Report on a special investigation of the City of Lakota for the period July 1, 2013 through May 31, 2015

Report on a special investigation of the City of Lakota for the period July 1, 2013 through May 31, 2015

Investigation of PCC Pavement Deterioration: A Few Facts are Worth More than 100 Opinions, Interim Report, HR-2074, 1995

Portland Cement Concrete (PCC) pavement has served the State of Iowa well for many years. The oldest Iowa pavement was placed in LeMars in 1904. Beginning in 1931, many miles of PCC pavement were built to "get out of the mud.” Many of these early pavements provided good performance without deterioration for more than 50 years. In the late 1950's, Iowa was faced with severe PCC pavement deterioration referred to as D cracking. Research identified the cause of this deterioration as crushed limestone containing a bad pore system. Selective quarrying and ledge control has alleviated this problem. In 1990, cracking deterioration was identified on a three year old pavement on us 20 in central Iowa. The coarse aggregate was a crushed limestone with an excellent history of performance in PCC pavement. Examination of cores showed very few cracks through the coarse aggregate particles. The cracks were predominately confined to the matrix. The deterioration was identified as alkali-silica reactivity (ASR) by a consultant.

Report on a special investigation of the City of Boyden for the period July 1, 2013 through April 30, 2015

Report on a special investigation of the City of Boyden for the period July 1, 2013 through April 30, 2015

Investigation of resins suitable for the preparation of biological sample for 3-D electron microscopy.

In the last two decades, the third-dimension has become a focus of attention in electron microscopy to better understand the interactions within subcellular compartments. Initially, transmission electron tomography (TEM tomography) was introduced to image the cell volume in semi-thin sections (∼500nm). With the introduction of the focused ion beam scanning electron microscope, a new tool, FIB-SEM tomography, became available to image much larger volumes. During TEM tomography and FIB-SEM tomography, the resin section is exposed to a high electron/ion dose such that the stability of the resin embedded biological sample becomes an important issue. The shrinkage of a resin section in each dimension, especially in depth, is a well-known phenomenon. To ensure the dimensional integrity of the final volume of the cell, it is important to assess the properties of the different resins and determine the formulation which has the best stability in the electron/ion beam. Here, eight different resin formulations were examined. The effects of radiation damage were evaluated after different times of TEM irradiation. To get additional information on mass-loss and the physical properties of the resins (stiffness and adhesion), the topography of the irradiated areas was analysed with atomic force microscopy (AFM). Further, the behaviour of the resins was analysed after ion milling of the surface of the sample with different ion currents. In conclusion, two resin formulations, Hard Plus and the mixture of Durcupan/Epon, emerged that were considerably less affected and reasonably stable in the electron/ion beam and thus suitable for the 3-D investigation of biological samples.

Investigation of the hepatitis C virus replication complex.

The NS5A protein of HCV is an essential component of the viral RNA replication machinery and may also function in modulation of the host cell environment. The exact function of NS5A in these processes remains unknown. NS5A is a large hydrophilic phosphoprotein protein consisting of three domains. The amino-terminal domain, designated domain I, coordinates a single zinc atom that is required for virus replication. We have determined the X-ray crystallographic structure of the domain I region of NS5A, and the structure sheds some light on the previously reported RNA binding activity observed for NS5A and suggests that the protein functions as a dimer. Here we describe the bacterial expression, purification, crystallization, and structural determination of the amino-terminal domain I of NS5A. The methods described herein should be of use for the generation of domain I for biochemical studies as well as future crystallization studies as antiviral compounds directed against this region of NS5A become available.

ADME pharmacogenetics: investigation of the pharmacokinetics of the antiretroviral agent lopinavir coformulated with ritonavir.

BACKGROUND: An ADME (absorption, distribution, metabolism and excretion)-pharmacogenetics association study may identify functional variants relevant to the pharmacokinetics of lopinavir co-formulated with ritonavir (LPV/r), a first-line anti-HIV agent. METHODS: An extensive search of literature and web resources helped select ADME genes and single nucleotide polymorphisms (SNPs, functional and HapMap tagging SNPs) with a proven or potentially relevant role in LPV/r pharmacokinetics. The study followed a two-stage design. Stage 1 (discovery) considered a Caucasian population (n=638) receiving LPV/r, where we selected 117 individuals with low LPV clearance (cases) and 90 individuals with high clearance (controls). Genotyping was performed by a 1536-SNP customized GoldenGate Illumina BeadArray. Stage 2 (confirmation) represented a replication study of candidate SNPs from the stage 1 in 148 individuals receiving LPV/r. The analysis led to formal population pharmacokinetic-pharmacogenetic modeling of demographic, environmental and candidate SNP effects. RESULTS: One thousand three hundred and eighty SNPs were successfully genotyped. Nine SNPs prioritized by the stage 1 analysis were brought to replication. Stage 2 confirmed the contribution of two functional SNPs in SLCO1B1, one functional SNP in ABCC2 and a tag SNP of the CYP3A locus in addition to body weight effect and ritonavir coadministration. According to the population pharmacokinetic-pharmacogenetic model, genetic variants explained 5% of LPV variability. Individuals homozygous rs11045819 (SLCO1B1*4) had a clearance of 12.6 l/h, compared with 5.4 l/h in the reference group, and 3.9 l/h in individuals with two or more variant alleles of rs4149056 (SLCO1B1*5), rs717620 (ABCC2) or rs6945984 (CYP3A). A subanalysis confirmed that although a significant part of the variance in LPV clearance was attributed to fluctuation in ritonavir levels, genetic variants had an additional effect on LPV clearance. CONCLUSION: The two-stage strategy successfully identified genetic variants affecting LPV/r pharmacokinetics. Such a general approach of ADME pharmacogenetics should be generalized to other drugs.

