Motion Cues Analysis for Parkinson Gait Recognition

Background: Previous assessment methods for PG recognition used sensor mechanisms for PG that may cause discomfort. In order to avoid stress of applying wearable sensors, computer vision (CV) based diagnostic systems for PG recognition have been proposed. Main constraints in these methods are the laboratory setup procedures: Novel colored dresses for the patients were specifically designed to segment the test body from a specific colored background. Objective: To develop an image processing tool for home-assessment of Parkinson Gait(PG) by analyzing motion cues extracted during the gait cycles. Methods: The system is based on the idea that a normal body attains equilibrium during the gait by aligning the body posture with the axis of gravity. Due to the rigidity in muscular tone, persons with PD fail to align their bodies with the axis of gravity. The leaned posture of PD patients appears to fall forward. Whereas a normal posture exhibits a constant erect posture throughout the gait. Patients with PD walk with shortened stride angle (less than 15 degrees on average) with high variability in the stride frequency. Whereas a normal gait exhibits a constant stride frequency with an average stride angle of 45 degrees. In order to analyze PG, levodopa-responsive patients and normal controls were videotaped with several gait cycles. First, the test body is segmented in each frame of the gait video based on the pixel contrast from the background to form a silhouette. Next, the center of gravity of this silhouette is calculated. This silhouette is further skeletonized from the video frames to extract the motion cues. Two motion cues were stride frequency based on the cyclic leg motion and the lean frequency based on the angle between the leaned torso tangent and the axis of gravity. The differences in the peaks in stride and lean frequencies between PG and normal gait are calculated using Cosine Similarity measurements. Results: High cosine dissimilarity was observed in the stride and lean frequencies between PG and normal gait. High variations are found in the stride intervals of PG whereas constant stride intervals are found in the normal gait. Conclusions: We propose an algorithm as a source to eliminate laboratory constraints and discomfort during PG analysis. Installing this tool in a home computer with a webcam allows assessment of gait in the home environment.

Retusch av landskapsfoto i annonser för turistmål : En kvantitativ undersökningkring den accepterade nivån av retusch

Etik kring bilder i annonser har diskuterats mycket, speciellt modell-, ochproduktbilder har kritiserats. Det tycks dock saknas forskning om acceptanskring efterbehandling av landskapsfotografier som ofta används vidmarknadsföring av turistmål. En webbenkätundersökning genomfördes medbildexempel för att undersöka vilken nivå av efterbehandling som ansågsverklighetstrogen, tilltalande och accepterbar i sådana annonser. Slutsatsenblev att fotografier där exponeringen korrigerats för att skapa en tydligare bildvar det mest accepterade. Skillnader i åsikter mellan åldrar, kön, de som haroch inte har tidigare erfarenhet av fotografi och retuschering diskuterades ochdet visade sig att kvinnor och de utan tidigare erfarenhet var lite mer kritiskatill efterbehandling. Det framkom att en del betraktare kan accepteraytterligare efterbehandling om den genomförs för att sälja en specifik känslaoch så länge inte betraktaren kan känna sig vilseledd.

Detecting Plants on Railway Embankments

This paper investigates problems concerning vegetation along railways and proposes automatic means of detecting ground vegetation. Digital images of railway embankments have been acquired and used for the purpose. The current work mainly proposes two algorithms to be able to achieve automation. Initially a vegetation detection algorithm has been investigated for the purpose of detecting vegetation. Further a rail detection algorithm that is capable of identifying the rails and eventually the valid sampling area has been investigated. Results achieved in the current work report satisfactory (qualitative) detection rates.

Tecnicas de sensoriamento remoto e geoprocessamento aplicadas ao mapeamento geologico e geotecnico no municipio de Tres Cachoeiras, litoral norte do Rio Grande do Sul

