Mineralization of the Bonanza Mine

The Bonanza mine of the Emery mining district in Powell County is on the largest veins in the area, and is developed to a depth of 680 feet by an incline shaft following the dip of the structure. Sulfide ores carrying gold and silver values are mined throughout the area which is easily accessible by road from Deerlodge, Montana, ten miles west of the district.

The Lilly Mine of Powell County, Montana

For many years the Elliston District, of Powell County has been a minor producer of gold, lead, zinc, and silver. Although never among the largest producing districts of the state, it has with the exception of the war years supplied a notable tonnage of ore to the neighboring mills ever since the first placer and lode claims were located there during the late eighteen hundreds.

Geology of Smoke Hollow Area 8 Miles Southeast of Deerlodge, Powell County, Montana

This investigation was undertaken primarily as a problem in geologic mapping. The stratigraphy was studied as to the character, age, and sequence of the geologic formations that are exposed. The conclusions were based principally on the field relationships and lithology because no fossils were found.

An Isothermal Study of an S.A.E. 6150 Steel

The purpose of this thesis is to set forth the method followed, the laboratory procedure practiced, the results obtained, the conclu­sions drawn, and the recommendations proposed as a consequence of a metallographic study of the isothermal transformation of an S.A.E. 6150 steel.

The Alloys of Gallium and Indium

Thermal analysis VIPS used to construct cooling and heating curves from which the phase diagram was determined. The data for the entire set of cooling curves were obtained by the use of mercury thermo­meters.

Hot-Dip Aluminizing of Low-Carbon Steels

In a relatively short period of sixty-five years, aluminum has grown to the rank of fifth in total weight of met­als produced in the world. Throughout its short life, aluminum has been found to have excellent corrosion-resistant properties; yet only in recent years has aluminum been under consideration as a corrosion-resistant coating for iron and steel.

Physiographic Surfaces and Weathering Near Butte

Three cycles of erosion have modified the Boulder batholith. The earliest cycle produced a peneplaination that has been largely obliterated by a partially completed intermediate cycle, and the recent cycle now in progress.

A Mineral Dressing Study of the Benefication of Philipsburg Manganese Carbonate Ore

The beneficiation of rhodochrosite ore to the extent that it is suitable for nodulizing and subsequent use in the steel industry is intriguing. Such ores from certain mines is relatively easy to beneficiate, but the rhodo-chrosite ore from several deposits of the Philipsburg district has never been successfully up-graded by any of the several known beneficiating methods.

The Isothermal Transformation Curve for S.A.E. 6150

More than 3000 years ago, men began quenching and tem­pering tools to improve their physical properties. The an­cient people found that iron was easier to shape and form in a heated condition. Charcoal was used as the fuel, and when the shaping process was completed, the smiths cooled the piece in the most obvious way, quenching in water. Quite un­intentionally, these people stumbled on the process for im­proving the properties of iron, and the art of blacksmithing began.

Isolation and Characterization of a Microorganism from Groundwater that Reduces Arsenate

