Temperature effect on seed germination in Canna indica L. (Cannaceae)

Comm indica L. is an herbaceous species with ornamental and medicinal value, having seeds with a hard seed coat. This study aimed to test the influence of constant temperatures ranging from 5 to 45 C, at 5 C intervals, on the germination of scarified seeds. Data obtained were analyzed through the model of enthalpy of activation in order to obtain the optimum temperature range for germination. The species showed seed germinability in a wide temperature range (10-40 degrees C) being the optimal temperature range between 13.84 and 34.41 degrees C, determined by the enthalpy of activation.

Ceramic Primer Heat-Treatment Effect on Resin Cement/Y-TZP Bond Strength

The purpose of this study was to evaluate the effect of different heat-treatment strategies for a ceramic primer on the shear bond strength of a 10-methacryloyloxydecyl-dihydrogen-phosphate (MDP)-based resin cement to a yttrium-stabilized tetragonal zirconia polycrystal (Y-TZP) ceramic. Specimens measuring 4.5 x 3.5 x 4.5 mm(3) were produced from Y-TZP presintered cubes and embedded in polymethyl methacrylate (PMMA). Following finishing, the specimens were cleaned using an ultrasound device and distilled water and randomly divided into 10 experimental groups (n=14) according to the heat treatment of the ceramic primer and aging condition. The strategies used for the experimental groups were: GC (control), without primer; G20, primer application at ambient temperature (20 degrees C); G45, primer application + heat treatment at 45 degrees C; G79, primer application + heat treatment at 79 degrees C; and G100, primer application + heat treatment at 100 degrees C. The specimens from the aging groups were submitted to thermal cycling (6000 cycles, 5 degrees C/55 degrees C, 30 seconds per bath) after 24 hours. A cylinder of MDP-based resin cement (2.4 mm in diameter) was constructed on the ceramic surface of the specimens of each experimental group and stored for 24 hours at 37 degrees C. The specimens were submitted to a shear bond strength test (n=14). Thermal gravimetric analysis was performed on the ceramic primer. The data obtained were statistically analyzed by two-way analysis of variance and the Tukey test (alpha=0.05). The experimental group G79 without aging (7.23 +/- 2.87 MPa) presented a significantly higher mean than the other experimental groups without aging (GC: 2.81 +/- 1.5 MPa; G20: 3.38 +/- 2.21 MPa; G100: 3.96 +/- 1.57 MPa), showing no difference from G45 only (G45: 6 +/- 3.63 MPa). All specimens of the aging groups debonded during thermocycling and were considered to present zero bond strength for the statistical analyses. In conclusion, heat treatment of the metal/zirconia primer improved bond strength under the initial condition but did not promote stable bonding under the aging condition.

Amifostine protective effect on cisplatin-treated rat testis

Cisplatin is a potent drug used in clinical oncology but causes spermatogenesis damage. Amifostine is a drug used against toxicity caused by ionizing irradiation and chemotherapeutic drugs. Since cisplatin provokes fertility and induces germ cell apoptosis and necrosis, we proposed to evaluate the amifostine cytoprotective action on testes of cisplatin-treated rats. Thirty-day-old prepubertal Wistar rats received a single cisplatin dose of 5 mg/kg and were killed after 3, 6, and 12 hr. The hematoxylin-eosin stained testicular sections were submitted to histological, morphometric, and stereological analysis. The terminal deoxynucleotidyl transferase-mediated deoxyuridinetriphosphate nick end-labeling (TUNEL) method was used to label apoptotic cells. TUNEL-positive and TUNEL-negative germ cells with abnormal nuclear morphology (ANM) were scored. Significant alterations of greater part of the parameters occurred in the cisplatin-treated group (CE) compared to the group that received amifostine before the cisplatin-treatment (ACE); however, testicular weight and volume did not vary between these groups. Tubular diameter was reduced in CE in comparison to ACE rats, while interstitial tissue and lymphatic space volume and volume density were significantly higher in CE rats; interstitial testicular edema probably occurred in cisplatin-treated rats. CE rats showed important histological alterations, which were more accentuated than in ACE rats. The numerical densities of apoptotic germ cells and TUNEL-negative cells with ANM were lower in ACE than in CE rats. In conclusion, the amifostine previously administered to prepubertal rats reduced the testicular damage caused by cisplatin. We conclude that amifostine partially protected the rat seminiferous epithelium against cisplatin toxicity.

