A Microprocessor-Based Pulse-Height Analyzer

Need to analyze particles in a flow? This system takes electrical pulses from acoustical or optical sensors and groups them into bands representing ranges of particle sizes.

Studies on diglycine sulphate

Both diglycine sulphate (DGS) and diglycine sulphate monohydrate (DGS.H2O) are reported to crystallize from solution with pH < 1(1,2). DGS.H2O (point group 2/m; Z = 4) shows a dielectric anomaly at 72°C suggestive of antiferroelectric transition(1). The crystals obtained by us from solution with pH < 0.5 at 20-25°C were always DGS (point group mmm; Z = 8) as confirmed by X-ray studies. The measurement of its dielectric constant along [100], [010] and [001] did not indicate any phase transition in the range 5-400°K. Thus DGS is a normal dielectric unlike TGS. The polarized Raman spectra and the infrared spectra were recorded to examine the configuration of glycine in DGS(3). The vibration spectra reveals that both the glycines in DGS exist as NH3+CH2COOH, thus precluding the hydrogen bond of the type N+-H…O- which exists between two glycine units in TGS. This seems to be a good reason for the difference in the dielectric behaviour of these two glycine sulphates.

Non-ohmic conduction and electrical switching under pressure of the charge transfer complexo-tolidine-iodine

The current voltage characteristics ofo-tolidine-iodine, with stoichiometry 1:1 grown from benzene, have been studied under high pressures upto 6 GPa atT=300 K andT=77 K. The characteristics show a pronounced deviation from ohmicity beyond a certain current for all pressures studied. At room temperature, beyond a threshold field the system switches from a low conductingOFF state to a high conductingON state with σON/σOFF ∼ 103. TheOFF state can be restored by the application of an a.c. pulse of low frequency. The temperature dependence of the two states studied indicates that theOFF state is semiconducting while theON state, beyond a certain applied pressure is metallic. The characteristics atT=77 K do not show any switching.

Food-borne pathogens - a key issue for all food animal industries

The modern consumer has an attitude that food safety is non-negotiable issue – the consumer simply demands food to be safe. Yet, at the same time, the modern consumer has an expectation that the food safety is the responsibility of others – the primary producer, the processing company, the supermarket, commercial food handlers and so on. Given this environment, all food animal industries have little choice but to regard food safety as a key issue. As an example, the chicken meat industry, via the two main industry funding bodies – the Rural Industries Research and Development Corporation (Chicken Meat) and the Poultry CRC – has a comprehensive research program that seeks to focus on reducing the risks of food-borne diseases at all points of the food processing chain – from the farm to the processing plant. The scale of the issue for all industries can be illustrated by an analysis of the problem of campylobacterosis – a major food-borne disease. It has been estimated that there are around 230,000 cases of campylobacterosis per year. In 1995, it was estimated that each case of food-borne campylobacterosis in the USA was costing between $(US) 350-580. Hence, a reasonable conservative estimate is that each Australian case in 2010 would result in a cost of around $500 (this includes hospital, medication and lost productivity costs). Hence, this single food-borne agent could be costing Australian society around $115 million annually. In the light of these types of estimated costs for just one food-borne pathogen, it is easy to understand the importance that all food animal industries place on food safety.

Effects of three different nano-silver formulations on cut Acacia holosericea vase life

The relative efficacies of three chemically different nano-silver (NS) formulations were evaluated for their potential to extend the vase life of short-lived cut Acacia holosericea foliage. The novel proprietary formulations were neutral NS, acidic NS and ionic NS. They were characterised in terms of particle size, pH value, colour and odour. The NS treatments were applied as vase (lower concentrations) or pulse (higher concentrations) solutions. Among the treatments compared, neutral NS as a 4 mg L-1 vase solution or as a 40 mg L-1 24 h pulse treatment and acidic NS as a 0.5 mg L-1 vase solution or as a 5 mg L-1 24 h pulse treatment significantly (P <= 0.05) extended the vase life of A. holosericea. Vase life extensions over the deionised water (DI) controls were associated with better maintenance of relative fresh weight and vase water uptake, suppression of bacterial growth in the vase water and stem-end, and delaying stem blockage. In contrast, ionic-NS applied as a 0.5 or 1 mg L-1 vase solution treatment or as a 5 or 10 mg L-1 pulse treatment caused severe phytotoxicity to cut A. holosericea stems. The results suggest that NS treatments, especially neutral NS and acidic NS pulse treatments, could be a potential postharvest technology for commercial application to cut A. holosericea. (C) 2011 Elsevier B.V. All rights reserved.

Sitting-time and 9-year all-cause mortality in older women

Background Studies of mid-aged adults provide evidence of a relationship between sitting-time and all-cause mortality, but evidence in older adults is limited. The aim is to examine the relationship between total sitting-time and all-cause mortality in older women. Methods The prospective cohort design involved 6656 participants in the Australian Longitudinal Study on Women's Health who were followed for up to 9 years (2002, age 76–81, to 2011, age 85–90). Self-reported total sitting-time was linked to all-cause mortality data from the National Death Index from 2002 to 2011. Cox proportional hazard models were used to examine the relationship between sitting-time and all-cause mortality, with adjustment for potential sociodemographic, behavioural and health confounders. Results There were 2003 (30.1%) deaths during a median follow-up of 6 years. Compared with participants who sat <4 h/day, those who sat 8–11 h/day had a 1.45 times higher risk of death and those who sat ≥11 h/day had a 1.65 times higher risk of death. These risks remained after adding sociodemographic and behavioural covariates, but were attenuated after adjustment for health covariates. A significant interaction (p=0.02) was found between sitting-time and physical activity (PA), with increased mortality risk for prolonged sitting only among participants not meeting PA guidelines (HR for sitting ≥8 h/day: 1.31, 95% CI 1.07 to 1.61); HR for sitting ≥11 h/day: 1.47, CI 1.15 to 1.93). Conclusions Prolonged sitting-time was positively associated with all-cause mortality. Women who reported sitting for more than 8 h/day and did not meet PA guidelines had an increased risk of dying within the next 9 years.

