Nitrate reductase activity in macroalgae and its vertical distribution in macroalgal epiphytes of seagrasses.

Macroalgal epiphytes within seagrass meadows make a significant contribution to total primary production by assimilating water column N and transferring organic N to sediments. Assimilation of NO3 – requires nitrate reductase (NR, EC 1.6.6.1); NR activity represents the capacity for NO3 – assimilation. An optimised in vitro assay for determining NR activity in algal extracts was applied to a wide range of macroalgae and detected NR activity in all 22 species tested with activity 2 to 290 nmolNO3 – min–1 g–1 frozen thallus. With liquid-N2 freezing immediately after sample collection, this method was practical for estimating NR activity in field samples. Vertical distribution of NR activity in macroalgal epiphytes was compared in contrasting Posidonia sinuosa and Amphibolis antarctica seagrass meadows. Epiphytes on P. sinuosa had higher mass-specific NR activity than those on A. antarctica. In P. sinuosa canopies, NR activity increased with distance from the sediment surface and was negatively correlated with [NH4 +] in the water but uncorrelated with [NO3 –]. This supported the hypothesis that NH4 + released from the sediment suppresses NR in epiphytic algae. In contrast, the vertical variation in NR activity in macroalgae on A. antarctica was not statistically significant although there was a weak correlation with [NO3 –], which increased with distance from the sediment. Estimated capacities for NO3 – assimilation in macroalgae epiphytic on seagrasses during summer (24 and 46 mmolN m–2 d–1 for P. sinuosa and A. antarctica, respectively) were more than twice the estimated N assimilation rates in similar seagrasses. When the estimates were based on annual average epiphyte loads for seagrass meadows in other locations, they were comparable to those of seagrasses. We conclude that epiphytic algae represent a potentially important sink for water-column nitrate within seagrass meadows.

Gas-liquid two phase flow through a vertical 90deg elbow bend

Pressure drop data are reported for two phase air-water flow through a vertical to horizontal 90° elbow bend set in 0.026 m i.d. pipe. The pressure drop in the vertical inlet tangent showed some significant differences to that found for straight vertical pipe. This was caused by the elbow bend partially choking the inflow resulting in a build-up of pressure and liquid in the vertical inlet riser and differences in the structure of the flow regimes when compared to the straight vertical pipe. The horizontal outlet tangent by contrast gave data in general agreement with literature even to exhibiting a drag reduction region at low liquid rates and gas velocities between 1 and 2 m s -1. The elbow bend pressure drop was best correlated in terms of le/d determined using the actual pressure loss in the inlet vertical riser. The data showed a general increase with fluid rates that tapered off at high fluid rates and exhibited a negative pressure region at low rates. The latter was attributed to the flow being smoothly accommodated by the bend when it passed from slug flow in the riser to smooth stratified flow in the outlet tangent. A general correlation was presented for the elbow bend pressure drop in terms of total Reynolds numbers. A modified Lockhart-Martinelli model gave prediction of the data.

Numerical simulation of the charge balance in an EBIT

The electron beam ions traps (EBITs) are widely used to study highly charged ions (HCIs). In an EBIT, a high energy electron beam collides with atoms and ions to generate HCIs in the trap region. It is important to study the physics in the trap. The atomic processes, such as electron impact ionisation (EI), radiative recombination (RR), dielectronic recombination (DR) and charge exchange (CX), occur in the trap and numerical simulation can give some parameters for design, predict the composition and describe charge state evolution in an EBIT [Phys. Rev. A 43 (199 1) 4861]. We are presently developing a new code, which additionally includes a description of the overlaps between the ion clouds of the various charge-states. It has been written so that it can simulate experiments where various machine parameters (e.g. beam energy and current) can vary throughout the simulation and will be able to use cross- sections either based on scaling laws or derived from atomic structure calculations. An object-oriented method is used in developing the new software, which is an efficient way to organize and write code. (C) 2003 Elsevier Science B.V. All rights reserved.