Multi-agent modelling for the simulation of a simple smart microgrid

The smart grid is a highly complex system that is being formed from the traditional power grid, adding new and sophisticated communication and control devices. This will enable integrating new elements for distributed power generation and also achieving an increasingly automated operation so for actions of the utilities as for customers. In order to model such systems a bottom-up method is followed, using only a few basic elements which are structured into two layers: a physical layer for the electrical power transmission, and one logical layer for element communication. A simple case study is presented to analyse the possibilities of simulation. It shows a microgrid model with dynamic load management and an integrated approach that can process both electrical and communication flows.

Adaptive variable structure control law for a variable speed wind turbine

Presentado en el 13th WSEAS International Conference on Automatic Control, Modelling and Simulation, ACMOS'11

Sliding mode control strategy for variable speed wind turbines

EFTA 2009

Commercial pond fish culture using waste water

Waste water from some National Electric Power Authority (NEPA) housing units in Nigeria was fed to a 0.4 ha pond which was stocked with 2,200 Sarotherodon galilaeus fingerlings with a mean weight of about 36.0gm and 1000 Cyprinus carpio fingerlings with a mean weight of 10gm. This yielded after 10 months, over 2300 kg of harvestable fish plus over 20,000 Sarotherodon galilaeus fingerlings. The growth rate of C. carpio was not very encouraging possibly because of the type of plankton that colonised the pond. The S. galilaeus became stunted because of overpopulation as there were no carnivores to control their excessive breeding. The physico-chemical parameters were favourable for the growth of fish food organisms

Sustainable energy solutions for irrigation and harvesting in developing countries

One of the critical problems currently being faced by agriculture industry in developing nations is the alarming rate of groundwater depletion. Irrigation accounts for over 70% of the total groundwater withdrawn everyday. Compounding this issue is the use of polluting diesel generators to pump groundwater for irrigation. This has made irrigation not only the biggest consumer of groundwater but also one of the major contributors to green house gases. The aim of this thesis is to present a solution to the energy-water nexus. To make agriculture less dependent on fossil fuels, the use of a solar-powered Stirling engine as the power generator for on-farm energy needs is discussed. The Stirling cycle is revisited and practical and ideal Stirling cycles are compared. Based on agricultural needs and financial constraints faced by farmers in developing countries, the use of a Fresnel lens as a solar-concentrator and a Beta-type Stirling engine unit is suggested for sustainable power generation on the farms. To reduce the groundwater consumption and to make irrigation more sustainable, the conceptual idea of using a Stirling engine in drip irrigation is presented. To tackle the shortage of over 37 million tonnes of cold-storage in India, the idea of cost-effective solar-powered on-farm cold storage unit is discussed.

Energías renovables en edificación: aplicación al abastecimiento de energía eléctrica y climatización

[ES]Este documento tiene el objeto de presentar el uso de las energías renovables en la edificación actual, para ello se analizaran las energías que hay en el mercado, sus beneficios y sus posibles aplicaciones en viviendas, naves industriales, polideportivos, centro comerciales, etc. Para lograr alcanzar todas estas competencias se hará mayor hincapié en el uso de estas nuevas tecnologías en abastecimientos de energía eléctrica y climatización, teniendo en cuenta que no todas las energías renovables son aplicables a la edificación y que no todas las energías tienen las mismas utilidades. El trabajo se lleva a cabo dentro de los trabajos de fin de grado de la escuela técnica superior de ingeniería de Bilbao (ETSIB), más concretamente se refiere al trabajo tipo TFG.3. El trabajo también consta de los apartados descargo de costes y planificación, donde se analiza el desglose de los gastos empleados para la realización de esta memoria y el tiempo elaboración para el mismo. Para concluir es añaden anexos, en los cuales se explican varias de las Normas que se manejan en la actualidad y también se incluyen algunos catálogos de productos comerciales y sus dispositivos para colocar en el edificio.

