Gaussian etched single transverse mode vertical-cavity surface-emitting laser

A continuous Gaussian profile matched to the fundamental mode was etched onto the aperture of a vertical cavity surface emitting laser (VCSEL). Single Gaussian spot emission was achieved over the entire operating current range.

High speed reconfiguration of dual-purpose vertical cavity surface emitting laser/detector

High-speed configuration results of a conventional 850 nm VCSEL that is modified to operate as an efficient avalanche detector as well as a laser are discussed. The measured laser-to-detector reconfiguration delay of 3.2 ns is longer than the 1.2 ns detector-to-detector reconfiguration delay.

All-optical switching in a vertical coupler space switch employing photocarrier-induced nonlinearity

A novel compact integrated nonlinear optical switch is demonstrated. Using a high-power picosecond pulse of 5-ps pulsewidth and 250-MHz repetition rate, all-optical switching with a contrast ratio of 23 dB has been achieved using an in-fiber input power < 14 dBm (100 pJ/pulse). The switch speed depends on the carrier sweep-out time, which can be reduced to the 10 ps range by either applying a reverse bias or by introduction of carrier recombination centers in the active layer.

East African Inland Fisheries Research Organization Annual Report for year ended 31st December 1949

The present work is now concentrated mainly on the Tilapia fishery. As a result of past experience it is easier to direct efforts in a way likely to give useful results. Work on the Tilapia is now beyond the purely exploratory stage and these fishing experiments are being carried but in areas which are known to contain large numbers of Tilapia. Nets of different mesh size are being used in order to catch all stages of these fish. These nets are being fished at the surface and at the bottom, close to the shore and further out. The data collected should provide more precise information regarding the periodic migration, both vertical and horizontal, of these fish, a better understanding of their life history and breeding habits, and indicate' the potential possibilities of this fishery. These data should explain the variation in numbers of fish caught by Africans during different months of the year; they should also make it possible to determine more exactly the best type of net for use in this particular fishery.

Optimizing the energy output of vertical axis wind turbines for fluctuating wind conditions

The control of a wind turbine to the mean wind speed in a gusty wind results in very poor performance. Fluctuations in wind speed with time constants shorter than the response time of a wind turbine results in operation away from optimum design conditions. The effectiveness of a turbine operating in a gusty wind is shown though the use of an unsteady performance coefficient, C e. This performance coefficient is similar in form to a power coefficient. However in order to accommodate unsteady effects, Ce is defined as a ratio of energy extracted to the total wind energy available over a set time period. The turbine's response to real wind data is modelled, in the first instance, by assuming a constant rotational speed operation. It is shown that a significant increase in energy production can be realized by demanding a Tip Speed Ratio above the steady state optimum. The constant speed model is then further extended to incorporate inertial and controller effects. Parameters dictating how well a turbine can track a demand in Tip Speed Ratio have been identified and combined, to form a non-dimensional turbine response parameter. This parameter characterizes a turbine's ability to track a demand in Tip Speed Ratio dependent on an effective gust frequency. A significant increase in energy output of 42% and 245% is illustrated through the application of this over-speed control. This is for the constant rotational speed and Tip Speed Ratio feedback models respectively. The affect of airfoil choice on energy extraction within a gusty wind has been considered. The adaptive control logic developed enables the application of airfoils demonstrating high maximum L/D values but sharp stalling characteristics to be successfully used in a VAWT design.

Vertical temperature structure of 250 m. water layer around Sri Lanka at the tail-end of the north-east monsoon

Data collected during cruises of the Hoyo Maru in Jan-Mar 1975 are analysed. Data is tabulated to show vertical temp profile, surface water temp and temp gradient. Each of these features is discussed. Thermoclines are shown to be established off the coast of India, their depth varying according to time of year. Upwelling off the Cochin coast is discussed. This occurs during Oct-Nov. Surface temp is considerably influenced by the north-east monsoon. The 'clockwise current' (or 'transparent current) characterised by high salinity, high transparency, and rich nutrient conchs, and which prevails in Jan-May brings oceanic water into the Bay of Bengal and sweeps along the Ceylon coast.

