101 red hot science starters.

Ofrece al departamento de ciencias un banco de actividades sencillas y eficaces para los tres años de duración de la etapa 3 (key stage 3) de secundaria que permite a los profesores ahorrar tiempo de preparación. Cada una de estas actividades de inicio es independiente y se corresponde con el año y objetivos de la Enseñanza Marco de Ciencias, utiliza técnicas interactivas mentales, verbales o de visualización y permiten la evaluación de las actividades de toda la clase en diez o quince minutos.

Facilitar el aprendizaje del l??xico espa??ol en Ruman??a : propuesta did??ctica para ense??ar los derivados meta-colectivos con Hot Potatoes

Resumen basadoen el de la publicaci??n

Fine wire resistance thermometer amplifier for atmospheric measurements

An improved amplifier for atmospheric fine wire resistance thermometry is described. The amplifier uses a low excitation current (50 mu A). This is shown to ensure negligible self-heating of the low mass fine wire resistance sensor, compared with measured nocturnal surface air temperature fluctuations. The system provides sufficient amplification for a +/- 50 degrees C span using a +/- 5 V dynamic range analog-to-digital converter, with a noise level of less than 0.01 degrees C. A Kelvin four-wire connection cancels the effect of long lead resistances: a 50 m length of screened cable connecting the Reading design of fine wire thermometer to the amplifier produced no measurable temperature change at 12 bit resolution.

Impact on CVD risk of modifying milk fat to decrease intake of SFA and increase intake of cis-MUFA

Despite the acknowledged benefits of reducing SFA intake few countries within the EU meet recognised targets. Milk and dairy products represent the single largest source of dietary SFA in most countries, yet epidemiological evidence indicates that milk has cardioprotective properties such that simply reducing consumption of dairy foods to meet SFA targets may not be a sound public health approach. The present paper explores the options for replacing some of the SFA in milk fat with cis-MUFA through alteration of the diet of the dairy cow, and the evidence that such changes can improve the indicators for CHD and CVD in general for the consumer. In addition, the outcome of such changes on risk factors for CHD and CVD at the population level is examined in the light of a modelling exercise involving data for eleven EU member states. Given the current and projected costs of health care, the results indicate that urgent consideration should be given to such a strategy.

Impact on CVD risk of modifying milk fat to decrease intake of SFA and increase intake of cis-MUFA

Despite the acknowledged benefits of reducing SFA intake few countries within the EU meet recognised targets. Milk and dairy products represent the single largest source of dietary SFA in most countries, yet epidemiological evidence indicates that milk has cardioprotective properties such that simply reducing consumption of dairy foods to meet SFA targets may not be a sound public health approach. The present paper explores the options for replacing some of the SFA in milk fat with cis-MUFA through alteration of the diet of the dairy cow, and the evidence that such changes can improve the indicators for CHD and CVD in general for the consumer. In addition, the outcome of such changes on risk factors for CHD and CVD at the population level is examined in the light of a modelling exercise involving data for eleven EU member states. Given the current and projected costs of health care, the results indicate that urgent consideration should be given to such a strategy.

Extinction processes in hot spots of avian biodiversity and the targeting of pre-emptive conservation action

Hot spots of endemism are regarded as important global sites for conservation as they are rich in threatened endemic species and currently experiencing extensive habitat loss. Targeting pre-emptive conservation action to sites that are currently relatively intact but which would be vulnerable to particular human activities if they occurred in the future is, however, also valuable but has received less attention. Here, we address this issue by using data on Endemic Bird Areas (EBAs). First, we identify the ecological factors that affect extinction risk in the face of particular human activities, and then use these insights to identify EBAs that should be priorities for pre-emptive conservation action. Threatened endemic species in EBAs are significantly more likely to be habitat specialists or relatively large-bodied than non-threatened species, when compared across avian families. Increasing habitat loss causes a significant increase in extinction risk among habitat specialists, but we found no evidence to suggest that the presence of alien species/human exploitation causes a significant increase in extinction risk among large-bodied species. This suggests that these particular human activities are contributing to high extinction risk among habitat specialists, but not among large-bodied species. Based on these analyses, we identify 39 EBAs containing 570 species (24% of the total in EBAs) that are not currently threatened with severe habitat loss, but would be ecologically vulnerable to future habitat loss should it occur. We show that these sites tend to be poorly represented in existing priority setting exercises involving hot spots, suggesting that vulnerability must be explicitly included within these exercises if such sites are to be adequately protected.

Building cluster and shading in urban canyon for hot dry climate - Part 1: Air and surface temperature measurements

Under low latitude conditions, minimization of solar radiation within the urban environment may often be a desirable criterion in urban design. The dominance of the direct component of the global solar irradiance under clear high sun conditions requires that the street solar access must be small. It is well known that the size and proportion of open spaces has a great influence on the urban microclimate This paper is directed towards finding the interaction between urban canyon geometry and incident solar radiation. The effect of building height and street width on the shading of the street surfaces and ground for different orientations have been examined and evaluated. It is aimed to explore the extent to which these parameters affect the temperature in the street. This work is based on air and surface temperature measurements taken in different urban street canyons in EL-Oued City (hot and and climate), Algeria. In general, the results show that there are less air temperature variations compared to the surface temperature which really depends on the street geometry and sky view factor. In other words, there is a big correlation between the street geometry, sky view factor and surface temperatures.