Low-frequency dielectric constant measurements in the critical polar + non-polar binary liquid system: Methanol + n-heptane

The low-frequency (5–100 kHz) dielectric constant epsilon (Porson) has been measured in the temperature range 7 × 10−5 < t = (T − Tc)/Tc < 8 × 10−2. Near Tc an exponent ≈0.11 characterizes the power law behaviour of Image consistent with the theoretically predicted t−α singularity. However, over the full range of t an exponent ≈0.35 is obtained.

A simple firing delay control circuit for bridge converters

A simple ramp control firing circuit, suitable for use with fully controlled, line-commutated thyristor bridge circuits, is discussed here. This circuit uses very few components and generates the synchronized firing pulses in a simple way. It operates from a single 15 V Supply and has an inherent pulse inhibit facility. This circuit provides the synchronized firing pulses for both thyristors of the same limb in a bridge. To ensure reliability, wide triggering pulses are used, which are modulated to pass through the pulse transformers1 and demodulated before being fed to the thyristor gates. The use of throe such circuits only for a three-phase bridge is discussed.

The truncated dielectric-coated conducting sphere-radiation and gain characteristic

An exhaustive study of the radiation and gain characteristics of a truncated dielectric-coated conducting spherical antenna excited in the symmetric TM mode has been reported. The effect of the various structure parameters on the radiation and the gain characteristics for a few even and odd order TM., modes for different structures is shown. The theorctical radiation patterns and gain have been compared with experiment. It is found that there is good agreement between theory and experiment in the case of TM es and TM os,modes. A theoretical and experimental study of the radiation and gain characcteristics in the frequency range 8.0 to 12.0 GHz has been reported.

Studies on dielectric behavior of insulator-conductor composites

This paper describes the dielectric behavior of an insulator-conductor composite, namely, the wax-graphite composite. The variation of specific capacitance of these composites with parameters such as volume fraction and grain size of the conducting particles and temperature has been studied. These observed variations have been explained using the same model [C. Rajagopal and M. Satyam, J. Appl. Phys. 49, 5536 (1978)] which explains electrical conduction in composites. The specific capacitance of these materials appears to be governed by the contact capacitance between the conducting particles and the number of contacts each particle has with its neighbors. The variation of specific capacitance with temperature is attributed to the change in contact area.

Data distribution and task scheduling for distributed computing of all-to-all comparison problems

This research studied distributed computing of all-to-all comparison problems with big data sets. The thesis formalised the problem, and developed a high-performance and scalable computing framework with a programming model, data distribution strategies and task scheduling policies to solve the problem. The study considered storage usage, data locality and load balancing for performance improvement in solving the problem. The research outcomes can be applied in bioinformatics, biometrics and data mining and other domains in which all-to-all comparisons are a typical computing pattern.

Aspects and Applications of Pulse Sequence Design for Solution-State Nuclear Magnetic Resonance Spectroscopy

NMR spectroscopy enables the study of biomolecules from peptides and carbohydrates to proteins at atomic resolution. The technique uniquely allows for structure determination of molecules in solution-state. It also gives insights into dynamics and intermolecular interactions important for determining biological function. Detailed molecular information is entangled in the nuclear spin states. The information can be extracted by pulse sequences designed to measure the desired molecular parameters. Advancement of pulse sequence methodology therefore plays a key role in the development of biomolecular NMR spectroscopy. A range of novel pulse sequences for solution-state NMR spectroscopy are presented in this thesis. The pulse sequences are described in relation to the molecular information they provide. The pulse sequence experiments represent several advances in NMR spectroscopy with particular emphasis on applications for proteins. Some of the novel methods are focusing on methyl-containing amino acids which are pivotal for structure determination. Methyl-specific assignment schemes are introduced for increasing the size range of 13C,15N labeled proteins amenable to structure determination without resolving to more elaborate labeling schemes. Furthermore, cost-effective means are presented for monitoring amide and methyl correlations simultaneously. Residual dipolar couplings can be applied for structure refinement as well as for studying dynamics. Accurate methods for measuring residual dipolar couplings in small proteins are devised along with special techniques applicable when proteins require high pH or high temperature solvent conditions. Finally, a new technique is demonstrated to diminish strong-coupling induced artifacts in HMBC, a routine experiment for establishing long-range correlations in unlabeled molecules. The presented experiments facilitate structural studies of biomolecules by NMR spectroscopy.

Economic consideration for reducing hospital presentations among patients with decompensated cirrhosis: not all presentations avoided can be considered equal

Individuals with decompensated cirrhosis and ascites requiring paracentesis utilize exceptionally high levels of hospital resources. Consequently, potential modifications to existing models of healthcare to assist patients in the management of their liver disease and reduce the need for hospital encounters have potential to improve patients’ health and reduce demand on acute hospital services. However, there is a paucity of data examining how much healthcare resources could be re-directed to interventions that prevent hospitalizations without net annual budgetary disadvantage (from the hospital’s perspective). The purpose of this study was to probabilistically examine how much healthcare resourcing could be saved per hospital presentation avoided among this clinical population.