The effect of a twin tunnel on the propagation of ground-borne vibration from an underground railway

Accurate predictions of ground-borne vibration levels in the vicinity of an underground railway are greatly sought after in modern urban centres. Yet the complexity involved in simulating the underground environment means that it is necessary to make simplifying assumptions about this system. One such commonly made assumption is to ignore the effects of neighbouring tunnels, despite the fact that many underground railway lines consist of twin-bored tunnels, one for the outbound direction and one for the inbound direction. This paper presents a unique model for two tunnels embedded in a homogeneous, elastic fullspace. Each of these tunnels is subject to both known, dynamic train forces and dynamic cavity forces. The net forces acting on the tunnels are written as the sum of those tractions acting on the invert of a single tunnel, and those tractions that represent the motion induced by the neighbouring tunnel. By apportioning the tractions in this way, the vibration response of a two-tunnel system is written as a linear combination of displacement fields produced by a single-tunnel system. Using Fourier decomposition, forces are partitioned into symmetric and antisymmetric modenumber components to minimise computation times. The significance of the interactions between two tunnels is quantified by calculating the insertion gains, in both the vertical and horizontal directions, that result from the existence of a second tunnel. The insertion-gain results are shown to be localised and highly dependent on frequency, tunnel orientation and tunnel thickness. At some locations, the magnitude of these insertion gains is greater than 20 dB. This demonstrates that a high degree of inaccuracy exists in any surface vibration prediction model that includes only one of the two tunnels. This novel two-tunnel solution represents a significant contribution to the existing body of research into vibration from underground railways, as it shows that the second tunnel has a significant influence on the accuracy of vibration predictions for underground railways. © 2011 Elsevier Ltd. All rights reserved.

Further investigations on the relative efficiency of different shaped otter boards

Horizontal curved, vertical curved and V-shaped otter boards were studied to compare their relative efficiency under identical fishing conditions. The gear operated with V-shaped otter boards performed well followed by the gear fitted with horizontal curved boards. Vertical curved boards were found to be comparatively less efficient, but with slight modification, can be used advantageously for bottom and off bottom fishes. Fishing at various depths with horizontal curved and V-shaped otter boards at different scope ratios showed better performance of horizontal curved boards at a scope ratio of 1:6 and V-shaped otter boards at a scope ratio of 1:5.

Transient growth and triggering in the horizontal Rijke tube Matthew

This theoretical paper examines a non-normal and non-linear model of a horizontal Rijke tube. Linear and non-linear optimal initial states, which maximize acoustic energy growth over a given time from a given energy, are calculated. It is found that non-linearity and non-normality both contribute to transient growth and that, for this model, linear optimal states are only a good predictor of non-linear optimal states for low initial energies. Two types of non-linear optimal initial state are found. The first has strong energy growth during the first period of the fundamental mode but loses energy thereafter. The second has weaker energy growth during the first period but retains high energy for longer. The second type causes triggering to self-sustained oscillations from lower energy than the first and has higher energy in the fundamental mode. This suggests, for instance, that low frequency noise will be more effective at causing triggering than high frequency noise.

On the comparative fishing experiments with a four-seam and a two-seam trawls on the east coast

Fishing experiments were undertaken to study the relative utility of a newly designed four seam type net on a conventional two seam net at the centre along the East Coast in both inshore and deeper zones (up to 100m.) and the results indicated that the new four seam net has given higher catch rate of 6 to 8% more with higher catch rate of fish supposed to belong to off bottom region. Further this gear found more selective in obtaining Lactarius, which is one of the good variety of fish from trawlers, in both quantity as well as in quality. In terms of horizontal spread this new net gave less on comparison with the conventional two seam net, thereby showed corresponding increase in vertical spread; but warp tension remained more or less same in both the gear. Both gear have worked equally well in majority of depth ranges experimented with optimum spread. Finally the results indicated that the new net can work well from the present trawlers along the coast.

Effect of weight of otter boards on the horizontal opening of trawl nets

The paper gives briefly the experiments carried out to determine the optimum weight of otter board that should be used for a trawl gear for better efficiency.

On the vertical distribution of seers and other commercially important fishes in the surface drift nets

This note highlights the author's attempts to determine the vertical height for catching seers (Scomberomorus sp.) and other commercially important fish off Kakinada coast.

Vertical distribution of marine wood boring and fouling organisms from the estuarine areas of the south west coast of India

Vertical distribution of marine wood boring and fouling organisms from three different estuarine areas namely, the Ernakulam channel in the Cochin backwaters, Ayiramthengu in the Kayamkulam Lake and Neendakara in the Asthamudi Lake during the post-monsoon, the pre-monsoon and the monsoon periods is presented. The boring organisms noticed during the present study were Martesia striata, Teredo furcifera, Nausitora hedleyi and Sphaeroma terebrans. The dominant fouling organisms were Balanus amphitrite amphitrite, calcareous worms and Modiolus sp. Algae and diatoms were very common on the sub-tidal panels during the monsoon. The incidence of Teredo, Nausitora and calcareous tube worms were significantly high on the bottom panels. Sphaeroma, Balanus and Modiolus occurred in greater numbers on the intertidal panels.