As técnicas de sensoriarnento remoto e geoprocessamento são fundamentais para processamento e integração de dados de mapeamento geológico/geotécnico, principalmente estudos de gerenciamento e planejamento. A área estudada compreende o município de Três Cachoeiras. Litoral Norte do Rio Grande do Sul o qual inclui-se na "Reserva da Biosfera da Mata Atlântica". O município tem st: deparado com problemas de localização de sitios adequados à disposição final dos resíduos sólidos. bem como o assentamento de loteamentos residenciais e industriais, localização de jazidas de extração de material para construção, fontes de abastecimento de água e necessidade de criação de áreas de preservação ambiental. O objetivo deste trabalho foi produzir mapeamentos da área em questão, através da pesquisa geológico-geotécnica desenvolvida com emprego de imagens de satélite e fotografias aéreas, em que as informações foram cruzadas no SIG. Baseado nisto, investigaram-se os aspectos acima mencionados. a partir de uma contribuição geológico/geotécnica ao município, incluindo-se levantamento de campo, fotointerpretação, processamento e classificação de imagens do município de Três Cachoeiras, sendo os dados integrados num sistema de geoprocessamento. Utilizando-se cartas planialtimétricas, fotografias aéreas e imagem de satélite LANDSAT TM5. foram criados planos de informação como o limite da área estudada, a estrutura viária municipal, a delimitação de reservas ecológicas baseadas na legislação ambiental vigente e, por meio do modelo numérico do terreno, a carta de declividade. A fotointerpretação gerou planos de rede de drenagem, litológica. morfoestruturas e formações superficiais. Os dados de campo. sobrepostos às litológicas obtidas por fotointerpretação, produziram a carta litológica. No tratamento das imagem, foram gerados produtos com contraste, operações entre bandas, filtragens e análise de componentes principais, os quais contribuíram parira classificação da imagem e resultando nos planos de rochas/solos e cobertura/uso do solo (carta de uso atual do solo). O cruzamento destas informações permitiu a obtenção da carta de formações superficiais, lidrogeológica que, juntamente com as cartas litológica, declividades e uso atual do solo distribuíram os atributos do meio físico em planos elaborados por novos cruzamentos, que satisfazem o objetivo do estudo, sendo estes planos o produto final, ou seja, cartas de recomendação: a extração de materiais para construção civil; a implantação de obras de infraestrutura; a disposição de resíduos sólidos e loteamentos; geotécnica à agricultura; à implantação de áreas destinadas à preservação ambienta1 e recuperação.

Integração de dados geológicos, de sensoriamento remoto, espectrorradiométricos e geofísica aplicada à prospecção de depósitos filoneanos de fluorita hidrotermal no sudeste de Santa Catarina

Os processamentos de imagens orbitais efetuados através de técnicas de sensoriamento remoto geraram informações qualitativas de natureza textural (morfo-estruturas). Estas permitiram (1) o reconhecimento de áreas com diferentes padrões estruturais tendo diferentes potencialidades para a prospecção de fluorita, (2) a identificação de novos lineamentos estruturais potencialmente favoráveis à mineralização e (3) evidenciaram prolongamentos extensos para as principais estruturas mineralizadas, (4) às quais se associam um grande número de estruturas, antes desconhecidas, com grande potencial prospectivo. O aprimoramento de técnicas de classificação digital sobre produtos de razões de bandas e análise por componentes principais permitiu identificar a alteração hidrotermal associada às estruturas, incorporando novos critérios para a prospecção de fluorita. Buscando-se quantificar os dados de alteração hidrotermal, foi efetuada a análise espectrorradiométrica das rochas do distrito fluorítico. Integrando estas informações com dados TM LANDSAT 5, em nível de reflectância, obteve-se a classificação espectral das imagens orbitais, o que permitiu a identificação de estruturas menores com um detalhe nunca antes obtido. Os processamentos de dados aerogeofísicos forneceram resultados sobre estruturas (magnetometria) e corpos graníticos afetados por alteração hidrotermal (aerogamaespectrometria). Estes produtos foram integrados com dados TM LANDSAT 5 associando o atributo textural da imagem orbital ao comportamento radiométrico das rochas. Diagnosticou-se o lineamento Grão-Pará como o principal prospecto do distrito. E levantaram-se uma série de dados sobre a compartimentação tectônica da região, a zonação de fácies das rochas graníticas (rocha fonte do flúor) e as alterações hidrotermais associadas ao magmatismo granítico. Isto permitiu a compreensão da distribuição regional dos depósitos de fluorita, adicionando-se um novo critério à prospecção de fluorita, a relação espacial entre a mineralização e a rocha fonte de F. Esta última corresponde à fácies granítica da borda do Maciço Pedras Grandes.

Plane Detection Using Affine Homography

AIRES, Kelson R. T.; ARAÚJO, Hélder J.; MEDEIROS, Adelardo A. D. Plane Detection Using Affine Homography. In: CONGRESSO BRASILEIRO DE AUTOMÁTICA, 2008, Juiz de Fora, MG: Anais... do CBA 2008.

