On the behavior of pliable plate dynamics in wind : application to vertical axis wind turbines

Numerous studies have shown that flexible materials improve resilience and durability of a structure. Several studies have investigated the behavior of elastic plates under the influence of a free stream, such as studies of the fluttering flag and others of shape reconfiguration, due to a free stream.

The principle engineering contribution of this thesis is the design and development of a vertical axis wind turbine that features pliable blades which undergo various modes of behavior, ultimately leading to rotational propulsion of the turbine. The wind turbine design was tested in a wind tunnel and at the Caltech Laboratory for Optimized Wind Energy. Ultimately, the flexible blade vertical axis wind turbine proved to be an effective way of harnessing the power of the wind.

In addition, this body of work builds on the current knowledge of elastic cantilever plates in a free stream flow by investigating the inverted flag. While previous studies have focused on the fluid structure interaction of a free stream on elastic cantilever plates, none had studied the plate configuration where the trailing edge was clamped, leaving the leading edge free to move. Furthermore, the studies presented in this thesis establish the geometric boundaries of where the large-amplitude flapping occurs.

Magnetic alignment of high-aspect ratio microwires into vertical arrays

Fundamental studies of magnetic alignment of highly anisotropic mesostructures can enable the clean-room-free fabrication of flexible, array-based solar and electronic devices, in which preferential orientation of nano- or microwire-type objects is desired. In this study, ensembles of 100 micron long Si microwires with ferromagnetic Ni and Co coatings are oriented vertically in the presence of magnetic fields. The degree of vertical alignment and threshold field strength depend on geometric factors, such as microwire length and ferromagnetic coating thickness, as well as interfacial interactions, which are modulated by varying solvent and substrate surface chemistry. Microwire ensembles with vertical alignment over 97% within 10 degrees of normal, as measured by X-ray diffraction, are achieved over square cm scale areas and set into flexible polymer films. A force balance model has been developed as a predictive tool for magnetic alignment, incorporating magnetic torque and empirically derived surface adhesion parameters. As supported by these calculations, microwires are shown to detach from the surface and align vertically in the presence of magnetic fields on the order of 100 gauss. Microwires aligned in this manner are set into a polydimethylsiloxane film where they retain their vertical alignment after the field has been removed and can subsequently be used as a flexible solar absorber layer. Finally, these microwires arrays can be protected for use in electrochemical cells by the conformal deposition of a graphene layer.

Guiding neutral atoms with two current-carrying wires and a vertical bias field on the atom chip

We demonstrate the guiding of neutral atoms with two parallel microfabricated current-carrying wires on the atom chip and a vertical magnetic bias field. The atoms are guided along a magnetic field minimum parallel to the current-carrying wires and confined in the other two directions. We describe in detail how the precooled atoms are efficiently loaded into the two-wire guide. We present a detailed experimental study of the motional properties of the atoms in the guide and the relationship between the location of the guide and the vertical bias field. This two-wire guide with vertical bias field can be used to realize large area atom interferometer.

Laser cooling of rubidium atoms from background vapor in diffuse light

In this paper we describe an experiment on laser cooling of Rb-87 atoms directly from a vapor background in diffuse light. Diffuse light is produced in a ceramic integrating sphere by multiple scattering of two laser beams injected through multimode fibers. A probe beam, whose propagation direction is either horizontal or vertical, is used to detect cold atoms. We measured the absorption spectra of the cold atoms by scanning the frequency of the probe beam, and observed both the absorption signal and the time of flight signal after we switched off the cooling light, from which we estimated the temperature and the number of cold atoms. This method is clearly attractive for building a compact cold atom clock.

Investigations on the vertical migration of planktonic Crustacea in the Bodensee-Obersee. [Translation from: Schriften des Vereins fur Geschichte des Bodensees und seiner Umgebung, 87, 177-187, 1969.]

The vertical zoning of the planktonic Crustacea in a lake is the expression of a complex set of different factors. Besides the measurable, external influences such as light, temperature, acid and C02 stratification, a particularly large part is played by internal factors, which co-ordinate a specific reaction in each species depending on state of development, age and sex. Supporting this extensive, predictable, annual course of diurnal depths and the daily vertical migrations, whose extent is again dependent on external conditions, primarily of course on the amount of light. The individual factors mentioned, however, are here also of great significance. Within the scope of a long-term study of the planktonic Copepoda of Lake Constance, some day and night series were in 1963 also carried out in the Obersee, in order to obtain at least volumetric data on the extent of the daily migrations of these creatures.

