Coeficiente de distribuição do inseticida tiametoxam na fração mineral de solos sob efeito de ácidos orgânicos mono, di e tricarboxílicos

The aim of this study was to investigate the sorption and desorption of thiamethoxam in contrasting soils under the effect of organic acids. The results showed that MTo sorption had higher Kd. The presence of organic acids increased sorption and reduced desorption of thiamethoxam at MTo. The opposite was observed for the LVdf where the presence of 400 µmol L-1 of acid reduced the sorption of thiamethoxam in a concentration of 20 µmol L-1, not influencing desorption. The dynamics of organic acids with minerals from the soil particles were clarified by infrared analysis.

Avaliação de diferentes métodos para a determinação de cobre em óleo mineral isolante por espectrometria de absorção atômica com forno de grafite

This aim of this work was to compare two methods for copper determination in insulating oils from power transformers by GFAAS. The first method was extraction induced by emulsion breaking, which determined the preconcentration of copper in an aqueous solution and exhibited a limit of quantification of 0.27 µg L-1. Also, a second method based on the direct introduction of samples into GFAAS in the form of detergent emulsions, prepared with Triton X-114 and HNO3, was investigated. In this case, the limit of quantification was 1.7 µg L-1. Seven samples of used oils were successfully analyzed by both methods.

LOW COST ANALYZER FOR THE DETERMINATION OF PHOSPHORUS BASED ON OPEN-SOURCE HARDWARE AND PULSED FLOWS

The need for automated analyzers for industrial and environmental samples has triggered the research for new and cost-effective strategies of automation and control of analytical systems. The widespread availability of open-source hardware together with novel analytical methods based on pulsed flows have opened the possibility of implementing standalone automated analytical systems at low cost. Among the areas that can benefit from this approach are the analysis of industrial products and effluents and environmental analysis. In this work, a multi-pumping flow system is proposed for the determination of phosphorus in effluents and polluted water samples. The system employs photometric detection based on the formation of molybdovanadophosphoric acid, and the fluidic circuit is built using three solenoid micropumps. The detection is implemented with a low cost LED-photodiode photometric detection system and the whole system is controlled by an open-source Arduino Uno microcontroller board. The optimization of the timing to ensure the color development and the pumping cycle is discussed for the proposed implementation. Experimental results to evaluate the system behavior are presented verifying a linear relationship between the relative absorbance and the phosphorus concentrations for levels as high as 50 mg L-1.

Immersion enthalpy variation of surface-modified mineral activated carbon in lead (II) aqueous solution adsorption: the relation between immersion enthalpy and adsorption capacity

An activated carbon was obtained by chemical activation with phosphoric acid, CM, from a mineral carbon. Afterwards, the carbon was modified with 2 and 5 molL-1, CMox2 and CMox5 nitric acid solutions to increase the surface acid group contents. Immersion enthalpy at pH 4 values and Pb2+ adsorption isotherms were determined by immersing activated carbons in aqueous solution. The surface area values of the adsorbents and total pore volume were approximately 560 m².g-1 and 0.36 cm³g-1, respectively. As regards chemical characteristics, activated carbons had higher acid sites content, 0.92-2.42 meq g-1, than basic sites, 0.63-0.12 meq g-1. pH values were between 7.4 and 4.5 at the point of zero charge, pH PZC. The adsorbed quantity of Pb2+ and the immersion enthalpy in solution of different pH values for CM activated carbon showed that the values are the highest for pH 4, 15.7 mgg-1 and 27.6 Jg-1 respectively. Pb2+ adsorption isotherms and immersion enthalpy were determined for modified activated carbons and the highest values were obtained for the activated carbon that showed the highest content of total acid sites on the surface.