Building cluster and shading in urban canyon for hot dry climate Part 2: Shading simulations

Under low latitude conditions, minimisation of solar irradiance within the urban environment may often be an important criterion in urban design. This can be achieved when the obstruction angle is large (high H/W ratio, H = height, W = width). Solar access to streets can always be decreased by increasing H/W to larger values. It is shown in this paper that the street canyon orientation (and not only the H/W ratio) has a considerable effect on solar shading and urban microclimate. The paper demonstrates through a series of shading simulation and temperature measurements that a number of useful relationships can be developed between the geometry and the microclimate of urban street canyons. These relationships are potentially helpful to assist in the formulation of urban design guidelines governing street dimensions and orientations for use by urban designers.

Comparison of white metal and resin socket terminations for wire ropes

Previously the authors have presented both theoretical and experimental work discussing the operating mechanism of a wire rope held in a tapered socket by means of a cast resin cone. The work reported here extends the investigation to address the question of whether the same socket fabricated with white metal operates in the same manner. To date, previous investigations have compared the operational efficiency of resin and white metal in terms of both strength and/or fatigue endurance. Some other work has analysed the operation of resin sockets or specific cast metal terminations. This paper seeks to draw the results from this work together, and, in addition to a theoretical analysis, presents experimental data obtained from a direct comparison of the operation mechanism for the same sockets filled with resin or white metal. Results show that white metal terminations have a very different distribution of stresses along the length of the socket basket from resin terminations, and a smaller but still significant amount of socket draw. For both types of termination the socket draw develops high frictional gripping forces which can transfer the load from the rope to the socket. The different stress distributions mean that the consequences of termination fabrication defects may not be the same for resin and white metal terminations.

Modelling the torsional interaction of wire and polyester fibre ropes used for offshore moorings

Oil rig mooring lines have traditionally consisted of chain and wire rope. As production has moved into deeper water it has proved advantageous to incorporate sections of fibre rope into the mooring lines. However, this has highlighted torsional interaction problems that can occur when ropes of different types are joined together. This paper describes a method by which the torsional properties of ropes can be modelled and can then be used to calculate the rotation and torque for two ropes connected in series. The method uses numerical representations of the torsional characteristics of both the ropes, and equates the torque generated in each rope under load to determine the rotation at the connection point. Data from rope torsional characterization tests have been analysed to derive constants used in the numerical model. Constants are presented for: a six-strand wire rope; a torque-balanced fibre rope; and a fibre rope that has been designed to be torque-matched to stranded wire rope. The calculation method has been verified by comparing predicted rotations with measured test values. Worked examples are given for a six-strand wire rope connected, firstly, to a torque-balanced fibre rope that offers little rotational restraint, and, secondly, to a fibre rope whose torsional properties are matched to that of the wire rope.

Nutrigenetics and CVD: what does the future hold?

CVD is a common killer in both the Western world and the developing world. It is a multifactorial disease that is influenced by many environmental and genetic factors. Although public health advice to date has been principally in the form of prescribed population-based recommendations, this approach has been surprisingly unsuccessful in reducing CVD risk. This outcome may be explained, in part, by the extreme variability in response to dietary manipulations between individuals and interactions between diet and an individual's genetic background, which are defined by the term 'nutrigenetics'. The shift towards personalised nutritional advice is a very attractive proposition. In principle an individual could be genotyped and given dietary advice specifically tailored to their genetic make-up. Evidence-based research into interactions between fixed genetic variants, nutrient intake and biomarkers of CVD risk is increasing, but still limited. The present paper will review the evidence for interactions between dietary fat and three common polymorphisms in the apoE, apoAI and PPAR gamma genes. Increased knowledge of how these and other genes influence dietary response should increase the understanding of personalised nutrition. While targeted dietary advice may have considerable potential for reducing CVD risk, the ethical issues associated with its routine use need careful consideration.

Symposium on 'nutrition interventions in high-risk groups' - CVD risk in South Asians: the importance of defining adiposity and influence of dietary polyunsaturated fat

The prevalence of the metabolic syndrome (MetS), CVD and type 2 diabetes (T2D) is known to be higher in populations from the Indian subcontinent compared with the general UK population. While identification of this increased risk is crucial to allow for effective treatment, there is controversy over the applicability of diagnostic criteria, and particularly measures of adiposity in ethnic minorities. Diagnostic cut-offs for BMI and waist circumference have been largely derived from predominantly white Caucasian populations and, therefore, have been inappropriate and not transferable to Asian groups. Many Asian populations, particularly South Asians, have a higher total and central adiposity for a similar body weight compared with matched Caucasians and greater CVD risk associated with a lower BMI. Although the causes of CVD and T2D are multi-factorial, diet is thought to make a substantial contribution to the development of these diseases. Low dietary intakes and tissue levels of long-chain (LC) n-3 PUFA in South Asian populations have been linked to high-risk abnormalities in the MetS. Conversely, increasing the dietary intake of LC n-3 PUFA in South Asians has proved an effective strategy for correcting such abnormalities as dyslipidaemia in the MetS. Appropriate diagnostic criteria that include a modified definition of adiposity must be in place to facilitate the early detection and thus targeted treatment of increased risk in ethnic minorities.