Hydrogen peroxide biosensor based on horseradish peroxidase-Au nanoparticles at viologen grafted glassy carbon electrode

A novel hydrogen peroxide biosensor was fabricated that is based on horseradish peroxidase-Au nanoparticles immobilized on a viologen-modified glassy carbon electrode (GCE) by amino cation radical oxidation in basic solution. The immobilized BAPV acts as a mediator and a covalent linker between GCE and the Au nanoparticles. The biosensor exhibited fast response, good reproducibility, and long-term stability.

PS-b-P4VP/CoSm杂化材料的制备及其磁性能

用溶液相金属盐沉积法在苯乙烯与4-乙烯基吡啶嵌段共聚物(PS-b-P4VP)胶束中制备了平均直径为12 nm的PS-b-P4VP/Co、PS-b-P4VP/CoSm(nCo∶nSm=3.8∶1,13.0∶1)、PS-b-P4VP/Sm纳米粒子。胶束溶液通过高温回流使磁性成核粒子和磁性金属原子的流动能力和扩散能力提高而获得尺寸均一的颗粒。

Synthesis, crystal structures and spectroscopic properties of copper(I) complexes containing beta-dialdiminato supporting ligands

Two mononuclear neutral copper(I) complexes, Cu(L-1)PPh3 (1), Cu(L-2)(PPh3)(2) (2) ([L-1](-) = [{N((C6H3Pr2)-Pr-i-2,6)C(H)}(2)CPh](-); [L-2](-) = [{N(C6H5)C(H)}(2)CPh](-)) have been synthesized and structurally characterized by X-ray crystallography. In complex 1, the copper(I) atom is in a distorted three-coordinate trigonal planar environment, whereas in complex 2 with the less sterically hindered beta-dialdiminato ligand, the copper(I) atom is the centre of a four-coordinate distorted tetrahedron. At room temperature complexes 1 and 2 in a film of PMMA exhibit green emission at 543 and 549 nm with lifetimes of 5.28 and 5.32 ns, respectively.

稀土三元催化剂对二氧化碳/环氧化合物共聚反应的催化机理研究

采用X射线光电子能谱(XPS)技术研究了二氧化碳与环氧丙烷共聚反应的稀土三元催化剂,探讨了中心金属的X射线光电子能谱与催化活性间的关系,指出稀土三元催化剂的活性中心在于配位活化后的锌氧键,稀土盐通过与烷氧基锌形成双金属桥键,改变了活性中心的电子云分布,从而提高了反应活性.

Preparation and properties of microporous membrane from poly(vinylidene fluoride-co-tetrafluoroethylene) (F2.4) for membrane distillation

Flat-sheet microporous membranes from F2.4 for membrane distillation (MD) were prepared by phase inversion process. Dimethylacetamide (DMAC) and LiClO(4)(.)3H(2)O/trimethyl phosphate (TMP) were, respectively, used as solvent and pore-forming additives. The effects of casting solution composition, exposure time prior to coagulation and temperature of precipitation bath on F2.4 membrane structure were investigated. The morphology of resultant porous membrane was observed by scanning electron microcopy. Some natures of F2.4 porous membrane after drying in air, such as mechanical properties and hydrophobicity, were exhibited and compared with poly(vinylidene fluoride) (PVDF) membrane prepared by the same ways. Stress-at-break and strength stress of F2.4 microporous membrane are higher than that of PVDF membrane, and elongation percentage of F2.4 membrane at break is about eight-fold as great as that of PVDF membrane. Contact angle of F2.4 microporous membrane to water (86.6 +/- 0.51degrees) was also larger than that of PVDF mernbrane (80.0 +/- 0.78degrees). MD experiment was carried out using a direct contact membrane distillation (DCMD) configuration as final test to permeate performance of resultant microporous membrane.

Mechanism and life study on polyaniline anti-corrosion coating

Solvent free polyaniline emeraldine base(EB) corrosion protection coating was prepared, employing aliphatic polyamine as solvent of EB as well as hardener of epoxy resin. This coating passed 2000h of salt fog test when the EB loading was about 1 wt%. The interaction between EB and iron indicated that EB acted as a "quasi-catalyst" to cause the formation of densed iron oxide film in the interface.