Análisis del comportamiento de diferentes tecnologías de aerogeneradores ante ráfagas de viento y huecos de tensión

[ES]Ante el desarrollo que está experimentando la energía eólica en la actualidad, suponiendo un porcentaje cada vez más elevado de la totalidad de la potencia instalada, la adecuación de los requisitos técnicos que ha de cumplir esta tecnología para minimizar su impacto sobre la red eléctrica se ha convertido en una prioridad. Para aprovechar al máximo los beneficios medioambientales que presenta el aprovechamiento del viento como fuente de energía, se deben estudiar alternativas para mejorar su comportamiento ante ráfagas de viento y huecos de tensión. En este documento se incluye una breve explicación del funcionamiento de las tres diferentes tecnologías de aerogeneradores, así como los problemas que derivan de la aparición de huecos de tensión y el comportamiento que presentan ante variaciones en la velocidad de viento. Se comprueba, a su vez, el modo de operación y la eficacia de las posibles soluciones que existen en la actualidad para minimizar el impacto que los inconvenientes de la energía eólica tienen sobre la red y la calidad del suministro eléctrico mediante la realización de simulaciones.

Generación de energía eléctrica por combustión de biomasa forestal mediante ciclo rankine. Central de 2MW

[ES]Este proyecto se centra en el estudio y diseño de una central de generación de energía eléctrica por medio de biomasa forestal. La motivación para la realización de este proyecto reside en la gran importancia que en los últimos años están tomando las energías renovables. El Calentamiento Global es un hecho que durante los últimos años ha llevado a la investigación y desarrollo de las energías alternativas, que frenan o contribuyen al ralentizamiento de este fenómeno. Por su parte la implantación de una planta como la que se estudia a continuación, no solo ayudaría a la reducción de emisiones netas de CO2 a la atmósfera, sino que también tendría numerosas ventajas como son la creación de empleo, la limpieza de bosques, lo que ayuda a la prevención de incendios y plagas, y proporcionaría una independencia energética. Los pasos que se van a seguir en el proyecto son los siguientes:  Explicar el alcance y los objetivos del proyecto. Desarrollar las posibles alternativas que existen para la valorización de la biomasa forestal, incluyendo un resumen de las ventajas y desventajas que cada una presenta. Informe detallado de la alternativa seleccionada, la combustión, que incluye la explicación del proceso en la planta desde que el residuo sale del bosque, hasta la obtención de la energía eléctrica. Análisis económico y rentabilidad de la planta. Realizar el cronograma del proyecto. Por último se realizará un análisis de los posibles riesgos.

Photonic and Device Design Principles for Ultrahigh-Efficiency (>50%), Spectrum-Splitting Photovoltaics

The sun has the potential to power the Earth's total energy needs, but electricity from solar power still constitutes an extremely small fraction of our power generation because of its high cost relative to traditional energy sources. Therefore, the cost of solar must be reduced to realize a more sustainable future. This can be achieved by significantly increasing the efficiency of modules that convert solar radiation to electricity. In this thesis, we consider several strategies to improve the device and photonic design of solar modules to achieve record, ultrahigh (> 50%) solar module efficiencies. First, we investigate the potential of a new passivation treatment, trioctylphosphine sulfide, to increase the performance of small GaAs solar cells for cheaper and more durable modules. We show that small cells (mm2), which currently have a significant efficiency decrease (~ 5%) compared to larger cells (cm2) because small cells have a higher fraction of recombination-active surface from the sidewalls, can achieve significantly higher efficiencies with effective passivation of the sidewalls. We experimentally validate the passivation qualities of treatment by trioctylphosphine sulfide (TOP:S) through four independent studies and show that this facile treatment can enable efficient small devices. Then, we discuss our efforts toward the design and prototyping of a spectrum-splitting module that employs optical elements to divide the incident spectrum into different color bands, which allows for higher efficiencies than traditional methods. We present a design, the polyhedral specular reflector, that has the potential for > 50% module efficiencies even with realistic losses from combined optics, cell, and electrical models. Prototyping efforts of one of these designs using glass concentrators yields an optical module whose combined spectrum-splitting and concentration should correspond to a record module efficiency of 42%. Finally, we consider how the manipulation of radiatively emitted photons from subcells in multijunction architectures can be used to achieve even higher efficiencies than previously thought, inspiring both optimization of incident and radiatively emitted photons for future high efficiency designs. In this thesis work, we explore novel device and photonic designs that represent a significant departure from current solar cell manufacturing techniques and ultimately show the potential for much higher solar cell efficiencies.