Root instrumentation with an erbium : yttrium-aluminum-garnet laser: Effect on the morphology of fibroblasts

Objective: the purpose of this study was to evaluate the effect of erbium:yttrium-aluminum-garnet laser instrumentation of root surfaces on the morphology of fibroblasts from continuous lineage. Method and materials: Dentinal slices with 4 mm(2) of surface area were obtained from teeth extracted for severe periodontal involvement. Specimens were assigned to one of three treatment groups: group 1, application of the laser with an energy level of 250 mJ at 103 pulses per second; group 2, application of the laser with an energy level of 80 mJ at 166 pulses per second; and group 3, similar to group 2, but with concomitant water irrigation of the device. The specimens were incubated in multiwell plates containing cell culture media. After 24 hours, the specimens were submitted to routine preparation for scanning electron microscopy. Three independent and blind examiners used photomicrographs to evaluate the morphology of the fibroblasts: 0 = without cells; 1 = flat cells; 2 = round cells; and 3 = combination of round and flat cells. Results: Statistical analysis indicated that there were significant differences among treatment groups and that group 3 was significantly different from groups 1 and 2. Conclusion: There was no difference between groups 1 and 2 in the morphology of fibroblasts. Laser instrumentation with concomitant irrigation impaired the adhesion of fibroblasts to dentinal surfaces.

Hygrothermal Aging Effect on Fatigue Behavior of GLARE

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Study of the annealing temperature effect on the structural and luminescent properties of SrWO4:Eu phosphors prepared by a non-hydrolytic sol-gel process

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Simultaneous solidification of two catalyst wastes and their effect on the early stages of cement hydration

Two catalyst wastes (RNi and RAI) from polyol production were considered as hazardous, due to their respective high concentration of nickel and aluminum contents. This article presents the study, done to avoid environmental impacts, of the simultaneous solidification/stabilization of both catalyst wastes with type II Portland cement (CP) by non-conventional differential thermal analysis (NCDTA). This technique allows one to monitor the initial stages of cement hydration to evaluate the accelerating and/or retarding effects on the process due to the presence of the wastes and to identify the steps where the changes occur. Pastes with water/cement ratio equal to 0.5 were prepared, into which different amounts of each waste were added. NCDTA has the same basic principle of Differential Thermal Analysis (DTA), but differs in the fact that there is no external heating or cooling system as in the case of DTA. The thermal effects of the cement paste hydration with and without waste presence were evaluated from the energy released during the process in real time by acquiring the temperature data of the sample and reference using thermistors with 0.03 A degrees C resolution, coupled to an analog-digital interface. In the early stages of cement hydration retarding and accelerating effects occur, respectively due to RNi and RAl presence, with significant thermal effects. During the simultaneous use of the two waste catalysts for their stabilization process by solidification in cement, there is a synergic resulting effect, which allows better hydration operating conditions than when each waste is solidified separately. Thermogravimetric (TG) and derivative thermogravimetric analysis (DTG) of 4 and 24 h pastes allow a quantitative information about the main cement hydrated phases and confirm the same accelerating or retarding effects due to the presence of wastes indicated from respective NCDTA curves.

Europium(III) Concentration Effect on the Spectroscopic and Photoluminescent Properties of BaMoO4:Eu

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Anatomical and biochemical characterization of the calcium effect on eucalyptus urophylla callus morphogenesis in vitro

Calcium chloride concentrations from 0.0 to 12.12 mM were added to the culture medium and calcium content in calluses were determined directly by X-ray fluorescence spectrometry, a non-destructive method, allowing the processing of the same tissue for histological analysis. A multivariate statistical analysis (PCA - Principal Components Analysis) grouped the treatments into 5 blocks and indicated the most responsive group. Lack of calcium supply caused a complete absence of a morphogenic process and tissue collapse. An increase in calcium concentration gave higher total protein and sugar contents, an increase in peroxidase specific activity and changes in the histological characteristics. It was possible to verify that calcium stimulated globular somatic embryo formation at concentration of 6.62 mM.