Eu~(2+),Dy~(3+)共掺杂硼铝锶长余辉玻璃陶瓷

首次介绍了一种新型长余辉材料 :Eu2 + ,Dy3 + 共掺杂硼铝锶长余辉玻璃陶瓷 ,该玻璃陶瓷用紫外灯、日光、荧光灯均可激发 ,发射黄绿色余辉 ,余辉的发射峰位于 5 16nm ,来自于Eu2 + 的 5d→ 8S7/ 2 跃迁。用12 0 0 0lx的荧光灯激发样品 2 0分钟 ,停止激发后 10秒时 ,该玻璃陶瓷的余辉亮度为 3 5 3cd/m2 ,色坐标为 :x =0 2 84 2 ,y =0 5 772 ;停止激发后 5小时 5 5分钟 ,该玻璃陶瓷的余辉亮度为 0 0 1cd/m2 ;停止激发 30小时后 ,余辉在黑暗中仍肉眼可见。文中对该玻璃陶瓷的相关性质进行了表征 ,并提出了可能的长余辉机理

有机/无机纳米杂化材料负载钛催化剂及聚合研究 Ⅰ.乙烯聚合

以苯乙烯与马来酸酐无规共聚物 ( SMA)为有机组分 ,以正硅酸乙酯 ( TEOS)为无机组分 ,利用 sol- gel方法制得纳米杂化材料 ,以此为载体合成了杂化材料载体钛系催化剂 .利用 XPS、IR分析了载体与 Ti Cl4 的结合方式 ,并进行了乙烯聚合的研究 .结果表明 ,聚乙烯活性并不高( 1.72× 10 6g/h·mol)且分子量分布为 4 .0左右 ;堆密度范围是 0 .30～ 0 .39g/cm3.

Phase transition and transition kinetics of a thermotropic poly(amide-imide) derived from 70% pyromellitic dianhydride, 30% terephthaloyl chloride, and 1,3-bis[4-(4 '-aminophenoxy)cumyl]benzene

The phase transition and transition kinetics of a liquid crystalline copoly(amide-imide) (PAI37), which was synthesized from 70 mol% pyromellitic dianhydride, 30 mol% terephthaloyl chloride, and 1,3-bis[4-(4'-aminophenoxy)cumyl]benzene, was characterized by differential scanning calorimetry, polarized light microscopy, X-ray diffraction, and rheology. PAI37 exhibits a glass transition temperature at 182 degreesC followed by multiple phase transitions. The crystalline phase starts to melt at similar to 220 degreesC and forms smectic C (S-C) phase. The Sc phase transforms into smectic A (S-A) phase when the temperature is above 237 degreesC. The S-C to S-A transition spans a broad temperature range in which the S-A phase vanishes and forms isotropic melt. The WARD fiber pattern of PAI37 pulled from the anisotropic melt revealed an anomalous chain orientation, which was characterized by its layer normal perpendicular to the fiber direction. The transition kinetics for the mesophase and crystalline phase formation was also studied.

Melting crystallization behavior of nylon 66

Analysis of isothermal and nonisothermal crystallization kinetics of nylon 66 was carried out using differential scanning calorimetry (DSC). The commonly used Avrami equation and that modified by Jeziorny were used, respectively, to fit the primary stage of isothermal and nonisothermal crystallizations of nylon 66. In the isothermal crystallization process, mechanisms of spherulitic nucleation and growth were discussed. The lateral and folding surface free energies determined from the Lauritzen-Hoffman treatment are sigma = 9.77 erg/cm(2) and sigma (e) = 155.48 erg/cm(2), respectively; and the work of chain folding is q = 33.14 kJ/mol. The nonisothermal crystallization kinetics of nylon 66 was analyzed by using the Mo method combined with the Avrami and Ozawa equations. The average Avrami exponent (n) over bar was determined to be 3.45. The activation energies (DeltaE) were determined to be -485.45 kJ/mol and -331.27 kJ/mol, respectively, for the isothermal and nonisothermal crystallization processes by the Arrhenius and the Kissinger methods.

Processible nanostructured materials with electrical conductivity and magnetic susceptibility: Preparation and properties of maghemite polyaniline nanocomposite films

We here present a versatile process for the preparation of maghemite/polyaniline (gamma-Fe2O3/ PAn) nanocomposite films with macroscopic processibility, electrical conductivity, and magnetic susceptibility. The gamma-Fe2O3 nanoparticles are coated and the PAn chains are doped by anionic surfactants of omega-methoxypoly(ethylene glycol) phosphate (PEOPA), 4-dodecylbenzenesulfonic acid (DBSA), and 10-camphorsulfonic acid (CSA). Both the coated gamma-Fe2O3 and the doped PAn are soluble in common organic solvents, and casting of the homogeneous solutions gives free-standing nanocomposite films with gamma-Fe2O3 contents up to similar to 50 wt %. The morphology of the gamma-Fe2O3 nanoparticles are characterized by transmission electron microscopy, UV-vis spectroscopy, and X-ray diffractometry. The gamma-Fe2O3/PAn films prepared from chloroform/m-cresol solutions of DBSA-coated gamma-Fe2O3 and CSA-doped PAn are conductive (sigma = 82-237 S/cm) and superpapamagnetic, exhibiting no hysteresis at room temperature. The zero-field-cooled magnetization experiment reveals that the nanocomposite containing 20.8 wt % gamma-Fe2O3 has a blocking temperature (T-b) in the temperature region of 63-83 K.