Effect of the heat flux direction on electrical properties of SrBi2Nb2O9 thin films crystallized using a microwave oven

Ferroelectric SrBi2Nb2O9 (SBN) thin films were prepared by the polymeric precursors method and deposited by spin coating onto Pt/Ti/SiO2/Si substrate and crystallized using a domestic microwave oven. It was studied the influence of the heat flux direction and the duration of the thermal treatment on the films crystallization. An element with high dielectric loss, a SiC susceptor, was used to absorb the microwave energy and transfers the heat to the film. Influence of the susceptor position to the sample crystallization was verified, the susceptor was, placed or below the substrate or above the film. The SBN perovskite phase was observed after a thermal treatment at 700 degreesC for 10 min when the susceptor was placed below the substrate and for 30 min when the susceptor was placed above the film. Electrical measurements revealed that the film crystallized at 700 degreesC for 10 min, with the susceptor placed below the film, presented dielectric constant, dielectric loss, remanent polarization and coercive field of, 67, 0.011, 4.2 muC/cm(2) and 27.5 kV/cm, respectively. When the films were crystallized at 700 degreesC for 30 min, with the susceptor placed above the film, the dielectric constant was 115 and the dissipation factor was around of 0.033, remanent polarization and coercive field were 10.8 muC/cm(2) and 170 kV/cm, respectively. (C) 2003 Elsevier B.V. All rights reserved.

The implications of laboratory Rn-222 flux measurements to the radioactivity in groundwaters: the case of a karstic limestone aquifer

Laboratory time-scale experiments were conducted on Carboniferous Limestone gravels from the Mendip Hills area, England, with the purpose of evaluating the release of Rn-222 to the water phase. The specific surface areas of the samples were 4.14 and 1.69 cm g(-1), which provided, respectively, values of 50.6 and 12.7 pCi for the released Rn. These results allowed the calculation of the emanation coefficient of this rock matrix with respect to the release of Rn, where completely different values corresponding to 23% and 6% were found, suggesting that the extent to which grain boundaries or imperfections in aggregates of micro-crystals of calcite intersect the particle surface certainly affects the Rn release. They also permitted the evaluation of models for the generation of Rn in rocks and transfer to water, in order to interpret the radioactivity due to this gas in groundwaters from the karstic aquifer of the Mendip Hills area, where the calculated activities in groundwater based on the values of 23% and 6% for the emanation coefficient were about 51 and 15 times higher than actually measured in groundwater. Therefore, the emanation coefficient in nature is considerably smaller than in the lab experiment, and another factor k (0 < k < 1) may be introduced into the equations related to the modelling, with the aim of adjusting the theoretical-practical results. (C) 1997 Elsevier B.V. Ltd. All rights reserved.

Influence of moisture absorption on mechanical behaviour of composites

Because of their application that normally demands high mechanical strength combined with low weight, the fibre/matrix interface became an important parameter concerning structural life. The problem of moisture absorption in materials has received attention in experimental studies on a composite systems as well as from a theorical point of view. The fibre/matrix interface plays an important role in the structural behaviour of composites due to the fact that load transfer from matrix to reinforce occurs at the interface. In this case the study of compatibility of fibre/matrix/environmental is essential to ensure a product that attend structural objectives, many times without failure possibilities. The composite used in this investigation is the carbon fibre/matrix epoxy composite, which was immersed in sea water standard during 94 days at 60 degrees C, submitted to tensile and compressive tests to study the influence of moisture absorption on mechanical behaviour. The interface was investigated through fracture surface analysis by SEM and a strong interface and a good adhesion fibre/matrix was observed.

Maximum number of flux lines inside columnar defects

We set new limits for the maximum number of fluxons trapped inside columnar defects, for both cases of metallic and insulated cores. We show that the saturation limit predicted by the Mkrtchyan and Shmidt theory is just a first approximation to our results, because it does not consider the presence of the remaining flux lines exterior to the defects.

The effect of soil moisture and cabbage amendment on the thermoinactivation of Phytophthora nicotianae

The analysis of the effect of soil water matric potential and temperature regimes on the inactivation of chlamydospores of Phytophthora nicotianae in cabbage amended soils was evaluated using three matric potentials (0, -10, and -30 kPa), temperature regimes of 1.5 h at 44 degreesC, 5 h at 41 degreesC and 8 h at 35 degreesC, or 3 h at 47 degreesC, 5 h at 44 degreesC and 8 h at 35 degreesC, with a baseline temperature of 25 degreesC during the rest of the day. The results indicated that survival of P. nicotianae was lowest in saturated soil; and as temperature increased, survival of the pathogen decreased at all soil water matric potentials evaluated. Cabbage amendments can enhance the effect of the heat treatment, further decreasing the pathogen population. The soil water matric potentials evaluated represent optimum levels for the study of thermal inactivation. However, under field conditions lower potentials may be found. Extending the range of soil water matric potentials and the treatment time would allow better comparisons with the field data. There is a clear indication that one irrigation period prior to solarization would provide enough moisture to inactivate the primary inoculum of P. nicotianae in the top soil under field conditions; however, other factors may affect the effectiveness of solarization, reducing or enhancing its potential.

