Hybridization effects on the out-of-plane electron tunneling properties of monolayers: is h-BN more conductive than graphene?

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Daily photosynthesis, water relations, and ion concentrations of uuonymus irrigated with treated wastewater

Euonymus japonica Thunb. (euonymus) plants were submitted for 9 months to two irrigation treatments using water from different sources: a control (C) water with electrical conductivity (EC) less than 1.2 dS.m(-1) and reclaimed wastewater (RW) with EC approximate to 4 dS.m(-1). At the end of the experiment, no differences in the total dry weight were observed between treatments, whereas the leaf dry mass increased (to the detriment of the root part in RW plants). Throughout the day, the stem water potential (Psi(stem)) of the RW plants was lower than in C, whereas stomatal conductance (g(S)) was slightly reduced in RW from 0800 HR to 1200 HR, but no significant variation in photosynthesis (P-n) or energy conversion efficiency (F'(v)/F'(m)) in photosystem II was detected through the effect of salinity. Gas exchange and fluorescence showed a tendency to increase after midday in plants treated with RW. The photosynthetic behavior and fluorescence of RW plants may have been related to the nitrogen and chlorophyll content of the leaves, confirming the resistance of the photosynthetic mechanism to salinity in this species in these conditions. The toxic effects produced by high concentrations of boron (B), sodium (Na+) and chloride (Cl-) were offset by the effect of other ions like magnesium (Mg2+), potassium (K+), and phosphorus (P) in plants irrigated with RW, thus improving their physiological status without decreasing their ornamental value.

Crescimento, composição mineral e sintomas visuais de deficiência nutricional em ipeca

The objective was to evaluate the effect of the omission of macronutrient and micronutrient boron in dry matter production, the characterization of the symptoms of nutritional deficiencies and mineral composition in plants of ipeca, an experiment was conducted in greenhouse conditions by the technique the missing element and visual diagnosis. A randomized block experimental design with four repetitions and the treatments were: complete and omissions of N, P, K, Ca, Mg, S and B. The analytical results demonstrated that the production of dry matter was affected in all of the treatments with omission of nutrients and that the ipeca plants presented characteristic symptoms of nutritional deficiencies due to the omissions of N, P, K, Ca, Mg, S and B and the concentrations of the macronutrients and of the micronutrient boron in the different parts of the ipeca plant varied when a certain nutrient was omitted in the solution.

Estudo das propriedades elétricas do cobre e alumínio; sobre a força magnética em um imã caindo dentro de um tubo

Magnetic fields can be produced by natural magnets, artificial magnets, and by circulating electric currents in wires and solenoids. An interesting experiment to observe the interaction between the magnetic field and free charges in a conductor, a magnet falling inside a tube made of conductive materials. The slowing down of the magnet by the appearance of a field in the opposite direction to the original one (Lenz's Law) is function the number of free electrons in the conductor and the electrical properties of this. Based on this, the objective of this study is to analyze the relationship between the electrical properties of conductors, copper and aluminum, with magnetic force on a neodymium magnet-iron-boron magnet falling inside a copper tube and aluminum, positioned vertically. In performing this experiment, we observed that it is a demonstration of Lenz-Faraday’s Law

Análise da curva de resfriamento e refino de grão da liga de alumínio AA 356

The macrostructure of an alloy solidification in the raw state is of utmost importance due to its influence on mechanical properties. A structure showing columnar grains is generally undesirable in most applications of cast products and grain refining aims to suppress the formation of these grains and get a fine-grained equiaxed structure that improves the supply of liquid metal and the mechanical properties, as yield strength and tensile strength limit, as well as the tendency of formation of hot cracks. The type and size of grains formed are determined by chemical composition, cooling rate and the use of inoculum for grain refining. Titanium and boron are the major refiners in the aluminum industry and can be added to the molten metal in the form of alloys such as Al-Ti, Al-Ti-B or Al-B. In this paper we will discuss the information obtained from cooling curves and first derivative of the cooling curve to obtain the thermal parameters that influence the process of grain refining alloy AA 356.0

Caracterização in vitro de técnica biomagnética empregando magnetômetros 3D para avaliar tempo de trânsito esofagiano

The biomagnetic techniques use different magnetic field detectors to measure parameters of the human physiology. Those techniques present the advantage of being noninvasive and radiation free. Among them we can show up the Superconducting Quantum Interference Device (SQUID), the Current Alternate Biosusceptometry (ACB) and, more recently, the employment of anisotropic magnetoresistive sensors. Those magnetic sensors have a low cost and good sensitivity to measure different physiological parameters using magnetic markers. The biomagnetic techniques have being used successfully through study on the characteristics of the gastrointestinal tract. Recent research, the magnetoresistors were used to evaluate the transit time and localization of magnetic sources in different parts of the gastrointestinal tract. The objective of this work is the characterization, with in vitro tests, of a biomagnetic instrumentation using two 3-axis magnetoresistors arranged in a gradiometric coplanar setup to evaluate esophageal transit time, analyze and compare the results of experimental signals and the magnetic theory, as well as evaluate the instrumentation gain with use of tri-axial sensor front to the mono-axial sensor. The instrumentation is composed by two three-axis sensing magnetometers, precision power supply and amplifier electronic circuits. The sensors fixed in a coplanar setup were separate by distance of 18 cm. The sensitivity tests had been carried through using a cylindrical magnet (ø = 4 mm and h = 4 mm) of neodymium-iron-boron (grid 35). The tests were done moving the permanent magnet on the sensors parallel axis, simulating the food transit in... (Complete abstract click electronic access below)

