-to-peer approach to content dissemination and search in collaborative networks

There are three key driving forces behind the development of Internet Content Management Systems (CMS) - a desire to manage the explosion of content, a desire to provide structure and meaning to content in order to make it accessible, and a desire to work collaboratively to manipulate content in some meaningful way. Yet the traditional CMS has been unable to meet the latter of these requirements, often failing to provide sufficient tools for collaboration in a distributed context. Peer-to-Peer (P2P) systems are networks in which every node is an equal participant (whether transmitting data, exchanging content, or invoking services) and there is an absence of any centralised administrative or coordinating authorities. P2P systems are inherently more scalable than equivalent client-server implementations as they tend to use resources at the edge of the network much more effectively. This paper details the rationale and design of a P2P middleware for collaborative content management.

Factors mediating the routinisation of e-learning within a traditional university education environment

Technology-enhanced or Computer Aided Learning (e-learning) can be institutionally integrated and supported by learning management systems or Virtual Learning Environments (VLEs) to offer efficiency gains, effectiveness and scalability of the e-leaning paradigm. However this can only be achieved through integration of pedagogically intelligent approaches and lesson preparation tools environment and VLE that is well accepted by both the students and teachers. This paper critically explores some of the issues relevant to scalable routinisation of e-learning at the tertiary level, typically first year university undergraduates, with the teaching of Relational Data Analysis (RDA), as supported by multimedia authoring, as a case study. The paper concludes that blended learning approaches which balance the deployment of e-learning with other modalities of learning delivery such as instructor–mediated group learning etc offer the most flexible and scalable route to e-learning but that this requires the graceful integration of platforms for multimedia production, distribution and delivery through advanced interactive spaces that provoke learner engagement and promote learning autonomy and group learning facilitated by a cooperative-creative learning environment that remains open to personal exploration of constructivist-constructionist pathways to learning.

A Design for Generating Personalised Feedback in Knowledge Construction

As the learning paradigm shifts to a more personalised learning process, users need dynamic feedback from their knowledge path. Learning Management Systems (LMS) offer customised feedback dependent on questions and the answers given. However these LMSs are not designed to generate personalised feedback for an individual learner, tutor and instructional designer. This paper presents an approach for generating constructive feedback for all stakeholders during a personalised learning process. The dynamic personalised feedback model generates feedback based on the learning objectives for the Learning Object. Feedback can be generated at Learning Object level and the Information Object level for both the individual learner and the group. The group feedback is meant for the tutors and instructional designer to improve the learning process.

Tillage and herbicide treatments with inter-row cultivation influence weed densities and yield of three industrial crops

Field experiments were conducted in northern Greece in 2003 and 2004 to evaluate effects of tillage regimes (moldboard plowing, chisel plowing, and rotary tilling), cropping sequences(continuous cotton, cotton-sugar beet rotation,and continuous tobacco) and herbicide treatments with inter-row hand hoeing on weed population densities. Total weed densities were not affected by tillage treatment except that of barnyardgrass (Echinochloa crus-galli), which increased only in moldboard plowing treated plots during 2003. Redroot pigweed (Amaranthus retroflexus)and black nightshade (Solanum nigrum) densities were reduced in continuous cotton, while purple nutsedge (Cyperus rotundus), E. crus-galli, S. nigrum, and johnsongras(Sorghum halepense) densities were reduced in tobacco. A. retroflexus and S. nigrum were effectively controlled by all herbicide treatments with inter-row hand hoeing,whereas E. crus-galli was effectively reduced by herbicides applied to cotton and tobacco. S. halepense density reduction was a result of herbicide applied to tobacco with inter-row hand hoeing. Yield of all crops was higher under moldboard plowing and herbicide treatments. Pre-sowing and pre-emergence herbicide treatments in cotton and pre-transplant in tobacco integrated with inter-row cultivation resulted in efficient control of annual weed species and good crop yields. These observations are of practical relevance to crop selection by farmers in order to maintain weed populations at economically acceptable densities through the integration of various planting dates, sustainable herbicide use and inter-row cultivation; tools of great importance in integrated weed management systems. Keywords: cropping sequence, herbicide, integrated weed management, inter-row cultivation,tillage.

An investigation of thermal comfort adaptation behaviour in office buildings in the UK

Around 40% of total energy consumption in the UK is consumed by creating comfortable indoor environment for occupants. Occupants’ behaviour in terms of achieving thermal comfort could have a significant impact on a building’s energy consumption. Therefore, understanding the interactions of occupants with their buildings would be essential to provide a thermal comfort environment that is less reliance on energy-intensive heating, ventilation and air-conditioning systems, to meet energysaving and carbon emission targets. This paper presents the findings of a year-long field study conducted in non-air-conditioned office buildings in the UK. Occupants’ adaptive responses in terms of technological and personal dimensions are dynamic processes which could vary with both indoor and outdoor thermal conditions. The adaptive behaviours of occupants in the surveyed building show substantial seasonal and daily variations. Our study shows that non-physical factors such as habit could influence the adaptive responses of occupants. However, occupants sometimes displayed inappropriate adaptive behaviour, which could lead to a misuse of energy. This paper attempts to illustrate how occupants would adapt and interact with their built environment and consequently contribute to development of a guide for future design/refurbishment of buildings and to develop energy management systems for a comfortable built environment.

The national food safety control system of China: a systematic review

In recent years, there have been increasing concerns over the safety of the Chinese food supply. Although many of these have only raised concern internally within China, several major food safety issues have had international repercussions. In response, China has implemented new food safety laws and management systems to improve its national food safety control system and reduce public and international concerns. This paper has describes and discusses the components of the Chinese system using the five key elements of a national food control system identified by the World Health Organization (WHO) and the Food and Agriculture Organization (FAO) as essential for an effective system. The latest Chinese national food safety control has made significantly improvement on its regulation framework, however, more work need to be done on standards, law enforcement, and information exchange.

An ontological approach to personalized medical knowledge recommendation

Knowledge recommendation has become a promising method in supporting the clinicians decisions and improving the quality of medical services in the constantly changing clinical environment. However, current medical knowledge management systems cannot understand users requirements accurately and realize personalized recommendation. Therefore this paper proposes an ontological approach based on semiotic principles to personalized medical knowledge recommendations. In particular, healthcare domain knowledge is conceptualized and an ontology-based user profile is built. Furthermore, the personalized recommendation mechanism is illustrated.

An ontological approach to personalized medical knowledge matching

Knowledge management has become a promising method in supporting the clinicians′ decisions and improving the quality of medical services in the constantly changing clinical environment. However, current medical knowledge management systems cannot understand users′ requirements accurately and realize personalized matching. Therefore this paper proposes an ontological approach based on semiotic principles to personalized medical knowledge matching. In particular, healthcare domain knowledge is conceptualized and an ontology-based user profile is built. Furthmore, the personalized matching mechanism and algorithm are illustrated.