On drift and diel vertical migration of bottom invertebrates of the Amur. [Translation from: Zoologicheskie Zhurnal 42 1601-1612, 1963.]

Planktobenthos was sampled in 1957-58 in the river Amur. A determination of the kind of organisms drifting in the mass of water of the Amur was carried out. Of special interest for the authors was the activity of drifting of benthic larvae.

The vertical distribution of zooplankton in the Goggausee (the influence of algae and Chaoborus flavicans) [Translation from: Carinthia II 166/186 373-385, 1976]

The Goggausee, a small, shallow, meromictic lake(700m long, 150m wide, max. depth=12m, mean depth=6m), was the site of a week long study (19-26 May 1974) of the limnology department of the University of Vienna. The study comprised pollen analysis and palaeolimnological studies on the one hand, as well as a stock- taking of physiochemical factors, primary production, bacteria, zooplankton, zoo benthos and fish on the other. This paper studies the zooplankton of the lake. The Goggausee is a meromictic lake, with its anoxic deep water, that restricts the vertical distribution of most zooplankton. The aim of the study was to pursue the vertical distribution of the rotifers and Crustacea. Density of individuals, biomass, percentages of zooplankton together and crustaceans and rotifers as groups. Special consideration is given to the the Dipteran Chaoborus flavicans.

La spin-off universitaria como mecanismo para la transferencia de conocimiento

En los últimos años, ha crecido el número de publicaciones existentes sobre el fenómeno de las spin-offs apareciendo así como un mecanismo revolucionario en el cumplimiento de la tercera misión de la universidad. El presente trabajo analiza la creación de spin-offs universitarias como método para la transferencia de conocimiento universidad-empresa, analizando en un principio la historia de la universidad, los modelos y mecanismos para la transferencia de conocimiento. El análisis continúa con una conceptualización del fenómeno una diferenciación de los tipos de spin-offs, además de destacar sus beneficios y factores condicionantes. Por último, se realiza una síntesis del marco legal vigente y un estudio aplicado sobre esta realidad en la UPV/EHU.

1.55-mu m InGaAs/InGaAlAs MQW vertical-cavity surface-emitting lasers with InGaAlAs/InP distributed Bragg reflectors

High-performance InGaAs/InGaAlAs multiple-quantum-well vertical-cavity surface-emitting lasers (VCSELs) with lnGaAlAs/InP distributed Bragg reflectors are proposed for operation at the wavelength of 1.55 mum. The lasers have good heat diffusion characteristic, large index contrast in DBRs, and weak temperature sensitivity. They could be fabricated either by metal-organic chemical vapor deposition (MOCVD) or by molecular beam epitaxy (MBE) growth. The laser light-current characteristics indicate that a suitable reflectivity of the DBR on the light output side in a laser makes its output power increase greatly and its lasing threshold current reduce significantly, and that a small VCSEL could output the power around its maximum for the output mirror at the reflectivity varying in a broader range than a large VCSEL does. (C) 2004 Elsevier Ltd. All rights reserved.

Concerning the current conditions and transport of sand in the shallow water areas off the coast of the south-eastern North Sea [Translation from: Hamburger Kustenforschung 29 [pages 41-43 only], 1974]

With the aid of the German Research Association in the central programme 'Sand movements in the German coastal region', an investigation into the current conditions in the shallow water areas of the coasts of the south-eastern North Sea between Sylt and the Weser estuary was carried out by the author. Foundations of the work are 19 continuous current recordings in five profiles normal to the coast from years 1971 to 1973. Off the coasts of the south-eastern North Sea varying tidal currents impinge; they are currents whose directions may vary periodically through all points of the compass. They are caused by the circulating tides in the North Sea (Amphidromien). The turning flow movement experiences a deformation in the very shallow coastal waters, and as it happens the flow turning movement in the case of high tide continues right up onto the outer flats, while here and in the fore-lying shallow water areas around the time of low water (on account of the small depths of waters), there prevails a more variable current. A result of this hydrodynamical procedure is the development of counter currents. This partial translation of the original paper provides the summary of this study of of the mudflat areas between the Elbe and Weser.