Bud source, asepsis and benzylaminopurine (BAP) effect on yacon (Polymnia sonchifolia) micropropagation

The yacon (Polymnia sonchifolia) is used largely for the high fructan content of its tubers; consequently, it is a good alternative for diabetics. One of the more important restricting factors of the commercial production of yacon is its susceptibility to nematode attack. This, as well as germplasm bank maintenance, justifies the importance of in vitro propagation of this species. In this way, our work aimed to verify the best asepsis method for yacon for the in vitro establishment from the rhizophore and the axillary buds of the aerial parts, and the effect of benzylaminopurine (BAP) addition to the culture medium. The number of contaminated cultures, the occurrence of phenolic oxidation and the occurrence of a vitreous aspect, showed differences with bud source, immersion time for asepsis, and BAP use. The results contribute to establishing a yacon micro propagation procedure.

Juvenile Hormone Effect on the Venom Gland Secretory Cycle in Workers of Apis mellifera (Hymenoptera, Apidae)

The present investigation analyzed the influence of Juvenile Hormone (JH) on the venom glands of Apis mellifera workers through protein dosage and electrophoresis of venom gland extracts of newly emerged workers which were treated with 1 μl JH dissolved in hexane, in concentration of 2μg/μl. Newly emerged workers non-treated and treated with 1 μl hexane were the controls. Both JH and hexane provoke quantitative changes on the gland protein titre and on the protein electrophoretic profile. The disappearance of protein bands in the venom gland extracts of 14 day-old treated workers, a situation normally found only in 35 day-old non-treated workers, suggests that the JH treatment induces a precocious maturation of the worker venom gland.

Temperature and stoichiometry effect on microstructural and ferroelectric properties of Pb(Zr1-xTix)O3 thin films prepared by chemical soulution deposition

Lead zirconate titanate (PZT) solutions were prepared using a polymeric precursor method, Zr n-propoxide and Ti i-propoxide were used as starting materials with ethylene glycol and water as solvents. The PZT solution was spin-coated on Pt/Ti/SiO2/Si substrates, baked on a hot plate, and finally heat-treated in a tube furnace between 400 and 800°C. The surface morphology and grain size of the films were characterized by atomic force microscopy (AFM), using a tapping mode with amplitude modulation. The films, thermal annealed at temperatures higher than 500°C, exhibited a dense microstructure, without noticeable cracks or voids. Electrical properties were investigated as a function of composition and annealing temperature.

Catecholamine effects on human melanoma cells evoked by α1-adrenoceptors

The biological effects of catecholamines in mammalian pigment cells are poorly understood. Our previous results showed the presence of α1-adrenoceptors in SK-Mel 23 human melanoma cells. The aims of this work were to (1) characterize catecholamine effects on proliferation, tyrosinase activity and expression, (2) identify the α1- adrenoceptor subtypes, and (3) verify whether chronic norepinephrine (NE) treatment modified the types and/or pharmacological characteristics of adrenoceptors present in SK-Mel 23 human melanoma cells. Cells treated with the aradrenergic agonist, phenylephrine (PHE, 10-5 or 10-4 M), for 24-72 h, exhibited decreased cell proliferation and enhanced tyrosinase activity, but unaltered tyrosinase expression as compared with the control. The proliferation and tyrosinase activity responses were inhibited by the α1-adrenergic antagonist prazosin, suggesting they were evoked by α1-adrenoceptors. The presence of actinomycin D, a transcription inhibitor, did not diminish PHE-induced effects. RT-PCR assays, followed by cloning and sequencing, demonstrated the presence of α1A- and α1B-adrenoceptor subtypes. NE-treated cells (24 or 72 h) were used in competition assays, and showed no significant change in the competition curves of α1-adrenoceptors as compared with control curves. Other adrenoceptor subtypes were not identified in these cells, and NE pretreatment did not induce their expression. In conclusion, the activation of SK-Mel 23 human melanoma α1- radrenoceptors elicit biological effects, such as proliferation decrease and tyrosinase activity increase. Desensitization or expression of other adrenoceptor subtypes after chronic NE treatment were not observed.