Exploring potentialities of the HR-CS FAAS technique in the determination of Ni and Pb in mineral waters

National Health Surveillance Agency (ANVISA) established in the decree number 54 maximum allowed levels for Ni and Pb in mineral and natural waters at 20 µg L-1 and 10 µg L-1, respectively. For screening analysis purposes, the high-resolution continuum source flame atomic absorption spectrometry technique (HR-CS FAAS) was evaluated for the fast-sequential determination of nickel and lead in mineral waters.Two atomic lines for Ni (232.003 nm - main and 341.477 nm - secondary) and Pb (217.0005 nm - main and 283.306 nm - secondary) at different wavelength integrated absorbance (number of pixels) were evaluated. Sensitivity enhanced with the increase of the number of pixels and with the summation of the atomic lines absorbances. The main figures of merit associated to the HR-CS FAAS technique were compared with that obtained by line-source flame atomic absorption spectrometry (LS FAAS). Water samples were pre-concentrated about 5-fold by evaporation before analysis. Recoveries of Pb significantly varied with increased wavelength integrated absorbance. Better recoveries (92-93%) were observed for higher number of pixels at the main line or summating the atomic lines (90-92%). This influence was irrelevant for Ni, and recoveries in the 92-104% range were obtained in all situations.

Efeito do método de preparo do solo, em área de reforma, nas suas características, na composição mineral e na produtividade de plantações de Eucalyptus grandis

O preparo do solo para o plantio de espécies florestais visa disponibilizar água e nutrientes para o rápido estabelecimento das mudas. Apesar de recentemente técnicas menos intensivas de preparo serem preconizadas, há situações em que o preparo mais intensivo é necessário. Neste trabalho avaliou-se o efeito de quatro métodos de preparo nas propriedades físicas e químicas do solo, na produção de biomassa e na composição mineral de plantação reformada de Eucalyptus grandis. Os tratamentos T1) queima dos resíduos da floresta anterior, destoca e subsolagem; T2) queima e destoca; T3) somente queima; e T4) cultivo mínimo (coveamento manual) foram aplicados em área anteriormente usada com plantação de eucalipto manejado por talhadia, em terceira rotação, e situada em Latossolo Vermelho distrófico no município de Santa Bárbara-MG. Aos 38 meses após o plantio, a maior produção de biomassa (81,6 t/ha) foi verificada no tratamento com maior intensidade de preparo do solo, com decréscimo significativo à medida que o preparo era menos intenso. A menor produtividade (50,4 t/ha) foi obtida com o cultivo mínimo. Entretanto, o solo deste tratamento, na época de avaliação, apresentou melhores características químicas e maior acúmulo de manta orgânica. Portanto, o coveamento foi o método de preparo que levaria à maior sustentabilidade da produção florestal, em razão da menor exportação de nutrientes.

Concentração de Zn e Mn nos efluentes do beneficiamento de carvão mineral e em Typha domingensis Pers (TYPHACEAE)

O estudo objetivou investigar a concentração de zinco e manganês nos efluentes do beneficiamento de carvão e em Typha domingensis Pers. Amostras de sedimento, água, raízes, caules e folhas (n = 8 cada) foram coletadas no Lavador da Mina do Trevo, Siderópolis, SC, e em um banhado sem influência da mineração (área-controle). O conteúdo disponível dos metais no sedimento, dissolvido na água e total em T. domingensis, foi determinado por espectrofotometria de absorção atômica. Os dados de concentração de metais nos diferentes compartimentos e áreas foram submetidos ao teste "t", à análise de variância (ANOVA I) e à análise de correlação de Pearson (r). A significância estatística entre as diferenças verificadas na ANOVA foi avaliada por meio do teste SNK (Student-Newman-Keuls-Test), p < 0,05 e > 0,01. Zn e Mn apresentaram-se em concentrações mais elevadas no sedimento do que na água, nas duas áreas. Ambos os metais foram detectados na água em concentrações mais elevadas na área minerada do que na área-controle, enquanto no sedimento apenas o Zn seguiu essa tendência. T. domingensis concentrou Zn em valores mais elevados na raiz, enquanto o Mn, nas folhas, evidenciando, ainda, concentrações mais elevadas de Zn na área minerada do que na área-controle. A explotação do carvão, portanto, disponibilizou Zn e Mn em concentrações mais elevadas na área minerada do que aquelas verificadas na área não minerada, comprometendo, assim, a biota. T. domingensis comportouse como espécie concentradora de metais, o que comprova sua potencialidade para utilização na fitorremediação de áreas degradadas.