Dynamic Stall on Vertical Axis Wind Turbines

In this study the dynamics of flow over the blades of vertical axis wind turbines was investigated using a simplified periodic motion to uncover the fundamental flow physics and provide insight into the design of more efficient turbines. Time-resolved, two-dimensional velocity measurements were made with particle image velocimetry on a wing undergoing pitching and surging motion to mimic the flow on a turbine blade in a non-rotating frame. Dynamic stall prior to maximum angle of attack and a leading edge vortex development were identified in the phase-averaged flow field and captured by a simple model with five modes, including the first two harmonics of the pitch/surge frequency identified using the dynamic mode decomposition. Analysis of these modes identified vortical structures corresponding to both frequencies that led the separation and reattachment processes, while their phase relationship determined the evolution of the flow.

Detailed analysis of the leading edge vortex found multiple regimes of vortex development coupled to the time-varying flow field on the airfoil. The vortex was shown to grow on the airfoil for four convection times, before shedding and causing dynamic stall in agreement with 'optimal' vortex formation theory. Vortex shedding from the trailing edge was identified from instantaneous velocity fields prior to separation. This shedding was found to be in agreement with classical Strouhal frequency scaling and was removed by phase averaging, which indicates that it is not exactly coupled to the phase of the airfoil motion.

The flow field over an airfoil undergoing solely pitch motion was shown to develop similarly to the pitch/surge motion; however, flow separation took place earlier, corresponding to the earlier formation of the leading edge vortex. A similar reduced-order model to the pitch/surge case was developed, with similar vortical structures leading separation and reattachment; however, the relative phase lead of the separation mode, corresponding to earlier separation, necessitated that a third frequency to be incorporated into the reattachment mode to provide a relative lag in reattachment.

Finally, the results are returned to the rotating frame and the effects of each flow phenomena on the turbine are estimated, suggesting kinematic criteria for the design of improved turbines.

Aerodynamics of vertical-axis wind turbines in full-scale and laboratory-scale experiments

Within a wind farm, multiple turbine wakes can interact and have a substantial effect on the overall power production. This makes an understanding of the wake recovery process critically important to optimizing wind farm efficiency. Vertical-axis wind turbines (VAWTs) exhibit features that are amenable to dramatically improving this efficiency. However, the physics of the flow around VAWTs is not well understood, especially as it pertains to wake interactions, and it is the goal of this thesis to partially fill this void. This objective is approached from two broadly different perspectives: a low-order view of wind farm aerodynamics, and a detailed experimental analysis of the VAWT wake.

One of the contributions of this thesis is the development of a semi-empirical model of wind farm aerodynamics, known as the LRB model, that is able to predict turbine array configurations to leading order accuracy. Another contribution is the characterization of the VAWT wake as a function of turbine solidity. It was found that three distinct regions of flow exist in the VAWT wake: (1) the near wake, where periodic blade shedding of vorticity dominates; (2) a transition region, where growth of a shear-layer instability occurs; (3) the far wake, where bluff-body oscillations dominate. The wake transition can be predicted using a new parameter, the dynamic solidity, which establishes a quantitative connection between the wake of a VAWT and that of a circular cylinder. The results provide insight into the mechanism of the VAWT wake recovery and the potential means to control it.

Anisotropic Bragg diffraction of finite-sized volume holographic grating in photorefractive crystals

Anisotropic diffraction of uniform plane wave by finite-sized volume holographic grating in photorefractive crystals is considered. It is found that the anisotropic diffraction can take place when some special conditions are satisfied. The diffracted image is obtained in experiment for the anisotropic Bragg diffraction in Fe:LiNbO3 crystals. A coupled wave analysis is presented to study the properties of anisotropic diffraction. An analytical integral solution for the amplitudes of the diffracted beams is submitted. A trade off between high diffraction efficiency and the deterioration of reconstruction fidelity is analyzed. Numerical evaluations also show that the finite-sized anisotropic volume grating exhibits strong angular and wavelength selectivity. All the results are useful for the optimizing design of VHOE based on finite-sized volume grating structures. (c) 2006 Elsevier GmbH. All rights reserved.