Multilevel load frequency control (a perturbational approach)

A two-level control scheme for the load frequency control of a multi-area power system utilizing certain possible beneficial aspects of interconnections is described in this paper. The problem is identified as the determination of the necessary equivalent perturbation on the control distribution matrix to provide the corrective control.

Influence of validation schemes in a laser Doppler anemometer period timing device for frequency measurement

The short duration of the Doppler signal and noise content in it necessitate a validation scheme to be incorporated in the electronic processor used for frequency measurement, There are several different validation schemes that can be employed in period timing devices. A detailed study of the influence of these validation schemes on the measured frequency has been reported here. These studies were carried out by using a combination of a fast A/D converter and computer. Doppler bursts obtained from an air flow were digitised and stored on magnetic discs. Suitable computer programs were then used to simulate the performance of period timing devices with different validation schemes and the frequency of the stored bursts were evaluated. It is found that best results are obtained when the validation scheme enables frequency measurement to be made over a large number of cycles within the burst.

Special Issue on Spatial Moment Techniques for Modelling Biological Processes

Over the last two decades, there has been an increasing awareness of, and interest in, the use of spatial moment techniques to provide insight into a range of biological and ecological processes. Models that incorporate spatial moments can be viewed as extensions of mean-field models. These mean-field models often consist of systems of classical ordinary differential equations and partial differential equations, whose derivation, at some point, hinges on the simplifying assumption that individuals in the underlying stochastic process encounter each other at a rate that is proportional to the average abundance of individuals. This assumption has several implications, the most striking of which is that mean-field models essentially neglect any impact of the spatial structure of individuals in the system. Moment dynamics models extend traditional mean-field descriptions by accounting for the dynamics of pairs, triples and higher n-tuples of individuals. This means that moment dynamics models can, to some extent, account for how the spatial structure affects the dynamics of the system in question.

Low-frequency dielectric constant measurements in the critical polar + non-polar binary liquid system: Methanol + n-heptane

The low-frequency (5–100 kHz) dielectric constant ε has been measured in the temperature range 7 × 10−5 < T = (T − Tc)/Tc < 8 × 10−2. Near Tc an exponent ≈0.11 characterizes the power law behaviour of dε/dt consistent with the theoretically predicted t−α singularity. However, over the full range of t an exponent ≈0.35 is obtained.

Haptiisit ja hapteemit : tapaustutkimus kuurosokean henkilön kosketukseen perustuvan kommunikaation kehityksestä

Haptices and haptemes: A case study of developmental process in touch-based communication of acquired deafblind people This research is the first systematic, longitudinal process and development description of communication using touch and body with an acquired deafblind person. The research consists of observational and analysed written and video materials mainly from two informants´ experiences during period of 14 years. The research describes the adaptation of Social-Haptic methods between a couple, and other informants´ experiences, which have been collated from biographies and through giving national and international courses. When the hearing and sight deteriorates due to having an acquired deafblind condition, communication consists of multi-systematic and adaptive methods. A person`s expressive language, spoken or Sign Language, usually remains unchanged, but the methods of receiving information could change many times during a person s lifetime. Haptices are made from haptemes that determines which regulations are analysed. When defining haptemes the definition, classification and varied meanings of touch were discovered. Haptices include sharing a personal body space, meaning of touch-contact, context and using different communication channels. Communication distances are classified as exact distance, estimated distance and touch distance. Physical distance can be termed as very long, long, medium or very close. Social body space includes the body areas involved in sending and receiving haptices and applying different types of contacts. One or two hands can produce messages by using different hand shapes and orientations. This research classifies how the body can be identified into different areas such as body orientation, varied body postures, body position levels, social actions and which side of the body is used. Spatial body space includes environmental and situational elements. Haptemes of movements are recognised as the direction of movements, change of directions on the body, directions between people, pressure, speed, frequency, size, length, duration, pause, change of rhythm, shape, macro and micro movements. Haptices share multidimensional meanings and emotions. Research describes haptices in different situations enhancing sensory information and functioning also as an independent language. Haptices includes social-haptic confirmation system, social quick messages, body drawing, contact to the people and the environment, guiding and sharing art experiences through movements. Five stages of emotional differentiation were identified as very light, light, medium, heavy and very heavy touch. Haptices give the possibility to share different art, hobby and game experiences. A new communication system development based on the analysis of the research data is classified into different phases. These are experimental initiation, social deconstruction, developing the description of Social-Haptic communication and generalisation of the theory as well as finding and conceptualising the haptices and haptemes. The use and description of haptices is a social innovation, which illustrates the adaptive function of the body and perceptual senses that can be taught to a third party. Keywords: deafblindness, hapteme, haptic, haptices, movement, social-haptic communication, social-haptic confirmation system, tactile, touch