Um Sistema de Informações Geográficas para Gestão de Energia Elétrica Móvel - SIGGENELM

Um problema que as empresas distribuidoras de energia elétrica convivem são as quedas repentinas no fornecimento, causando inúmeros prejuízos tanto para essas empresas quanto para seus consumidores. Essa dissertação apresentará uma ferramenta que utilizará conhecimentos de sistemas de informações geográficas junto com o uso de inferência nebulosa para orientar a disposição de veículos híbridos (elétricos e à combustão) que podem operar como mini-usinas elétricas no abastecimento de localidades que esteja necessitando de energia em um determinado momento. Para isso, será levantada uma base de dados com características dos veículos híbridos e locais necessitados, dados esses que alimentarão um sistema nebuloso agregado à ferramenta MapServer e a um SIG (Sistema de Informações Geográficas) para, dessa forma, mostrar como saída do sistema qual veículo estará mais apto naquele instante para abastecer o local da demanda de energia.

Effect of the A cation size disorder and synthesis conditions on the properties of an iron perovskite series

Póster presentado en The Energy and Materials Research Conference - EMR2015 celebrado en Madrid (España) entre el 25-27 de febrero de 2015

Detecção e classificação de VTCDs em sistemas de distribuição de energia elétrica usando redes neurais artificiais.

O objetivo deste trabalho é conhecer e compreender melhor os imprevistos no fornecimento de energia elétrica, quando ocorrem as variações de tensão de curta duração (VTCD). O banco de dados necessário para os diagnósticos das faltas foi obtido através de simulações de um modelo de alimentador radial através do software PSCAD/EMTDC. Este trabalho utiliza um Phase-Locked Loop (PLL) com o intuito de detectar VTCDs e realizar a estimativa automática da frequência, do ângulo de fase e da amplitude das tensões e correntes da rede elétrica. Nesta pesquisa, desenvolveram-se duas redes neurais artificiais: uma para identificar e outra para localizar as VTCDs ocorridas no sistema de distribuição de energia elétrica. A técnica aqui proposta aplica-se a alimentadores trifásicos com cargas desequilibradas, que podem possuir ramais laterais trifásicos, bifásicos e monofásicos. No desenvolvimento da mesma, considera-se que há disponibilidade de medições de tensões e correntes no nó inicial do alimentador e também em alguns pontos esparsos ao longo do alimentador de distribuição. Os desempenhos das arquiteturas das redes neurais foram satisfatórios e demonstram a viabilidade das RNAs na obtenção das generalizações que habilitam o sistema para realizar a classificação de curtos-circuitos.

Thermal analyses, spectral characterization and structural interpretation of Yb3+ doped TeO2-ZnO-ZnCl2 glasses

Bulk-lasses have been prepared in the TeO2-ZnO-ZnCl2 systems. Their characteristic temperatures were determined and analyzed. Raman and FT-IR spectra were used to analyze the effect of ZnCl2 on the structure and spectral properties of tellurite glasses and OH- groups in this glass system. The spectroscopic properties including absorption spectra, emission cross-sections and fluorescence lifetimes of Yb3+ in TeO2-ZnO-ZnCl2 were measured and calculated. It is demonstrated that the progressive replacement less than 20 mol% of TeO2 by ZnCl2 improves the thermal stability, removes the OH- groups, turns TeO4 bipyramidal arrangement into TeO3 (and/or TeO3+1) trigonal pyramids structures and results in the decrease of the symmetry of the structure, which increases the emission cross-sections and lifetimes. But when the content of ZnCl2 up to 30 mol%, the glass system becomes more hygroscopic and introduces more OH- groups, which decrease the emission cross-sections and shorten the lifetimes. The results show that the glass system with (TeO2)-Te-69-(ZnO)-Zn-10-20ZnCl(2)-1Yb(2)O(3) is a desirable component for active laser media for high power generation. (c) 2005 Elsevier B.V. All rights reserved.

Effect of F- ions on emission cross-section and fluorescence lifetime of Yb3+-doped tellurite glasses

The effects of F- ions in Yb3+-doped tellurite glass systems on the emission cross-section and measured fluorescence lifetime are investigated. The results show that both the emission cross-section and the fluorescence lifetime of Yb3+ ions increase from 1.32 to 1.39 pm(2) and from 0.93 to 1.12 ms respectively with the increase of F- ions from 0 to 10 mol% and that such oxyfluoride tellurite glass system is a promising laser host matrix for high power generation. FT-IR spectra were used to analyze the effect of F- ions on the structure of tellurite glasses and the change of OH- groups in this glass system. Analysis demonstrates that the addition of fluoride decreases the symmetry of the structure of tellurite glasses resulting in increasing of the emission cross-section and removes the OH- groups resulting in increasing of the measured fluorescence lifetime of Yb3+ ions. (c) 2005 Elsevier B.V. All rights reserved.