Australian children with special health care needs: Social-emotional and learning competencies in the early years

This study examined the relationship between special health care needs and social-emotional and learning competence in the early years, reporting on two waves of data from the Kindergarten Cohort of Growing up in Australia: The Longitudinal Study of Australian Children (LSAC). Six hundred and fifty children were identified through the 2-question Special Health Care Needs Screener as having special health care needs. Children with special health care needs were more likely to be male, to have been of low birth weight, to be taking prescription medications, to be diagnosed with a specific health condition and to be from families where the mother was less well educated. These children scored significantly lower on teacher-rated social-emotional and learning competencies prior to school compared to a control group of children without special health care needs. Multiple regression analyses indicated that being identified with a special health care need prior to school predicted lower social-emotional and learning competencies in the early years of school. Results are discussed in terms of the implications for policy and practice.

Low temperature synthesis of carbon nanotubes on indium tin oxide electrodes for organic solar cells

The electrical performance of indium tin oxide (ITO) coated glass was improved by including a controlled layer of carbon nanotubes directly on top of the ITO film. Multi-wall carbon nanotubes (MWCNTs) were synthesized by chemical vapor deposition, using ultra-thin Fe layers as catalyst. The process parameters (temperature, gas flow and duration) were carefully refined to obtain the appropriate size and density of MWCNTs with a minimum decrease of the light harvesting in the cell. When used as anodes for organic solar cells based on poly(3-hexylthiophene) (P3HT) and phenyl-C61-butyric acid methyl ester (PCBM), the MWCNT-enhanced electrodes are found to improve the charge carrier extraction from the photoactive blend, thanks to the additional percolation paths provided by the CNTs. The work function of as-modified ITO surfaces was measured by the Kelvin probe method to be 4.95 eV, resulting in an improved matching to the highest occupied molecular orbital level of the P3HT. This is in turn expected to increase the hole transport and collection at the anode, contributing to the significant increase of current density and open circuit voltage observed in test cells created with such MWCNT-enhanced electrodes.

Analysis and correction of voltage profile in low voltage distribution networks containing photovoltaic cells and electric vehicles

Voltage drop and rise at network peak and off–peak periods along with voltage unbalance are the major power quality problems in low voltage distribution networks. Usually, the utilities try to use adjusting the transformer tap changers as a solution for the voltage drop. They also try to distribute the loads equally as a solution for network voltage unbalance problem. On the other hand, the ever increasing energy demand, along with the necessity of cost reduction and higher reliability requirements, are driving the modern power systems towards Distributed Generation (DG) units. This can be in the form of small rooftop photovoltaic cells (PV), Plug–in Electric Vehicles (PEVs) or Micro Grids (MGs). Rooftop PVs, typically with power levels ranging from 1–5 kW installed by the householders are gaining popularity due to their financial benefits for the householders. Also PEVs will be soon emerged in residential distribution networks which behave as a huge residential load when they are being charged while in their later generation, they are also expected to support the network as small DG units which transfer the energy stored in their battery into grid. Furthermore, the MG which is a cluster of loads and several DG units such as diesel generators, PVs, fuel cells and batteries are recently introduced to distribution networks. The voltage unbalance in the network can be increased due to the uncertainties in the random connection point of the PVs and PEVs to the network, their nominal capacity and time of operation. Therefore, it is of high interest to investigate the voltage unbalance in these networks as the result of MGs, PVs and PEVs integration to low voltage networks. In addition, the network might experience non–standard voltage drop due to high penetration of PEVs, being charged at night periods, or non–standard voltage rise due to high penetration of PVs and PEVs generating electricity back into the grid in the network off–peak periods. In this thesis, a voltage unbalance sensitivity analysis and stochastic evaluation is carried out for PVs installed by the householders versus their installation point, their nominal capacity and penetration level as different uncertainties. A similar analysis is carried out for PEVs penetration in the network working in two different modes: Grid to vehicle and Vehicle to grid. Furthermore, the conventional methods are discussed for improving the voltage unbalance within these networks. This is later continued by proposing new and efficient improvement methods for voltage profile improvement at network peak and off–peak periods and voltage unbalance reduction. In addition, voltage unbalance reduction is investigated for MGs and new improvement methods are proposed and applied for the MG test bed, planned to be established at Queensland University of Technology (QUT). MATLAB and PSCAD/EMTDC simulation softwares are used for verification of the analyses and the proposals.

Low rank Runge-Kutta methods, symplecticity and stochastic Hamiltonian problems with additive noise

In this paper we extend the ideas of Brugnano, Iavernaro and Trigiante in their development of HBVM($s,r$) methods to construct symplectic Runge-Kutta methods for all values of $s$ and $r$ with $s\geq r$. However, these methods do not see the dramatic performance improvement that HBVMs can attain. Nevertheless, in the case of additive stochastic Hamiltonian problems an extension of these ideas, which requires the simulation of an independent Wiener process at each stage of a Runge-Kutta method, leads to methods that have very favourable properties. These ideas are illustrated by some simple numerical tests for the modified midpoint rule.

Adoption of low-cost rail level crossing warning devices : an Australian case study

The objective of this chapter is to provide rail practitioners with a practical approach for determining safety requirements of low-cost level crossing warning devices (LCLCWDs) on an Australian railway by way of a case study. LCLCWDs, in theory, allow railway operators to improve the safety of passively controlled crossing by upgrading a larger number of level crossings with the same budget that would otherwise be used to upgrade these using the conventional active level crossing control technologies, e.g. track circuit initiated flashing light systems. The chapter discusses the experience and obstacles of adopting LCLCWDs in Australia, and demonstrates how the risk-based approach may be used to make the case for LCLCWDs.

Relationships between maternal feeding and child weight in younger Australian children – Findings from the NOURISH obesity prevention trial

Studies show that in 3-11 year-olds, parental feeding style is directly associated with child weight [1] and also moderates the association between feeding practices and weight [2]. This cross-sectional study aimed to examine these relationships in younger children. Data from 331 of 698 first-time mothers of healthy term children (151 boys, mean age 24±1 months) enrolled in the NOURISH RCT included (a) measured child weight, (b) self-reported feeding styles and controlling feeding practices, and (c) maternal and child covariates. ANCOVA compared mean child weight-for-age z-score (cWAZ) across 4 feeding styles. Regression examined the associations between cWAZ and 5 controlling feeding practices. Moderated multiple regression analysis was planned to examine effects of feeding style on relationships between feeding practices and cWAZ. Feeding style (indulgent = 38.6%, authoritarian = 35.8%, authoritative = 13.1%, uninvolved = 12.5%) was not independently associated with cWAZ. However, ’pressure to eat’ was negatively associated with cWAZ (�=-0.131, p<0.05) higher pressure associated with lower cWAZ. Given feeding style was not associated with cWAZ, moderation analysis was not performed. Contrary to findings in older children, cWAZ in 2-year-olds was not associated with maternal feeding style. However, the negative association between child weight and pressure feeding found in 6-11year-olds [2] appears to hold in toddlers. Educating mothers about potentially detrimental long-term effects of pressure feeding in early childhood, may be more practical and effective in promoting healthy weight than targeting the less concrete concept of feeding styles. References: [1] Hughes, Appetite, 2005;44:83-92. [2] Hennessy, Appetite, 2010;54:369-377.