High-Frequency Current Source Inverter

The frequency range of the current source inverter (CSI) is limited by the slow commutation process in the inverter circuit. A method to reduce the commutation time and to limit the commutation capacitor voltage is proposed. A brief description of the conventional CSI and a detailed analysis of the commutation intervals of the proposed circuit are given. The experimental waveforms observed in the laboratory verify the validity of the analysis.

Spectral analysis of pair-correlation bandwidth: Application to cell biology images

Images from cell biology experiments often indicate the presence of cell clustering, which can provide insight into the mechanisms driving the collective cell behaviour. Pair-correlation functions provide quantitative information about the presence, or absence, of clustering in a spatial distribution of cells. This is because the pair-correlation function describes the ratio of the abundance of pairs of cells, separated by a particular distance, relative to a randomly distributed reference population. Pair-correlation functions are often presented as a kernel density estimate where the frequency of pairs of objects are grouped using a particular bandwidth (or bin width), Δ>0. The choice of bandwidth has a dramatic impact: choosing Δ too large produces a pair-correlation function that contains insufficient information, whereas choosing Δ too small produces a pair-correlation signal dominated by fluctuations. Presently, there is little guidance available regarding how to make an objective choice of Δ. We present a new technique to choose Δ by analysing the power spectrum of the discrete Fourier transform of the pair-correlation function. Using synthetic simulation data, we confirm that our approach allows us to objectively choose Δ such that the appropriately binned pair-correlation function captures known features in uniform and clustered synthetic images. We also apply our technique to images from two different cell biology assays. The first assay corresponds to an approximately uniform distribution of cells, while the second assay involves a time series of images of a cell population which forms aggregates over time. The appropriately binned pair-correlation function allows us to make quantitative inferences about the average aggregate size, as well as quantifying how the average aggregate size changes with time.

Reassessing spatial and temporal dynamics of kangaroo populations

Long-running datasets from aerial surveys of kangaroos (Macropus giganteus, Macropus [uliginosus, Macropus robustus and Macropus rufus) across Queensland, New South Wales and South Australia have been analysed, seeking better predictors of rates of increase which would allow aerial surveys to be undertaken less frequently than annually. Early models of changes in kangaroo numbers in response to rainfall had shown great promise, but much variability. We used normalised difference vegetation index (NDVI) instead, reasoning that changes in pasture condition would provide a better predictor than rainfall. However, except at a fine scale, NDVI proved no better; although two linked periods of rainfall proved useful predictors of rates of increase, this was only in some areas for some species. The good correlations reported in earlier studies were a consequence of data dominated by large droughtinduced adult mortality, whereas over a longer time frame and where changes between years are less dramatic, juvenile survival has the strongest influence on dynamics. Further, harvesting, density dependence and competition with domestic stock are additional and important influences and it is now clear that kangaroo movement has a greater influence on population dynamics than had been assumed. Accordingly, previous conclusions about kangaroo populations as simple systems driven by rainfall need to be reassessed. Examination of this large dataset has permitted descriptions of shifts in distribution of three species across eastern Australia, changes in dispersion in response to rainfall, and an evaluation of using harvest statistics as an index of density and harvest rate. These results have been combined into a risk assessment and decision theory framework to identify optimal monitoring strategies.

Frequency and temperature-dependent mobility of a charged carrier on a randomly interrupted strand

A randomly interrupted strand model of a one-dimensional conductor is considered. An exact analytical expression is obtained for the temperature-dependent ac mobility for a finite segment drawn at random, taking into account the reflecting barriers at the two open ends. The real part of mobility shows a broad resonance as a function of both frequency and temperature, and vanishes quadratically in the dc limit. The frequency (temperature) maximum shifts to higher values for higher temperatures (frequencies).