Effect of ammoniation and moisture-content on the quality of signal grass (Brachiaria-decumbens stapf) hay

The experiment was carried out to evaluate the effects of two moisture levels (18-20% and 13-15%) and three anhydrous ammonia levels (0.0; 1.5; 3.0% of NH3) on the quality of Brachiaria decumbens Stapf hay. The hay was bailed in April and weighed and treated under plastic cover during 30 days. The hay presented a similar chemical composition when bailed with high or low moisture. The percentages of NDF (80.59; 77.61; 76.10%); hemicellulose (32.56; 29.48; 28.76%) and lignin (9.53; 8.21; 7.54% decreased and the percentages of crude protein (4.04; 11.35; 13.22%) and IVDMD (36.78; 49.72; 54.33%) increased as the NH3 level increased. The fractions ADF, cellulose, and ADIN did not change due to the ammoniation. The incidence of fungi decreased with application of NH3 being the better results obtained with the 1.5% treatments.

Anthropogenic influences on annual flux of cations and anions at meio stream basin, São Paulo State, Brazil

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Influence of Wood Moisture Content on the Modulus of Elasticity in Compression Parallel to the Grain

Brazilian Standard ABNT NBR7190:1997 for timber structures design, adopts a first degree equation to describe the influence of wood moisture content. Periodically, when necessary, the referred standard is revised in order to analyze inconsistencies and to adopt considerations according new realities verified. So, the present paper aims to examine the adequacy of its equation which corrects to 12% of moisture the values of rigidity properties obtained on experimental tests. To quantify the moisture influence on modulus of elasticity, it was applied tests of compression parallel to the grain for six specimens of different strength classes, considering nominal moisture of 12; 20; 25; 30%. As results, modulus of elasticity in the moisture range 25-30% showed statistically equivalents, and was obtained a first degree equation to correlate the studied variables which leads to statically equivalent estimations when compared with results by ABNT NBR7190:1997 equation. However, it was indicated to maintain the current expression for the next text of the referred document review, without prejudice to statistical significance of the estimates.

The primary sources of carbon loss during the crop-establishment period in a subtropical Oxisol under contrasting tillage systems

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Evaluation by Free Vibration Method of Moisture Absorption Effects in Polyamide/Carbon Fiber Laminates

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effect of soil moisture content and the irrigation frequency on the sugarcane germination

The aim of this work was to observe the interaction between soil moisture and irrigation time intervals on the germination of sugarcane cv. RB785148 sets in semi-controlled conditions. One-bud sets of the variety RB785148 were germinated in ceramic pots filled with soil under a transparent PVC cover using soil humidity levels of 22, 25 and 30%, that were restored at intervals of 7, 14 and 21 days. The experiment was carried out at three different periods of the year: May-June/94; Oct.-Nov./94; and Mar.-Apr./95. The results indicate that the germination decreased mainly in function of the decrease in soil humidity, whereas irrigation interval have no statistical effect on germination. An interaction between humidity level and irrigation interval was observed. A variation of the timecourse of the germination could be observed when the results of the experiments installed at different dates were compared.

Tracheobronchial consequences of the use of heat and moisture exchangers in dogs

Purpose: To determine the effect of heat and moisture exchange (HME) on the tracheobronchial tree (TBT) using a unidirectional anesthesic circuit with or without CO2 absorber and high or low fresh gas flow (FGF), in dogs. Methods: Thirty-two dogs were randomly allocated to four groups: G1 (n = 8) valvular circuit without CO2 absorber and high FGF (5 L·min-1); G2 (n = 8) as G1 with HME; G3 (n = 8) circuit with CO2 absorber with a low FGF (1 L·min-1); G4 (n = 8) as G3 with HME. Anesthesia was induced and maintained with pentobarbital. Tympanic temperature (TT), inhaled gas temperature (IGT), relative (RH) and absolute humidity (AH) of inhaled gas were measured at 15 (control), 60, 120 and 180 min of controlled ventilation. Dogs were euthanized and biopsies in the areas of TBT were performed by scanning electron microscopy. Results: The G2 and G4 groups showed the highest AH (>20 mgH2O·L-1) and G1 the lowest (< 10 mgH2O·L-1) and G3 was intermediate (<20 mgH2O·L-1) (P < 0.01). There was no difference of TT and IGT among groups. Alterations of the mucociliary system were greatest in G1, least in G2 and G4, and intermediate in G3. Conclusion: In dogs, introduction of HME to a unidirectional anesthetic circuit with/without CO2 absorber and high or low FGF preserved humidity of inspired gases. HME attenuated but did not prevent alterations of the mucociliary system of the TBT.