Investigation of classical epidemiological links between patients harbouring identical, non-predominant meticillin-resistant Staphylococcus aureus genotypes and lessons for epidemiological tracking.

According to molecular epidemiology theory, two isolates belong to the same chain of transmission if they are similar according to a highly discriminatory molecular typing method. This has been demonstrated in outbreaks, but is rarely studied in endemic situations. Person-to-person transmission cannot be established when isolates of meticillin-resistant Staphylococcus aureus (MRSA) belong to endemically predominant genotypes. By contrast, isolates of infrequent genotypes might be more suitable for epidemiological tracking. The objective of the present study was to determine, in newly identified patients harbouring non-predominant MRSA genotypes, whether putative epidemiological links inferred from molecular typing could replace classical epidemiology in the context of a regional surveillance programme. MRSA genotypes were defined using double-locus sequence typing (DLST) combining clfB and spa genes. A total of 1,268 non-repetitive MRSA isolates recovered between 2005 and 2006 in Western Switzerland were typed: 897 isolates (71%) belonged to four predominant genotypes, 231 (18%) to 55 non-predominant genotypes, and 140 (11%) were unique. Obvious epidemiological links were found in only 106/231 (46%) patients carrying isolates with non-predominant genotypes suggesting that molecular surveillance identified twice as many clusters as those that may have been suspected with classical epidemiological links. However, not all of these molecular clusters represented person-to-person transmission. Thus, molecular typing cannot replace classical epidemiology but is complementary. A prospective surveillance of MRSA genotypes could help to target epidemiological tracking in order to recognise new risk factors in hospital and community settings, or emergence of new epidemic clones.

Ultra high performance supercritical fluid chromatography coupled with tandem mass spectrometry for screening of doping agents. I: Investigation of mobile phase and MS conditions.

The conditions for the analysis of selected doping substances by UHPSFC-MS/MS were optimized to ensure suitable peak shapes and maximized MS responses. A representative mixture of 31 acidic and basic doping agents was analyzed, in both ESI+ and ESI- modes. The best compromise for all compounds in terms of MS sensitivity and chromatographic performance was obtained when adding 2% water and 10mM ammonium formate in the CO2/MeOH mobile phase. Beside mobile phase, the nature of the make-up solvent added for interfacing UHPSFC with MS was also evaluated. Ethanol was found to be the best candidate as it was able to compensate for the negative effect of 2% water addition in ESI- mode and provided a suitable MS response for all doping agents. Sensitivity of the optimized UHPSFC-MS/MS method was finally assessed and compared to the results obtained in conventional UHPLC-MS/MS. Sensitivity was improved by 5-100-fold in UHPSFC-MS/MS vs. UHPLC-MS/MS for 56% of compounds, while only one compound (bumetanide) offered a significantly higher MS response (4-fold) under UHPLC-MS/MS conditions. In the second paper of this series, the optimal conditions for UHPSFC-MS/MS analysis will be employed to screen >100 doping agents in urine matrix and results will be compared to those obtained by conventional UHPLC-MS/MS.

Investigation ofsolid - state cooler based on electrocaloric effect

Electrocaloric cooling based on ability of material to change temperature by applying an electric field under adiabatic conditions is relatively new and challenging direction of ferroelectrics research. In this work we report about analytical, simulation and experimental data for BaSrTiO3 thin film and bulk ceramic samples. Detailed discussion of a theoretical base of the electrocaloric effect is included. Demonstrated experimental and computational results exemplify rational approach to a problem of solid-state cooler construction.

