Influence of Contact Angle and Tube Size on Capillary-Driven Flow Under Microgravity

The influence of contact angle and tube radius on the capillary-driven flow for circular cylindrical tubes is studied systematically by microgravity experiments using the drop tower. Experimental results show that the velocity of the capillary flow decreases monotonically with an increase in the contact angle. However, the time-evolution of the velocity of the capillary flow is different for different sized tubes. At the beginning of the microgravity period, the capillary flow in a thinner tube moves faster than that in a thicker tube, and then the latter overtakes the former. Therefore, there is an intersection between the curves of meniscus velocity vs microgravity time for two differently sized tubes. In addition, for two given sized tubes this intersection is delayed when the contact angle increases. The experimental results are analyzed theoretically and also supported by numerical computations.

Influence of Rayleigh-Taylor Instability on Liquid Propellant Reorientation in a Low-Gravity Environment

A computational simulation is conducted to investigate the influence of Rayleigh-Taylor instability on liquid propellant reorientation flow dynamics for the tank of CZ-3A launch vehicle series fuel tanks in a low-gravity environment. The volume-of-fluid (VOF) method is used to simulate the free surface flow of gas-liquid. The process of the liquid propellant reorientation started from initially flat and curved interfaces are numerically studied. These two different initial conditions of the gas-liquid interface result in two modes of liquid flow. It is found that the Rayleigh-Taylor instability can be reduced evidently at the initial gas-liquid interface with a high curve during the process of liquid reorientation in a low-gravity environment.

The influence of diets and body manipulations on the growth of African prawn Macrobrachium vollenhovenii (Herklots)

Live African prawns Macrobrachium vollenhovenii were collected from Asejire reservoir (Nigeria) by trapping. After acclimatization, the prawns were differently amputated: some had their eye-stalks cut; some had their chelae cut; some had both eyestalks and chelae cut while some were intact which served as the control. Each set was placed under different levels of crude protein viz 15%; 20%; and 25%. Weekly weight changes were monitored. Results obtained were subjected to statistical analysis including analysis of variance (ANOVA). The results showed that prawns fed with 20% crude protein had the best growth rate. Specimens with the eyestalk and chelae removed also showed superior growth when compared with the others. Specimens that had their eyestalks removed were able to feed for 18 hours in the day while those with intact body fed for 6 hours during the same period. The amputation of the chelate appendages reduced considerably the cannibalistic urge in the prawns. This enabled a high number of prawns to be grown in the experimental tanks

Influence of HCl on CO and NO emissions in combustion

The influence of HCl on CO and NO emissions was experimentally investigated in an entrained flow reactor (EFR) and an internally circulating fluidized bed (ICFB). The results in EFR show the addition of HCl inhibits CO oxidation and NO formation at 1073 K and 1123 K. At the lower temperature (1073 K) the inhibition of HCl becomes more obvious. In ICFB, chlorine-containing plastic (PVC) was added to increase the concentration of HCl during the combustion of coal or coke. Results show that HCl is likely to enhance the reduction of NO and N2O. HCl greatly increases CO and CH4 emission in the flue gas. A detailed mechanism of CO/NO/HCl/SO2 system was used to model the effect of HCl in combustion. The results indicate that HCl not only promotes the recombination of radicals O, H, and OH, but also accelerates the chemical equilibration of radicals. The influence of HCl on the radicals mainly occurs at 800-1200 K. (C) 2009 Elsevier Ltd. All rights reserved.

Influence of atomic densities on propagation property for ultrashort pulses in a two-level medium

The influence of atomic densities on the propagation property for ultrashort pulses in a two-level atom (TLA) medium is investigated. With higher atomic densities, the self-induced transparency (SIT) cannot be recovered even for 2π ultrashort pulses. New features such as pulse splitting, red-shift and blue-shift of the corresponding spectra arise, and the component of central frequency gradually disappears.

Three-dimensional models of mantle convection : influence of phase transitions and temperature-dependent viscosity

Two of the most important questions in mantle dynamics are investigated in three separate studies: the influence of phase transitions (studies 1 and 2), and the influence of temperature-dependent viscosity (study 3).

(1) Numerical modeling of mantle convection in a three-dimensional spherical shell incorporating the two major mantle phase transitions reveals an inherently three-dimensional flow pattern characterized by accumulation of cold downwellings above the 670 km discontinuity, and cylindrical 'avalanches' of upper mantle material into the lower mantle. The exothermic phase transition at 400 km depth reduces the degree of layering. A region of strongly-depressed temperature occurs at the base of the mantle. The temperature field is strongly modulated by this partial layering, both locally and in globally-averaged diagnostics. Flow penetration is strongly wavelength-dependent, with easy penetration at long wavelengths but strong inhibition at short wavelengths. The amplitude of the geoid is not significantly affected.

