Fast imaging of an atmospheric pressure glow discharge in he with a polymer film

To visualize the development of an atmospheric pressure glow discharge in He and the influence of polymer film on the discharge, short exposure time images were recorded using a gated intensified charge coupled detector. If the polymer film is stretched in the middle of the gap, a discharge region on each side of the polymer is created with the characteristic structure of a glow discharge. In this case, strongly asymmetric discharge current pulses can be generated depending on the frequency and the applied voltage.

Steam reforming of model compounds and fast pyrolysis bio-oil on supported noble metal catalysts

The production of hydrogen by steam reforming of bio-oils obtained from the fast pyrolysis of biomass requires the development of efficient catalysts able to cope with the complex chemical nature of the reactant. The present work focuses on the use of noble metal-based catalysts for the steam reforming of a few model compounds and that of an actual bio-oil. The steam reforming of the model compounds was investigated in the temperature range 650-950 degrees C over Pt, Pd and Rh supported on alumina and a ceria-zirconia sample. The model compounds used were acetic acid, phenol, acetone and ethanol. The nature of the support appeared to play a significant role in the activity of these catalysts. The use of ceria-zirconia, a redox mixed oxide, lead to higher H-2 yields as compared to the case of the alumina-supported catalysts. The supported Rh and Pt catalysts were the most active for the steam reforming of these compounds, while Pd-based catalysts poorly performed. The activity of the promising Pt and Rh catalysts was also investigated for the steam reforming of a bio-oil obtained from beech wood fast pyrolysis. Temperatures close to, or higher than, 800 degrees C were required to achieve significant conversions to COx and H-2 (e.g., H-2 yields around 70%). The ceria-zirconia materials showed a higher activity than the corresponding alumina samples. A Pt/ceria-zirconia sample used for over 9 h showed essentially constant activity, while extensive carbonaceous deposits were observed on the quartz reactor walls from early time on stream. In the present case, no benefit was observed by adding a small amount of O-2 to the steam/bio-oil feed (autothermal reforming, ATR), probably partly due to the already high concentration of oxygen in the bio-oil composition. (c) 2005 Elsevier B.V. All rights reserved.

Updated parameters for the transiting exoplanet WASP-3b using RISE, a new fast camera for the Liverpool Telescope

Some of the first results are reported from RISE - a new fast camera mounted on the Liverpool Telescope primarily designed to obtain high time-resolution light curves of transiting extrasolar planets for the purpose of transit timing. A full and partial transit of WASP-3 are presented, and a Markov-Chain Monte Carlo analysis is used to update the parameters from the discovery paper. This results in a planetary radius of 1.29(-0.12)(+0.05) R-J and therefore a density of 0.82(-0.09)(+0.14) rho(J), consistent with previous results. The inclination is 85.06(-0.15)(+0.16) deg, in agreement (but with a significant improvement in the precision) with the previously determined value. Central transit times are found to be consistent with the ephemeris given in the discovery paper; however, a new ephemeris calculated using the longer baseline results in T-c(0) = 2 454 605.55915 +/- 0.00023 HJD and P = 1.846835 +/- 0.000002 days.

Fast, quantitative nucleoside protection under solvent-free conditions

Persilylation of nucleoside hydroxyls was effected in quantitative yields under solvent-free conditions using a ball mill. In addition, one-pot persilylation and acylation of cytidine was performed as an exemplar reaction demonstrating the utility of solvent-free approaches to nucleoside chemistry.