Surface explosive instability for high frequency waves

High frequency three-wave nonlinear 'explosive' interaction of the surface modes of a semi-infinite beam-plasma system under no external field is investigated. The conditions that favour nonlinear instability, keep the plasma linearly stable. The beam runs parallel to the surface. If at least one of the three wave vectors of the surface modes is parallel to the beam, explosive interaction at the surface takes place after it has happened in the plasma bulk, provided the bulk waves propagate almost perpendicular to the surface and are of short wavelength. On the other hand if the bulk modes have long wavelength and propagate almost parallel to the surface, the surface modes can 'explode' first.

A criterion for existence of low frequency pure surface magnetoplasmon modes in the Faraday configuration

The low frequency surface magnetoplasmon-type polaritons in the Faraday configuration will propagate as generalized surface modes if 4ε∞/(ε∞ − 1)2 greater-or-equal, slanted μ2 and as pure surface modes if this inequality is reversed. The possibility of using the low frequency surface waves as a suitable probe for measuring the carrier concentration of a given sample is discussed.

Spatial subdivision among assemblages of Spanish mackerel, Scomberomorus commerson (Pisces: Scombridae) across northern Australia: implications for fisheries management

Aim: This study investigated the use of stable δ13C and δ18O isotopes in the sagittal otolith carbonate of narrow-barred Spanish mackerel, Scomberomorus commerson, as indicators of population structure across Australia. Location: Samples were collected from 25 locations extending from the lower west coast of Western Australia (30°), across northern Australian waters, and to the east coast of Australia (18°) covering a coastline length of approximately 9500 km, including samples from Indonesia. Methods: The stable δ13C and δ18O isotopes in the sagittal otolith carbonate of S. commerson were analysed using standard mass spectrometric techniques. The isotope ratios across northern Australian subregions were subjected to an agglomerative hierarchical cluster analysis to define subregions. Isotope ratios within each of the subregions were compared to assess population structure across Australia. Results: Cluster analysis separated samples into four subregions: central Western Australia, north Western Australia, northern Australia and the Gulf of Carpentaria and eastern Australia. Isotope signatures for fish from a number of sampling sites from across Australia and Indonesia were significantly different, indicating population separation. No significant differences were found in otolith isotope ratios between sampling times (no temporal variation). Main conclusions: Significant differences in the isotopic signatures of S. commerson demonstrate that there is unlikely to be any substantial movement of fish among these spatially discrete adult assemblages. The lack of temporal variation among otolith isotope ratios indicates that S. commerson populations do not undergo longshore spatial shifts in distribution during their life history. The temporal persistence of spatially explicit stable isotopic signatures indicates that, at these spatial scales, the population units sampled comprise functionally distinct management units or separate ‘stocks’ for many of the purposes of fisheries management. The spatial subdivision evident among populations of S. commerson across northern and western Australia indicates that it may be advantageous to consider S. commerson population dynamics and fisheries management from a metapopulation perspective (at least at the regional level).

Some aspects of multilevel load-frequency control of a power system

The application of multilevel control strategies for load-frequency control of interconnected power systems is assuming importance. A large multiarea power system may be viewed as an interconnection of several lower-order subsystems, with possible change of interconnection pattern during operation. The solution of the control problem involves the design of a set of local optimal controllers for the individual areas, in a completely decentralised environment, plus a global controller to provide the corrective signal to account for interconnection effects. A global controller, based on the least-square-error principle suggested by Siljak and Sundareshan, has been applied for the LFC problem. A more recent work utilises certain possible beneficial aspects of interconnection to permit more desirable system performances. The paper reports the application of the latter strategy to LFC of a two-area power system. The power-system model studied includes the effects of excitation system and governor controls. A comparison of the two strategies is also made.

Infrared spectra of 1.3-dithiole-2-thione and its selenium analogues ând frequency assignment and molecular force constants

Infrared spectra of 1,3-dithiole-2-thione (DTT) and its four selenium analogues have been studied in the region 4000 to 20 cm�1. Assignment of all the fundamental frequencies was made by noting the band shifts on progressive selenation. Normal coordinate analysis procedures have been applied for both in-plane and out-of-plane vibrations to help the assignments. The Urey�Bradley force function supplemented with valence force constants for the out-of-plane vibrations was employed for coordinate calculations. A correlation of the infrared assignments of DTT with its different selenium analogues is accomplished. Further, the infrared assignments are compared with those of trithiocarbonate ion and its selenium analogues and other structurally related heterocyclic molecules.