(2) Using a simple criterion for the deflection of an upwelling or downwelling by an endothermic phase transition, the scaling of the critical phase buoyancy parameter with the important lengthscales is obtained. The derived trends match those observed in numerical simulations, i.e., deflection is enhanced by (a) shorter wavelengths, (b) narrower up/downwellings (c) internal heating and (d) narrower phase loops.

(3) A systematic investigation into the effects of temperature-dependent viscosity on mantle convection has been performed in three-dimensional Cartesian geometry, with a factor of 1000-2500 viscosity variation, and Rayleigh numbers of 10^5-10^7. Enormous differences in model behavior are found, depending on the details of rheology, heating mode, compressibility and boundary conditions. Stress-free boundaries, compressibility, and temperature-dependent viscosity all favor long-wavelength flows, even in internally heated cases. However, small cells are obtained with some parameter combinations. Downwelling plumes and upwelling sheets are possible when viscosity is dependent solely on temperature. Viscous dissipation becomes important with temperature-dependent viscosity.

The sensitivity of mantle flow and structure to these various complexities illustrates the importance of performing mantle convection calculations with rheological and thermodynamic properties matching as closely as possible those of the Earth.

Influence of number of valves on catch composition of a fishing pot trap (Lege) in River Rima, north western Nigeria

Three types of prototype (Lege) traps with different numbers of entrance valves were evaluated in River Rima, north western Nigeria. The traps contained 4,6 and 8 valves, tagged 4-V, 6-V and 8-V respectively. The experiment was carried out in a randomized complete block design with one factor each replicated three times. Data collected on fish diversity, number biomass and sizes were subjected to descriptive statistics and analysis of variance. The results of the catch composition showed close diversity index of 0.86 for 6-V, 0.80 for 8-V and 0.60 for 4-V Lege traps. However, the number (41%) and biomass 48%) of fish caught in the 6-V Lege trap were significantly (P0.05) higher than those caught in the other traps. There was no definite trend in the sizes (length and girth) of fish caught in the traps. On the basis of species diversity, and the number and biomass of fish caught, the 6-V Lege showed preference for adoption than the other two traps. However, further studies are recommended on the appropriate mesh size net for the trap in line with the provisions of fisheries edicts

Characterization of a multi-keV x-ray source produced by nanosecond laser irradiation of a solid target: The influence of laser focus spot and target thickness

The influence of focus spot and target thickness on multi-keV x-ray sources generated by 2 ns duration laser heated solid targets are investigated on the Shenguang II laser facility. In the case of thick-foil targets, the experimental data and theoretical analysis show that the emission volume of the x-ray sources is sensitive to the laser focus spot and proportional to the 3 power of the focus spot size. The steady x-ray flux is proportional to the 5/3 power of the focus spot size of the given laser beam in our experimental condition. In the case of thin-foil targets, experimental data show that there is an optimal foil thickness corresponding to the given laser parameters. With the given laser beam, the optimal thin-foil thickness is proportional to the -2/3 power of the focus spot size, and the optimal x-ray energy of thin foil is independent of focus spot size. (C) 2008 American Institute of Physics.

Influence of number of valves on catch composition of a fishing pot trap (Lege) in River Rima, north western Nigeria

Three types of prototype (Lege) traps with different numbers of entrance valves were evaluated in River Rima, north western Nigeria. The traps contained 4,6 and 8 valves, tagged 4-V, 6-V and 8-V respectively. The experiment was carried out in a randomized complete block design with one factor each replicated three times. Data collected on fish diversity, number, biomass and sizes were subjected to descriptive statistics and analysis of variance. The results of the catch composition showed close diversity index of 0.86 for 6-V, 0.80 for 8-V and 0.60 for 4-V Lege traps. However, the number (41%) and biomass (48%) of fish caught in the 6-V Lege trap were significantly (P<0.05) higher than those caught in the other traps. There was no definite trend in the sizes (length and girth) of fish caught in the traps. On the basis of species diversity, and the number and biomass of fish caught, the 6-V Lege showed preference for adoption than the other two traps. However, further studies are recommended on the appropriate mesh size net for the trap in line with the provisions of fisheries edicts

Influence of target thickness on the generation of high-density ion bunches by ultrashort circularly polarized laser pulses

Ion acceleration by ultrashort circularly polarized laser pulse in a solid-density target is investigated using two-dimensional particle-in-cell simulation. The ions are accelerated and compressed by the continuously extending space-charge field created by the evacuation and compression of the target electrons by the laser light pressure. For a sufficiently thin target, the accelerated and compressed ions can reach and exit from the rear surface as a high-density high-energy ion bunch. The peak ion energy depends on the target thickness and reaches maximum when the compressed ion layer can just reach the rear target surface. The compressed ion layer exhibits lateral striation which can be suppressed by using a sharp-rising laser pulse. (c) 2008 American Institute of Physics.