Optimization of FRT Active Power Performance of a DFIG during Transient Grid Faults

Optimal fault ride-through (FRT) conditions for a doubly-fed induction generator (DFIG) during a transient grid fault are analyzed with special emphasis on improving the active power generation profile. The transition states due to crowbar activation during transient faults are investigated to exploit the maximum power during the fault and post-fault period. It has been identified that operating slip, severity of fault and crowbar resistance have a direct impact on the power capability of a DFIG, and crowbar resistance can be chosen to optimize the power capability. It has been further shown that an extended crowbar period can deliver enhanced inertial response following the transient fault. The converter protection and drive train dynamics have also been analyzed while choosing the optimum crowbar resistance and delivering enhanced inertial support for an extended crowbar period.

The impact of global routing on the performance of NoCs in FPGAs

With the over-provisioned routing resource on FPGA, the topology choice for NoC implementation on FPGA is more flexible than on ASIC. However, it is well understood that the global wire routing impacts the performance of NoC on FPGA because the topology is routed by using fixed routing fabric. An important question that arises is: will the benefit of diameter reduction by using a highly connective topology outweigh the impact of global routing? To answer this question, we investigate FPGA based packet switched NoC implementations with different sizes and topologies, and quantitatively measure the impact of global routing to each of these networks. The result shows that with sufficient routing resources on modern FPGA, the global routing is not on the critical path of the system, and thus is not a dominating factor for the performance of practical multi-hop NoC system. © 2011 IEEE.

Completeness and timeliness: Cancer registries could/should improve their performance

Cancer registries must provide complete and reliable incidence information with the shortest possible delay for use in studies such as comparability, clustering, cancer in the elderly and adequacy of cancer surveillance. Methods of varying complexity are available to registries for monitoring completeness and timeliness. We wished to know which methods are currently in use among cancer registries, and to compare the results of our findings to those of a survey carried out in 2006.

Methods
In the framework of the EUROCOURSE project, and to prepare cancer registries for participation in the ERA-net scheme, we launched a survey on the methods used to assess completeness, and also on the timeliness and methods of dissemination of results by registries. We sent the questionnaire to all general registries (GCRs) and specialised registries (SCRs) active in Europe and within the European Network of Cancer Registries (ENCR).

Results
With a response rate of 66% among GCRs and 59% among SCRs, we obtained data for analysis from 116 registries with a population coverage of ∼280 million. The most common methods used were comparison of trends (79%) and mortality/incidence ratios (more than 60%). More complex methods were used less commonly: capture–recapture by 30%, flow method by 18% and death certificate notification (DCN) methods with the Ajiki formula by 9%.

The median latency for completion of ascertainment of incidence was 18 months. Additional time required for dissemination was of the order of 3–6 months, depending on the method: print or electronic. One fifth (21%) did not publish results for their own registry but only as a contribution to larger national or international data repositories and publications; this introduced a further delay in the availability of data.

Conclusions
Cancer registries should improve the practice of measuring their completeness regularly and should move from traditional to more quantitative methods. This could also have implications in the timeliness of data publication.

Review of visco-plastic soil models for predicting the performance of embankments on soft soils

A number of constitutive models that account for creep or secondary compression and rate dependent behaviour of soil have been reviewed in terms of their strengths and weaknesses. Some results of numerical analysis of some embankments have been discussed and an effort has been made to find out their strengths and limitations.

Performance and wear of coated carbide drill in machining of carbon fibre reinforced composite/titanium stack

In this research we investigate the performance of drilling process in carbon fibre reinforced composite (CFC) material, titanium alloy and the hybrid stack of these two materials, using coated carbide drill bit. We study the effect of the process parameters such as the feed rate and speed on the induced forces and torques, also on the wear of drill and surface roughness of the holes. In the composite material the percentage of surface damage in both drilling CFC on its own and drilling in stack form is estimated. Also, the effect of worn drill on the surface damage is identified. In the titanium, the burr formation in stack and non-stack form is investigated. The wear of the drill results in increased forces and torques required for drilling. This increases the surface delaminations substantially at the entrance in drilling of CFC. However, the surface roughness of the holes reduces with the wear of the drill in CFC drilling. Also, the surface delamination and surface roughness of the holes in the CFC whilst drilled in hybrid form reduces significantly. This is despite the increase of the forces and torques required in drilling CFC in stack form. Copyright © 2012 Inderscience Enterprises Ltd.

The effect of the spectral distribution of wave energy on the performance of a bottom hinged flap type wave energy converter

The power output from a wave energy converter is typically predicted using experimental and/or numerical modelling techniques. In order to yield meaningful results the relevant characteristics of the device, together with those of the wave climate must be modelled with sufficient accuracy.

The wave climate is commonly described using a scatter table of sea states defined according to parameters related to wave height and period. These sea states are traditionally modelled with the spectral distribution of energy defined according to some empirical formulation. Since the response of most wave energy converters vary at different frequencies of excitation, their performance in a particular sea state may be expected to depend on the choice of spectral shape employed rather than simply the spectral parameters. Estimates of energy production may therefore be affected if the spectral distribution of wave energy at the deployment site is not well modelled. Furthermore, validation of the model may be affected by differences between the observed full scale spectral energy distribution and the spectrum used to model it.

This paper investigates the sensitivity of the performance of a bottom hinged flap type wave energy converter to the spectral energy distribution of the incident waves. This is investigated experimentally using a 1:20 scale model of Aquamarine Power’s Oyster wave energy converter, a bottom hinged flap type device situated at the European Marine Energy Centre (EMEC) in approximately 13m water depth. The performance of the model is tested in sea states defined according to the same wave height and period parameters but adhering to different spectral energy distributions.

The results of these tests show that power capture is reduced with increasing spectral bandwidth. This result is explored with consideration of the spectral response of the device in irregular wave conditions. The implications of this result are discussed in the context of validation of the model against particular prototype data sets and estimation of annual energy production.

Physical Layer Secrecy Performance over Rayleigh/Rician Fading Channels

In this paper, we investigate the physical layer secrecy performance of a single-input single-output system that consists of single antenna devices and operates in the presence of a single antenna passive eavesdropper over dissimilar fading channels. In particular, we consider two scenarios in terms of dissimilar fading channel arrangements: the legal/illegal channels are subject to Rayleigh/Rician fading, respectively; and the legal/illegal channels are subject to Rician/Rayleigh fading, respectively. Specifically, analytical expressions for the probability of the existence of a non-zero secrecy capacity and the secrecy outage probability are derived by using statistical characteristics of the signal-to-noise ratio. Numerical results are provided for selected scenarios to illustrate applications of the developed analytical expressions.