Hydrogen sulfide measurement by headspace-gas chromatography-mass spectrometry (HS-GC-MS): application to gaseous samples and gas dissolved in muscle.

The aim of our study was to present a new headspace-gas chromatography-mass spectrometry (HS-GC-MS) method applicable to the routine determination of hydrogen sulfide (H(2)S) concentrations in biological and gaseous samples. The primary analytical drawback of the GC/MS methods for H(2)S measurement discussed in the literature was the absence of a specific H(2)S internal standard required to perform quantification. Although a deuterated hydrogen sulfide (D(2)S) standard is currently available, this standard is not often used because this standard is expensive and is only available in the gas phase. As an alternative approach, D(2)S can be generated in situ by reacting deuterated chloride with sodium sulfide; however, this technique can lead to low recovery yield and potential isotopic fractionation. Therefore, N(2)O was chosen for use as an internal standard. This method allows precise measurements of H(2)S concentrations in biological and gaseous samples. Therefore, a full validation using accuracy profile based on the β-expectation tolerance interval is presented. Finally, this method was applied to quantify H(2)S in an actual case of H(2)S fatal intoxication.

Report on a review of selected general and application controls over the Iowa Department of Human Services’ Issuance Verification System for the period March 19, 2009 through April 17, 2009

Report on a review of selected general and application controls over the Iowa Department of Human Services’ Issuance Verification System for the period March 19, 2009 through April 17, 2009

Nitrogen application timing and soil inorganic nitrogen dynamics under no-till oat/maize sequential cropping

The timing of N application to maize is a key factor to be considered in no-till oat/maize sequential cropping. This study aimed to evaluate the influence of pre-planting, planting and sidedress N application on oat residue decomposition, on soil N immobilisation and remineralisation and on N uptake by maize plants in no-till oat/maize sequential cropping. Undisturbed soil cores of 10 and 20 cm diameter were collected from the 0-15 cm layer of a no-till Red Latossol, when the oat cover crop was in the milk-grain stage. Two greenhouse experiments were conducted simultaneously. Experiment A, established in the 10 cm diameter cores and without plant cultivation, was used to asses N dynamics in soil and oat residues. Experiment B, established in the 20 cm diameter cores and with maize cultivation, was used to assess plant growth and N uptake. An amount of 6.0 Mg ha-1 dry matter of oat residues was spread on the surface of the cores. A rate of 90 kg N ha-1 applied as ammonium sulphate in both experiments was split in pre-planting, planting and sidedress applications as follows: (a) 00-00-00 (control), (b) 90-00-00 (pre-planting application, 20 days before planting), (c) 00-90-00 (planting application), (d) 00-30-60 (split in a planting and a sidedress application 31 days after emergence), (e) 00-00-00* (control, without oat residue) and (f) 90-00-00* (pre-planting application, without oat residue). The N concentration and N content in oat residues were not affected during decomposition by N fertilisation. Most of the fertiliser NH4+-N was converted into NO3--N within 20 days after application. A significant decrease in NO3--N contents in the 0-4 cm layer was observed in all treatments between 40 and 60 days after the oat residue placement on the soil surface, suggesting the occurrence of N immobilisation in this period. Considering that most of the inorganic N was converted into NO3- and that no immobilisation of the pre planting fertiliser N occurred at the time of its application, it was possible to conclude that pre-planting applied N was prone to losses by leaching. On the other hand, with split N applications, maize plants showed N deficiency symptoms before sidedress application. Two indications for fertiliser-N management in no-till oat/maize sequential cropping could be suggested: (a) in case of split application, the sidedress should be earlier than 30 days after emergence, and (b) if integral application is preferred to save field operations, this should be done at planting.

Use of the FACTS solvation model for protein-ligand docking calculations. Application to EADock.

Protein-ligand docking has made important progress during the last decade and has become a powerful tool for drug development, opening the way to virtual high throughput screening and in silico structure-based ligand design. Despite the flattering picture that has been drawn, recent publications have shown that the docking problem is far from being solved, and that more developments are still needed to achieve high successful prediction rates and accuracy. Introducing an accurate description of the solvation effect upon binding is thought to be essential to achieve this goal. In particular, EADock uses the Generalized Born Molecular Volume 2 (GBMV2) solvent model, which has been shown to reproduce accurately the desolvation energies calculated by solving the Poisson equation. Here, the implementation of the Fast Analytical Continuum Treatment of Solvation (FACTS) as an implicit solvation model in small molecules docking calculations has been assessed using the EADock docking program. Our results strongly support the use of FACTS for docking. The success rates of EADock/FACTS and EADock/GBMV2 are similar, i.e. around 75% for local docking and 65% for blind docking. However, these results come at a much lower computational cost: FACTS is 10 times faster than GBMV2 in calculating the total electrostatic energy, and allows a speed up of EADock by a factor of 4. This study also supports the EADock development strategy relying on the CHARMM package for energy calculations, which enables straightforward implementation and testing of the latest developments in the field of Molecular Modeling.