This is an investigation into the microbially mediated processes involved in the transformation of arsenic. With the recent change in the Federal Maximum Contaminant Level for arsenic in drinking water, an increasing amount of resources are being devoted to understanding the mechanisms involved in the movement of arsenic. Arsenic in drinking water typically comes from natural sources, but the triggers that result in increased release of arsenic from parent material are poorly understood. Knowledge of these processes is necessary in order to make sound engineering decisions regarding drinking water management practices. Recent years have brought forth the idea that bacteria play a significant role in arsenic cycling. Groundwater is a major source of potable water in this and many other countries. To date, no reports have been made indicating the presence and activity of arsenate reducing bacteria in groundwater settings, which may increase dissolved arsenic concentrations. This research was designed to address this question and has shown that these bacteria are present in Maine groundwater. Two Maine wells were sampled in order to culture resident bacteria that are capable of dissimilatory arsenate reduction. Samples were collected using anaerobic techniques fiom wells in Northport and Green Lake. These samples were amended with specific compounds to enrich the resident population of arsenate utilizing bacteria. These cultures were monitored over time to establish rates of arsenate reduction. Cultures fiom both sites exhibited arsenate reduction in initial enrichment cultures. Isolates obtained fiom the Green Lake enrichments, however, did not reduce arsenate. This indicates either that a symbiotic relationship was required for the observed arsenate reduction or that fast-growing fermentative organisms that could survive in high arsenate media were picked in the isolation procedure. The Northport cultures exhibited continued arsenate reduction after isolation and successive transfers into fiesh media. The cultured bacteria reduced the majority of 1 a arsenate solutions in less than one week, accompanied by a corresponding oxidation of lactate. The 16s rRNA fiom the isolate was arnplifled and sequenced. The results of the DNA sequence analysis indicate that the rRNA sequence of the bacteria isolated at the Northport site is unique. This means that this strain of bacteria has not been reported before. It is in the same taxonomic subgroup as two previously described arsenate respirers. The implications of this study are significant. The fact that resident bacteria are capable of reducing arsenate has implications for water management practices. Reduction of arsenate to arsenite increases the mobility of the compound, as well as the toxicity. An understanding of the activity of these types of organisms is necessary in order to understand the contribution they are making to arsenic concentrations in drinking water. The next step in this work would be to quantitj the actual loading of dissolved arsenic present in aquifers because of these organisms.

Improving Surveying Accuracy and Efficiency in Connecticut: An Accuracy Assessment of GEOID03 and GEOID09

Comparing published NAVD 88 Helmert orthometric heights of First-Order bench marks against GPS-determined orthometric heights showed that GEOID03 and GEOID09 perform at their reported accuracy in Connecticut. GPS-determined orthometric heights were determined by subtracting geoid undulations from ellipsoid heights obtained from a network least-squares adjustment of GPS occupations in 2007 and 2008. A total of 73 markers were occupied in these stability classes: 25 class A, 11 class B, 12 class C, 2 class D bench marks, and 23 temporary marks with transferred elevations. Adjusted ellipsoid heights were compared against OPUS as a check. We found that: the GPS-determined orthometric heights of stability class A markers and the transfers are statistically lower than their published values but just barely; stability class B, C and D markers are also statistically lower in a manner consistent with subsidence or settling; GEOID09 does not exhibit a statistically significant residual trend across Connecticut; and GEOID09 out-performed GEOID03. A "correction surface" is not recommended in spite of the geoid models being statistically different than the NAVD 88 heights because the uncertainties involved dominate the discrepancies. Instead, it is recommended that the vertical control network be re-observed.

Creating Useful Products From Connecticut's 2000 LIDAR Data Set JHR 08-314 Project 07-2

The State of Connecticut owns a LIght Detection and Ranging (LIDAR) data set that was collected in 2000 as part of the State’s periodic aerial reconnaissance missions. Although collected eight years ago, these data are just now becoming ready to be made available to the public. These data constitute a massive “point cloud”, being a long list of east-north-up triplets in the State Plane Coordinate System Zone 0600 (SPCS83 0600), orthometric heights (NAVD 88) in US Survey feet. Unfortunately, point clouds have no structure or organization, and consequently they are not as useful as Triangulated Irregular Networks (TINs), digital elevation models (DEMs), contour maps, slope and aspect layers, curvature layers, among others. The goal of this project was to provide the computational infrastructure to create a first cut of these products and to serve them to the public via the World Wide Web. The products are available at http://clear.uconn.edu/data/ct_lidar/index.htm.

BioCentury Research Farm Update

The BioCentury Research Farm (BCRF) had a diversity of users in 2011. Iowa State faculty and staff from agricultural and biosystems engineering (ABE), agricultural systems technology (AST), agronomy, chemical and biological engineering (CBE), civil, construction, and environmental engineering (CCEE), food science and human nutrition (FSHN), horticulture, mechanical engineering (ME), and natural resource ecology and management (NREM) conducted research, teaching, and outreach at the BCRF. Private industry users included Avello Bioenergy, DCE, Frontline BioEnergy, and Virent, Inc.