Confecção e caracterização de filmes finos de boro para a medida da taxa de reação 10B(N, a)7LI na terapia por captura de nêutrons pelo boro

The Boron Neutron Capture Therapy (BNCT), based on the 10B(n,α)7Li reaction, represents a promising modality for the treatment of cancers that are resistents to conventional treatments. So, it is necessary to find drugs (boron compounds) with high selectivity for each type of cancer, the neutrons source should be well characterized and the rate of 10B(n,α)7Li reaction should be measured with great accuracy as possible. This study aimed to develop a method for manufacturing thin films of boron, for measure the 10B(n,α)7Li reaction, and analyze the uniformity of the films. Five thin films of boron were manufactured with three different concentrations of boric acid, heated to transform the acid in boron, irradiated with thermic neutrons coupled to CR-39 detectors, in BNCT line at the reactor IEA-R1 IPEN/CNEN, São Paulo. After the irradiation, the detectors were chemically attacked with NaOH to reveal the tracks. The methodology presented is effective because it resulted in deposition of boron as thin film enabling the quantitative analysis of 10B(n,α)7Li reaction. The analysis of the uniformity of density of the induced tracks in CR-39 shows that, in most of the films, there is no uniformity in surface distribution of boron, but when the film is divided, we obtain some uniform sectors

Estudo de cerâmicas avançadas para fins de blindagem balística

The research involving new materials has always been considered as a differential in the development of a technology company. This occurred naturally since ancient times, often motivated by reasons of a certain age, where the most common material used was also the name of your time and may be cited as an example the Bronze Age, and later was the Iron. Currently, the use of firearms are they used in resolving conflicts between countries, or a more equivocal, as an instrument of social banditry make innovations in the area of shielding welcome, whether for personal use, in the form of vests or vehicle such as cars, tanks and even aircraft. In this context, is a Silicon Carbide Ceramic, with low density and high hardness. Thus, the aim of this study is the evaluation and comparison of these materials, seeking to improve their properties by means of additives such as boron and silicon metal and amorphous YAG. For this work, the specimens were pre-shaped by means of uniaxial later to be referred for isostatic pressing and sintering. The maximum percentage for each additive was 5%, except for the YAG whose percentage was 8.2% (mass percentage). All compositions were subjected to the same tests (x-ray diffraction, apparent density, optical microscopy, Vickers hardness, scanning electron Microscopita), so that one could draw a comparison between the materials under study, samples that showed better mechanical properties and micro structural, related here by hardness testing and microscopy (optical and SEM) were the silicon carbide doped with YAG and alumina samples, demonstrating the potential of these materials for ballistic protection. Other compositions have high porosity, which is highly undesirable, since in order to harmful influences on the mechanical properties discussed below

Influência do boro no crescimento e acúnulo de nutrientes em porta-enxertos de caramboleira

Pós-graduação em Agronomia (Ciência do Solo) - FCAV

Nanoelectrocatalytic oxidation of lactic acid using nickel nanoparticles

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Redistribution of B-10 absorbed by leaves and roots of cashew seedlings

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Efeito da suplementação com boro no metabolismo ósseo de camundongos diabéticos não obesos

Pós-graduação em Alimentos e Nutrição - FCFAR

Atributos químicos no solo e produção de Cynodon dactylon cv. Tierra Verde sob doses de biofertilizante orgânico

The concentration of nutrients in plant is related to the soil, fertilization, climate, season, cultivar and cultural practices. Aiming to evaluate the soil chemical properties, the dry matter production of shoots and roots, nutrient content in the plant and the chemical composition of the grass Tierra Verde subjected to levels of organic biofertilizer as nitrogen source, an experiment was conducted in a greenhouse at the Faculty of Veterinary Medicine , UNESP, Araçatuba-SP, January-September 2010. Treatments were arranged in a completely randomized design with six fertilized biofertilizer doses (0, 33, 66, 132, 264, 528 m3 ha-1) and five repetitions for three cuts. We used the model split plot, with doses of biofertilizer considered as main treatments and cuts as sub-plots. We obtained a linear response in the production of dry mass of shoots and roots to the dose of 528 m3 ha-1 of organic biofertilizer. Nitrogen fertilization influenced the soil chemical properties and levels of organic matter, sulfur, boron and manganese, and in foliar levels of phosphorus, potassium and copper. The chemical composition was not altered by the influence of organic biofertilizer doses applied to the soil.

Desenvolvimento de detector eletroquímico para cromatografia líquida de alta eficiência baseado em um eletrodo modificado com nanopartículas metálicas para determinação de ácidos carboxílicos em vinhaça de cana-de-açúcar

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Boro em cana-de-açúcar cultivada em solução nutritiva

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)