Avaliação ecológico-econômica do manguezal de Macau/RN e a importância da aplicação de práticas preservacionistas pela indústria petrolífera local

This work presents the results of a survey in oil-producing region of the Macau City, northern coast of Rio Grande do Norte. All work was performed under the Project for Monitoring Environmental Change and the Influence of Hydrodynamic forcing on Morphology Beach Grass Fields, Serra Potiguar in Macau, with the support of the Laboratory of Geoprocessing, linked to PRH22 - Training Program in Geology Geophysics and Information Technology Oil and Gas - Department of Geology/CCET/UFRN and the Post-Graduation in Science and Engineering Oil/PPGCEP/UFRN. Within the economic-ecological context, this paper assesses the importance of mangrove ecosystem in the region of Macau and its surroundings as well as in the following investigative exploration of potential areas for projects involving reforestation and / or Environmental Restoration. At first it was confirmed the ecological potential of mangrove forests, with primary functions: (i) protection and stabilization of the shoreline, (ii) nursery of marine life, and (iii) source of organic matter to aquatic ecosystems, (iv) refuge of species, among others. In the second phase, using Landsat imagery and techniques of Digital Image Processing (DIP), I came across about 18,000 acres of land that can be worked on environmental projects, being inserted in the rules signed the Kyoto Protocol to the market carbon. The results also revealed a total area of 14,723.75 hectares of activity of shrimp production and salting that can be harnessed for the social, economic and environmental potential of the region, considering that over 60% of this area, ie, 8,800 acres, may be used in the planting of the genus Avicennia considered by the literature that the species best sequesters atmospheric carbon, reaching a mean value of 59.79 tons / ha of mangrove

Compressão de Imagens Usando a Função de Peano e a Transformada Wavelet 1D

In this work, spoke about the importance of image compression for the industry, it is known that processing and image storage is always a challenge in petrobrás to optimize the storage time and store a maximum number of images and data. We present an interactive system for processing and storing images in the wavelet domain and an interface for digital image processing. The proposal is based on the Peano function and wavelet transform in 1D. The storage system aims to optimize the computational space, both for storage and for transmission of images. Being necessary to the application of the Peano function to linearize the images and the 1D wavelet transform to decompose it. These applications allow you to extract relevant information for the storage of an image with a lower computational cost and with a very small margin of error when comparing the images, original and processed, ie, there is little loss of quality when applying the processing system presented . The results obtained from the information extracted from the images are displayed in a graphical interface. It is through the graphical user interface that the user uses the files to view and analyze the results of the programs directly on the computer screen without the worry of dealing with the source code. The graphical user interface, programs for image processing via Peano Function and Wavelet Transform 1D, were developed in Java language, allowing a direct exchange of information between them and the user

Análise e classificação de imagens de lesões da pele por atributos de cor, forma e textura utilizando máquina de vetor de suporte

The skin cancer is the most common of all cancers and the increase of its incidence must, in part, caused by the behavior of the people in relation to the exposition to the sun. In Brazil, the non-melanoma skin cancer is the most incident in the majority of the regions. The dermatoscopy and videodermatoscopy are the main types of examinations for the diagnosis of dermatological illnesses of the skin. The field that involves the use of computational tools to help or follow medical diagnosis in dermatological injuries is seen as very recent. Some methods had been proposed for automatic classification of pathology of the skin using images. The present work has the objective to present a new intelligent methodology for analysis and classification of skin cancer images, based on the techniques of digital processing of images for extraction of color characteristics, forms and texture, using Wavelet Packet Transform (WPT) and learning techniques called Support Vector Machine (SVM). The Wavelet Packet Transform is applied for extraction of texture characteristics in the images. The WPT consists of a set of base functions that represents the image in different bands of frequency, each one with distinct resolutions corresponding to each scale. Moreover, the characteristics of color of the injury are also computed that are dependants of a visual context, influenced for the existing colors in its surround, and the attributes of form through the Fourier describers. The Support Vector Machine is used for the classification task, which is based on the minimization principles of the structural risk, coming from the statistical learning theory. The SVM has the objective to construct optimum hyperplanes that represent the separation between classes. The generated hyperplane is determined by a subset of the classes, called support vectors. For the used database in this work, the results had revealed a good performance getting a global rightness of 92,73% for melanoma, and 86% for non-melanoma and benign injuries. The extracted describers and the SVM classifier became a method capable to recognize and to classify the analyzed skin injuries

Localização e mapeamento simultâneos de ambientes planos usando visão monocular e representação híbrida do ambiente

The goal of this work is to propose a SLAM (Simultaneous Localization and Mapping) solution based on Extended Kalman Filter (EKF) in order to make possible a robot navigates along the environment using information from odometry and pre-existing lines on the floor. Initially, a segmentation step is necessary to classify parts of the image in floor or non floor . Then the image processing identifies floor lines and the parameters of these lines are mapped to world using a homography matrix. Finally, the identified lines are used in SLAM as landmarks in order to build a feature map. In parallel, using the corrected robot pose, the uncertainty about the pose and also the part non floor of the image, it is possible to build an occupancy grid map and generate a metric map with the obstacle s description. A greater autonomy for the robot is attained by using the two types of obtained map (the metric map and the features map). Thus, it is possible to run path planning tasks in parallel with localization and mapping. Practical results are presented to validate the proposal