Potential Accessibility of Web-based mathematical information resources

This paper presents a research concerning the conversion of non-accessible web pages containing mathematical formulae into accessible versions through an OCR (Optical Character Recognition) tool. The objective of this research is twofold. First, to establish criteria for evaluating the potential accessibility of mathematical web sites, i.e. the feasibility of converting non-accessible (non-MathML) math sites into accessible ones (Math-ML). Second, to propose a data model and a mechanism to publish evaluation results, making them available to the educational community who may use them as a quality measurement for selecting learning material.Results show that the conversion using OCR tools is not viable for math web pages mainly due to two reasons: many of these pages are designed to be interactive, making difficult, if not almost impossible, a correct conversion; formula (either images or text) have been written without taking into account standards of math writing, as a consequence OCR tools do not properly recognize math symbols and expressions. In spite of these results, we think the proposed methodology to create and publish evaluation reports may be rather useful in other accessibility assessment scenarios.

Contribution of isotope ratio mass spectrometry to the investigation of improvised explosives: isotopic study of black powders ans ammonium nitrates

The establishment of legislative rules about explosives in the eighties has reduced the illicit use of military and civilian explosives. However, bomb-makers have rapidly taken advantage of substances easily accessible and intended for licit uses to produce their own explosives. This change in strategy has given rise to an increase of improvised explosive charges, which is moreover assisted by the ease of implementation of the recipes, widely available through open sources. While the nature of the explosive charges has evolved, instrumental methods currently used in routine, although more sensitive than before, have a limited power of discrimination and allow mostly the determination of the chemical nature of the substance. Isotope ratio mass spectrometry (IRMS) has been applied to a wide range of forensic materials. Conclusions drawn from the majority of the studies stress its high power of discrimination. Preliminary studies conducted so far on the isotopic analysis of intact explosives (pre-blast) have shown that samples with the same chemical composition and coming from different sources could be differentiated. The measurement of stable isotope ratios appears therefore as a new and remarkable analytical tool for the discrimination or the identification of a substance with a definite source. However, much research is still needed to assess the validity of the results in order to use them either in an operational prospect or in court. Through the isotopic study of black powders and ammonium nitrates, this research aims at evaluating the contribution of isotope ratio mass spectrometry to the investigation of explosives, both from a pre-blast and from a post-blast approach. More specifically, the goal of the research is to provide additional elements necessary to a valid interpretation of the results, when used in explosives investigation. This work includes a fundamental study on the variability of the isotopic profile of black powder and ammonium nitrate in both space and time. On one hand, the inter-variability between manufacturers and, particularly, the intra-variability within a manufacturer has been studied. On the other hand, the stability of the isotopic profile over time has been evaluated through the aging of these substances exposed to different environmental conditions. The second part of this project considers the applicability of this high-precision technology to traces and residues of explosives, taking account of the characteristics specific to the field, including their sampling, a probable isotopic fractionation during the explosion, and the interferences with the matrix of the site.

Concentrations of resveratrol and derivatives in foods and estimation of dietary intake in a Spanish population: European Prospective Investigation into Cancer and Nutrition (EPIC)-Spain cohort

Resveratrol has been shown to have beneficial effects on diseases related to oxidant and/or inflammatory processes and extends the lifespan of simple organisms including rodents. The objective of the present study was to estimate the dietary intake of resveratrol and piceid (R&P) present in foods, and to identify the principal dietary sources of these compounds in the Spanish adult population. For this purpose, a food composition database (FCDB) of R&P in Spanish foods was compiled. The study included 40 685 subjects aged 3564 years from northern and southern regions of Spain who were included in the European Prospective Investigation into Cancer and Nutrition (EPIC)-Spain cohort. Usual food intake was assessed by personal interviews using a computerised version of a validated diet history method. An FCDB with 160 items was compiled. The estimated median and mean of R&P intake were 100 and 933 mg/d respectively. Approximately, 32% of the population did not consume RΠ The most abundant of the four stilbenes studied was trans-piceid (53·6 %), followed by trans-resveratrol (20·9 %), cis-piceid (19·3 %) and cis-resveratrol (6·2 %). The most important source of R&P was wines (98·4 %) and grape and grape juices (1·6 %), whereas peanuts, pistachios and berries contributed to less than 0·01 %. For this reason the pattern of intake of R&P was similar to the wine pattern. This is the first time that R&P intake has been estimated in a Mediterranean country.

Investigation of discrete imaging models and iterative image reconstruction in differential X-ray phase-contrast tomography.

Differential X-ray phase-contrast tomography (DPCT) refers to a class of promising methods for reconstructing the X-ray refractive index distribution of materials that present weak X-ray absorption contrast. The tomographic projection data in DPCT, from which an estimate of the refractive index distribution is reconstructed, correspond to one-dimensional (1D) derivatives of the two-dimensional (2D) Radon transform of the refractive index distribution. There is an important need for the development of iterative image reconstruction methods for DPCT that can yield useful images from few-view projection data, thereby mitigating the long data-acquisition times and large radiation doses associated with use of analytic reconstruction methods. In this work, we analyze the numerical and statistical properties of two classes of discrete imaging models that form the basis for iterative image reconstruction in DPCT. We also investigate the use of one of the models with a modern image reconstruction algorithm for performing few-view image reconstruction of a tissue specimen.