Report on a review of selected general and application controls over the Iowa Department of Transportation’s Internal Billing System for the period April 6, 2009 through July 31, 2009

Report on a review of selected general and application controls over the Iowa Department of Transportation’s Internal Billing System for the period April 6, 2009 through July 31, 2009

Report on a review of selected general and application controls over the Iowa State University of Science and Technology (Iowa State University) Purchase Order/Requisition System for the period of March 20 through April 28, 2009

Report on a review of selected general and application controls over the Iowa State University of Science and Technology (Iowa State University) Purchase Order/Requisition System for the period of March 20 through April 28, 2009

Report on the review of selected general and application controls over the State University of Iowa (University of Iowa) ePro System for the period June 15, 2009 through July 31, 2009

Report on the review of selected general and application controls over the State University of Iowa (University of Iowa) ePro System for the period June 15, 2009 through July 31, 2009

Report on a review of selected general and application controls over the University of Northern Iowa Accounts Payable/Purchasing System for the period of June 10, 2009 through August 20, 2009

Report on a review of selected general and application controls over the University of Northern Iowa Accounts Payable/Purchasing System for the period of June 10, 2009 through August 20, 2009

Prescriptions de protection incendie en Suisse : étude de leur domaine d'application et de leur respect par l'investigation d'incendies

Avant - Propos Le feu et la protection incendie Quel que soit l'usage d'un bâtiment, chaque étape de la construction est soumise à l'application de normes. Certaines, utilisées par les architectes et les ingénieurs, concernent le gros oeuvre ; en simplifiant leur rôle, elles assurent la solidité et la stabilité de l'immeuble. Si celui-ci est ouvert au public, des aménagements particuliers concernant la sécurité des personnes sont imposés. D'autres comme les prescriptions sur les installations électriques intérieures, précisent la manière de construire une alimentation, le type de matériel utilisable en fonction du courant et de la tension, les sécurités destinées à éviter toute détérioration des circuits et tout risque d'électrocution, etc. Enfin, les prescriptions en matière de protection incendie jouent évidemment un rôle préventif et, dans le domaine judiciaire, servent de références pour qualifier une éventuelle infraction ; elles évitent qu'une source de chaleur installée dans un bâtiment - tel qu'un appareil de chauffage ou des plaques de cuisson - ou susceptible d'apparaître consécutivement à l'usure d'un matériau ou à son vieillissement - disparition d'un isolant thermique, défaut d'étanchéité d'un conduit transportant les gaz chauds de combustion, par exemple - ne communiquent une partie de l'énergie calorifique dégagée à un combustible et ne l'enflamme. Le concept de protection incendie implique d'exposer et de développer les principales notions relatives à l'inflammation d'un matériau, à sa combustion ainsi qu'au transport de l'énergie calorifique. Fréquemment, le milieu dans lequel le générateur de chaleur est installé joue un rôle dans la phase d'allumage de l'incendie. Il est évident que les prescriptions de protection incendie s'appliquent à chaque élément de construction et, par conséquent, doivent être respectées par toute personne participant à la réalisation d'un ouvrage : le chauffagiste, l'électricien, l'installateur sanitaire, le constructeur de cuisine, mais également le maçon qui construit la cheminée, le peintre et le décorateur qui posent des revêtements ou des garnitures inflammables, le menuisier qui utilise le bois pour dissimuler des conduites de fumée, etc. Dès lors, tout sinistre, hormis celui qui est perpétré délibérément, ne peut s'expliquer que par : - le non-respect ou le défaut d'application d'une prescription de protection incendie; - une lacune de la norme qui ignore une source d'échauffement et/ou un mode de transfert de l'énergie calorifique. Le but premier de ce travail consiste à : - analyser les sinistres survenus durant les années 1999 à 2005 dans plusieurs cantons suisses qui ont fait l'objet d'une investigation de la part d'un service technique de la police ou d'un expert ; - examiner les éléments retenus pour expliquer la cause de l'incendie à la norme afin de répondre à la question : « l'application d'une ou de plusieurs directives lors de l'installation ou de l'utilisation du générateur d'énergie calorifique aurait-elle évité à ce dernier de communiquer une partie de la chaleur dégagée à un combustible et à l'enflammer ? » Le second objectif visé est d'apporter une solution à la question précédente : - si la norme existe, c'est un défaut d'installation ou d'utilisation de la source de chaleur qui est à l'origine de l'incendie. Il importe donc de connaître la raison pour laquelle la prescription a été ignorée ou appliquée de manière erronée ou lacunaire; - si la norme n'existe pas, ce sont les prescriptions en matière de protection incendie qui doivent être complétées. Le chapitre suivant abordera ces thèmes en proposant divers postulats destinés à évaluer l'efficacité actuelle du concept de protection incendie en Suisse.

Théorie et application de l'impôt sur le capital / par Menier,...

Collection : Bibliothèque de la réforme fiscale et économique

Report on a review of selected general and application controls over the State University of Iowa BuildUI System for the period June 14, 2010 through July 19, 2010

Report on a review of selected general and application controls over the State University of Iowa BuildUI System for the period June 14, 2010 through July 19, 2010

Report on a review of selected general and application controls over the Iowa State University of Science and Technology Accounts Receivable System for the period of March 29, 2010 through May 6, 2010

Report on a review of selected general and application controls over the Iowa State University of Science and Technology Accounts Receivable System for the period of March 29, 2010 through May 6, 2010

Report on a review of selected application controls over the University of Northern Iowa Non-Student Accounts Receivable System for the period June 10, 2010 through July 23, 2010

Report on a review of selected application controls over the University of Northern Iowa Non-Student Accounts Receivable System for the period June 10, 2010 through July 23, 2010